• Korean Journal of Cognitive Science
• /
• v.20 no.2
• /
• pp.125-154
• /
• 2009

This paper describes the possibility of human physiological data, especially brain-wave activity, to detect cognitive overload, a phenomenon that may occur while learner uses an e-learning system. If it is found that cognitive overload to be detectable, providing appropriate feedback to learners may be possible. To illustrate the possibility, while engaging in cognitive activities, cognitive load levels were measured by EEG (electroencephalogram) to seek detection of cognitive overload. The task given to learner was a computerized listening and recall test designed to measure working memory capacity, and the test had four progressively increasing degrees of difficulty. Eight male, right-handed, university students were asked to answer 4 sets of tests and each test took from 61 seconds to 198 seconds. A correction ratio was then calculated and EEG results analyzed. The correction ratio of listening and recall tests were 84.5%, 90.6%, 62.5% and 56.3% respectively, and the degree of difficulty had statistical significance. The data highlighted learner cognitive overload on test level of 3 and 4, the higher level tests. Second, the SEF-95% value was greater on test3 and 4 than on tests 1 and 2 indicating that tests 3 and 4 imposed greater cognitive load on participants. Third, the relative power of EEG gamma wave rapidly increased on the 3rd and $4^{th}$ test, and signals from channel F3, F4, C4, F7, and F8 showed statistically significance. These five channels are surrounding the brain's Broca area, and from a brain mapping analysis it was found that F8, right-half of the brain area, was activated relative to the degree of difficulty. Lastly, cross relation analysis showed greater increasing in synchronization at test3 and $4^{th}$ at test1 and 2. From these findings, it is possible to measure brain cognitive load level and cognitive over load via brain activity, which may provide atimely feedback scheme for e-learning systems.

• Journal of Korea Society of Industrial Information Systems
• /
• v.18 no.5
• /
• pp.81-92
• /
• 2013

The satellite includes many release mechanisms such as solar array deployment, antenna deployment, cover to protect contamination in scientific equipment, pyro value of the propulsion subsytem, and bypass device in Li-Ion cell module. A drive the initiators is a critical to the successful mission because the initiators of release mechanism driving by the pyrotechnic circuit is operated in single short. The pyrotechnic circuit has to provide switching network for safety. A typical switching network has defect consisting of high current rating fire switch to handle switching transient current during fire the initiator. The pyrotechnic circuit is required some form of power conditioning to reduce the peak power demanded from the bus if the initiators are to be fired from the main bus. This paper design a pyrotechnic circuit synchronized to the fire-command to activate the fire switch to overcome use high current rating fire switch to handle switching transient current during fire the initiator. The pyrotechnic circuit provides a current limited widow pulse for fire current synchronized to the fire-command to insure that fire switch will only carry the current but never switch it. The current limited widow pulse for fire current can be possible to use low current rating and light mass switch in switching network. The current limit function in the pyrotechnic circuit reduces supply voltage to initiator and provides the effect of power conditioning function to reduce peak bus power. The pyrotechnic circuit to apply satellite development on geostationary orbit is verified the function by test in development model.

• Journal of KIISE:Software and Applications
• /
• v.29 no.12
• /
• pp.883-894
• /
• 2002

Classical deterministic testing controls the execution of concurrent programs based on the equivalence between specifications and programs. However, it is not directly applicable to a situation in which synchronization sequences, being valid but infeasible, are taken into account. To resolve this problem, we had proposed automata-based deterministic testing in our previous works, where a concurrent program is executed according to one of the sequences accepted by the automaton recognizing all sequences semantically equivalent to a given sequence. In this paper, we present the automata-based testing environment for Java multi-thread programs, and we design and implement "Deterministic Executor" in the testing environment. "Deterministic Executor" transforms a Java multi-thread program by applying automata-based deterministic testing, the transformed program presents testing results. "Deterministic Executor" uses "Automata Generator", which generates an equivalent automaton of a test sequence, and "Replay Controller", which controls the execution of programs according to the sequence accepted by the automaton. By illustrating automata-based testing procedures with a gas station example, we show how the proposed approach does works in a Java multi-threaded program.roach does works in a Java multi-threaded program.

