• 한국광학회지
• /
• 제14권1호
• /
• pp.38-43
• /
• 2003

$LiNbO_3$의 스트레인광학효과와 ~l.4$\mu\textrm{m}$ 두께 이상으로 증착된 Mo(molybdenum)/Pt(platinum) 금속 박막으로부터 발생되는 압축스트레인을 이용하여 채널 광도파로 제작 공정을 개발하였다. 제작된 광도파로는 단일모드로 관찰되었으며, 삽입 손실이 TE, TM 입사 편광모드 각각에 대해서 6.2, 7.7 dB/cm로 측정되었다. 전극 길이와 간격이 11 mm, 21 $\mu\textrm{m}$인 광변조기를 스트레인광학형 광도파로 구조를 이용하여 제작하였으며, $V_{\pi}$= 16.1 V와 100% 변조 깊이가 1.55$\mu\textrm{m}$ 파장 영역에서 측정되었다. 또한 1$\times$2광 파워 분리기를 제작한 결과 0.63$\mu\textrm{m}$ 파장 영역에서 on/off 특성이 $\pm$25V에서 관찰되었다.

• 전자공학회논문지D
• /
• 제35D권1호
• /
• pp.72-78
• /
• 1998

Polarization mode converters have been produced by utilizing Ti:LiNbO$_{3}$ channel waveguide and strain-optic effect. Shear strain for periodic perturbations of optical channel waveguides and phase matching can be obtained by an evaporated periodic SiO$_{2}$ thin film at 300.deg. C. The electrodes located on the either side of waveguide provide a means to electro-optically tune the wavelength for maximum polarization conversion via the electrooptic effect. The maximum conversion effeciency was observed at 21.deg. C for V=0 and 46.deg. C for V=30V aro the device having 7 .mu.m waveguide wiith and 350 periodic pads. The dependence of the number of pads on conversion efficiency was observed experimentally.fficiency was observed experimentally.

• 한국전기전자재료학회논문지
• /
• 제28권12호
• /
• pp.776-780
• /
• 2015

In this paper, we have studied the effect of mechanical polishing to Ga-polar face for reducing the wafer bowing and strain in free-standing GaN. After the mechanical polishing to Ga-polar face, the bowing of the free-standing GaN substrate significantly decreased with increasing the size of diamond slurry, and eventually changed the bowing direction from concave to convex. Furthermore, the full width at half maximum (FWHM) of high-resolution X-ray diffraction (HR-XRD) were decreased, especially the FWHM of (1 0 2) reflection for $1.0{\mu}m$ size of diamond slurry was significantly decreased from 630 to 203 arcsec. In the case, we confirmed that the compressive strain in Ga-polar face was fully released by Raman measurement.

• 센서학회지
• /
• 제10권3호
• /
• pp.163-172
• /
• 2001

넓은 지역에 걸친 침입자의 침투를 감시하기 위하여 수십 km의 광섬유 길이 전체를 감지부로 사용할 수 있는 광섬유 BOTDA (Brillouin Optical Time Domain Analysis) 센서를 개발하였다. 광섬유 BOTDA 센서는 한 개의 레이저 다이오드와 두 개의 광전 변조기(electro-optic modulator)를 사용하여 간단하게 구성하였다. 침입자에 의한 광섬유의 변형률 변화를 탐지하는 실험을 수행하기 위하여 광학테이블 위에 광섬유에 변형률을 인가하기 위한 실험장치를 설치하여 실험을 수행하였다. 이 실험으로부터 시간간격 1.5 초동안 광섬유 약 4.81 km의 길이를 거리분해능 3 m로 침입자를 탐지할 수 있음을 확인하였다.

• 한국광학회지
• /
• 제17권5호
• /
• pp.430-436
• /
• 2006

1550nm 파장대역에서 편광에 관계없이 동작하는 $Ti:LiNbO_3\;2{\times}2$ 삽입/분기 광 멀티플렉서를 구현하였다. 소자는 두 개의 입 출력 광도파로, 두 개의 편광모드분리기, 두 개의 편광모드 변환기 그리고 전기광학효과로 파장을 가변시킬 수 있는 전극으로 구성되었다. TE, TM 편광에 대해서 단일모드 특성을 갖는 채널 광도파로는 x-cut $LiNbO_3$에 Ti 확산 방법으로 제작하였으며, 채널 광도파로 위에 배열된 $SiO_2$ 패드의 전단 스트레인을 이용하여 위상정합 편광모드변환기를 구현하였다. 한편 전기광학효과를 이용하여 파장을 가변시키기 위해서 전압을 인가하여 광도파로의 복 굴절률을 변화시켰다. 0.094nm/V 파장가변률과 최대 17nm 파장을 가변시켰으며, 8.2dB 부 모드레벨과 3.72nm FWHM을 측정하였다.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 2004년도 춘계 학술발표회 제16권1호
• /
• pp.486-489
• /
• 2004

