• Korea-Australia Rheology Journal
• /
• v.21 no.4
• /
• pp.225-233
• /
• 2009

In various attempts to relate the behaviour of highly-elastic liquids in complex flows to their rheometrical behaviour, obvious candidates for study have been the variation of shear viscosity with shear rate, the two normal stress differences $N_1$ and $N_2$, especially $N_1$, and the extensional viscosity $\eta_E$. In this paper, we shall be mainly interested in 'constant-viscosity' Boger fluids, and, accordingly, we shall limit attention to $N_1$ and $\eta_E$. We shall concentrate on two important flows - axisymmetric contraction flow and "splashing" (particularly that which arises when a liquid drop falls onto the tree surface of the same liquid). Modern numerical techniques are employed to provide the theoretical predictions. It is shown that the two obvious manifestations of viscoelastic rheometrical behaviour can sometimes be opposing influences in determining flow characteristics. Specifically, in an axisymmetric contraction flow, high $\eta_E$ can retard the flow, whereas high $N_1$ can have the opposite effect. In the splashing experiment, high $\eta_E$ can certainly reduce the height of the so-called Worthington jet, thus confirming some early suggestions, but, again, other rheometrical influences can also have a role to play and the overall picture may not be as clear as it was once envisaged.

• Korean Journal of Environmental Biology
• /
• v.34 no.2
• /
• pp.73-78
• /
• 2016

Bhutanese forests have been well preserved and can sequester the atmospheric carbon (C). In spite of its importance, understanding Bhutanese forest C dynamics was very limited due to the lack of available data. However, forest C model can simulate forest C dynamics with comparatively limited data and references. In this study, we aimed to simulate Bhutanese forest C dynamics at 6 plots with the Forest Biomass and Dead organic matter Carbon (FBDC) model, which can simulate forest C cycles with small amount of input data. The total forest C stock ($Mg\;C\;ha^{-1}$) ranged from 118.35 to 200.04 with an average of 168.41. The C stocks ($Mg\;C\;ha^{-1}$) in biomass, litter, dead wood, and mineral soil were 3.40-88.13, 4.24-24.95, 1.99-20.31, 91.45-97.90, respectively. On average, the biomass, litter, dead wood, and mineral soil accounted for 36.0, 5.5, 2.5, and 56.0% of the total C stocks, respectively. Although our modeling approach was applied at a small pilot scale, it exhibited a potential to report Bhutanese forest C inventory with reliable methodology. In order to report the national forest C inventory, field work for major tree species and forest types in Bhutan are required.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.35 no.2
• /
• pp.327-340
• /
• 2015

General Circulation Models (GCMs) are the basic tool used for modelling climate. However, the spatio-temporal discrepancy between GCM and observed value, therefore, the models deliver output that are generally required calibration for applied studies. Which is generally done by Multi-Model Ensemble (MME) approach. Stochastic downscaling methods have been used extensively to generate long-term weather sequences from finite observed records. A primary objective of this study is to develop a forecasting scheme which is able to make use of a MME of different GCMs. This study employed a Nonstationary Hidden Markov Chain Model (NHMM) as a main tool for downscaling seasonal ensemble forecasts over 3 month period, providing daily forecasts. Our results showed that the proposed downscaling scheme can provide the skillful forecasts as inputs for hydrologic modeling, which in turn may improve water resources management. An application to the Nakdong watershed in South Korea illustrates how the proposed approach can lead to potentially reliable information for water resources management.

• Journal of Korea Multimedia Society
• /
• v.6 no.6
• /
• pp.1088-1099
• /
• 2003

The syntax-directed translation using semantic actions is frequently used in construction of compiler for text programming languages. it is very useful for the language designers to develop compiler back-end using a syntax structure of a source programming language. Due to the lack of the integrated representation method for a parse tree node and modeling method of syntax structures, it is very hard to construct compiler using syntax-directed translation in visual languages. In this Paper, we propose a visual language compiler generation method for constructing a visual languages compiler automatically, using syntax-directed translation. Our method uses the Picture Layout Grammar as a underlying grammar formalism. This grammar allows our approach to generate parser efficiently u sing And-Or-Waiting Graph and encapsulating syntax definition as one unit. Unlike other systems, we suggest separating the specification and the generation of semantic actions. Because of this, it provides a very efficient method for modification.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.31 no.2C
• /
• pp.208-218
• /
• 2006

In this paper, we introduce the creation methods of attack detection model using data mining technologies that can classify the latest attack types, and can detect the modification of existing attacks as well as the novel attacks. Also, we evaluate comparatively these attack detection models in the view of detection accuracy and detection time. As the important factors for creating detection models, there are data, attribute, and detection algorithm. Thus, we used NetFlow data gathered at the real network, and KDD Cup 1999 data for the experiment in large quantities. And for attribute selection, we used a heuristic method and a theoretical method using decision tree algorithm. We evaluate comparatively detection models using a single supervised/unsupervised data mining approach and a combined supervised data mining approach. As a result, although a combined supervised data mining approach required more modeling time, it had better detection rate. All models using data mining techniques could detect the attacks within 1 second, thus these approaches could prove the real-time detection. Also, our experimental results for anomaly detection showed that our approaches provided the detection possibility for novel attack, and especially SOM model provided the additional information about existing attack that is similar to novel attack.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.29 no.6
• /
• pp.641-650
• /
• 2011

Airborne LIDAR system, utilized in various forest studies, provides efficiently spatial information about vertical structures of forest areas. The tree height is one of the most essential measurements to derive forest information such as biomass, which can be estimated from the forest terrain model. As the terrain model is generated by the interpolation of ground points extracted from LIDAR data, filtering methods with high reliability to classify reliably the ground points are required. In this paper, we applied three representative filtering methods to forest LIDAR data with diverse characteristics, measured the errors and performance of these methods, and analyzed the causes of the errors. Based on their complementary characteristics derived from the analysis results, we have attempted to combine the results and checked the performance improvement. In most test areas, the convergence method showed the satisfactory results, where the filtering performance were improved more than 10% in maximum. Also, we have generated DTM using the classified ground points and compared with the verification data. The DTM retains about 17cm RMSE, which can be sufficiently utilized for the derivation of forest information.

