• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2012년도 춘계학술대회 논문집
• /
• pp.150-154
• /
• 2012

A flow induced mechanical vibration and acoustic resonance should be considered at design stage because they are mainly occurred in the tube bank of boiler. Acoustic resonance is occurred when the vortex shedding frequency of tube bank coincides with the acoustic natural frequency of the cavity. Effective solution to avoid acoustic resonance is installing acoustic baffles in the tube banks parallelly inside of the flow cavity. Thus, location and number of acoustic baffles should be exactly calculated to eliminate the acoustic resonance. This paper presents case study of acoustic resonance due to inappropriate number and location of acoustic baffles. Measured frequency and mode in the study is verified by FEM acoustic modal analysis. The number and location of acoustic baffles to avoid acoustic resonance are calculated by using FEM acoustic modal analysis.

• 유체기계공업학회:학술대회논문집
• /
• 유체기계공업학회 2005년도 연구개발 발표회 논문집
• /
• pp.126-132
• /
• 2005

UV disinfection system allows the disinfection of municipal and industrial water and wastewater without the use of expensive chlorination and dechlorination techniques, labor intensive equipments In traditional ultraviolet systems the UV lamps are seperated from water by quartz sleeves. quartz is one of. the few materials that is virtually transparent to UV light, the UV lamp is placed inside the Quartz sleeve. UV light from the lamp is passed through the quartz and into the water, thereby providing disinfection. In fluoropolymer tube-used non-contact UV systems, the water flows through fluoropolymer plastic tubes. banks of UV lamps surround these tubes such that each tube gets exposed to ultra violet light from all sides. in non-contact design the lamps operates at almost constant temperature. this design is extremly efficient in the utilization of UV energy and superior to conventional contact- systems.

• International Journal of Air-Conditioning and Refrigeration
• /
• 제9권2호
• /
• pp.19-27
• /
• 2001

In the present study, the effects of film Reynolds number (60∼200) and volumetric content of non-absorbable gases (0∼10%) in water vapor on the absorption process of aqueous LiBr solution were investigated experimentally. The formation of solution film on the horizontal tubes of six rows was observed to be complete for Re>100. Transition film Reynolds number was found to exist above which the Nusselt number and Schmidt number diminishes with solution flow rate. As the concentration of non-absorbable gases increased, mass transfer rate decreased more seriously than heat transfer rate did. the degradation effects of non-absorbable gases seemed to be significant especially when small amount of non-absorbable gases was introduced to the pure water vapor.

• 대한기계학회논문집B
• /
• 제35권9호
• /
• pp.923-932
• /
• 2011

본 연구에서는 복합화력발전소 가스터빈 출구가스 안내덕트 내부의 가스유동장이 배열회수보일러 전열기구에 미치는 영향을 CFD기법을 이용하여 분석하였다. 안내덕트 내부 난류흐름의 경우, 유속의 편차가 크고 선회 효과 및 상승류 현상이 심한 특징을 가지고 있음으로 이와 같은 유동의 수치해석을 위해 2개 방정식 난류점성 모델 중 RNG k-${\epsilon}$ 모델을 사용하였으며 유동장의 영향을 가장 많이 받는 배열 회수보일러 최종과열기관의 열전달특성변화를 파악하기 위하여 NTU 방식을 이용한 수치해석결과와, 산업계에서 적용하는 설계기법에 의한 결과를 비교하였다.

• 동력기계공학회지
• /
• 제12권5호
• /
• pp.48-53
• /
• 2008

Heat exchangers are commonly used in practice in a wide range of application, from heating and air-conditioning system in a household, to chemical processing and power production in a large plant. Heat transfer in a heat exchanger usually involves convection in each fluid and conduction through the wall separating the two fluids. The heat transfer characteristics of tube banks of in-line arrangements of four circular cylinders in a cross flow are compared for a range of tube locations and Reynolds numbers. The in-line pitch ratio was set up in the range of $1.5\leq L/d\leq4.0$, where L is the center to center distance and d the circular cylinder diameter, and in the Reynolds number of $13,000\leq Re\leq50,000$. The local and mean Nusselt numbers were estimated, and then. Subsequently, the heat transfer characteristics of four circular cylinders were found to exhibit a strong dependency upon the cylinder spacing and separation point of their upstream cylinders.

• 대한기계학회논문집B
• /
• 제35권2호
• /
• pp.215-220
• /
• 2011

산업용 보일러의 열효율을 높이고 체적을 줄이기 위하여 0.5 t/h 급 무연소실 보일러를 개발하였다. 별도의 연소실이 없이 증발관이 화염에 노출된 구조에서 화염 안정성을 확보하기 위하여 금속섬유버너를 채택하였다. 증발관은 관군의 형태로 버너 하류에 배치되고 하류에 설치된 증발관에는 휜을 설치하여 열교환 면적을 확보하였다. 무연소실 보일러는 관군에 대한 열전달 관계식으로부터 설계하였고 본 연구에서는 시제품에 대한 실험 및 보일러 내부의 유동 및 열전달에 대한 수치해석을 수행하여 관군에 대한 관계식을 적용한 설계와 비교하였다.

