• Journal of Korean Society for Atmospheric Environment
• /
• v.29 no.1
• /
• pp.97-104
• /
• 2013

Methyl alcohol is one of the basic intermediates in the chemical industry and is also being used as a fuel additive and as a clean burning fuel. In this study, conversion of carbon dioxide to methyl alcohol was investigated using catalytic chemical methods. Ceramic monoliths (M) with $400cell/in^2$ were used as catalyst supports. Monolith-supported CuO-ZnO catalysts were prepared by wash-coat method. The prepared catalysts were characterized by using ICP analysis, TEM images and XRD patterns. The catalytic activity for carbon dioxide hydrogenation to methyl alcohol was investigated using a flow-type reactor under various reaction temperature, pressure and contact time. In the preparation of monolith-supported CuO-ZnO catalysts by wash-coat method, proper concentration of precursors solution was 25.7% (w/v). The mixed crystal of CuO and ZnO was well supported on monolith. And it was known that more CuO component may be supported than ZnO component. Conversion of carbon dioxide was increased with increasing reaction temperature, but methyl alcohol selectivity was decreased. Optimum reaction temperature was about $250^{\circ}C$ under 20 atm because of the reverse water gas shift reaction. Maximum yield of methyl alcohol over CuO-ZnO/M catalyst was 5.1 mol% at $250^{\circ}C$ and 20 atm.

• Korean Journal of Materials Research
• /
• v.5 no.2
• /
• pp.169-177
• /
• 1995

The diffusion barrier property of 100-nm-thick titanium nitride (TiN) film between Cu and Si was investigated using sheet resistance measurements, etch-pit observation, x-ray diffractometry, Auger electron spectroscopy, and transmission electron microscopy. The TiN barrier fails due to the formation of crystalline defects (dislocations) and precipitates (presumably Cu-silicides) in the Si substrate which result from the predominant in-diffusion of Cu through the TiN layer. In contrast with the case of Al, it is identified that the TiN barrier fails only the in-diffusion of Cu because there is no indication of Si pits in the Si substrate. In addition, it appears that the stuffing of TiN does not improve the diffusion barrier property in the Cu/TiN/Si structure. This indicates that in the case of Al, the chemical effect that impedes the diffusion of Al by the reaction of Al with $TiO_{2}$ which is present in the grain boundaries of TIN is very improtant. On the while, in the case of Cu, there is no chemical effect because Cu oxides, such as $Cu_{2}O$ or CuO, is thermodynamically unstable in comparison with $TiO_{2}$. For this reason, it is considered that the effect of stuffing of TiN on the diffusion barrier property is not significant in the Cu/ TiN/Si structure.

• Journal of the Korean Vacuum Society
• /
• v.15 no.4
• /
• pp.374-379
• /
• 2006

In this study, carbon nanotubes (CNTs) were grown on glass substrates coated with Ni/Cr by an atmospheric pressure plasma enhanced chemical vapor deposition(AP-PECVD) and their structural and electrical characteristics were investigated as a possible application to the field emitter of field emission display (FED) devices. The substrate temperature ($400{\sim}500^{\circ}C$) were varied and the grown CNTs were multi wall CNTs (at $500^{\circ}C$, 15 - 20 layers of graphene sheets, distance of each layer : 0.3nm, inner diameter: 10 - 15nm, outer diameter: 30 - 40nm). The ratio of defective carbon peak to graphite carbon peak of the CNTs grown at $500^{\circ}C$ (C measured by fourier transform(FT)-Raman was 0.772 $I_D / I_G$ ratio. When field emission properties were measured, the turn-on field was $2.92V/{\mu}m$ and the emission field at $1mA/cm^2$ was $5.325V /{\mu}m$.

