• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2009.06a
• /
• pp.228-229
• /
• 2009

$VO_2$ thermistor was fabricated on $Al_2O_3$ substrate. and has a CTR (Critical Temperature Resistor) characteristic. $VO_2$ thermistor has a about $10^6$ resistance($\Omega$) in normal temperature. But When temperature is a about $80^{\circ}C$, Resistance of $VO_2$ thermistor is a about some hundred resistance: The resistance of $VO_2$ thermistor increased with increasing length and decreasing width.

• Nuclear Engineering and Technology
• /
• v.52 no.11
• /
• pp.2620-2629
• /
• 2020

As an early stage in the development of a water calorimeter, this study established a computer simulation methodology for analyzing the thermal behavior of a water calorimeter based on radiation transport and energy deposition. As a result, this study developed a method wherein the energy deposition distribution, which is obtained by applying Monte Carlo methods in water calorimeters, is directly used as a heat source for the thermal analysis model. Based on the proposed method, heat transfer in a water vessel and the effect of thermistor self-heating were analyzed. Through an analysis of the water velocities with and without a water vessel, it was found that a water vessel can serve as a convection barrier. Furthermore, it was confirmed that when considering thermistor self-heating, the water temperature change at the thermistor location is 0.219 mK higher compared to that when the thermistor was not considered. Therefore, thermistor self-heating must be considered to analyze the thermal behavior of a water calorimeter more accurately.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.11 no.7
• /
• pp.546-551
• /
• 1998

$Mn{1-X}Fe{2+X}O_4, Mg_{1-X}Fe_{2+X}O_4$ (x=0.0, 0.025, 0.1, 0.2) for negative temperature coefficient (NTC) thermistor was prepared by calcination at $800^{\circ}C$ and sintering at form 1100 to $1250^{\circ}C$ with $50^{\circ}C$ intervals. The best linear property was obtained in the Mn-based sample sintered at $1200^{\circ}C$ with x=0.0 composition. Temperature coefficient of resistance, $\alpha$, was $-5.6%/^{\circ}C$ in the Mn-based sample, $-5.2%/^{\circ}C$ in the MM-based sample, and $-1.6%/^{\circ}C$ in the Mg-based sample. thermistor parameter, B, was in the range of 2665~7780 K. The results show the possibility that Mn-Ni-Co based thermistor could be substituted by the composition used in this study.

• Proceedings of the KIEE Conference
• /
• 1988.07a
• /
• pp.343-345
• /
• 1988

In this paper the fabrication and application of Composite-Thermistor were studied. Composite-Thermistor specimens were made by conventional process. Some compounds of vanadium oxides and semiconductor oxides as a fillers were used to fabricate Composite-Thermistor, and Epoxy Resins are used as a polymer matrix. The results of resistivity-temperature characteristics were measured in the range from -100 ($^{\circ}C$) to 200($^{\circ}C$). The harder polymer, Eccogel series #1365-80 and Spurr Epoxy are more preferable compared to the Eccogel (1365-45) with some fillers.

• The Bulletin of The Korean Astronomical Society
• /
• v.37 no.2
• /
• pp.188.2-188.2
• /
• 2012

인공위성의 성능을 최대화 하고 긴 운용 수명을 확보하기 위해 부품들의 온도를 특정 범위로 유지 시키는 것은 매우 중요며 이를 위한 온도 모니터링 시스템은 필수적이다. 온도 모니터링 방법은 온도에 따라 저항이 변하는 Thermistor를 이용하는 방법과 출력 전류가 변하는 반도체 센서(AD590)를 이용하는 방법으로 나눌 수 있다. Thermistor의 경우 매우 정밀하게 온도를 모니터링 할 수 있지만 넓은 측정 범위에 대해서는 비선형성 가진다는 단점을 가진다. 이에 반해 반도체 센서의 경우 오차가 크지만 넓은 측정 범위에 대해서도 선형성을 가진다는 장점을 가진다. 본 논문에서는 특정 구간에 대해서 정밀한 온도 모니터링이 필요한 곳에 적용되는 Thermistor를 이용한 온도 모니터링 시스템의 측정 Mechanism에 대해서 고찰한다. 측정 Mechanism의 고찰은 온도에 따른 이산화 된 출력을 내주기 위해 사용되는 Thermistor, Current Source, A/D Converter 등의 하드웨어 적인 부분뿐만 아니라 출력된 값을 이용해 물리적인 온도로 변환시키는데 사용되는 Gain Offset, Calibration Curve 등의 소프트웨어 적인 부분도 포함한다. 또한 하드웨어와 소프트웨어적인 설계 변수를 조절함으로서 온도 모니터링 시스템의 측정범위를 개선하는 방안에 대해 고찰한다. 이렇게 본 논문에서 고찰한 Thermistor를 이용한 저궤도 위성용 온도 모니터링 시스템의 측정범위 개선 방안은 추후 인공위성에 적용되는 온도 모니터링 시스템의 설계에 Design Guide Line을 제시할 것이라고 판단한다.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.13 no.6
• /
• pp.297-303
• /
• 2003

