• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.3 no.4
• /
• pp.295-302
• /
• 2002

PAHs (polycyclic aromatic hydrocarbons) deposited in soil are one of serious problems against sustainable land use. In this paper, chemical soil flushing in a packed sandy soil matrix using a natural surfactant, $\beta$-cyclodextrin (CD) was studied via a fluorescence spectroscopy and a dye labelling. The contaminants are lipophilic ring compounds- phenanthrene and naphthalene. Sand type and flushing intensity (rate and concentration) are chosen as important investigation variables. The removal efficiencies were proportional to flow rate, concentration, temperature of the flushing solution and voidity of the sand column. Initial sorption of the surfactant onto the soil matrix was found to be a key step while flow shear was more crucial in the latter steps. The residual portion of the surfactant, which was most likely to be due to the initial sorption, would not be so influential on this type of soil washing for long times. These results will be useful in future for pilot scale in situ washing and for establishing better soil washing strategy.

• Journal of Environmental Health Sciences
• /
• v.24 no.2
• /
• pp.74-79
• /
• 1998

This study was conducted to evaluate the surfactant solutions which influence solvent extraction from light hydrocarbon contaminated soils. Nine characteristic compounds were studied: benzene, toluene, ethylbenzene, o-xylene, mxylene, p-xylene, n-propylbenzene, 1,2,4-trimethylbenzene, and n-butylbenzene which were found in gasoline. Adsee-799 and Witbreak DRA-22 showed some extractive capacity for light hydrocarbons from soil. There was no added advantage obtained by using other surfactants in this study. No removal of contaminants from soil was observed when the surfactant concentration was 0.5 percent or below. When the surfactant concentration was 4 percent, the average recovery for some hydrocarbons was 10.8 percent, which was the best obtained at these levels. There was 10 percent surfactant contribution for methanol extraction from soil with the Witbreak DPG-482 and Witbreak DRA-22. This study provided a useful screening technique for procedures that can be used to remediate soils contaminated with light hydrocarbons.

• Journal of the Korean Applied Science and Technology
• /
• v.31 no.1
• /
• pp.7-13
• /
• 2014

A cationic ester type surfactant, namely N-2-hydroxy-3-(2-hydroxyacetoxy) proply-N,N-dimethyldodecylaminium chloride(HPDA) was synthesized and confirmed by FT-IR and $^1H$-NMR spectroscopy. Surface tensions on the diluted aqueous solutions of the synthetic compounds were measured and evaluated critical micelle concentration. Surface tension was 33~34 dyne/cm in the range of $10^{-3}{\sim}10^{-2}mol/L$ and critical micelle concentration(c.m.c) value was $8.5{\times}10^{-3}mol/L$ by surface tension method. Emulsifying properties of the synthetic surfactant(HPDA) and Sodium lauryl sulfate (SLS), tetradecyl trimethyl ammonium bromide (TTAB) was tested. As a results, synthetic glycolic acid ester type compounds(HPDA) has been confirmed as a good emulsifier. The foaming power and stability of synthesized ester type surfactant was measured by Ross-Miles method.

• Journal of the Mineralogical Society of Korea
• /
• v.17 no.4
• /
• pp.299-307
• /
• 2004

Surfactant adsorption by two montmorillonite types with different interlayer cations of Ca and Na was characterized by examining the time dependence of surfactant behavior on the clay surfaces. Surfactants with different micelle concentration were conducted in our experiment to observe a nonequilibrium activity of cationic surfactant on the clay over reaction periods ranging from 0.1 min to 11 days. As compared with Ca-montmorillonite (SAz), a more active intrusion of surfactant molecules into the interlayers was found in Na-montmorillonite (SWy). During a short 'initiation' stage, the basal spacing of SWy montmorillonite increased rapidly with logarithmic time. For SAz montmorillonite, however, the abrupt basal spacing increase occurred at the later stage of the reaction. From the result, the difference in the adsorption behavior exhibited by the two montmorillonite types partly results from their intrinsic nature, that is, inorganic cations originally existing on the clay surfaces. Additionally, the micelle concentration of surfactants affects the development of organo-montmorillonite, especially, in the intercalant formation and stabilization under nonequilibrium.