• Journal of Broadcast Engineering
• /
• v.12 no.1 s.34
• /
• pp.11-27
• /
• 2007

T-DMB(Terrestrial-Digital Multimedia Broadcasting) for portable and mobile broadcasting service was officially launched in the metropolitan area of Korea in December 2005. The development of interactive data services and the expansion of T-DMB network have been now progressed, and the regional T-DMB broadcasters will be selected in the near future. Although it is important to evaluate service area and reduce a fringe area for optimizing RF coverage of T-DMB, there was no professional system to support those works, and therefore lots of resources in budget, manpower and time were required. The measurement considering characteristics of SFN(Single Frequency Network) is essential in the implementation of T-DMB network which needs to control synchronization, spacing and output power of transmitters. In addition, mobile measurement, enough measured parameters for many-sided analysis of reception quality, efficient management of enormous measured data and representation of measured results on the electronic map are also important in evaluating service area. In this paper, we derived requirements for a new measurement system in T-DMB by considering the above details, and we proposed and developed an integrated measurement and analysis system. The developed system was applied to the implementation of T-DMB network of KBS and field tests, and it proved its efficiency and accuracy in result.

• Geophysics and Geophysical Exploration
• /
• v.20 no.1
• /
• pp.43-48
• /
• 2017

The applicability of refraction survey has been tested using a wave glider widely used in long-term ocean observations around the world. To record seismic refractions, a single channel streamer with metal weight and a seismic recording system were mounted on the wave glider. We used GPS precise time synchronization signal and radio frequency (RF) communication to synchronize shot and recorder triggers and to control acquired data quality in real time. When the wave glider is positioned close to the set point, a 2,000 J sparker is exploded along the designed track at 2 second intervals. Through the test survey, we were able to successfully acquire refractions from the subsurface.

• Journal of the Earthquake Engineering Society of Korea
• /
• v.9 no.4 s.44
• /
• pp.19-28
• /
• 2005

Long span structures with low natural frequencies such as shopping malls, large offices, and assembly rooms may experience signification dynamic responses due to human activities. In many cases, the group activities are common thing in comparison with the single activity. The purpose of this study is to evaluate the responses of building structure subjected to group human loads using mode shapes. For this purpose, equations to estimate the magnitudes ol responses ol structure subjected to group walking loads are derived. And the correlation of loads is verified for identifying the relation of each human load composing of group human loads using two load cells. The method is proposed for evaluating the responses of structure subjected to group loads using mode shapes and correlation function related to each human loads. The effectiveness ol the proposed method is verified analytically using a simple beam and floor and experimentally on a footbridge measuring the structural response induced by group pedestrians for the case of synchronization or not. Results indicate that the amplitudes of group walking loads can be easily estimated if the mode shapes are available, and that the corresponding structural responses can be estimated easily by the simple response measurement using the proposed method.

• Korean Journal of Biological Psychiatry
• /
• v.8 no.2
• /
• pp.251-257
• /
• 2001

Backgrounds : Gamma band oscillatory activity is considered to be related to cognitive functions and illustrates that the concept of event-related oscillations bridges the gap between single neurons and neural assemblies. An event-related gamma oscillation is the time-locked responses of specific frequency, and can be identified by computing the amplitude frequency characteristics of the averaged event-related potentials(ERPs) after stimulation. Objectives : We purposed to present experimental paradigm to investigate ${\gamma}$-band oscillation activities from the recording of ERPs by using auditory oddball paradigm and investigate the difference of ${\gamma}$-band activity between schizophrenia and normal controls. Methods : The ERPs resulting from auditory stimuli with oddball paradigm in a group of schizophrenics(n=11), and also a group of age-, sex-, and handedness matched normal controls, were recorded by 128 channel EEG. The ${\gamma}$-band oscillatory activities were calculated by using time-frequency wavelet decomposition of the signal between 20 and 80Hz. The ${\gamma}$-band oscillatory activities of both groups were compared by t-test. Results : The ${\gamma}$-band oscillatory of the leads Fz, Cz, and Pz of both groups were represented well in the time-frequency maps. Significant increases of the ${\gamma}$-band activity in normal controls compared with schizophrenics were observed around 160 msec, 350 msec, and 800 msec after stimulation. Conclusions : Our results suggested that the increment in ${\gamma}$-band oscillatory activity during cognitive operations and decreased ${\gamma}$-band activity in schizophrenics may be associated with the cognitive dysfunctions and the pathophysiology of the schizophrenia.

