• Journal of the Korean GEO-environmental Society
• /
• v.10 no.7
• /
• pp.125-133
• /
• 2009

Wastewater sludge had normally filled up in land before revising the law of waste material management in 2003, which does not permit landfill of organic sludge in Korea. After the law, most sludge has been littered in the ocean up to now. However, due to the London Convention 96 Protocol, littering sludge in the ocean will also be prohibited after 2011. This Protocol makes countries find out new methods to treat wastewater sludge. There is no exception in Korea too. Many researchers have urgently try to find out better ways to treat sludge. One of ways is to make sludge recycle energy and the success of it depends on drying method. Specifically, it really depends how to make sludge dry ecologic friendly and economic efficiently. Therefore, wastewater sludge produced in Youngdong was analyzed to make it energy resources in this study. The sludge was tested to analyze the drying and chemical characteristics of it by irradiating microwave. In the result, it is sure that the sludge has little heavy metals as like as others in country side. High calories, 3370 Kcal, shows that it has good potential to be recycle energy. Moreover, weight deduction of the sludge vs. time shows long S-curve and has same deduction ratio. Specifically, S-curve can be divided by three sections based on the curvature points. There are steady state reduction ratio of weight and approximately 80% of weight duction in the second section. This results can be used to estimate the amount of sludge reduction in the full-scale microwave dryer. Drying capacity of microwave shows approximately 1.0 kg/kw/hr. It makes sure that sludge recycle energy has the potential of economic efficiency too.

• Journal of Korean Society on Water Environment
• /
• v.26 no.5
• /
• pp.810-815
• /
• 2010

Ultrasonic sludge pre-treatment has been studied to enhance the performance of anaerobic digestion by increasing sludge hydrolysis which is regarded as the rate-limiting-step of anaerobic digestion. In this study, the effect of ultrasonic pre-treatment on sludge hydrolysis (solubilization) and methane production was investigated. Sludge solubilization efficiency increased with ultrasonic energy input. However, it is uneconomical to apply more than 720 kJ/L as the solubilization efficiency per energy input declines afterwards. Volatile fatty acids concentration increased after the ultrasonic sludge hydrolysis. Anaerobic batch digestion showed that methane volume reached 64.7 and 84.5 mL after 18 days of incubation with the control sludge and ultrasonically hydrolyzed sludge, respectively. Methane production potential, maximum methane production rate, and the lag time of modified Gompertz equation were changed from 70 mL, 6.4 mL/day, and 1.2 days to 89 mL, 9.6 mL/day, and 0.5 day, respectively, after the ultrasonic sludge treatment. The results proved that ultrasonic pre-treatment contributed significantly not only for the methane production but also for the reduction of anaerobic digestion time which is critical for the performance of anaerobic sludge digestion.

• Journal of Environmental Health Sciences
• /
• v.37 no.6
• /
• pp.467-473
• /
• 2011

Objectives: Wastewater treatment plants typically produce a large volume of waste sludge. In this study, the conditioning and dewatering properties of a digested and thickened sludge from an industrial wastewater treatment plant were investigated in order to improve the dewaterbility of the sludge. Methods: Jar-tests and Buchner funnel tests were carried out to assess the conditioning and dewatering properties of a waste sludge. TTF (Time to Filter Test) and SRF (Specific Resistance to Filtration) were adopted as the indices of sludge dewaterbility. Results: The valuation indices influencing the dewaterbility of the waste sludge, including TTF, SRF, water contents, VS/TS ratio and turbidity, were measured. The TTF and SRF of the digested and thickened sludge were decreased to 40 sec, $3.43{\times}10^{12}$ m/kg, and 39 sec, $1.09{\times}10^{12}$ m/kg, respectively. Conclusions: The conditioner composed of natural inorganic materials turned out to be effective in the reduction of sludge water contents.