• Korean Journal of Medicinal Crop Science
• /
• v.3 no.3
• /
• pp.207-216
• /
• 1995

This study was conducted to establish technologies for plug seedling production using somatic embryos-derived regenerants and their seeds in Bupleurum falcatum L. Among distilled water, GA (0.1mg/l) and putrescine (0.lmg/l) treated to regenerants for acclimatization, GA was most effective to develop shoots and roots, 1/2X MS medium and NAA 0.1mg/l + BA 0. 5mg/l enhanced the growth rates of the regenerants and increased dry weight. Activated charcoal effected to grow markedly leaves and roots of the regenerants at the level of 0.4 %. Regenerants increased their plant height, root length and dry weight at $30^{\circ}C$. Plug seedlings originated from seeds of the tissue culture regenerants showed the maxium growth on the mixture of peatmoss soil (2) and mountain sand (1) .Root length, leaf area and dry weight of plug seedlings increased significantly when No.1, 2 and 3 of Wondergrow solution were mixed in the ratio of 1.3 - 0.9 - 0.1. Light supplement (4%) and high tem­perature $(30^{\circ}C)$ promoted the growth of plug seedlings as well as dry weight. Ninety days seedlings were more vigorous and adaptable for transplanting than other seedlings.

• Journal of Digital Convergence
• /
• v.12 no.6
• /
• pp.407-414
• /
• 2014

The aim of this study was to evaluate the photodynamic therapy effects against staphylococci using Photofrin and Radachlorin with Light emitting diode(LED). Experimental methods, The bacterial suspensions containing Staphylococcus aureus and Staphylococcus epidermidis at $1{\times}10^5$ were prepared and diluted to different concentrations of photosensitizer, Photofrin or Radachlorin, on 1.25, 2. 5,5 and $10{\mu}g/ml$. The bacterial suspensions were exposed to 630 and 670 nm LED light at the energy density of 14.4 and $19.8J/cm^2$, respectively. The CFU results of S. aureus and S. epidermidis were showed 33 and 50 colony forming at $5{\mu}g/ml$ of Photofrin, respectively and both of them perfectely were dead at $5{\mu}g/ml$ of Radachlorin. The fluorescent intensity by flow cytometry was showed the increase in the dead cells than the normal cells. In the TEM photograph, the damage of bacterial membrane and the distortion of cell morphology were observed. These results suggest that photodynamic therapy combine with Photofrin and Radachlorin can be applied a new modality for antibacterial therapy.

• Journal of Environmental Health Sciences
• /
• v.43 no.3
• /
• pp.194-201
• /
• 2017

Objectives: Zinc oxide nanoparticles (ZnO NPs) are widely used in various commercial products, but they are exposed to the environment and can induce toxicity. In this study, we investigated the environmental fate and bioaccumulation of ZnO NPs in a microcosm. Methods: The microcosm was composed of water, soil (Lufa Soil 2.2) and organisms (Oryzias latipes, Neocaridina denticulata, Semisulcospira libertina). Point five and 5 mg/L of ZnO NPs were exposed in the microcosm for 14 days. Total Zn concentrations were measured using an Inductively Coupled Plasma Mass Spectrometer (ICP-MS) and intracellular NPs were observed using Transmission Electron Microscopy (TEM). Results: In the initial stages of exposure, the Zn concentrations in water increased in all exposure groups and then decreased, while the Zn concentration in soil increased after three hours for the 5 mg/L solution. Zn concentrations also showed increasing trends in N. denticulata and S. libertina at 0.5 and 5 mg/L, and in O. latipes at 5 mg/L. Accumulation of NPs was found in the livers of O. latipes and hepatopancreas of N. denticulata and S. libertina. Conclusions: In the early stages of exposure, ZnO NPs remained in the water, and then were transported to the soil and test species. Unlike other species, total Zn concentrations in N. denticulata and S. libertina increased for both 0.5 mg/L and 5 mg/L. Therefore, ZnO NPs were more easily accumulated in zoobenthos than in fish.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.28 no.5
• /
• pp.1017-1021
• /
• 1999

Shindari, a traditional low alcoholic drink in Cheju island, was prepared with nuruk and the rice porridge. The rice porridge was fermented with 10% nuruk at a temperature of $25^{\circ}C,\;35^{\circ}C,\;45^{\circ}C$ for 24 hours. In all temperature, total acidity and oBrix were increased gradually and pH were decreased gradually and viscosity were considerably decreased after 2 hours and then slightly decreased. Alcohol contents were also increased during fermentation and especially at $45^{\circ}C$. The organic acids were mainly found phytic acid and succinic acid. The fermented liquids rice porridge contained maltose and glucose as free sugar, amount of them increased during fermentation. Lactic acid bacteria cell count increased at higher tem perature of fermentation and reached to $10^{7}\;cfu/ml\;at\;35^{\circ}C$ for 10hr. In conclusion, the optimal fermentation conditions Shindari preparation were at $35^{\circ}C$, 24hrs. pH, titratable acidity, viscosity and soluble solids in the optimal fermentation condition were 4.2, 0.18%, 190cp, $12.2^{\circ}Brix$, respectively.

