• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2001년도 추계학술대회논문집A
• /
• pp.646-653
• /
• 2001

LQG/LTR Control Methology is recently used for the analysis of multi-variable control in frequency domain. Target filter loop is designed by the demanding requirements such as cross-over frequency, disturbance rejection in low frequency domain, zero steady-state error, identification of maximum and minimum singular values and sensor noise rejection in high frequency domain. Loop transfer recovery is accomplished by solving the cheap control and then simulation close to the target filter loop. In this study, LQG/LTR Control Methodology is applied to the seat suspension system. It is found that this technique is very effective to control the system and improve the ride quality of human body.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2000년도 추계학술대회논문집A
• /
• pp.564-569
• /
• 2000

Model Based Compensator(MBC) is recently used for the analysis of multi-variable control in frequency domain. Target loop is designed by the demanding requirements such as cross-over frequency, disturbance rejection in low frequency domain, zero steady-state error, identification of maximum and minimum singular values and sensor noise rejection in high frequency domain. Loop transfer recovery will be continued in frequency domain until the plant with MBC comes close to the target loop. In this study, the technique using MBC is applied to the elevator vibration control system. It is found that this technique is very effective to control the vibration system.

• JSTS:Journal of Semiconductor Technology and Science
• /
• 제17권4호
• /
• pp.534-542
• /
• 2017

This paper presents a fast locking technique for a fractional-N PLL frequency synthesizer. The technique directly measures $K_{VCO}$ on a chip, computes the VCO's target tuning voltage for a given target frequency, and directly sets the loop filter voltage to the target voltage before the PLL begins the normal closed-loop locking process. The closed-loop lock time is significantly minimized because the initial frequency of the VCO are put very close to the desired final target value. The proposed technique is realized and designed for a 4.3-5.3 GHz fractional-N synthesizer in 65 nm CMOS and successfully verified through extensive simulations. The lock time is less than $12.8{\mu}s$ over the entire tuning range. Simulation verifications demonstrate that the proposed method is very effective in reducing the synthesizer lock time.

• 제어로봇시스템학회:학술대회논문집
• /
• 제어로봇시스템학회 1992년도 한국자동제어학술회의논문집(국내학술편); KOEX, Seoul; 19-21 Oct. 1992
• /
• pp.1028-1033
• /
• 1992

Loop shaping techniques are developed for the LQG/LTR controller design of singular multivariable sytems. One approach is to use the mode form of plant and the other is to replace the eigenvalues at 0 by ones at .epsilon.(.rarw.0). These two concepts for the target filter loop design are applied to a flight autopilot. And it is shown that these techniques are effective ones for the desired loop-shaping of singular multivariable systems.

• 전자공학회논문지S
• /
• 제35S권5호
• /
• pp.35-41
• /
• 1998

This paper presents a decoupling controller of the missile seeker scan loop with a spin-stabilized platform. A precise seeker motion with respect to the scan command is essential for the higher acquisition probability of the target. As the seeker scan loop is a deeply cross-coupled two input two output system, an accurate pointing or scanning for each axis to the target is very difficult, even though provided with the help of a high performance controller. When a decoupling control is applied to the seeker scan loop, the cross-coupling between two axes can be reduced to a remarkable amount. As a low order of controller is required for the real time operation, a PI controller with decoupling filter is suggested and compared with other controllers. A linearized dynamic model of seeker scan loop is used and validated through the comparison of experimental results of step responses.

• 한국마린엔지니어링학회:학술대회논문집
• /
• 한국마린엔지니어링학회 2005년도 전기학술대회논문집
• /
• pp.1005-1010
• /
• 2005

In this paper, it is presented a frequency modulated continuous wave radar (FMCW) for distance measurement. The frequency range is $10{\sim}11$ GHz and the sweep time of the signal is 100 ms. The test target is 0.8 m2 of metal plate. The experiment is performed in open ground and the pyramidal horn antenna of about 22 dBi gain is used. The beat frequency according to the target moving to 40 m is measured. There is a good agreement between measured and calculated results. But the resolution of the FMCW radar is not good such as about 10 cm. It is result from the nonlinear signal of voltage controlled oscillator (VCO). To improve the nonlinear characteristic of VCO, a high pass filter and phase locked loop (PLL) frequency synthesizer are included in the radar system.

