• 한국전산유체공학회:학술대회논문집
• /
• 2005.10a
• /
• pp.31-34
• /
• 2005

This article has investigated the spatial distribution of the solid particles in polymerization reactors using CFD analysis (FLUENT v. 6.2.1). The suspension of the solids in stirred reactors is affected by a number of parameters including particle diameter, vessel shape, impeller size, impeller speed, and rotating direction of stirrer. The degree of solids suspension in the vessel was quantified with a statistical average value, ${\sigma}^2$. The best stirring conditions were determined based on ${\sigma}^2$, which was found to depend on the vessel bottom shape.

• Journal of Korea Soil Environment Society
• /
• v.2 no.3
• /
• pp.23-30
• /
• 1997

The purpose of this study was to evaluate effects of solids content and mixing speed in treatment of petroleum hydrocarbon contaminated soils using a slurry-phase bioreactor. Performance results on slurry-phase bioremediation of diesel fuel contaminated soil were generated at the bench-scale level. The fate of TPH(Total Petroleum Hydrocarbon) was evaluated in combination with biological treatment. Abiotic and biotic fate of the TPH were determined using soil not previously exposed to compounds in diesel fuel. The reactor volume for given throughput can be reduced by maximizing the solids content. Applications of 50% and 20% solids content(dry weight basis) were showed a little difference(57.5% : 61.6%) in biological TPH removal rate each other. Mixing and particle suspension are critical to desorption and biological degradation. In this standpoint, this study was performed using two mixing speed. When the reactor was operated at 70rpm, it had a better result in the particle suspension and TPH removal rate than the reactor with mixer rotated at 20rpm. In the reactor applied 20rpm, it was resulted in failure of particle suspension.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2011.11a
• /
• pp.745-749
• /
• 2011

Two-dimemsional liquid-solid multiphase fluid dynamics was used to analyze the suspension and mix of liquid fuel and solid particles in fuel tank installed mixing impeller. In this paper, the multiphase flow was modeled using Eulerian Grandular Multiphase model. Experimental measurements of the axial distribution of solids concentration in stirred tanks under 12vol% solid loading were used for comparison with the CFD simulation. Four cases for the impeller location and flow pumping direction also were reviewed under 10.5% solids loading and 700rpm in fuel mix tank. The result of quality of suspension was compared with each cases and the impeller location and operation of mixing fuel tank was established.

• Journal of Practical Agriculture & Fisheries Research
• /
• v.23 no.2
• /
• pp.33-41
• /
• 2021

The effect of homogenization treatment on the suspension stability of makgeolli was evaluated. The non-soluble solids of makgeolli that were not homogenized were precipitated at 1.0-68 mm after 10 minutes of standing and 2.0-70.5 mm after 30 minutes of standing. On the other hand, in the makgeolli homogenized with a blender for more than 20 seconds, no precipitated non-soluble solids were observed during the initial 10 minutes, and when it was left still for 30 minutes, it showed precipitation of 2.0 mm (control 58.0 mm). The makgeolli treated with a high-pressure homogenizer did not show any sedimentation until 30 minutes of standing. In the sensory evaluation, the high-pressure homogenized makgeolli had a score of 3.93, whereas non-treated had a score of 2.80, which was improved by 40% by homogenization.

• Korean Journal of Food Science and Technology
• /
• v.25 no.5
• /
• pp.589-591
• /
• 1993

Effects of enzymatic hydrolysis of polysaccharides with using three commercial mixed enzymes (Ultrazyme, Celluclast, Viscozyme) were investigated on supernatant ratio, solid yields and viscosity of sea mustard extracts. The result showed that enzymatic hydrolysis prior to extraction increased the solids concentration up to 27.3% and the solids yield up to 14.0%. However the supernatant ratio after centrifugation of the sea mustard suspension was rather reduced. The viscosity of the extracts was significantly increased during initial enzymatic hydrolysis.

