• 한국염색가공학회지
• /
• 제14권4호
• /
• pp.197-207
• /
• 2002

The physical properties and dyeability of the nylon 6 fibers prepared by high speed spinning at take-up speed of 4,100~5,600m/min were investigated. The strain decreased as the take-up speed was raised from 4,100m/min to 4,400m/min, but further increase of take-up speed could not decrease the strain. The stresses of the fibers spinned at various take-up speed did not make any noticeable differences. Birefringences, densities and crystallinities of the fibers increased with the take-up speed and then reached to a nearly maximum value at 5,300m/min. In DSC diagrams, the $\gamma$ form of crystal became dominant at higher take-up speed. The dye uptakes of C. I. Acid Blue 113 on the fibers decreased a little with the increase of take-up speed.

• 한국철도학회:학술대회논문집
• /
• 한국철도학회 2000년도 추계학술대회 논문집
• /
• pp.250-257
• /
• 2000

The speed-up of conventional trains is considered as one of the efficient methods to relieve traffic jam and to increase the capacity of transportation. In this study, we measured and analyzed the ride comfort of a push-pull Saemaeul Train with speed-up of 5km/h in curves and 10km/h on straight tracks as compared with present operation speed of the push-pull Saemaeul Trains. Four main lines-Honam, Kyungboo, Janghang, Kyungjeon- were chosen as representative lines for speed-up feasibility study. The increase of mean ride comfort index in case of speed-up is 0.5-2㏈. The mean ride comfort index of vertical direction in case of speed-up is 107-110㏈ for Honam line, 104-112㏈ for Kyungboo line, 108-112㏈ for Janghang line and 105-108㏈ for Kyungjeon line, which are rather high as compared with German trains of similar grade with maximum vehicle speed of 160km/h.

• 한국철도학회:학술대회논문집
• /
• 한국철도학회 2001년도 춘계학술대회 논문집
• /
• pp.105-113
• /
• 2001

This report was studied about speed-up for main line of KNR(Korea National Railroad) by High Speed Train. The maximum speed of Kyun-Pu line was recorded a 140km/h by Saemaul train in 1985 and the average speed its is a 107km/h now. For operation KTX Kyun-Pu High Speed Train and G7 Korea High Speed Train in KNR line, this report was studied about operation status of High Speed Train in advanced countries, operation situation of train in KNR line and plan of speed-up for main line.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2001년도 춘계학술대회논문집
• /
• pp.1227-1231
• /
• 2001

To provide faster service and to relief the road traffic jam, the increase of service speed of conventional railway has been intensively considered. In this study, we measured and analyzed the vibration ride comfort of Saemaeul Train to evaluate the feasibility of 5km/h speed-up in curves and l0km/h speed-up on straight tracks. Four main lines, such as Honam, Kyungboo, ]anghang, Kyungjeon were chosen as representative lines for speed-up feasibility study. The increase of mean ride comfort index in case of speed-up is 0.5-2㏈. The mean ride comfort index of vertical direction in case of speed-up is 107 ∼110 ㏈ for Honam line, 104 ∼112 ㏈ for Kyungboo line, 108∼112 ㏈ for Janghang line and 105∼108 ㏈ for Kyungjeon line. Through this study, we found that the Saemaul Express has slight margin to increase the service speed from the view point of vibration ride comfort.

• 한국소성가공학회:학술대회논문집
• /
• 한국소성가공학회 1997년도 춘계학술대회논문집
• /
• pp.261-264
• /
• 1997

A single action press robot, which consists of a driving unit, rotator, up-down feed base and feed bar, is developed and applied for the press automation. The driving unit is made up with a face cam and blade cam, which have a phase angle. The feeding system consists of a double speed-up apparatus and linear motion guides, and has a fast motion characteristics. A horizontal feeding speed of the feed bar is increased twice by the double speed-up apparatus. The driving mechanism could be simplified due to the speed-up of the feeding unit.

