• Current Photovoltaic Research
• /
• v.7 no.4
• /
• pp.111-120
• /
• 2019

The output power of a crystalline silicon (c-Si) photovoltaic (PV) module is not directly the sum of the powers of its unit cells. There are several losses and gain mechanisms that reduce the total output power when solar cells are encapsulated into solar modules. Theses factors are getting high attention as the high cell efficiency achievement become more complex and expensive. More research works are involved to minimize the "cell-to-module" (CTM) loss. Our paper is aimed to focus on electrical losses due to interconnection and mismatch loss at PV modules. Research study shows that among all reasons of PV module failure 40.7% fails at interconnection. The mismatch loss in modern PV modules is very low (nearly 0.1%) but still lacks in the approach that determines all the contributing factors in mismatch loss. This review paper is related to study of interconnection loss technologies and key factors contributing to mismatch loss during module fabrication. Also, the improved interconnection technologies, understanding the approaches to mitigate the mismatch loss factors are precisely described here. This research study will give the approach of mitigating the loss and enable improvement in reliability of PV modules.

• Journal of the Korean earth science society
• /
• v.29 no.5
• /
• pp.408-418
• /
• 2008

In this study, solar eclipse records were investigated during the Three Kingdoms era of ancient Korea using astronomical calculations and numerical simulations. Under the condition that the solar eclipses were actually observed at the well known capitals of the Three Kingdoms, I investigated the probabilities that the optimal observation areas of the Early Silla, Goguryeo, and Baekje records would appear around Chinese continent. I found higher probabilities than those suggested by Park and La (1994), although the numerical values are still low, especially in the case of the Early Silla records. On the other hand, the probability that the optimal observation area of the Later Silla records will be present around South Korea is only 13.6%, although the area shows a good match with the known capital. I also analyzed the number distribution of the eclipse records for the Three Kingdoms (except for the latter Silla's) according to the observers' locations: at the optimal observation areas and at the known capitals. And then I compared with the number distribution of all eclipses observable from those locations. From the $\chi^2$-test, I found that the Goguryeo and Baekje records had better representation of their population distributions at the latter regions ($\chi^2$=27.93 and 205.5) than at the former ones ($\chi^2$=34.19 and 211.5). Therefore, it is difficult to conclude that the observers' locations during the Three Kingdoms period were either near China, as suggested by Park and La, or in the Korean peninsula, solely based on these results. It is thus recommended that more studies are required to confirm the real observers' locations during the Three Kingdoms era.

• The Journal of the Korea Contents Association
• /
• v.18 no.7
• /
• pp.656-664
• /
• 2018

The following study was conducted to determine the optimal location in terms of efficiency for solar energy facilities, and to propose a policy implications for the orientation of the installments. 92 cases in Jeollanam-do Province were selected. A regression analysis was performed between the average electricity generation time as the dependent variable, and the facility, weather and site conditions as the independent variables. As a result, 5 variables were deemed significant. Larger site areas, closer proximity to rivers, islands, oceans, etc., least south-oriented, higher average wind speed, and facilities in agricultural land use and natural environment conservation land use had the highest efficiency. This study minimized the possibility of secure databases and errors following facility types, and was limited in the number of sites studied, since this was only conducted in Jeollanam-do Province. Nevertheless, these conclusions still offer important policy implications for determining the most optimal location for solar energy facilities.

• Journal of The Korean Astronomical Society
• /
• v.50 no.4
• /
• pp.125-129
• /
• 2017

