• Applied Science and Convergence Technology
• /
• 제25권3호
• /
• pp.56-60
• /
• 2016

The ALD process is an adequate technique to meet the requirements that come with the downscaling of semiconductor devices. To obtain thin films of the desired standard, it is essential to understand the thermal decomposition properties of the precursors. As such, this study examined the thermal decomposition properties of TEMAHf precursors and its effect on the formation of $HfO_2$ thin films. FT-IR experiments were performed before deposition in order to analyze the thermal decomposition properties of the precursors. The measurements were taken in the range of $135^{\circ}C-350^{\circ}C$. At temperatures higher than $300^{\circ}C$, there was a rapid decrease in the absorption peaks arising from vibration of $Sp^3$ C-H stretching. This showed that the precursors experienced rapid decomposition at around $275^{\circ}C-300^{\circ}C$. $HfO_2$ thin films were successfully deposited by Atomic Layer Deposition (ALD) at $50^{\circ}C$ intervals between $150^{\circ}C$ to $400^{\circ}C$; the deposited films were characterized using a reflectometer, X-ray photoelectron spectroscopy (XPS), Grazing Incidence X-ray Diffraction (GIXRD), and atomic force microscopy (AFM). The results illustrate the relationship between the thermal decomposition temperature of TEMAHf and properties of thin films.

• 전기학회논문지
• /
• 제59권8호
• /
• pp.1401-1405
• /
• 2010

We have successfully demonstrated of metal-insulator-semiconductor (MIS) capacitors with $HfO_2$/p-Si structures. The $HfO_2$ film was grown at $200^{\circ}C$ on H-terminated Si wafer by atomic layer deposition (ALD) system. TEMAHf and $H_2O$ were used as the hafnium and oxygen sources. A cycle of the deposition process consisted of 0.1 s of TEMAHf pulse, 10 s of $N_2$ purge, 0.1 s of $H_2O$ pulse, and 60 s of $N_2$ purge. The 5 nm thick $HfO_2$ layer prepared on Si substrate by ALD exhibited excellent electrical properties, including low leakage currents, no mobile charges, and a good interface with Si.

• 한국재료학회지
• /
• 제18권3호
• /
• pp.148-152
• /
• 2008

A new cost-effective atomic layer deposition (ALD) technique, known as Proximity-Scan ALD (PS-ALD) was developed and its benefits were demonstrated by depositing $Al_2O_3$ and $HfO_2$ thin films using TMA and TEMAHf, respectively, as precursors. The system is consisted of two separate injectors for precursors and reactants that are placed near a heated substrate at a proximity of less than 1 cm. The bell-shaped injector chamber separated but close to the substrate forms a local chamber, maintaining higher pressure compared to the rest of chamber. Therefore, a system configuration with a rotating substrate gives the typical sequential deposition process of ALD under a continuous source flow without the need for gas switching. As the pressure required for the deposition is achieved in a small local volume, the need for an expensive metal organic (MO) source is reduced by a factor of approximately 100 concerning the volume ratio of local to total chambers. Under an optimized deposition condition, the deposition rates of $Al_2O_3$ and $HfO_2$ were $1.3\;{\AA}/cycle$ and $0.75\;{\AA}/cycle$, respectively, with dielectric constants of 9.4 and 23. A relatively short cycle time ($5{\sim}10\;sec$) due to the lack of the time-consuming "purging and pumping" process and the capability of multi-wafer processing of the proposed technology offer a very high through-put in addition to a lower cost.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2006년도 하계학술대회 논문집 Vol.7
• /
• pp.8-9
• /
• 2006

Hafnium oxide ($HfO_2$) thin films were deposited on p-type (100) silicon wafers by atomic layer deposition (ALD) using TEMAHf and $O_3$. Prior to the deposition of $HfO_2$ films, a thin Hf ($10\;{\AA}$) metal layer was deposited. Deposition temperature of $HfO_2$ thin film was $350^{\circ}C$ and its thickness was $150\;{\AA}$. Samples were then annealed using furnace heating to temperature ranges from 500 to $900^{\circ}C$. The MOS capacitor of round-type was fabricated on Si substrates. Thermally evaporated $3000\;{\AA}$-thick AI was used as top electrode. In this work, We study the interface characterization of $HfO_2$/Hf/Si MOS capacitor depending on annealing temperature. Through AES(Auger Electron Spectroscopy), capacitance-voltage (C-V) and current-voltage (I-V) analysis, the role of Hf layer for the better $HfO_2$/Si interface property was investigated. We found that Hf meta1 layer in our structure effective1y suppressed the generation of interfacial $SiO_2$ layer between $HfO_2$ film and silicon substrate.

• 대한전자공학회논문지SD
• /
• 제44권5호
• /
• pp.8-14
• /
• 2007

본 논문에서는 MOS 소자의 게이트 유전체로 사용될 고유전 박막으로 $HfO_2$/Hf 박막을 제조하여 그 전기적 특성을 관찰하였다. $HfO_2$박막은 TEMAH와 $O_3$ 전구체를 사용한 ALD 방법으로 p-type (100) 실리콘 웨이퍼 위에 증착하였다. $HfO_2$막을 증착시키기 전에 중간층으로써 Hf 금속 층을 증착하였다. Round-type의 MOS 커패시터 제작을 위해, 상부 전극은 Al 또는 Pt을 이용하여 약 2000 ${\AA}$ 두께의 전극을 형성하였다. $HfO_2$ 박막은 화학정량적 특성을 보였으며, $HfO_2$/Si 계면에서 Si-O 결합 대신 Hf-Si 결합과 Hf-Si-O 결합이 관찰되었다. $HfO_2$와 Si 사이의 Hf 중간층은 $SiO_x$의 성장이 억제되었고, $HfSi_xO_y$으로 변형되었다. 이러한 결과로 $HfO_2$/Hf/Si 구조에서 Hf 중간층이 있음으로 게이트 유전체의 고유전율이 유지되면서 계면 특성이 개선됨을 확인하였다.