• 한국운동역학회지
• /
• 제23권2호
• /
• pp.91-97
• /
• 2013

The purpose of this study was to compare the effect of a new warm-up condition, overloaded arm weights (721 g each arm, [OA]), on the bat speed during warm-up and immediately after warm-up with traditional warm-up conditions such as no-extra mass warm-up (control condition, [CO]) and overloaded bat warm-up (885 g donut on a bat, [OB]) conditions. Twenty male subjects who had competitive baseball experience participated in this study. Electromagnetic motion capture system was used to capture body segment motions. Results indicated that the OB showed significantly slower bat speed than the CO and OA did during warm-up (p<.05) and the bat speeds of OA and OB were similar. There was no main effect of different types of warm-up condition on the bat speed at post-warm-up swings. However, the first trial immediately after the OA and OB showed significant slower than the later trials (p<.05). Conclusively, the overloaded arm weights and overloaded bat did not show statistical superiority than the standard warm-up conditions in the deck circle and recovery time more than 3 minutes after loaded warm-up is recommended.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2001년도 추계학술대회논문집 II
• /
• pp.1223-1228
• /
• 2001

We have been developing the pantograph for Korean High Speed Train for the last five years. To fulfil the following requirements at designed speed of 350km/h ： 1) contact loss less than 1 ％, 2) aerodynamic noise less than 91dB, 3) average uplift force less than 200N, the pantograph has been modified two times since the first prototype pantograph was manufactured, By means of the following up characteristic test, low speed wind tunnel test, and high speed wind tunnel test for the prototype pantographs, we found that the aerodynamic uplift force did not exceed l60N at speed up to 350km/h and the aerodynamic noise was less than 88dB, that the following up characteristics of the prototype pantograph was excellent.

• 한국철도학회:학술대회논문집
• /
• 한국철도학회 2011년도 정기총회 및 추계학술대회 논문집
• /
• pp.2064-2071
• /
• 2011

We are developing an innovative super-speed land transportation system running in a partial vacuum in tunnels with small inside diameter to reduce the aerodynamic drag forces. This paper presents the experimental results obtained on a small scale model when a super-speed train model passing through a tunnel with small inside diameter and a partial vacuum to reduce the aerodynamic drag forces. The experiments were performed on a 1/52-scale moving model rig in which a train model with a diameter of 58 mm and a length of 603 mm was accelerated in a launching tube with 12.27 m length by means of the compressed air launcher and then passed through a tunnel model with 17.149 m length. The partial vacuum was maintained in the tunnel in order to reduce the energy consumption of the propulsion system of the super-speed tube train at super-speed of 700 km/h. In this study, the blockage ratio of train to tunnel model is 0.336. Experimental results show the nonlinear effects of the vacuum on the speed-up of the train model in the tunnel model under the partial vacuum up to 0.21 atm and at the velocity up to 684 km/h. This paper is first study for experiments on the speed-up of a super-speed train model in the partial vacuum tunnels.

• 한국철도학회:학술대회논문집
• /
• 한국철도학회 2000년도 춘계학술대회 논문집
• /
• pp.423-430
• /
• 2000

With speed-up of existing railway, a greater attention is paid to the riding safety and the comfort of the passengers. They are combined to some technical factors related to track such as alignment, derailment coefficient, and track bearing capacity, A quantitative analysis method for those technical factors is presented in this study. Calculating the allowable transit speed, the technical reviews of speed-up of Janghang-Line(Chunan∼Janghang) are conducted. And the alternatives for improving train speed in existing railway are proposed.

• 한국철도학회:학술대회논문집
• /
• 한국철도학회 2011년도 정기총회 및 추계학술대회 논문집
• /
• pp.2456-2463
• /
• 2011

Conventional railways are less competitive than other land transportation means in term of speed, and thus users preference and transportation share for rail system are relatively lower than others. For example, most of the conventional lines except the Seoul~Busan corridor run at an average speed of 70 km/h or less, which imposes certain constraints on roles and functions as the trunk lines. In this regard, the speed of the conventional lines should be improved up to 200 km/h to gain competitiveness, promote balanced regional development and lead the era of low carbon green growth. As track system is one of the most important elements for the speed-up, it is critical to come up with optimum technical solutions. Improvement of ballast track structure with efficient track installation can provide structural stability for higher speed and ensure operational safety with lower maintenance efforts. Thus, this study focuses on consequences followed by the speed-up including increase of load imposed on the track and impacts on track components, and provide solutions for track maintenance by analyzing impact on the track structure by speed. Also, it compares ballast and concrete tracks under designing and construction and considers how to meet needs for passengers comfort and environmental requirements as a strategic approach.