We investigate the solar cycle variation of microwave and extreme ultraviolet (EUV) intensity in latitude to compare microwave polar brightening (MPB) with the EUV polar coronal hole (CH). For this study, we used the full-sun images observed in 17 GHz of the Nobeyama Radioheliograph from 1992 July to 2016 November and in two EUV channels of the Atmospheric Imaging Assembly (AIA) $193{\AA}$ and $171{\AA}$ on the Solar Dynamics Observatory (SDO) from 2011 January to 2016 November. As a result, we found that the polar intensity in EUV is anti-correlated with the polar intensity in microwave. Since the depression of EUV intensity in the pole is mostly owing to the CH appearance and continuation there, the anti-correlation in the intensity implies the intimate association between the polar CH and the MPB. Considering the report of Gopalswamy et al. (1999) that the enhanced microwave brightness in the CH is seen above the enhanced photospheric magnetic field, we suggest that the pole area during the solar minimum has a stronger magnetic field than the quiet sun level and such a strong field in the pole results in the formation of the polar CH. The emission mechanism of the MPB and the physical link with the polar CH are not still fully understood. It is necessary to investigate the MPB using high resolution microwave imaging data, which can be obtained by the high performance large-array radio observatories such as the ALMA project.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2016.05a
• /
• pp.743-744
• /
• 2016

Due to the many amenities of a modern power with solar power and green energy alternative to injury by cutting down on the number of solar energy and pollution and environmental factors. There is still much research and trying to incorporate a variety of applications. In this paper, create a daytime energy by fusing solar panels and billboards, and at night has the advantage that you can save more energy used to sign by the sign serves also and at the same time energy acts like a tent when the day by using the power usage is expected to be higher.

• Current Photovoltaic Research
• /
• v.12 no.2
• /
• pp.37-40
• /
• 2024

One of the current innovation trends in the solar industry is the increase in the size of silicon wafers. As the wafer size increases, the series resistance of the module rises, highlighting the need for research on methods for cutting and bonding solar cells. Among these, the Infrared (IR) laser scribing technique has been extensively researched. However, there is still insufficient optimization research regarding the thermal damage caused by lasers on the Transparent Conductive Oxide (TCO) layer of Heterojunction (HJT) solar cells. Therefore, in this study, we systematically varied conditions such as IR laser scribing speed, frequency, power, and the number of scribes to investigate their impact on the performance of cut cells under each condition. Additionally, we conducted a comparative analysis of thermal damage effects on the TCO layer based on varying scribing depths.

• Journal of the Microelectronics and Packaging Society
• /
• v.27 no.4
• /
• pp.55-60
• /
• 2020

The PERC photovoltaic (PV) modules installed in PV power plant are still reports potential-induced degradation (PID) degradation due to high voltage potential differences. This is because Na+ ions in the cover glass of PV modules go through the encapsulant (EVA) and transferred to the surface of solar cells. As positive charges are accumulated at the ARC (SiOx/SiNx) interface where many defects are distributed, shunt-resistance (Rsh) is reduced. As a result, the leakage current is increased, and decrease in solar cell's power output. In this study, to prevent of this phenomenon, a Moth-eye nanostructure was deposited on the rear surface of an optical film using Nano-Imprint Lithography method, and a solar mini-module was constructed by inserting it between the cover glass and the EVA. To analyze the PID phenomenon, a cell-level PID acceleration test based on IEC 62804-1 standard was conducted. Also analyzed power output (Pmax), efficiency, and shunt resistance through Light I-V and Dark I-V. As a result, conventional solar cells were decreased by 6.3% from the initial efficiency of 19.76%, but the improved solar cells with the Moth-eye nanostructured optical film only decreased 0.6%, thereby preventing the PID phenomenon. As of Moth-eye nanostructured optical film, the transmittance was improved by 4%, and the solar module output was improved by 2.5%.

• Korean Journal of Agricultural and Forest Meteorology
• /
• v.16 no.4
• /
• pp.297-303
• /
• 2014

