• 한국정보통신학회:학술대회논문집
• /
• 한국해양정보통신학회 2004년도 춘계종합학술대회
• /
• pp.635-641
• /
• 2004

본 논문에서는 802.113 무선 근거리 통신망(wireless LAM)용 5.25GHz 저잡음 증폭기(LNA)에 대해 고가 장비를 사용하지 않고도 전압이득, 잡음지수 및 입력 임피던스를 측정할 수 있는 새로운 형태의 고주파 81ST(Built-In Self-Test, 자체내부검사)회로 설계 및 검사 기술을 제안한다. 본 연구에서 제작된 BIST 회로는 기존의 고가 검사 장비 대신 고주파 회로의 결함검사나 성능검사에 적용될 수 있다. 이러한 BIST 회로는 1V의 공급전압에서 동작하며, 0.18$\mu\textrm{m}$ SiGe 공정으로 제작되어 있다. 이러한 접근방법은 입력 임피던스 정합과 출력 전압 측정을 이용한다. 본 방법에서는 DUT(Device Under Test: 검사대상이 되는 소자)와 BIST 회로가 동일 칩 상에 설계되어 있기 때문에 측정할 때 단지 디지털 전압계와 고주파 전압 발생기만이 필요하며, 측정이 간단하고 비용이 저렴하다는 장점이 있다. BIST 회로가 차지하는 면적은 LNA가 차지하는 전체면적의 약 18%에 불과하다.

• 한국소음진동공학회논문집
• /
• 제19권8호
• /
• pp.843-849
• /
• 2009

The reliable operation of a swing check valve in the main feed water system of a power plant is most essential for successful shout-down process. A failure to close the valve at proper time often leads to the instability of the main feed water system, or even to an emergency stop of the power plant. In reality it is a very difficult task to monitor the behavior of a swing check valve. Furthermore it is impossible to see the motion of the valve. In this work two measurements were carried out simultaneously to determine the precise valve closure time. The dynamic pressure measurements were made at the inlet and outlet regions of the swing check valve. The transient vibration of the valve housing in the direction of water flow was also measured, which enabled the measurement of the transient vibration of the valve housing near valve closure. By comparing the results produced from these measurements the precise valve closure time could be determined. By carrying out order tracking technique using the dynamic pressure signals and pump rpm signal, the complicated dynamic problems inside the main feed water system can be more easily dealt with. This measurement scheme might be implemented in a power plant on a real-time basis without much difficulty. If this could be implemented, valuable information essential for shut-down operations can readily be passed on to the main control room. The feasibility of this implementation was demonstrated by this experimental work.

• 한국소음진동공학회논문집
• /
• 제22권12호
• /
• pp.1227-1236
• /
• 2012

The low speed machinery faults are usually caused by the bearing failure of the rolling elements. As the life time of the bearing is limited, the condition monitoring of bearing is very important to maintain the continuous operation without failures. A few monitoring techniques using time domain, frequency domain and fuzzy neural network vibration analysis are introduced to detect and diagnose the faults of the low speed machinery. This paper presents a method of fault detection for the rolling element bearing in the low speed machinery using the Wiener filtering and shock pulse counting techniques. Wiener filter is used for noise cancellation and it clearly makes the shock pulse emerge from the time signal with the high level of noise. The shock pulse counting is used to determine the various faults obviously from the shock signal with transient pulses not related with the bearing fault. Machine fault simulator is used for the experimental measurement in order to verify this technique is the powerful tool for the low speed machine compared with the frequency analysis. The test results show that the method proposed is very effective parameter even for the signal with high contaminated noise, speed variation and very low energy. The presented method shows the optimal tool for the condition monitoring purpose to detect the various bearing fault with high accuracy.

• 한국음향학회지
• /
• 제27권2호
• /
• pp.66-74
• /
• 2008

본 논문에서는 HE-AAC (High Efficiency Advanced Audio Coding) 오디오 부호화기의 저주파 대역과 고주파 대역을 담당하고 있는 AAC부호화기와 SBR (Spectral Band Replication) 부호화기에 대해 낮은 비트율에서 효과적인 개선 방법을 제안한다. AAC 부호화기가 담당하는 저주파 대역에서 과도신호가 발생하는 부분의 프리에코를 줄이기 위하여 적용 주파수범위가 저주파 대역 방향으로 선택적으로 확장되는 eTNS (exteded Temporal Noise Shaping) 방법을 고안하였다. 또한 SBR에 의해 부호화되는 고주파 대역에서 톤 성분 복원 시에 잡음층 (Noise floor)이 추가 발생되지 않도록 정현파 모델을 통해 톤을 사전 인지하고 인지된 톤들의 주파수를 QMF 밴드의 중앙으로 재배치하여 성능 향상을 이루었다. 제안한 방법들을 사용하여 복호화한 샘플 음원들에 대해 주/객관적 음질평가를 실시한 결과, 표준 HE-AAC에 비해 향상된 결과를 보여주었다.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2001년도 춘계학술대회논문집E
• /
• pp.530-535
• /
• 2001

Variations of temperature field in a Hele-Shaw convection cell (HSC) were measured using a holographic interferometry with varying Rayleigh number. Experimental results show a steady flow pattern at low Rayleigh numbers and a time-dependent periodic flow at high Rayleigh numbers. Especially, the period of oscillation at $Ra = 6.35{\times}10^6$ was 62 seconds. Two different measurement methods of holographic interferometry, double-exposure method and real-time method, were employed to measure the temperature field variations of HSC convective flow. In the double-exposure method, unwanted waves can be eliminated and reconstruction images are clear, but transient flow structure cannot be observed clearly. On the other hand, transient flow can be observed and reconstructed well using the real-time method. However, the fringe patterns reconstructed by the real-time method contain more noise, compared with the double-exposure method. The two holographic interferometer techniques employed complementary in this study were proved to be useful for analyzing the temperature field variations of unsteady thermal fluid flows.