In this paper, we try to detect the peel out effect and find the strain difference between the main structure and retrofitting patch material when they separate from each other. In the experiment, two fiber optic Bragg grating sensors are applied to the main concrete structure and the patching material separately at the same position. The sensors show coincident behaviors at the initial loading, but different behaviors after a certain load. The test results show the possibility of optical fiber sensor monitoring of beam structures retrofitted by the composite patches.

• 한국전기전자재료학회논문지
• /
• 제32권5호
• /
• pp.426-431
• /
• 2019

In this study, we report the effect of pre-treatment of alpha-$Ga_2O_3$ grown on a sapphire substrate by halide vapor phase epitaxy (HVPE). During the pre-treatment process, 10 sccm of GaCl gas was injected to the sapphire substrate at $470^{\circ}C$. The surface morphologies of the alpha-$Ga_2O_3$ layers grown with various pre-treatment time (3, 5, and 10 min) were flat and crack-free. The transmittance of the alpha-$Ga_2O_3$ epi-layers was measured to analyze their optical properties. The transmittance was over 80% within the range of visible light. The strain in the alpha-$Ga_2O_3$ grown with a pre-treat 5 min was measured, and was found to be close to the theoretical XRD peak position. This can be explained by the reduction of strain having caused a lattice mismatch between the alpha-$Ga_2O_3$ layer and sapphire substrate. The calculated dislocation density of the screw and edge were $2.5{\times}10^5cm^{-2}$ and $8.8{\times}10^9cm^{-2}$, respectively.

• 한국전기전자재료학회논문지
• /
• 제18권11호
• /
• pp.1048-1055
• /
• 2005

The formula to calculate a variation of optical path length of single crystal by the electric field was derived by this study. The formula was applied to $Bi_{12}SiO_{20}$ single crystal. The results are as follows. In case of the applied electric field in the body diagonal direction and the passing light along the same direction, the variation of optical path length had the largest value. The symmetry of the space distribution of optical path length satisfied $E3C_2\;8C_3$, the set of elements of the symmetry of $Bi_{12}SiO_{20}$ single crystal. The property which gave the largest influence to the variation of optical path length is the strain of length by the Inverse piezoelectric effect. The second influence, is the variation of the refractive index by the electro-optic effect. The variation of optical path length by the inverse piezoelectric effect and by the electro-optic effect have a reverse sign each other.

• Journal of Magnetics
• /
• 제2권2호
• /
• pp.58-66
• /
• 1997

Recently, artificially modulated magnetic multilayer materials, for examples giant magnetoresistant magnetic head materials and magneto-optic recording materials in the wavelength of a blue laser beam, attract great attention in the electronics industry due to their unique properties derived from the modulated multilayer structure. Since the multilayer structure as well as amorphous structure, is non-equilibrium state in terms of free energy, an assessment of the thermal staibility in the multilayer structure is crucially importnat both for basic research and applications. In this review paper, effective microscopic interdiffusion process in the two dimensional multilayer structure will be described in terms of steep concentration gradient effect, strain effect and magnetic transition effect.

• 한국정밀공학회:학술대회논문집
• /
• 한국정밀공학회 2002년도 추계학술대회 논문집
• /
• pp.416-420
• /
• 2002

This Paper describes a matched-filter type strain sensor system using optical fiber Bragg grating (FBG) sensor. Matched-filter type uses another wavelength-matched FBG filter to track wavelength shift in the FBG sensor. Filter FBG is attached on a fiber stretcher and stretched by PZT actuator. To overcome the nonlinearity and hysteresis of the PZT actuator that degrades system accuracy, a string resonator which can measure an absolute strain is employed. And the effect of vibration modes on string resonator is investigated particularly regarding its sensitivity and stability.