The effect of solar irradiance has been used to estimate daily maximum temperature, which make it possible to reduce the error inherent to lapse-rate based elevation difference correction in mountainous terrain. Still, recent observations indicated that the effect of solar radiation would need correction for estimation of daily maximum temperature. It was attempted to examine what would cause the variability of solar irradiance effect in determination of daily maximum temperature under natural field conditions and to suggest improved methods for estimation of the temperature distribution over mountainous regions. Temperature at 1500 and the wind speed for 1100 to 1500 were obtained at 10 validation sites with various topographical features including slope and aspect within a mountainous $50km^2$ catchment for 2012-2013. Lapse-rate corrected temperature estimates on clear days were compared with these observations, which would represent the differential irradiance effect among sloped surfaces. Results indicated a negative correlation between the mean wind speed and the estimation error. A simple scheme was derived from relationship between wind speed and estimation error for daily temperature to correct the effect of solar radiation. This scheme was incorporated into an existing model to estimate daily maximum temperature based on the effect of solar radiation. At 10 validation sites on clear days, estimates of 1500 LST temperature with and without the correction scheme were compared. It was found that a substantial improvement was achieved when the correction scheme was applied in terms of bias correction as well as error size reduction at all sites.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2016.02a
• /
• pp.154.2-154.2
• /
• 2016

In this work, we introduce a solution-processed CdS interlayer for use in inverted bulk heterojunction (BHJ) solar cells, and compare this material to a series of standard organic and inorganic cathode interlayers. Different combinations of solution-processed CdS, ZnO and conjugated polyelectrolyte (CPE) layers were compared as cathode interlayers on ITO substrates to construct inverted solar cells based on $PTB7:PC_{71}BM$ and a $P3HT:PC_{61}BM$ as photoactive layers. Introduction of a CdS interlayer significantly improved the power conversion efficiency (PCE) of inverted $PTB7:PC_{71}BM$ devices from 2.0% to 4.9%, however, this efficiency was still fairly low compared to benchmark ZnO or CPE interlayers due to a low open circuit voltage ($V_{OC}$), stemming from the deep conduction band energy of CdS. The $V_{OC}$ was greatly improved by introducing an interfacial dipole (CPE) layer on top of the CdS layer, yielding outstanding diode characteristics and a PCE of 6.8%. The best performing interlayer, however, was a single CPE layer alone, which yielded a $V_{OC}$ of 0.727 V, a FF of 63.2%, and a PCE of 7.89%. Using $P3HT:PC_{61}BM$ as an active layer, similar trends were observed. Solar cells without the cathode interlayer yielded a PCE of 0.46% with a poor $V_{OC}$ of 0.197 V and FF of 34.3%. In contrast, the use of hybrid ZnO/CPE layer as the cathode interlayer considerably improved the $V_{OC}$ of 0.599 V and FF of 53.3%, resulting the PCE of 2.99%. Our results indicate that the CdS layer yields excellent diode characteristics, however, performs slightly worse than benchmark ZnO and CPE layers in solar cell devices due to parasitic absorption below 550 nm. These results suggest that the hybrid inorganic/organic interlayer materials are promising candidates as cathode interlayers for high efficiency inverted solar cells through the modification of interface contacts.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.43 no.7
• /
• pp.1048-1054
• /
• 2014

The purpose of this study was carried out to investigate the cause of sulfur dioxide occurrence, general element composition, sulfur compounds, heavy metals, macro- & micro-minerals, and oxidation-reduction potential (ORP) following baking time course of RS (RS1, RS2, RS3, and RS4) and mudflat solar salts (MSS). Sulfur dioxide ($SO_2$) and sulfite ($SO{_3}^{2-}$) were not detected in MSS or RS. However, sulfate ($SO{_4}^{2-}$) content significantly decreased in RS (29,878.15~36,097.45 ppm) compared to that in MSS (35,601.65 ppm). ORP was 181.15 mV in MSS, and 58.55 mV in RS1. Moisture content was 9.34% in MSS and 0.00% in RS with increased NaCl (94.77~95.77%). Moisture and NaCl contents showed no significant difference in RS. Insoluble and sandy residues were higher in RS than in MSS, whereas Ca and K showed no significant difference. Mg and Cl contents were higher in RS than in MSS. Br level was higher in MSS (628.1 ppm) than in RS (512.72~586.62 ppm), but there was no significant difference in $NO_3$. Heavy metals (Pb, As, and Hg) were more abundant in RS than in MSS, but levels were still safe. These results suggest that MSS and RS may increase protection against from $SO_2$ and $SO{_3}^{2-}$.