• 한국통신학회논문지
• /
• 제24권6B호
• /
• pp.1203-1210
• /
• 1999

적응필터에서는 기준 입력신호와 상관없는 원신호의 목표신호 성분에 의해서 적응필터의 계수가 오조정된다. 본 논문에서는 목표신호가 있는 경우에 대해서 NSA(normalized sign algorithm)의 정상상태 성능과 수렴특성을 NLMS 알고리즘과 비교 분석했다. NLMS 알고리즘의 평균자승오차는 목표신호의 전력에 비례하지만, NSA는 목표신호 전력의 제곱근에 비례한다. 수렴특성은 목표신호가 큰 경우 NSA는 NLMS 알고리즘에 비해서 느리게 적응한다. 본 논문에서는 이론적으로 분석된 정상상태 성능과 수렴특성을 컴퓨터 시뮬레이션을 통해서 검증한다.

• 전기학회논문지P
• /
• 제58권4호
• /
• pp.427-431
• /
• 2009

In this study, the dynamic characteristic of a contact wire and pantograph suppling electrical power to high-speed trains are investigated from an electrical response point of view. To analysis power line disturbance by induced contact loss phenomenon for high speed operation, a hardware Simulator which considered contact loss between contact wire and the pantograph as well as contact wire deviation is developed. It is confirmed that a contact wire and pantograph model are necessary for studying the dynamic behavior of the pantograph system. One of the most important needs accompanied by increasing the speed of high-speed train is reduced that an arc phenomenon by loss of contact brings out EMI. In case of a high-speed train using electrical power, as comparison with diesel rolling stock, PLD(Power Line Disturbance) such as harmonic, transient voltage and current, EMI(Electromagnetic Interference), dummy signal injection etc usually occurs. Throughout experiment, it is verified that an arc phenomenon is brought out for simulator operation and consequently conducted noise is flowed in electric circuit by power line disturbance.

• 전산구조공학
• /
• 제10권3호
• /
• pp.125-131
• /
• 1997

대부분의 동적계는 기진력 및 계 인자들에 있어서 다양한 불확정 특성을 갖고 있다. 본 연구에서는 기진력의 불확정성과 계 인자들의 불확정성을 모두 갖는 선형 동적계에 대한 응답해석 과정을 제안하였다. 확률특성을 갖는 계 인자와 응답은 섭동법에 의해 모델링되었으며, 응답해석은 불규칙 진동 이론에 의하여 정식화 되었다. 또한 제안된 응답 모델에 의해 계산되기 어려운 응답의 평균에 대한 해석은 확률유한요소법을 사용하였다. 적용 예로서 정상 백색잡음 기진력을 받으며 불확정 질량과 스프링 상수를 갖는 1자유도계 문제에 대하여 과도응답을 계산하고, 그 결과를 수치 시뮬레이션 결과와 비교하여 그 타당성을 검토하였다.

• 대한기계학회논문집B
• /
• 제25권11호
• /
• pp.1624-1631
• /
• 2001

Variations of temperature field in a Hele-Shaw convection cell (HSC) were measured using a holographic interferometry with varying Rayleigh number. Experimental results show a steady flow pattern at low Rayleigh numbers and a time-dependent periodic flow at high Rayleigh numbers. Especially, the period of oscillation at Ra = 6.35 $\times$ 10$^{6}$ was 62 seconds. Two different measurement methods of holographic interferometry, double-exposure method and real-time method, were employed to measure the temperature field variations of HSC convective flow. In the double-exposure method, unwanted waves can be eliminated and reconstruction images are clear, but transient flow structure cannot be observed clearly. On the other hand, transient flow can be observed and reconstructed well using the real-time method. However, the fringe patterns reconstructed by the real-time method contain more noise, compared with the double-exposure method. The two holographic interferometer techniques employed complementary in this study were proved to be useful fur analyzing the temperature field variations of unsteady thermal fluid flows.

• 대한조선학회논문집
• /
• 제57권3호
• /
• pp.175-181
• /
• 2020

For the success of a structural integrity management, it is essential to acquire structural response data at some critical locations with limited number of sensors. In this study, the structural response of numerical model was estimated by data fusion approach based on the Kalman filter known as stochastic recursive filter. Firstly, transient direct analysis was conducted to calculate the acceleration and strain of the numerical standing beam model, then the noise signals were mixed to generate the numerical measurement signals. The acceleration measurement signal was provided to the Kalman filter as an information on the external load, and the displacement measurement, which was transformed from the strain measurement by using strain-displacement conversion relationship, was provided into the Kalman filter as an observation information. Finally, the Kalman filter estimated the displacement by combining both displacements calculated from each numerically measured signal, then the estimated results were compared with the results of the transient direct analysis.