• Journal of the Korean GEO-environmental Society
• /
• v.12 no.6
• /
• pp.17-23
• /
• 2011

In this study, a series of experiments were carried out to remove total petroleum hydrocarbon(TPH) and toluene by soil flushing. In batch experiments, Triton X-100 and SWA 1503 showed TPH removal efficiency of 79.0% and 69.0%, respectively. Although the TPH removal efficiency increased as the surfactant was increased in the concentration range 1-11mmol/L, the optimum concentration was 1mmol/L, considering the ratio of the removal efficiency to the amount of surfactant injected. In column experiment, the optimal velocity was 0.3mL/min. The physical aquifer model(PAM) result revealed that the soil flushing removed as much as 5.5% of the toluene under 3 pore volume(PV) conditions. To improve the soil flushing efficiency, it is necessary to find optimal condition through recirculation or reuse of surfactant.

• Journal of the Korean Applied Science and Technology
• /
• v.28 no.4
• /
• pp.449-454
• /
• 2011

This surfactant can be used as a cosmetics and chemical dispersants. The variation of critical micelle concentration(CMC) with temperature for N-eicosyl pyridinium bromide over the range $40^{\circ}C$ to $60^{\circ}C$ has been measured by drop methods. Thermodynamic quantities for micellization of N-eicosyl pyridinium bromide in water have been calculated by polynominal equation.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.14 no.2
• /
• pp.145-148
• /
• 2008

Cationic surfactant can be used as cosmetics and chemical dispersants. The variation of critical micelle concentration (CMC) with temperature over the range $40^{\circ}C$ to $60^{\circ}C$ for N-octadecyl pyridinium bromide was measured by drop methods. Thermodynamic quantities such as free energy, enthalpy, entropy and heat capacity for micellization of N-octadecyl pyridinium bromide in water were calculated by fourth-degree polynominal equation In the result, free energy change was decreased generally by the increment of temperature.

• Journal of the Korean Applied Science and Technology
• /
• v.24 no.1
• /
• pp.79-85
• /
• 2007

The diffusion behavior of phenol, toluene and benzoic acid in aqueous SDS solution was examined. It showed a similar experimental results for phenol and toluene. The diffusion coefficients of the solutes were characterized by the presence of two distinct regions: below the cmc and above the cmc. For phenol and toluene, it remained approximately unchanged when the SDS concentration was below the cmc. Above the cmc there was an apparent decrease in the diffusion coefficients of the two solutes with increasing SDS concentration. However, for benzoic acid the diffusion behavior was different from that of phenol and toluene. The diffusion coefficient of benzoic acid decreased slightly with increasing SDS concentration, however the diffusion coefficient was almost constant above the cmc. For benzoic acid the diffusion behavior was dependent on the joint contribution of benzoic acid molecules as well as the benzoate ions.

• KSBB Journal
• /
• v.6 no.4
• /
• pp.337-344
• /
• 1991

The liquid-liquid extraction of lipase A from Candide cylindracea and lipase B from porcine pancrease was carried out using reversed micellar organic solvents. Effects of various factors such as ionic strength, pH, and species and concentration of surfactant, on lipase solubilization were studied. A cationic surfactant cetyl-trimethyl ammonium bromide (CTAB) in isooctane/nhexanol(1:1) was found to be an effective solvent and its optimum concentration was 50 mM. KCl among various salts tested was the most effective and the efficiency of solubilization of lipase increased with decreasing the ionic strength of salts. The maximum activity and solubiliz ation of protein were obtained at pH 8. The stripping efficiency has a maximum value at pH 4 and increases with KCl concentration in the range of 0.2∼1.0 M. After the solubilization and stripping, the overall recovery efficiency of mass and specific activity of lipases was 62% and 66%, respectively.

• Journal of Integrative Natural Science
• /
• v.7 no.2
• /
• pp.120-123
• /
• 2014

When a hydrophobic and hydrophilic environments of bis(2,2'-bipyridyl) copper(II) ($Cu(bpy)_2{^{2+}}$) are produced in the presence of anionic surfactant sodium dodecyl sulfate (SDS), cyclic voltammetry is used to investigate the microscopic environments which occurs at the glassy carbon electrode. In order to see the relation between ${\Delta}E_p$ and a critical micelle concentration (CMC), ${\Delta}E_p$ vs. -Log[SDS] for the redox couples are plotted. The concentration at the intersection of two lines is 2.57 mM SDS, and this concentration can be determined as the CMC (relative error: below 0.03%; 2.63 mM SDS by surface tensiometry).