• ETRI Journal
• /
• v.26 no.5
• /
• pp.375-383
• /
• 2004

This paper proposes a common interleaving method associated with independent channel-encoding among transmitter antenna branches in orthogonal frequency and code division multiplexing based on multiple-input multiple-output (MIMO) multiplexing to achieve an extremely high throughput such as 1 Gbps using a 100 MHz bandwidth. This paper also investigates the average packet error rate performance as a function of the average received signal energy per bit-to-background noise power spectrum density ratio $(E_b/N_0)$. We found that the loss in the required average received $E_b/N_0$ of the proposed method is only within approximately 0.3 dB in up to a 12-path Rayleigh fading channel, using 16QAM and Turbo coding with a coding rate of 5/6. We also clarify that even for a large fading correlation among antenna branches, 1 Gbps is still possible by increasing the transmission power. Therefore, the proposed method reduces the processing rate to 1/4 in the turbo decoder with only a slight loss in the required average received $E_b/N_0$.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.42 no.7 s.337
• /
• pp.49-56
• /
• 2005

In this paper, we describe a solution to improve the effects of the transmitter leakage signals on the frequency modulated continuous wave (FMCW) radar with a single antenna configuration. We analyze characteristics of the IF noise caused by insufficient isolation between transmitter and receiver. The magnitude of the intermediate frequency (IF) noise from a front-end can be reduced by matching the LO signal delay time with that of the largest leakage source. Because the IF noise has periodic singularities at nT$_{m}$/2, t=0,1,2$\cdots$, we find that spectrum of the IF noise due to the leakage signals is very similar to that of the VCO moduation signal except low frequency elements in the vicinity of DC. Based on the studies, we fabricated a W-band homodyne FMCW radar sensor and verified the proposed solution. The results are applicable to design of the homodyne FMCW radar with a single antenna configuration.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.13 no.6
• /
• pp.101-108
• /
• 2013

In this paper, we propose a method in which the negative acknowledge (NACK) message is used as command for cooperation and spectrum sharing. This allows for an automatic request for cooperation and sharing when the direct link of the primary user is in outage, and also allows for saving the number of control messages in cooperation-spectrum sharing based paradigm. In the sharing phase, the selected relay shares a power fraction of $1-{\alpha}$ for secondary transmitted signal while the remaining of ${\alpha}$ is for primary retransmitted signal. In the case of no relay collected, primary transmitter uses NACK as a command to retransmit the signal with fully power fraction (${\alpha}=1$). Both systems are assumed to employ BPSK signals. In this scheme, we propose the joint optimal decoding in the secondary user. The frame error rate (FER) performance at both systems is then analyzed. The theoretical and simulation results validate the analysis and confirm the efficiency of the protocol.

• ETRI Journal
• /
• v.42 no.6
• /
• pp.859-871
• /
• 2020

A spectrally encapsulated (SE) orthogonal frequency-division multiplexing (OFDM) precoding scheme for wireless short packet transmission, which can suppress the out-of-band emission (OoBE) while maintaining the advantage of the cyclic prefix (CP)-OFDM, is proposed. The SE-OFDM symbol consists of a prefix, an inverse fast Fourier transform (IFFT) symbol, and a suffix generated by the head, center, and tail matrices, respectively. The prefix and suffix play the roles of a guard interval and suppress the OoBE, and the IFFT symbol has the same size as the discrete Fourier transform symbol in the CP-OFDM symbol and serves as an information field. Specifically, as the center matrix generating the IFFT symbol is orthogonal, data and pilot symbols can be allocated to any subcarrier without distinction. Even if the proposed precoder is required to generate OFDM symbols with spectral efficiency in the transmitter, a corresponding decoder is not required in the receiver. The proposed scheme is compared with CP-OFDM in terms of spectrum, OoBE, and bit-error rate.

• Journal of Astronomy and Space Sciences
• /
• v.37 no.4
• /
• pp.219-228
• /
• 2020

A CubeSat platform has become a popular choice due to inexpensive commercial off-the-shelf (COTS) components and low launch cost. However, it requires more power-efficient and higher-data rate downlink capability for space applications related to remote sensing. In addition, the platform is limited by the size, weight and power (SWaP) constraints as well as the regulatory issue of licensing the radio frequency (RF) spectrum. The requirements and limitations have put optical communications on promising alternatives to RF communications for a CubeSat platform, owing to the power efficiency and high data rate as well as the license free spectrum. In this study, we analyzed the performance of optical downlink communications compatible with CubeSat platforms in terms of data rate, bit error rate (BER) and outage probability. Mathematical models of BER and outage probability were derived based on not only the log-normal model of atmospheric turbulence but also a transmitter with a finite extinction ratio. Given the fixed slot width, the optimal guard time and modulation orders were chosen to achieve the target data rate. And the two performance metrics, BER and outage data rate, were analyzed and discussed with respect to beam divergence angle, scintillation index and zenith angle.

