• Proceedings of the Korean Institute of Surface Engineering Conference
• /
• 2012.05a
• /
• pp.236-237
• /
• 2012

ZnO nanorods were grown on R-plane sapphire substrates with the seed layers annealed at different temperature. The effects of annealing temperature for the seed layers on the properties of the ZnO nanorods were investigated by scanning electron microscopy, X-ray diffraction, UV-visible spectroscopy, and photoluminescence. For the as-prepared seed layers, the ZnO nanorods and the ZnO nanosheets were observed. Only the ZnO nanorods were grown as the annealing temperature was above $700^{\circ}C$. The optical transmittance in the UV region was almost zero while that in the visible region was gradually increased as the annealing temperature increased to $700^{\circ}C$. The optical band gap of the ZnO nanorods was increased as the annealing temperature increased to $700^{\circ}C$. In the visible region, the refractive index was decreased with increasing the wavelength, and the extinction coefficient was decreased as the annealing temperature increased to $700^{\circ}C$. The non-linear exciton radiative life time of the FX emission peak was established by cubic equation. The values of Varshni's empirical equation fitting parameters were ${\alpha}=4{\times}10^{-3}eV/K$, ${\beta}=1{\times}10^4K$, and $E_g(0)=3.335eV$ and the activation energy was found to be about 94.6 meV.

• Korean Journal of Metals and Materials
• /
• v.50 no.5
• /
• pp.383-387
• /
• 2012

The activation of Mg-10 wt%$Fe_2O_3$ was completed after one hydriding-dehydriding cycle. Activated Mg-10 wt%$Fe_2O_3$ absorbed 5.54 wt% H for 60 min at 593 K under 12 bar $H_2$, and desorbed 1.04 wt% H for 60 min at 593 K under 1.0 bar $H_2$. The effect of the reactive grinding on the hydriding and dehydriding rates of Mg was weak. The reactive grinding of Mg with $Fe_2O_3$ is believed to increase the $H_2$-sorption rates by facilitating nucleation (by creating defects on the surface of the Mg particles and by the additive), by making cracks on the surface of Mg particles and reducing the particle size of Mg and thus by shortening the diffusion distances of hydrogen atoms. The added $Fe_2O_3$ and the $Fe_2O_3$ pulverized during mechanical grinding are considered to help the particles of magnesium become finer. Hydriding-dehydriding cycling is also considered to increase the $H_2$-sorption rates of Mg by creating defects and cracks and by reducing the particle size of Mg.

• Applied Chemistry for Engineering
• /
• v.32 no.4
• /
• pp.385-392
• /
• 2021

In this study, impact of Co proportion and calcination temperature of ceria on the Co/CeO₂ was analyzed by comparing nitrogen monoxide oxidation performance of various catalysts and their physico-chemical properties. The structural properties of each catalyst were studied by XRD and BET analysis, and the surface crystal states of cobalt were proposed according to the surface density. Oxidation states of elements were observed through Raman and XPS analysis, and the relationship between typical oxidation states and nitrogen monoxide oxidation performance was designed. Through H₂-TPR, oxygen-transferring capacity due to changes in the characteristics of catalysts were identified, and activation sites (Co³⁺) for oxidation were suggested.

• Membrane and Water Treatment
• /
• v.13 no.3
• /
• pp.129-137
• /
• 2022

In this study, the removal of Ciprofloxacin (CPX) from aqueous solutions was investigated by a new activated carbon adsorbent prepared from orange peel (ACOP) with chemical activation using ZnCl₂. The physicochemical properties of orange peel activated carbon were characterized by proximate and ultimate analysis, scanning electron microscopy, BET surface area determination and Fourier transformation infrared spectroscopic studies. According to Brunauer-Emmett-Teller isotherm and non-local-density functional theory, the cumulative surface area, pore volume and pore size of ACOP were determined as 1193 m² g^-1, 0.83 cc g^-1 and 12.7 Å, respectively. The effects of contact time, pH, temperature and ACOP dose on the batch adsorption of CPX were studied. Adsorption equilibrium data of CPX with ACOP were found to be compatible with both the Langmuir and Freundlich isotherms. CPX adsorption capacity of ACOP was calculated as 181.8 mg g^-1 using Langmuir isotherm. The CPX adsorption kinetics were found to be harmonious with the pseudo-second-order kinetic model. Conclusively, ACOP can be assessable as an effective adsorbent for the removal of ciprofloxacin (CPX) from aqueous solutions.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2012.08a
• /
• pp.154-155
• /
• 2012

