• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.35 no.8B
• /
• pp.1188-1196
• /
• 2010

In this paper, worldwide standards and regulations on in-band/out-of-band emission characteristics of DMB broadcasting equipments are reviewed, and emission mask requirements of terrestrial low power DMB repeater under 10mW/MHz are analyzed. Out-of-band emission mask drafts suitable for single/multiple block low power repeaters are proposed. Validity and usefulness of the proposed drafts is evaluated and verified in the several experiments. Using the proposed standard, small-sized and cost-effective DMB repeater can be easily implemented to broaden DMB broadcasting coverage by reducing weak signal areas.

• Proceedings of the Korea Electromagnetic Engineering Society Conference
• /
• 2005.11a
• /
• pp.313-316
• /
• 2005

In this paper, an active antenna for terrestrial DMB(Digital Multimedia Broadcasting) repeater is designed. This active antenna is consist of receiving antenna and LNA(Low Noise Amplifier), A receiving antenna fed by using a microstrip line and radiation part is designed with rectangular spiral structure. An receiving antenna with frequency range of 162$\sim$212MHz, gain of -10dBi and LNA with gain of 20dBi, noise figure of 2.2 at frequency range for T-DMB are achieved.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.23 no.4
• /
• pp.491-498
• /
• 2012

Recently, many papers have been proposed in order to improve the OFDM system performance in T-DMB DOCR (Digital On Channel Repeater), by using removing the feedback signal so that the transmitter power can be increased or by using the equalizer to remove ICI. Despite these efforts, however, signal quality at the receiving terminal has not been improved because of constellation smearing in T-DMB DOCR. In this paper, in order to suppress constellation smearing, we propose an effective equalizer algorithm that can improve system performance. We perform adaptive channel estimation and non-coherent decision directed noise cancellation method that can estimate the channel subsequently during data symbols period in the frequency domain. So we can obtain better quality of the signal at the receiving terminal. In order to secure QoS(Quality of Service) required in T-DMB handsets, we evaluate SNR and BER in T-DMB DOCR(Digital On Channel Repeater) and verified by simulation. In this simulation results, this system is satisfied the performance of BER=$10^{-5}$ at less than SNR=14 dB at the receiver after compensation of phase noise -18 dBc.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.22 no.4
• /
• pp.453-461
• /
• 2011

In order to use more efficiently limited frequency resources at the broadcasting band and to eliminate blanket area of the terrestrial broadcasting and to improve broadcasting quality. The importance of repeaters has increasing continuously. However, in case of T-DMB digital on channel repeater in OFDM systems, some of the signal radiated feedback again at the receiver antenna. So it generates feedback signal interference in repeater system. Also phase noise increases ICI(Inter Carrier Interference). It affects seriously the frequency domain equalizer. In this paper, we remove the feedback signal interference by LMS with correlation. Also we propose an effective equalizer algorithm that can remove ICI caused by phase noise and the power amplifier's back-off. In this simulation results, this system is satisfied the performance of BER=$10^{-4}$ at less than SNR=14 dB after compensation of phase noise.

• Journal of Broadcast Engineering
• /
• v.13 no.3
• /
• pp.365-379
• /
• 2008

In this paper we consider technological requirements of the on-channel repeater to broadcast the terrestrial digital multimedia broadcasting (T-DMB) signals using single frequency networks (SFN) and propose the configuration and implementation method of the equalization on-channel repeater (OCR) that meet such requirements. The proposed equalization OCR not only has short time delay, but shows high output power and good quality of output signal by removing a feedback signal due to incomplete antenna isolation and multipath signal existing between the main transmitter and the OCR. In addition, computer simulations and laboratory tests results are provided to figure out performance of the proposed equalization OCR.

