• 제어로봇시스템학회:학술대회논문집
• /
• 제어로봇시스템학회 2004년도 ICCAS
• /
• pp.439-443
• /
• 2004

In this research, we describe the sorting conditions modeling by friction force. As in any mechanism which is required to provide good dynamic performance and high accuracy, performance evaluation of optimal control. To understand friction it is necessary to investigate the topography of the sliding surfaces in contact. Any surfaces, even apparently smooth surfaces, are microscopically rough. When two surfaces come into contact, the true contact takes place only at point where asperities come together. The sorting conditions of sorting mechanism with friction force is sorting force must be equal with force can sorting one highest veneer among loaded veneer. This is just a thing being sorted veneer have friction with under veneer and this friction disturb sorting at the same time. Hence, the sorting conditions evaluation is important to sorting one veneer must get under control friction with veneer.

• 자원리싸이클링
• /
• 제30권4호
• /
• pp.3-10
• /
• 2021

도시광산의 대표적인 사례인 폐 전자부품 재활용 분야는 유용한 선별기술의 개발이 필요하다. 본 연구에서는 전자부품들을 4개의 그룹으로 선별하기 위해 딥러닝에 의한 이미지 식별을 기반으로 한 선별기를 개발하였다. 전자부품들은 폐 인쇄회로기판으로부터 회수되었으며, 처리 후 차이점에 따라 분리되어야 한다. 선별기는 GPU, 카메라, 컨베이어벨트, 공기 압축기로 이루어진 워크스테이션으로 구성되어있다. 컨베이어벨트(벨트 속도: 6cm/s) 위에 있는 작은 크기(3.5cm 이하)의 전자부품들을 데이터로 가져와 학습했다. 이미지 식별의 정확도는 종류에 따라 96%, 그리고 그룹에 따라 99%였다. 벨트속도와 압축공기의 블로다운 시간과 같은 작동조건에 변화를 주었을 때, 이미지 식별의 정확도 그리고 블로다운에 의한 회수율을 측정하여 선별의 최적 조건을 결정했다. 최적조건에서 이미지 분류의 정확도는 그룹별로 98.7%였다. 선별 효율은 70% 이상이었다.

• 한국수자원학회논문집
• /
• 제49권1호
• /
• pp.73-81
• /
• 2016

본 연구에서는 식생에 의한 하도 변화와 하상토 분급특성을 파악하였다. 유사의 유출 특성은 불규칙하며, 식생 밀도가 증가함에 따라 유출되는 유사량은 감소하였다. 하상고는 불규칙하게 변하며, 하상토 표층에서 유사 입경은 작아졌다. 식생 밀도가 증가함에 따라 하상 표층에서 무차원 중 앙입경의 비는 감소하였다. 식생대에서 유사가 포착되거나, 식생대와 주흐름 사이에 경계층 흐름이 발생하여 유사가 퇴적되며, 식생대에서 흐름의 방향이 변화되어 표층에서 하상토 입도는 불규칙하게 분포하였다. 무차원 하상토 입경이 감소함에 따라, 차폐효과는 일정하게 감소하였다. 식생밀도가 증가함에 따라 하상 표층에서 차폐효과가 증가하며, 이것은 실험 수로 하류단에서 유사 유출량이 감소하는 것과 일치한다. 식생 밀도가 $0.5stems/cm^2$에서 저수로 이동은 감소하고 안정적인 특성을 보여주었으나, $0.7stems/cm^2$에서 저수로 이동은 증가하였다. 이것은 식생 밀도가 증가하면서 저수로 사행도가 증가하고, 식생대에서 유사가 퇴적되어 새로운 저수로가 형성되었기 때문이다.

• 한국생산제조학회지
• /
• 제24권2호
• /
• pp.211-216
• /
• 2015

Recently, because of the growth in the leisure industry and interest in health, the demand for bicycles has increased. In this research, considering the vertical load on a bike frame under static state conditions, the deflection and mass of the bike frame were minimized by satisfying the service condition and performing optimization. The thickness of the bicycle-frame tube was set to a design variable, and its sensitivity was confirmed by an analysis of means (ANOM). To optimize the solution, a response-surface-method (RSM) model was constructed using D-Optimal and central composite design(CCD). The optimization was performed using a non-dominant sorting genetic algorithm (NSGA-II), and the optimal solution was verified by finite-element analysis.

• 수산경영론집
• /
• 제45권2호
• /
• pp.85-95
• /
• 2014

Fish stocking is important element of land-based aquaculture management. To maintain constant stocking rate considering biological and economic condition is a convenient strategy in intensive aquaculture. This study is aimed to analyze the effect of over-stocking(more than aquaculture capacity) for certain periods of time. This study make the mathematical decision making model that finds the value of decision variable to minimize cost that sums up the water pool usage cost and sorting cost under critical standing corp constraint. The proposed mathematical decision making model was applied to 12 sample combination of sorting cost and the number of fish on the Oliver flounder culture farms. If a immature fish can be sold for high price than farming cost, restricted over-stocking resulted in a improvement of economic performance. When extensive comparable biological and market data become available, analysis model can be widely applied to yield more accurate results.