The promise of nano-crystalites (nc) as a technological material, for applications including display backplane, and solar cells, may ultimately depend on tailoring their behavior through doping and crystallinity. Impurities can strongly modify electronic and optical properties of bulk and nc semiconductors. Highly doped dopant also effect structural properties (both grain size, crystal fraction) of nc-Si thin film. As discussed in several literatures, P atoms or radicals have the tendency to reside on the surface of nc. The P-radical segregation on the nano-grain surfaces that called self-purification may reduce the possibility of new nucleation because of the five-coordination of P. In addition, the P doping levels of ${\sim}2{\times}10^{21}\;at/cm^3$ is the solubility limitation of P in Si; the solubility of nc thin film should be smaller. Therefore, the non-activated P tends to segregate on the grain boundaries and the surface of nc. These mechanisms could prevent new nucleation on the existing grain surface. Therefore, most researches shown that highly doped nc-thin film by using conventional PECVD deposition system tended to have low crystallinity, where the formation energy of nucleation should be higher than the nc surface in the intrinsic materials. If the deposition technology that can make highly doped and simultaneously highly crystallized nc at low temperature, it can lead processes of next generation flexible devices. Recently, we are developing a novel CVD technology with a neutral particle beam (NPB) source, named as neutral beam assisted CVD (NBaCVD), which controls the energy of incident neutral particles in the range of 1~300eV in order to enhance the atomic activation and crystalline of thin films at low temperatures. During the formation of the nc-/pm-Si thin films by the NBaCVD with various process conditions, NPB energy directly controlled by the reflector bias and effectively increased crystal fraction (~80%) by uniformly distributed nc grains with 3~10 nm size. In the case of phosphorous doped Si thin films, the doping efficiency also increased as increasing the reflector bias (i.e. increasing NPB energy). At 330V of reflector bias, activation energy of the doped nc-Si thin film reduced as low as 0.001 eV. This means dopants are fully occupied as substitutional site, even though the Si thin film has nano-sized grain structure. And activated dopant concentration is recorded as high as up to 1020 #/$cm^3$ at very low process temperature (＜ $80^{\circ}C$) process without any post annealing. Theoretical solubility for the higher dopant concentration in Si thin film for order of 1020 #/$cm^3$ can be done only high temperature process or post annealing over $650^{\circ}C$. In general, as decreasing the grain size, the dopant binding energy increases as ratio of 1 of diameter of grain and the dopant hardly be activated. The highly doped nc-Si thin film by low-temperature NBaCVD process had smaller average grain size under 10 nm (measured by GIWAXS, GISAXS and TEM analysis), but achieved very higher activation of phosphorous dopant; NB energy sufficiently transports its energy to doping and crystallization even though without supplying additional thermal energy. TEM image shows that incubation layer does not formed between nc-Si film and SiO2 under later and highly crystallized nc-Si film is constructed with uniformly distributed nano-grains in polymorphous tissues. The nucleation should be start at the first layer on the SiO2 later, but it hardly growth to be cone-shaped micro-size grains. The nc-grain evenly embedded pm-Si thin film can be formatted by competition of the nucleation and the crystal growing, which depend on the NPB energies. In the evaluation of the light soaking degradation of photoconductivity, while conventional intrinsic and n-type doped a-Si thin films appeared typical degradation of photoconductivity, all of the nc-Si thin films processed by the NBaCVD show only a few % of degradation of it. From FTIR and RAMAN spectra, the energetic hydrogen NB atoms passivate nano-grain boundaries during the NBaCVD process because of the high diffusivity and chemical potential of hydrogen atoms.