• Journal of Advanced Marine Engineering and Technology
• /
• 제32권5호
• /
• pp.691-697
• /
• 2008

Heat exchangers are commonly used in practice in a wide range of application, from heat and air-conditioning system in a household, to chemical processing and power production in large plant. An Experimental study was conducted to investigated the fluid flow and heat transfer around four circular cylinders of in-line in a cross flow of air. The local and average heat transfer characteristics for tube banks are investigated in the present study. Heat transfer in a heat exchanger usually involves convection in each fluid and conduction through the wall separating the two fluid. The in-line pitch ratio was in the range $1.5{\leq}L/d{\leq}4.0$, where L is the center distance and d the cylinder diameter, and in the Reynolds number $8,000{\leq}Re{\leq}50,000$. The local and mean Nusselt numbers were estimated. Subsequently, the heat transfer characteristics of four circular cylinders are found to exhibit a strong dependency upon the separation point of their upstream cylinders.

• Journal of Advanced Marine Engineering and Technology
• /
• 제25권4호
• /
• pp.857-868
• /
• 2001

The aerodynamic forces and wake structures of the non-rotating downstream cylinder which is located behind the spinning upstream cylinder in tandem and staggered arrangement have been investigated by experimental method at Re= $1.32{\times}10^4$. The measurements of wake flow and pressure distributions of downstream cylinder are carried out in various spin parameters by combination of both longitudinal spacing rations L/d=1.5, 3.0, 4.5 and transverse spacing ratios T/d =0.0, -0.5, 0.5. For the present experiment, it has been found that the spin parameter of spinning upstream cylinder affect more easily the downstream cylinder in tandem arrangement than that in staggered arrangement.

• 한국태양에너지학회 논문집
• /
• 제31권4호
• /
• pp.9-18
• /
• 2011

This study assessed the performance of a compact heat exchanger with staggered tube banks for recuperation of high temperature exhaust thermal energy for SOFC fuel cell system. The compact heat exchanger in this study is two pass system which consists of $315{\times}202.5{\times}48.5mm^3$ and 132 tubes of $6.0mm{\Phi}$ for each heat exchanger. From experiments of the 2 pass heat exchanger system, air temperature was increased from $60{\sim}85^{\circ}C$ to $402{\sim}482^{\circ}C$ while gas temperature was decreased from $600^{\circ}C$ to $305{\sim}402^{\circ}C$ according to mass flow rates of 3.9~7.8 g/s. The experimental heat transfer rates of the heat exchanger were compared with CFD numerical solutions with the conventional ${\xi}-NTU$ method. From the comparisons, the following conclusions were obtained. For the heat exchanger system, the relative errors of heat transfer rate by CFD solution were from 7.1 to 27%, and those by ${\xi}-NTU$ method were from 0.6% to 21% compared with experimental data. From the comparisons, it can be said that both of CFD and ${\xi}-NTU$ method almost simulated to experimental data except specific conditions. Pressure drops through air tubes and gas passages were calculated with both of the CFD computation and head loss equations. The differences between them were from 14 to 22%.

• 대한지리학회지
• /
• 제43권4호
• /
• pp.466-476
• /
• 2008

한라산 북사면에 소재하는 구린굴의 천장이 함몰되고, 동굴 지상을 흐르던 병문천이 동굴 안으로 유입되면서 442m 길이의 구린굴 가운데 73m 구간이 하천 유로로 바뀌었다. 구린굴 유로의 폭과 높이는 각각 447cm 및 501cm이며, 벽면은 용암선반이 발달한 전형적인 용암동굴의 모습을 보이나 바닥에는 기반암 하도 특유의 마식지형이 나타난다. 거북등 모양의 절리가 발달한 동굴 천장의 암반 두께는 $30{\sim}60cm$에 불과하며, 이런 장소에서는 천장이 함몰하기 쉬워 유로 구간에는 전부 4개 지점에 윈도우가 발달한다. 구린굴 유로가 출현하기 이전의 지상 유로는 병문천의 지류로서 제4함몰 윈도우 지점을 지나 표고 660m 지점에서 구린굴 동쪽 유역으로부터 흘러나오는 본류에 합류하였다. 그러나 구린굴 지상 유로의 하상에 윈도우가 형성되면서 지상 유로는 구린굴 유로로 대체되고, 새로운 유로는 표고 660m 지점에서 본류에 합류하게 되었다. 이후 구린굴 상류 쪽으로 병문천 유역이 확대되면서 구린굴을 통과하는 유로가 본류로 바뀌었다. 그러나 홍수류가 발생하면 구린굴 지상 유로에도 유수가 발생하므로 병문천은 제4함몰 윈도우 지점에서 일시적으로 분기 하천의 형태를 이룬다. 제주도 용암동굴의 천장에서는 낙반 현상이 지속적으로 일어나고 있으므로 제주도의 수계 발달에 미치는 용암동굴의 영향은 현재 진행형이라고 할 수 있다.