• 한국작물학회지
• /
• 제53권4호
• /
• pp.434-439
• /
• 2008

The amount of salt to make seed sorting solution of the specific gravity of 1.13 was reconsidered and determined as 3.8 kg salt in 18 L water, which is lower amount than currently used. Five rice cultivars were examined. Percent germination and seedling emergence were not similar. Seedling emergence rate of Japonica varieties, Nampyungbyeo and Daerypbyeo-1 were 87% and 95% under specific gravity of 1.13, respectively. Seedling emergence rate of Tongil type variety, Dasanbyeo was as high as 67% in specific gravity of 1.06. Seedling emergence rate of waxy rice, Hwasunchalbyeo and Aranghangchalbyeo were examined. Seedling emergence rate was 94% in both cultivars in specific gravity of 1.04. Seedling emergence rate was same in specific gravity of 1.08 which is generally used for selecting seed currently. Early growth (plant height, leaf number, and dry weight) were not significantly different by specific gravity within species. In all cultivars except waxy rice, highest seedling emergence rate was observed in specific gravity of 1.13 which is currently used for selection and decreased as specific gravity is lowed. However, considering total amount of seeds in each group of specific gravity, amount of seed in lower specific gravity group is relatively small and total seedling emergence rate within variety dose not show big difference. However, if seeds with low speicific gravity are produced due to the bad grain filling condition and consequently total seed content of low specific gravity increases, results will be differnt. Reduction in total growth and yield could occur. It will be important to comply with the seed sorting criterion of 1.13 for Japonica, 1.06 for Tongil, and 1.04 for waxy rice variety to ensure the maximum rice growth and yield.

• 한국유기농업학회지
• /
• 제16권3호
• /
• pp.239-258
• /
• 2008

This study identifies the spectrum of different forms of sharing labor in farm houses following the increase in the production of organic produce and deals with the gender division of labor and every day life of the farm households. The increased labor burdens of organic farming give more work opportunities to wives, weakening the gender barriers. However, some of the farm households seeking for economic feasibility are strengthening the gender barriers by specialized work divisions, leading to outside order labor of harvest, sorting, and packaging in order to increase efficiency in agricultural management in extreme cases. Even in the alternative distribution system, farm households has become subject to the distribution system as it is shown that coop claimed the segmentation of sorting work. This is because the convenience of the customers goes before the advantages of producers. Jinju, seeking for economic feasibility, has established the springboard for growth by greenhouse through monoculture and specialization and are operating economic growth stably. Farm couples with this condition, where their incomes are relatively high, are attempting to recharge their energy during low seasons. It is expected that this will be a model case of conventionalization of organic farming. Significance of organic farming in this matter is discussed.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2007년도 추계학술대회논문집
• /
• pp.702-707
• /
• 2007

A Color Discerning Device(CDD) is the equipment to use in a Rice Processing Complex(RPC). A CDD can sorting discolored grain according to light and shade. The existing a CDD's driving performance is not so good as overseas machine. Besides, transportation process causes a defect in the mechanism from impact or harmonic excitation or etc. This study is represented the problem of CDD through experiment and simulation on a CDD. To analysis the problem of driving condition, devide each part of CDD for performed modal analysis. The problem of driving of driving condition and transportation process solved by carry out modal analysis and static analysis.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2006년도 추계학술대회논문집
• /
• pp.571-576
• /
• 2006

A Color Discerning Device(CDD) is the equipment to use in Rice Processing Complex(RPC). By use a high-speed charge-coupled device camera, CDD can sorting discolored grain according to light and shade. The existing CDD's driving performance is not so good as overseas machine. Besides, transportation process causes a defect in the mechanism from impact or harmonic excitation or etc. This study is represented the problem of CDD through modal analysis and static analysis by using ANSYS workbench. To analysis the problem of driving condition, devide each part of CDD for performed modal analysis. The problem of driving condition and transportation process solved by carry out modal analysis and static analysis.

• 한국세라믹학회지
• /
• 제51권2호
• /
• pp.132-137
• /
• 2014

The study was performed with low-grade limestone, which is used to make cement or is disposed of due to its low CaO content. In this study, the optimal condition of limestone with which to manufacture precipitated calcium carbonate (PCC) and limestone in fiber was determined through in-situ reactions. The best firing condition is with slaked lime with rapid cooling after 2 h of firing at $1000^{\circ}C$. In addition, the content of CaO can be increased by sorting the low-grade limestone using a 200 mesh filter, and the optical quality of old newspaper (ONP) was similar when using both low-grade and high-grade limestone. Also, controlling the particle size of PCC is an important factor pertaining to the optical characteristics of paper.