• Transactions on Control, Automation and Systems Engineering
• /
• v.4 no.1
• /
• pp.43-48
• /
• 2002

We show that humans execute the postural control ingeniously by regulating the impedance properties of the musculo-skeletal system as the motor command against the alteration of the environment. Adjusting muscle activity can control the impedance properties of the musculo-skeletal system. To quantify the changes in human arm viscoelasticity on the vertical plane during interaction with the environment, we asked our subject to hold an object. By utilizing surface electromyographic(EMG) studies, we determined a relationship between the perturbation and a time-varying muscle co-activation. Our study showed when the subject lifts the object by himself the muscle stiffness increases while the torque remains the same just before the lift-off. These results suggest that the central nervous system(CNS) simultaneously controls not only the equilibrium point(EP) and the torque, but also the muscle stiffness as themotor command in posture control during the contact task.

• Journal of the Korean Society of Clothing and Textiles
• /
• v.12 no.1 s.26
• /
• pp.27-35
• /
• 1988

In order to investigate a practical application of the fibrous adsorbent to heavy metal ions, acrylic fibers were treated with the hydroxylamine solution that was producted by hydroxylamine hydrochloride and potasium hydroxide in a condition of strong alkaline and $70^{\circ}C$. The adsorption mechanism of copper(2) ion on the fibrous adsorbent, that is hydroxylaminated acrylic fibers, was studied. The adsorption of copper(2) ion was explained in terms of the activated adsorption that are formed the complex with the ligand, such as C=N, N-H, NHOH, on the surface of the adsorbent. The activation energy was evaluated to be 3.8 Kcal/mol. and the times of adsorption equilibrium was approximately 10 minutes. The uptake of copper(2) ion was found to be effected with the increase of temperatures and the pH dependence.

• Journal of the Korean Chemical Society
• /
• v.19 no.5
• /
• pp.381-385
• /
• 1975

Calcinated alunite powder (surface area 5100 $cm^2/g$) was found to react with well stirred ammonium buffer solution (pH 8.0) following Jander's equation. The rate constants increase with the amount of solid and temperature of reaction system. The energy of activation for the reactions (at $30{\sim}60^{\circ}C$) was 15.7 kcal/mole. The rate-determining step appears to involve ionization of alunite.

• Proceedings of the KIEE Conference
• /
• 2001.11a
• /
• pp.90-92
• /
• 2001

Carbon monoxide-sensing behavior of Pt-SiC Schottky diodes. fabricated on the same SiC substrate have been systematically compared and analyzed as a function of carbon monoxide concentrati on and temperature by I-V and ${\Delta}I$-t methods under steady-state and transient condition. Adsorption activation energies of Carbon monoxide on the surface of Pt-SiC Schottky diodes is investigated in a high temperature range ($100{\sim}500^{\circ}C$). The optimal temperature for behavior sensing is $300^{\circ}C$ and saturation concentration is 200 ppm.

• Journal of Ginseng Research
• /
• v.37 no.3
• /
• pp.300-307
• /
• 2013

20S-dihydroprotopanaxatriol (2H-PPT) is a derivative of protopanaxatrol from ginseng. Unlike other components from Panax ginseng, the pharmacological activity of this compound has not been fully elucidated. In this study, we investigated the modulatory activity of 2H-PPT on the cellular responses of monocytes and macrophages to understand its immunoregulatory actions. 2H-PPT strongly upregulated the release of radicals in sodium nitroprusside-treated RAW264.7 cells and the surface levels of costimulatory molecule CD86. More importantly, this compound remarkably suppressed nitric oxide production, morphological changes, phagocytic uptake, cell-cell aggregation, and cell-matrix adhesion in RAW264.7 and U937 cells in the presence or absence of lipopolysaccharide, anti-CD43 antibody, fibronectin, and phorbal 12-myristate 13-acetate. Therefore, our results suggest that 2H-PPT can be applied as a novel functional immunoregulator of macrophages and monocytes.