Mn-Ni-Co type thin films were prepared at various conditions by a rf magnetron sputtering system. At the condition. or substrate temperature of $300^{\circ}C$ and $Ar/O_2$= 10/0, a cubic spinel phase was obtained. When oxygen was included in process gas, a cubic spinel phase was not formed even after the thermal annealing at $900^{\circ}C$. The thermistor thin film had no other elements except Mn, Ni and Co. The infrared reflection spectra of the thermistor thin films showed that the films had somewhat high reflectance for incoming infrared ray with some angle. The etch rate of the thermistor thin films was about 63nm/min at a condition of DI water : $HNO_3$: HCl = 60 : 30 : 10 vol%. The B constant and temperature coefficient of resistance of the thermistor thin films were 3500 K and -3.95 %/K, respectively. The voltage responsivity of the thermistor thin film infrared sensor was 108.5 V/W and its noise equivalent power and specific detectivity were $5.1\times 10^{-7}$ W/$Hz^{-1/2}$ and $0.2\times 10^6$cm $Hz^{1/2}$/W, respectively.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.26 no.2
• /
• pp.98-103
• /
• 2013

The alumina substrates that Ni electrode was printed on and the multi-layered PTCR thermistors of which composition is $(Ba_{0.998}Ce_{0.002})TiO_3+0.001MnCO_3+0.05BN$ were fabricated by a thick film process, and the effect of re-oxidation temperature on their resistivities and resistance jumps were investigated, respectively. Ni electroded alumina substrate and the multi-layered PTC thermistor were sintered at $1150^{\circ}C$ for 2 h under $PO_2=10^{-6}$ Pa and then re-oxidized at $600{\sim}850^{\circ}C$ for 20 min. With increasing the re-oxidation temperature, the room temperature resistivity increased and the resistance jump ($LogR_{290}/R_{25}$) decreased, which seems to be related to the oxidation of Ni electrode. The small sized chip PTC thermistor such as 2012 and 3216 exhibits a nonlinear and rectifying behavior in I-V curve but the large sized chip PTC thermistor such as 4532 and 6532 shows a linear and ohmic behavior. Also, the small sized chip PTC thermistor such as 2012 and 3216 is more dependent on the re-oxidation temperature and easy to be oxidized in comparison with the large sized chip PTC thermistor such as 4532 and 6532. So, the re-oxidation conditions of chip PTC thermistor may be determined by considering the chip size.

• Journal of the Korean Society of Safety
• /
• v.32 no.2
• /
• pp.46-51
• /
• 2017

This paper presents classification of domestic fire detector using response time index. Response time is measured using fire detector distributed in Korea, and the response time index is estimated. Plunge test prescribed by FM is conducted to measure response time of fire detector. The detector used to test is fixed temperature type(thermistor and bimetal type) and rate of rise temperature type(thermistor and pneumatic type). The nominal operation temperature of fixed temperature type detector is $70^{\circ}C$ and rate of rise temperature is $15^{\circ}C/min$. The fixed temperature type is measured 7 products, and the rate of rise temperature type is measured 5 products. The results show that in case of fixed temperature type(thermistor) is classified "Quick" or "Standard" and fixed temperature type(bimetal) is not classified. The rate of rise temperature type(thermistor) is classified "Fast" or "Ultra Fast" and the rate of rise temperature type(pneumatic) is classified "Very Fast" or "Ultra Fast". The pneumatic type shows more fast response than thermistor type. Also these results indicate the fixed temperature type(bimetal) is not suitable for early stage fire detection.

• 전기의세계
• /
• v.41 no.3
• /
• pp.38-42
• /
• 1992

써미스터(THERMLISTOR)는 Thermally Sensitive Resistor의 약칭으로 온도변화에 대한 저항치의 변화가 극히 크게 변화하는 특징을 갖는 감온반도체이다. 이중에는 부특성 또는 NTC(Negative Temperature Coeffient) THERMISTOR와 정특성 또는 PTC(Positive Temperature Coeffient)THERMISTOR의 두종류와 NTC와 동일한 부의 온도계수이지만 어떤 온도영역에서 저항치가 급격히 감소하는 CTR로 분류한다. 이렇게 3가지 종류로 분류되는 THERMISTOR중 우리주변에서 가장 널리 보급되고 가정생활에서 실제로 흔히 볼수 있는 가전기기의 온도검출용 sensor로 많이 사용되고 있는 THERMISTOR SENSOR에 대해서만 기초지식을 알아보기로 하고 다음기회에는 응용기술에 대해서 알아보기로 하겠다.

• 전기의세계
• /
• v.31 no.6
• /
• pp.437-444
• /
• 1982

Although several kinds of conduction mechanism of PTC thermistor have been reported, there were few satisfying results. In this paper, the reported conduction mechanism theories were scrutinized and analyzed by using the experimental results. PTC thermistors for this study were manufactured by adding Sb$\_$2/O$\_$3/, AI$\_$2/O$\_$3/, TiO$\_$2/, and SiO$\_$2/ to BaTiO$\_$3/, and by sintering it at different temperatures. In order to analyze the conduction mechanism, R-T characteristics and its frequency dependence of specimens were measured. And also, the structures of specimens were studied. Especially this paper emphasized the explanation of the resistivity characteristics as the grain growth state of PTC thermistor specimens with respect to soaking temperature. According to the results, the resistivity of PTC thermistor whose grain was formed by semiconducting, was independent to the grain size at room temperature. For small and uniform grain size, the slope of the resistivity near the Curie temperature and the resistivity above the Curie temperature became greater and PTCR effect was improved.