• Journal of Satellite, Information and Communications
• /
• v.2 no.2
• /
• pp.22-28
• /
• 2007

Spectrum spreading, in its general form, can be conceived as an artificial expansion of the signal bandwidth with respect to the minimum Nyquist band required to transmit the desired information. Spreading can be functional to several objectives, including resilience to interference and jammers and reduction of power spectral density levels. In the paper, signal spreading is manly used for increasing the received energy, thus satisfying link budget constraints, for terminals with low aperture antennas, without increasing the transmitted EIRP. As a matter of fact, in many mobile scenarios, even when MODCOD configurations with very low spectral efficiency (i.e. QPSK-1/4) in DVB-S2 standard, are used, the link budget cannot be closed. Spectrum spreading has been recently proposed as a technique to improve system performance without introducing additional MODCOD configurations under the constraint of fixed power spectrum density level at the transmitter side. To this aim, the design of spectrum spreading techniques shall keep into consideration requirements such as spectrum mask, physical layer performance, link budget, hardware reuse, robustness, complexity, and backward compliance with existing commercial equipments. The proposed implementation allows to fully reuse the standard DVB-S2 circuitry and is inserted as an 'inner layer' in the standard DVB-S2 chain.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.10 no.5
• /
• pp.565-570
• /
• 2015

Spread spectrum communications have increased interest due to their immunity to channel fading and low probability of intercept. One of the limitations of the traditional digital spread spectrum systems is the need for spreading code synchronization. Chaotic communication is the analogue alternative of digital spread spectrum systems beside some extra features like simple transceiver structures. In this paper, This paper was used instead of the digital modulation and demodulation carriers for use in the chaotic signal in a digital communication system among the chaotic modulation schemes, the Differential Chaos Shift Keying(DCSK) is the most efficient one because its demodulator detects the data without the need to chaotic signal phase recovery. Also Implementation of Differential Chaos Shift Keying Communication System Using Matlab/Simulink and the receiver con decode the binary information sent by the transmitter, performance curves of DCSK are given in terms of bit-error probability versus signal to noise ratio with spreading factor as a parameter and we compare it to BPSK modulation.

• The Journal of the Acoustical Society of Korea
• /
• v.41 no.1
• /
• pp.16-29
• /
• 2022

This paper presents a Doppler shift estimation method and signal processing schemes for Direct Sequence Spread Spectrum (DSSS) transmission to overcome the Doppler shift due to the moving of the underwater communication unit. The proposed method estimates a Doppler shift via 2 step procedures using the preamble with the two 64-length Frank sequences which has a good self-correlation characteristic and is insensitive to the Doppler shift. Furthermore, a packet of DSSS underwater mobile communication and a RAKE receiver are designed using the proposed Doppler shift estimation method. Due to the modulation scheme of the designed DSSS underwater mobile communication using Differential-Quadrature Phase Shift Keying (DQPSK) for the data symbol transmission, the RAKE receiver dose not need a phase tracking and easily makes coherent signals among the combining RAKE branches. The designed RAKE receiving scheme including the proposed Doppler shift estimation method successfully decides information data using the DSSS signal transmitted from the pseudo-moving transmitter with velocity upto about 17.5 m/s.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.9 no.1
• /
• pp.98-107
• /
• 1998

For implementation of FM-DS/SS system. This paper has analyzed SO(Synchronous Oscillator) being oscillated by the motivation of injected signal. Transmitter has adopted FM-DS/SS modulation method using RF output-signal of FM. Receiver is used SO to demodulation of FM-DS/SS and applied sliding correlator for synchronization of PN clock. As a result of the inspection, SO presented stable lock ability in spite of doppler apperance and proved the synchronous properties of it in the FM-DS/SS system.

• Journal of the military operations research society of Korea
• /
• v.16 no.2
• /
• pp.118-134
• /
• 1990

This paper considers the mutual interference problem of several users employing the same FH systems in selected multiple user environments. The environment consists of a desired transmitter-receiver pair located in an area where there are M interfering users distributed in accordance with a specified probability density function. Both coherent Phase-Shift-Keyed and incoherent Frequencey-Shift-Keyed modulations are considered. The general formulas of the average bit error probability are derived. The calculation results are summarized and analyzed. The average bit error probability is highly dependent on the relative location of interferences to the desired link, the time duty factor of the hopping and the number of available channels.