• 한국음향학회지
• /
• 제30권2호
• /
• pp.107-113
• /
• 2011

본 논문에서는 발현악기 물리적 모델링에서의 개선된 루프필터 설계 방법을 제안한다. V$\"{a}$lim$\"{a}$ki가 제안한 기존의 루프필터 설계 방법은 악기의 음이 오래 지속되는 경우에는 타당하지만, 그렇지 못한 경우에는 악기 음의 주파수 의존 감쇠를 표현하지 못하는 문제점이 있다. 이를 해결하기 위해 녹음된 악기의 단위음에 대해 감쇠구간을 선택, 배음의 개수를 최소 5개부터 20개까지 변경하며 루프필터의 파라미터를 추정하고 이를 이용한 합성음과 원 신호 간 주파수 영역에서의 신호 대 잡음비가 가장 좋은 파라미터를 선택한다. 제안한 방법의 성능 검증을 위해 몸통의 구조와 현의 재질이 각각 다른 기타, 가야금, 거문고를 대상악기로 선정하였다. 제안한 방법은 배음의 지속시간에 상관없이 악기 음의 주파수 의존 감쇠를 잘 표현하는 루프필터 파라미터를 추정해 낼 수 있었다.

• 한국항공우주학회지
• /
• 제48권11호
• /
• pp.873-880
• /
• 2020

본 논문은 스트랩다운 탐색기 측정치와 INS 정보를 이용하여 시선각속도를 추정하는 유도필터 설계에 대해서 다룬다. 제안하는 유도필터는 탐색기 측정치와 유도탄 자세로부터 획득 가능한 시선각과 표적의 위치와 유도탄과의 상대 위치를 측정치로 하고 있으며, 주기 및 동기가 맞지 않는 두 센서의 출력을 사용하기 위해 비동기 필터를 기반으로 하고 있다. 제안한 방법을 통해 시간지연이 큰 탐색기 측정치를 사용함으로써 생길 수 있는 기생루프에 대한 영향을 줄이고 추정성능을 향상시킬 수 있다.

• 한국통신학회논문지
• /
• 제29권4A호
• /
• pp.429-438
• /
• 2004

본 논문에서는 WCDMA 시스템을 위한 판정궤환 동기식 동기추적 회로 (decision-feedback coherent code tracking loop)를 설계하고 AWGN 환경과 페이딩 환경에서 위상 에러와 심볼 에러의 영향을 고려하여 지터 분산을 해석한다. 먼저, AWGN 환경에서의 지터 분산을 위상 에러와 비트 오율을 포함하여 펄스성형 필터(pulse-shaping filter), 타이밍 오프셋 (timing offset), 신호 대 잡음비 (signal-to-interferences ratio), 루우프 대역폭(loop-bandwidth)에 대한 일반식으로 유도하고 페이딩 환경에서 지터 분산의 상한치 (upper bonnd)를 유도한다. 끝으로, WCDMA 순방향 링크의 DPCH 프레임 포맷 #13을 목표 시스템(target system)으로 설정하여 2차 동기식 등기추적 회로를 설계하고 AWGN 환경과 Rayleigh 페이딩 환경에서 지터 분산의 이론치와 시뮬레이션 결과를 비교, 분석한다.

• 한국기계가공학회지
• /
• 제10권4호
• /
• pp.102-108
• /
• 2011

LQG/LTR control scheme is applied to the two axes stage using piezoelectric actuator for tracking reference input and suppressing hysteresis effect in this paper. The plant is combined with an integrator to improve the tracking ability. LQG/LTR controller is designed by making desirable target filter loop remove all poles except for an integrator included in new design plant model and loop transfer recovery. Decoupler in the shape of FIR filter is added to remove the coupling effect between the two axes motion and so feedback control loop is designed independently for the each axis motion.