• Korean Journal of Veterinary Research
• /
• v.34 no.2
• /
• pp.395-406
• /
• 1994

To study the conditions to enhance success of embryo transfer in the dog, 20 mixed-breed bitches were used for the experiment along with 4 male dogs for mating. The bitches were paired according to synchronism of natural estrus, or the counterpart as donor or recipient was treated with gonadotropin as FSH (follicular stimulating hormone) or PMSG (pregnant mare serum gonadotropin) for induction of estrus to be synchronized with estrus of the other bitch in natural estrus. Embryo recovery was performed in two ways for comparison, either by flushing each uterine horn after ovariohysterectomy or by flushing each horn in the state of non-ovariohysterectomy. In addition, the result of pregnancy according to the embryo stage and the repeatability of the experimental animals as donor or recipient were also investigated. FSH or PMSG was administered to the bitches which had passed over 4 months from last estrus, resulting in estrus-positive in 3 dogs of 6 FSH-treated dogs (50.0%), and in 5 dogs of 9 PMSG-treated dogs (55.6%), determined by proestrus signs and vaginal smear test. Estrus-positive bitches induced with gonadotropin were used as donor or recipient resulting in one embryo-recovered bitch as donor and one offspring-delivered bitch as recipient in 5 PMSG-treated dogs, whereas no result was obtained from 3 FSH-treated dogs. The rate of embryo recovery to be compared with number of corpus luteum was 68.2% in ovariohysterectomized dogs and 55.2% in non-ovariohysterectomized dogs, respectively. The number of dogs from which embryo was collected were 4 dogs of 6 ovariohysterectomized dogs (66.7%) and 6 dogs of 7 non-ovariohysterectomized dogs (85.7%), respectively. The result of parturition was obtained from one dog of 5 estrus-induced recipients, whereas no result was obtained from 3 natural-estrus recipients. The only dog which delivered a male puppy had been transferred 3 morulae and 2 blastocysts. Of 6 repeat-used bitches in canine embryo transfer, 3 dogs showed repeatability either as donor or recipient. These results indicated that inducing estrus of a dog with gonadotropin is feasible in canine embryo transfer to be synchronized with that of a natural-estrus dog, that embryo recovery is also possible in non-hysterectomized dogs, that the estrus-induced dog is also usable as recipient to result in parturition, and that repeat-use of a bitch as donor or(and) recipient is possible in canine embryo transfer.

• Journal of the Korean Geotechnical Society
• /
• v.27 no.12
• /
• pp.107-116
• /
• 2011

Rigid soil containers (or rigid boxes) are often used for 1g shaking table tests. The rigid boxes, however, do not accurately simulate the amplification of ground acceleration and phase difference of seismic motion in the model ground due to the confinement of shear deformation and the reflection of seismic wave at the box walls. Laminar soil containers (or laminar shear boxes) can simulate the free field motion at convincingly superior accuracy than the rigid ones. In this study, the soft ground is modeled for both types of boxes and is subjected to seismic loading using a 1g shaking table. The comparison of the results using the two types of soil containers illustrates that, in case of the rigid box, the ground acceleration shows non uniform distribution and the phase synchronization of input motion. Whereas, the dynamic behavior of the laminar shear box shows good agreement with the free field behaviors such as the amplification of ground acceleration and the occurrence of phase difference.

• Journal of Biomedical Engineering Research
• /
• v.29 no.1
• /
• pp.32-39
• /
• 2008

This paper reports on a realtime OS based master-slave configuration robot control system for laparoscopic surgery robot which enables telesurgery and overcomes shortcomings with conventional laparoscopic surgery. Surgery robot system requires control system that can process large volume information such as medical image data and video signal from endoscope in real-time manner, as well as precisely control the robot with high reliability. To meet the complex requirements, the use of high-level real-time OS (Operating System) in surgery robot controller is a must, which is as common as in many of modem robot controllers that adopt real-time OS as a base system software on which specific functional modules are implemened for more reliable and stable system. The control system consists of joint controllers, host controllers, and user interface units. The robot features a compact slave robot with 5 DOF (Degree-Of-Freedom) expanding the workspace of each tool and increasing the number of tools operating simultaneously. Each master, slave and Gill (Graphical User Interface) host runs a dedicated RTOS (Real-time OS), RTLinux-Pro (FSMLabs Inc., U.S.A.) on which functional modules such as motion control, communication, video signal integration and etc, are implemented, and all the hosts are in a gigabit Ethernet network for inter-host communication. Each master and slave controller set has a dedicated CAN (Controller Area Network) channel for control and monitoring signal communication with the joint controllers. Total 4 pairs of the master/slave manipulators as current are controlled by one host controller. The system showed satisfactory performance in both position control precision and master-slave motion synchronization in both bench test and animal experiment, and is now under further development for better safety and control fidelity for clinically applicable prototype.