• The Korean Journal of Malacology
• /
• v.25 no.2
• /
• pp.145-151
• /
• 2009

The ultrastructural changes in germ cells during oogenesis of the melania snail, Semisulcospira libertina libertina have been investigated by light and electron microscopy. The ovary is located on the surface of the hepatopancreas in the spiral posterior region. The ovary exhibited greenish color in the gonadal mature season. The ovary was composed of a number of oogenic follicles. Oogenesis was divided into five stages with histological features: (1) oogonia, (2) previtellogenic, (3) initial vitellogenic, (4) active vitellogenic, and (5) mature stages. Oogonia were oval in shape, $4-6\;{\mu}m$ in diameter, and had a large nucleus. Previtellogenic oocytes were about $20\;{\mu}m$ in diameter and the cytoplasm reacted with hematoxylin in H-E satin. Initial vitellogenic stage, oocytes were $60-80\;{\mu}m$ in diameter, and small yolk granules of low electron density are scattered in the cytoplasm. Oocytes in the initial vitellogenic stage were connected with ovarian follicle by egg stalk. Active vitellogenic oocyte were $100-120\;{\mu}m$ in diameter. Electron density, size and quantity of yolk granules that are distributed in the cytoplasm have increased from the previous stage. Result of TEM observations, the oocyte contains well-developed Golgi complex, endoplasmic reticula and tubular mitochondria in the cytoplasm. Cytoplasm of mature oocyte was filled with proteinaceous yolk globules of high electron density. In this stage, the length of microvilli in the egg envelope was approximately $1.1\;{\mu}m$.

• Journal of the Microelectronics and Packaging Society
• /
• v.13 no.1 s.38
• /
• pp.1-5
• /
• 2006

We prepared 80 nm-thick TiSix on each 70 nm-thick amorphous silicon and polysilicon substrate using an RF sputtering with $TiSi_2$ target. TiSix composite silicide layers were stabilized by rapid thermal annealing(RTA) of $800^{\circ}C$ for 20 seconds. Line width of $0.5{\mu}m$ patterns were embodied by photolithography and dry etching process, then each additional annealing process at $750^{\circ}C\;and\;850^{\circ}C$ for 3 hours was executed. We investigated the change of sheet resistance with a four-point probe, and cross sectional microstructure with a field emission scanning electron microscope(FE-SEM) and transmission electron microscope(TEM), respectively. We observe an abrupt change of resistivity and voids at the silicide surface due to interdiffusion of silicide and composite titanium silicide in the amorphous substrates with additional $850^{\circ}C$ annealing. Our result implies that the electrical resistance of composite titanium silicide may be tunned by employing appropriate substrates and annealing condition.

• Journal of the Microelectronics and Packaging Society
• /
• v.25 no.3
• /
• pp.31-36
• /
• 2018

This research scrutinizes the reason of failure after pressure cooker test (PCT) for DRAM device. We use the physical inspecting tools, such as microscope, SEM and TEM, and finally find the discolor phenomenon, corrosion of Al and delamination of inter-metal dielectric (IMD) in the failed devices after PCT. Furthermore, we discover the abnormal $Al_XO_Y$ layer on Al through the careful additional measurements. To find the reason, we evaluate the effect of package ball size and pinhole in passivation layer. Unfortunately, those aren't related to the problems. We also estimate halide effect of Al. The halogens such like Cl are contained within EMC material. Those result in the slight improving of PCT characteristics but do not perfectly solve the problems. We make a hypothesis of Galvanic corrosion. We can find the residue of Ti at the edge of pad open area. We can see the improving the PCT characteristics by the time split of repair etch. The possible mechanism of the PCT failure can be deduced as such following sequence of reactions. The remained Ti reacts on the pad Al by Galvanic corrosion. The ionized Al is easily react with the $H_2O$ supplied under PCT environment, and finally transfers to the abnormal $Al_XO_Y$ layer.