• Journal of Satellite, Information and Communications
• /
• v.8 no.2
• /
• pp.22-28
• /
• 2013

In this paper, new LBS (location based service) are proposed using conventional DMB (digital multimedia/mobile broadcasting) system. LBS applications are proposed that can be suitable for the subway and ground transportation based on S-DMB (satellite-DMB) and T-DMB (terrestrial-DMB) respectively. In the shaded area such as subway, the broadcasting signal transmitted from the satellite of S-DMB system should be retransmitted by the earth repeater called the gap filler and each gap filler has its own identification value called the gap filler ID which introduces the area in which the gap filler was installed. Therefore, the LBS can be implemented by using the gap filler ID of S-DMB on the subway in which the GPS (global positioning system) can't be received. Unlike the LBS on the subway, the combination of T-DMB and DGPS (differential GPS) will be introduced as a way for ground transportation. Generally, DGPS has been designed to compensate the position value calculated from the GPS signal so that positioning error of about 1 meter can be obtained by using DGPS information. T-DMB system transmitting DGPS signal will be expected to be commercial in Korea and, if using DGPS information transmitted through T-DMB network, LBS with more precise positioning than GPS alone can be implemented in the ground vehicles.

• Journal of Broadcast Engineering
• /
• v.13 no.5
• /
• pp.565-573
• /
• 2008

This paper proposes noise reduction methods to improve the channel estimation performance in Equalization On-Channel Repeater (E-OCR) for Terrestrial-Digital Multimedia Broadcasting (T-DMB) system. In the E-OCR for T-DMB system, the channel estimation is performed by the pilot signal extraction and the channel coefficient estimation. Since the performance of the channel estimation highly depends on the estimated channel coefficients whose accuracy is associated with the received signal-to-noise ratio (SNR), it is important to reduce noise existing at the estimated channel coefficients. To reduce such noise components, various noise reduction methods of the estimated channel coefficients based on the M -point weighted moving average are proposed. Computer simulations show that the proposed methods improve the estimation performance by more than 2 to 3 dB in terms of the symbol error rate after equalization.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.45 no.1
• /
• pp.27-32
• /
• 2008

In the signals-shadowed areas, In order to providing the suitable signals reception level repeaters are used for relay the signals. Repeater receives the weak signals and amplifies it up to required power level, The amplified signals get radiated by the various methods. Both antenna distribution and LCX(Leakage Coaxial Cable) are typical methods in the repeater and BTS signals radiation. Their applications are depended on the environment condition and frequency band. Generally the antenna distribution are used for the mobile telecommunication networks which use the higher frequency band than 500MHz. On the other side, LCX distribution is suitable to the frequency band under 500MHz. The network plan of repeater in FM, T-DMB, Fire Radio and Internal subway communication network are the typical LCX application fields. Cell planning with repeaters are based on the free space loss, LCX connection loss and actual field data. The actual field data can be the most important factor to design the network planning.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.11 no.6
• /
• pp.157-162
• /
• 2011

In this study, we design and implement a cavity filter for the Korea T-DMB broadcasting transmitter station and repeater system. HFSS 3 dimensional field simulation tool is used for this study. T-DMB filter has to be high quality factor Q, and cavity filter is applying in T-DMB system due to high handling power. We use HFSS simulation tool for design to obtain exact resonant frequency with easy design. A cavity filter is implemented based on the simulated results, and test results are compared with simulations. Measured resonant frequency and bandwidth are 211.8MHz and 0.1MHz, and correspond with design values.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.10 no.6
• /
• pp.91-97
• /
• 2011

In this study, we design and implement a cavity filter for the Korea T-DMB broadcasting transmitter station and repeater system. HFSS 3 dimensional field simulation tool is used for this study. T-DMB filter has to be high quality factor Q, and cavity filter is applying in T-DMB system due to high handling power. We use HFSS simulation tool for design to obtain exact resonant frequency with easy design. A cavity filter is implemented based on the simulated results, and test results are compared with simulations. Measured resonant frequency and bandwidth are 211.8MHz and 0.1MHz, and correspond with design values.