• Journal of Korean Society for Geospatial Information Science
• /
• v.19 no.3
• /
• pp.41-47
• /
• 2011

Processing of the raw LiDAR data requires the high-end processor, because data form is a vector. In contrast, if LiDAR data is converted into a regular grid pattern by filltering, that has advantage of being in a low-cost equipment, because of the simple structure and faster processing speed. Especially, by using grid data classification, such as Quadtree, some of trees and cars are removed, so it has advantage of modeling. Therefore, this study presents the algorithm for automatic extraction of ground points using Quadtree and refion growing method from LiDAR data. In addition, Error analysis was performed based on the 1:5000 digital map of sample area to analyze the classification of ground points. In a result, the ground classification accuracy is over 98%. So it has the advantage of extracting the ground points. In addition, non-ground points, such as cars and tree, are effectively removed as using Quadtree and region growing method.

• Journal of the Korean Society of Environmental Restoration Technology
• /
• v.11 no.3
• /
• pp.28-38
• /
• 2008

The purpose of this study are to compare existing presence-absence predictive models and to predict suitable habitat for Goral (Nemorhaedus caudatus raddeanus) that is an endangered and protected species in Seoraksan national park using the best model among existing predictive models. The methods of this study are as follows. First, 375 location data and 9 environmental data layers were implemented to build a model. Secondly, 4 existing presence-absence models : Generalized Linear Model (GLM), Generalized Addictive Model (GAM), Classification and Regression Tree (CART), and Artificial Neural Network (ANN) were tested to predict the Goal habitat. Thirdly, ROC (Receiver Operating Characteristic) and Kappa statistics were used to calculate a model performance. Lastly, we verified models and created habitat suitability maps. The ROC AUC (Area Under the Curve) and Kappa values were 0.697/0.266 (GLM), 0.729/0.313 (GAM), 0.776/0.453 (CART), and 0.858/0.559 (ANN). Therefore, ANN was selected as the best model among 4 models. The models showed that elevation, slope, and distance to stream were the significant factors for Goal habitat. The ratio of predicted area of ANN using a threshold was 31.29%, but the area decreased when human effect was considered. We need to investigate the difference of various models to build a suitable wildlife habitat model under a given condition.

• Journal of the Korean Society of Environmental Restoration Technology
• /
• v.21 no.1
• /
• pp.103-118
• /
• 2018

Ecosystems in subalpine regions are recognized as areas vulnerable to climatic changes because rainfall and the possibility of flora migration are very low due to the characteristics of topography in the regions. In this context, habitat niche was formulated for representative species of arbors in subalpine regions in order to understand the effects of climatic changes on alpine arbor ecosystems. The current potential habitats were modeled as future change areas according to the climatic change scenarios. Based on the growth conditions and environmental characteristics of the habitats, the study was conducted to identify direct and indirect causes affecting the habitat reduction of Abies nephrolepis. Diverse model algorithms for explanation of the relationship between the emergence of biological species and habitat environments were reviewed to construct the environmental data suitable for the six models(GLM, GAM, RF, MaxEnt, ANN, and SVM). Weights determined through TSS were applied to the six models for ensemble in an attempt to minimize the uncertainty of the models. Based on the current climate determined by averaging the climates over the past 30years(1981~2010) and the HadGEM-RA model was applied to fabricate bioclimatic variables for scenarios RCP 4.5 and 8.5 on the near and far future. The results of models of the alpine region tree species studied were put together and evaluated and the results indicated that a total of eight national parks such as Mt. Seorak, Odaesan, and Hallasan would be mainly affected by climatic changes. Changes in the Baekdudaegan reserves were analyzed and in the results, A. nephrolepis was predicted to be affected the most in the RCP8.5. The results of analysis as such are expected to be finally utilizable in the survey of biological species in the Korean peninsula, restoration and conservation strategies considering climatic changes as the analysis identified the degrees of impacts of climatic changes on subalpine region trees in Korean peninsula with very high conservation values.

• The Journal of Society for e-Business Studies
• /
• v.17 no.2
• /
• pp.149-163
• /
• 2012

Logistics systems provide their service to customers by coordinating the resources with limited capacity throughout the underlying processes involved to each other. To maintain the high level of service under such complicated condition, it is essential to carry out the real-time monitoring and continuous management of logistics processes. In this study, we propose a method of estimating the service completion time of key processes based on process-state information collected in real time. We first identify the factors that influence the process completion time by modeling and analyzing an influence diagram, and then suggest algorithms for quantifying the factors. We suppose the container terminal logistics and the process of discharging and loading containers to a vessel. The remaining service time of a vessel is estimated using a decision tree which is the result of machine-learning using historical data. We validated the estimation model using container terminal simulation. The proposed model is expected to improve competitiveness of logistics systems by forecasting service completion in real time, as well as to prevent the waste of resources.