• Journal of Powder Materials
• /
• v.29 no.6
• /
• pp.492-498
• /
• 2022

N-doped Na₂Ti₆O₁₃@TiO₂ (denoted as N-NTO@TiO₂) composites are successfully synthesized using a simple two-step process: 1) ball-milling of TiO₂ with Na₂CO₃ followed by heat treatment at 900℃; 2) mixing of the prepared Na₂Ti₆O₁₃ with titanium isopropoxide and calcining with urea at 500℃. The prepared composites are characterized using XRD, SEM, TEM, FTIR, and BET. The N-NTO@TiO₂ composites exhibit well-defined crystalline and anatase TiO₂ with exposed {101} facets on the external surface. Moreover, dopant N atoms are uniformly distributed over a relatively large area in the lattice of the composites. Under visible light irradiation, ~51% of the aqueous methylene blue is photodegraded by N-NTO@TiO₂ composites, which is higher than the values shown by other samples because of the coupling effects of the hybridization of NTO and TiO₂, N-doping, and presence of anatase TiO₂ with exposed {101} facets.

• Journal of the Korean Electrochemical Society
• /
• v.9 no.2
• /
• pp.64-69
• /
• 2006

Cathode materials of Al-doped $Li(Ni_{1/3}Co_{1/3}Mn_{1/3-x}Al_x)O_2$ (x=0.0, 0.005, 0.01 0.05) for lithium ion batteries were synthesized with ultra-sonic spray pyrolysis method and single-step heat treatment. No secondary phases were found in all synthesized powders. The intensity ratio of $I_{003}\;to\;I_{104}$, however, slightly decreased and the particle size increased with the Al contents. The cells with bare, 0.5 and 1.0 at% Al-doped powders showed the initial discharge capacities of 182, 180 and $184mAhg^{-1}$ in a voltage range of $3.0\sim4.5V$ at 1C rate, and the capacity retentions of 81, 77 and 78% at the end of 30 cycles, respectively. But in the voltage range of $3.0\sim4.6V$, the Al-doping significantly enhanced the cycle stability. For example, the discharge capacity after 50 cycles was maintained to 70% in the 0.5 at% Al-doped sample compared to only 30% in no doped sample. The improvement of the cycle stability was thought to be due to $Mn^{3+}$ ion decrease as the Al doping from the XPS analysis results.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.35 no.1
• /
• pp.44-49
• /
• 2022

In this paper, we investigated current (I)- and voltage (V)-sweeping properties in a double-stack structure, Ge₂Sb₂Te₅/Ti/W-doped Ge₈Sb₂Te₁₁, a candidate medium for applications to multilevel phase-change memory. 200-nm-thick and W-doped Ge₂Sb₂Te₅ and W-doped Ge₈Sb₂Te₁₁ films were deposited on p-type Si(100) substrate using magnetron sputtering system, and the sheet resistance was measured using 4 point-probe method. The sheet resistance of amorphous-phase W-doped Ge₈Sb₂Te₁₁ film was about 1 order larger than that of Ge₂Sb₂Te₅ film. The I- and V-sweeping properties were measured using sourcemeter, pulse generator, and digital multimeter. The speed of amorphous-to-multilevel crystallization was evaluated from a graph of resistance vs. pulse duration (t) at a fixed applied voltage (12 V). All the double-stack cells exhibited a two-step phase change process with the multilevel memory states of high-middle-low resistance (HR-MR-LR). In particular, the stable MR state is required to guarantee the reliability of the multilevel phase-change memory. For the Ge₂Sb₂Te₅ (150 nm)/Ti (20 nm)/W-Ge₈Sb₂Te₁₁ (50 nm), the phase transformations of HR→MR and MR→LR were observed at t<30ns and t<65ns, respectively. We believe that a high speed and stable multilevel phase-change memory can be optimized by the double-stack structure of proper Ge-Sb-Te films separated by a barrier metal (Ti).

• Journal of Electrochemical Science and Technology
• /
• v.4 no.2
• /
• pp.71-80
• /
• 2013

The study of methyl viologen ($MV^{2+}$) mediated oxygen reduction in electrolytic ethanol media possesses potential application in the electrochemical synthesis of hydrogen peroxide mainly due to the advantages of the much increased solubility of molecular oxygen ($O_2$) and high degree of reversibility of $MV^{2+/{\bullet}+}$ redox couple. The diffusion coefficients of both $MV^{2+}$ and $O_2$ were investigated via electrochemical techniques. For the first time, $MV^{2+}$ mediated $O_2$ reduction in electrolytic ethanol solution has been proved to be feasible on both boron-doped diamond and micro-carbon disc electrodes. The electrocatalytic response is demonstrated to be due to the radical cation, $MV^{{\bullet}+}$. The homogeneous electron transfer step is suggested to be the rate determining step with a rate constant of $(1{\pm}0.1){\times}10^5M^{-1}s^{-1}$. With the aid of a simulation program describing the EC' mechanism, by increasing the concentration ratio of $MV^{2+}$ to $O_2$ electrochemical catalysis can be switched from a partial to a 'total catalysis' regime.