• Journal of Mechanical Science and Technology
• /
• v.14 no.10
• /
• pp.1159-1167
• /
• 2000

Particles in liquid-solid suspension flow might enhance or suppress the rate of heat transfer and turbulence depending on their size and concentration. The heat transfer characteristics of liquid-solid suspension in turbulent flow are not well understood due to the complexibility of interaction between solid particles and turbulence of the carrier fluid. In this study, the heat transfer coefficients of liquid-solid mixtures are investigated using a double pipe heat exchanger with suspension flows in the inner pipe. Experiments are carried out using spherical fly ash particles with mass median diameter ranging from 4 to $78{\mu}m$. The volume concentration of solids in the slurry ranged from 0 to 50% and Reynolds number ranged from 4,000 to 11,000. The heat transfer coefficient of liquid-solid suspension to water flow is found to increase with decreasing particle diameter. The heat transfer coefficient increases with particle volume concentration exhibiting the highest heat transfer enhancement at the 3% solid volume concentration and then gradually decreases. A correlation for heat transfer to liquid-solid flows in a horizontal pipe is presented.

• Proceedings of the Korean Geotechical Society Conference
• /
• 1992.10a
• /
• pp.65-68
• /
• 1992

In characterizing a suspension, heterogenety is included onto the previous characterization using solids concentrations and flocculent characteristics, because of its importance in hydrodynamics. The mechanism of interface formation during the sedimentation of concentrated suspension (thickening) is investigated from a microcosm consisting of four particles in a same plane and a smaller particle below. The critical distances after shich interface forms are calculated as a function of particle size ratio when the small particle is located in the middle of the squre datermined by the large particles. The results shows that the critical separation distance increase as the size ratio approaches to one (homogeneous suspension). This conforms to the trend of existing observations that homogeneous suspensions create the solid-liquid interface at much lower concentration (at al larger separation distance) that the heterogeneous suspensions.

• Journal of the Korean Ceramic Society
• /
• v.41 no.9
• /
• pp.647-652
• /
• 2004

In aqueous tape casting of alumina slurry systems, the relationships between the suspension compositions and the defects of the dried tapes were discussed. The suspensions compositions were controlled with the ratios of the solids, water and organics binder contents. The effects of the thickness of dried tape and kinds of binder system were also examined. In the defect free region, the apparent viscosity showed nearly same value due to the count balancing effect of solid and organic binder content on the apparent viscosity. When water content was constant, increasing solid led to decrease of organic binder content. The defect free region was narrowed with increasing of casting thickness. When linear type acrylic emulsion binders system (D1000 and D 1035) were used, defect free zone formed the belt type in the triangle of solid, water and organic binder content according to the line of constant water contents. However the defect free region was not found in the cross-link type emulsion binder system (D 1050).

• Current Research on Agriculture and Life Sciences
• /
• v.32 no.4
• /
• pp.211-214
• /
• 2014

This study investigated the effects of using a pollen suspension for artificial pollination on the labor costs, fruit set, and fruit quality attributes of 'Fuji' apples. The pollen germination rate was 20% in a 20% fructose solution after 6 hours, and the pollen remained stable for 6 hours in the same solution. The king fruit per flower cluster exhibited a normal fruit set, regardless of the treatment. Plus, none of the artificial pollination applications affected the fruit length/diameter ratio, flesh firmness, soluble solids concentration, or titratable acidity in the harvested 'Fuji' apple fruits. However, the labor savings were significantly higher with the pollen suspension treatment when compared with the cotton swab or love-touch. Therefore, the labor cost was four-fold less in use of pollen suspension than in use of cotton swab for artificial pollination.

• Korea-Australia Rheology Journal
• /
• v.15 no.1
• /
• pp.9-17
• /
• 2003

The rheological behaviour of anatase $TiO_2$ with organic coating has been investigated extensively in this study. The yield stress was measured over a wide range of solids concentration and pH using stress-controlled and speed-controlled rheometers. The organic treatment leads to a shift of the isoelectric point (IEP) from around pH 5.5 to pH 2.4. A maximum yield stress occurs in the vicinity of the isoelectric point determined by electrokinetic measurements. The transition of rheological behaviour between elastic solid and viscous liquid is represented by a stress plateau in a plot of stress against strain. It is hypothesised that the slope of the stress plateau reflects the uniformity of the structure, and hence the distribution of bond strength. Altering the concentration and the surface chemistry can vary the bond strength and its distribution. therefore, resulting in different type of failure: "ductile-type" or "brittle-type". pH and volume fraction dependence of yield stress could be described quantitatively using existing models with reasonable agreement.easonable agreement.