• Journal of Electrochemical Science and Technology
• /
• v.7 no.1
• /
• pp.52-57
• /
• 2016

Nanoporous-layer-covered TiO₂ nanotube arrays (Type II TNTs) were fabricated by two-step electrochemical anodization. For comparison, conventional TiO₂ nanotube arrays (Type I TNTs) were also prepared by one-step electrochemical anodization. Types I and II TNTs were detached by selective etching and then transferred successfully to a transparent F-doped SnO₂ (FTO) substrate by a sol-gel process. Both FTO/Types I and II TNTs allowed front side illumination to exhibit incident photon-to-current efficiencies (IPCEs) in the long wavelength region of 300 to 750 nm without the absorption of light by the iodine-containing electrolyte. The Type II TNT exhibited longer electron lifetime and faster charge transfer than the Type I TNT because of its relatively fewer defect states. These beneficial effects lead to a high overall energy conversion efficiency (5.32 %) of the resulting dye-sensitized solar cell.

• Proceedings of the IEEK Conference
• /
• 2004.06b
• /
• pp.371-374
• /
• 2004

In this paper, Ni Germane-silicide formed on undoped $Si_{0.8}Ge_{0.2}$ as well as source/drain dopants doped $Si_{0.8}Ge_{0.2}$ was characterized by the four-point probe for sheet resistance. x-ray diffraction (XRD), x-ray photoelectron spectroscopy (XPS) and field emission scanning electron microscope (FESEM). Low resistive NiSiGe is formed by one step RTP (Rapid thermal processing) with temperature range at $500{\~}700^{\circ}C$. To enhance the thermal stability of Ni Germane-silicide, Ni/Co/TiN structure with different Co concentration were studied in this work. Low sheet resistance was obtained by Ni/Co/TiN structure with high Co concentration using 2-step RTP and it almost keeps the same low sheet resistance even after furnace annealing at $650^{\circ}C$ for 30 min.

• Proceedings of the KIEE Conference
• /
• 1999.07d
• /
• pp.1992-1994
• /
• 1999

Dicumyl peroxide (DCP) is used for crosslinking agent in general. And the correlation between polyethylene and DCP is significant in particular radiation environment. On this paper, The effects on $Co^{60}{\gamma}$-ray irradiation of polyethylene doped dicumyl peroxide(DCP) were investigated. We experimented on electrical properties as following; electrical tree inception and growing type for applying AC step voltage, AC breakdown strength, volume resistivity, capacitance and dissipation factor at high frequency as increasing dosage. Also, chemical analysis was performed TGA, gel content.

• Journal of Hydrogen and New Energy
• /
• v.28 no.4
• /
• pp.361-368
• /
• 2017

Alanate-based materials, which were known to have high hydrogen storage capacity, were synthesized by mechanochemically metathesis reaction of metal chloride and sodium alanate without solvent. XRD patterns of synthesized materials showed that metathesis reaction of cations between metal chloride and sodium alanate was progressed favorably without any solvent. Magnesium alanate showed that 3.2 wt.% of hydrogen was evolved by the thermal decomposition. The addition of a small amount of Ti to the magnesium alanate greatly reduced hydrogen evolution temperature. Also, Ti doped magnesium alanate had a good regeneration property. Both the calcium and lithium-magnesium alanate showed the lower starting temperature of the two step hydrogen evolution and fast kinetics for the hydrogen evolution.

• Journal of Photoscience
• /
• v.7 no.2
• /
• pp.59-61
• /
• 2000

As a potential electroluminescent material, tetrahydrochrysene (THC) is prepared using the dehydrocyclization following the acyloin condensation of methyl-3-phenyl propionate as key step from trans-mehyl cinnamate in 3 steps. THC showed emission at 428 and 456 nm after the photo- and electro-excitation, respectively. The luminance of THC doped on PVK was about /$25 cdm^2$ at 30 voltage with 70 nm of thickness. The results suggests that a new fluorescent organic dye, THC can be used organic electroluminescent device.

• Journal of the Korean Vacuum Society
• /
• v.12 no.S1
• /
• pp.56-59
• /
• 2003

Wurtzite GaN films are grown by low-pressure MOCVD on (0001)-plane sapphire substrates. The GaN films have a total thickness of 4 $\mu$m with a surface Mg-doped p-type layer, which has a thickness of 0.5 $\mu$m. 90k eV $Mn^{+}$ ions are implanted into the GaN films at room temperature with doses ranging from $1 \times10^{15}$ to $1 \times 10^{16}\textrm{cm}^{-2}$. After an annealing step at $770^{\circ}C$ in flowing $N_2$, the structural characteristics of the $Mn^{+}$ implanted GaN films are studied by X-ray diffraction (XRD), Rutherford backscattering spectrometry (RBS) and atomic force microscopy (AFM). The structural and morphological changes brought about by $Mn^{+}$ implantation and annealing are characterized.