• Environmental Engineering Research
• /
• v.19 no.1
• /
• pp.59-66
• /
• 2014

The aim of this study was to assess the effect of pre-aeration on sludge solubilization and the behaviors of nitrogen, dissolved sulfide, sulfate, and siloxane. The results of this study showed that soluble chemical oxygen demand in sewage sludge could be increased through pre-aeration. The pre-aeration process resulted in a higher methane yield compared to the anaerobic condition (blank). The pre-aeration of sewage sludge, therefore, was shown to be an effective method for enhancing the digestibility of the sewage sludge. In addition, this result confirms that the pre-aeration of sewage sludge prior to its anaerobic digestion accelerates the growth of methanogenic bacteria. Removal rates for $NH_3$-N and T-N increased simultaneously during pre-aeration, indicating simultaneous nitrification and denitrification. The siloxane concentration in sewage sludge decreased by 40% after 96 hr of pre-aeration; in contrast, the sulfide concentration in sewage sludge did not change. Therefore, pre-aeration can be employed as an efficient treatment option to achieve higher methane yield and lower siloxane concentration in sewage sludge. In addition, reduction of nitrogen loading by pre-aeration can reduce operating costs to achieve better effluent water quality in wastewater treatment plant and benefit the anaerobic process by minimizing the toxic effect of ammonia.

• Journal of Microbiology and Biotechnology
• /
• v.29 no.9
• /
• pp.1434-1443
• /
• 2019

Although chemical oxygen demand (COD) is an important issue for wastewater treatment, COD reduction with microalgae has been less studied compared to nitrogen or phosphorus removal. COD removal is not efficient in conventional wastewater treatment using microalgae, because the algae release organic compounds, thereby finally increasing the COD level. This study focused on enhancing COD removal and meeting the effluent standard for discharge by optimizing sludge inoculation timing, which was an important factor in forming a desirable algae/bacteria consortium for more efficient COD removal and higher biomass productivity. Activated sludge has been added to reduce COD in many studies, but its inoculation was done at the start of cultivation. However, when the sludge was added after 3 days of cultivation, at which point the COD concentration started to increase again, the algal growth and biomass productivity were higher than those of the initial sludge inoculation and control (without sludge). Algal and bacterial cell numbers measured by qPCR were also higher with sludge inoculation at 3 days later. In a semi-continuous cultivation system, a hydraulic retention time of 5 days with sludge inoculation resulted in the highest biomass productivity and N/P removal. This study achieved a further improved COD removal than the conventional microalgal wastewater treatment, by introducing bacteria in activated sludge at optimized timing.

• Journal of Digital Convergence
• /
• v.10 no.10
• /
• pp.221-227
• /
• 2012

In Korea, ocean dumping has been widely used as the ultimate disposal of sewage sludge. However, ocean dumping of food wasted and sewage sludge from 2013 is expected to legally restricted as London convention on marine pollution prevention has been effective in 2009. This research aims to examine the effect of HEAS in treating the environmental pollution load caused by organic high concentrated sludge. Thus, onsite laboratory scale treatability test using HEAS was adopted to treat the high concentrated organic sludge from sewage and industrial wastewater treatment plant. The research results showed that the HEAS is useful to reduce the environmental pollution caused by organic high concentrated sludge. Specific results are as follows. 1. The organic removal after the sludge digestion using the high efficiency aeration system was 55.2-85.8%. Although these results were lower than those from the general sewage treatment, the high efficiency aeration system could be evaluated as efficient, considering the object sludge contained the industrial waster water. 2. The average removal efficiency was about 25.2%. 3. It was revealed that sludge digestion by the high efficiency aeration system could effectively contribute to the sludge treatment cost. Especially, the high efficiency aeration system is more applicable to the onsite treatment of small sewage and wastewater treatment plant that contains high solid content sludge, industrial wastewater sludge, high fixed solid sludge.

• Journal of Advanced Marine Engineering and Technology
• /
• v.25 no.5
• /
• pp.1098-1107
• /
• 2001

This study is to develop the pretreatment for the excess and digested sludge by elector-coagulation and dewatering. Electrocoagulation is applied to excess and digested sludge before transferring to the pistion type for dewatering. Piston type filter press as a laboratory scale plant was used to estimate the dewaterability. MMD of excess sludge was increased from initial diameter of particles ($34.16{\mu}m$) to the 87%($64.01{\mu}m$) after electrocoagulation. Al electrode is more effective than Fe electrode for the dewaterabiltity of excess sludge Electrodewatering after electrocoagulation as pretreatment makes the water content of sludge cake 50~60 wt%.

• Environmental Sciences Bulletin of The Korean Environmental Sciences Society
• /
• v.3 no.3
• /
• pp.169-175
• /
• 1999

2,4-Dinitrophenol(DNP) is a metabolic uncoupler that prevents cells from creating energy for growth and it has been suggested that the availability of sodium ions may be important in mitigating the effects of uncouplers. Accordingly, the degradation of DNP was investigated using activated sludge which had been adapted to mineralize DNP. After the acclimation of the activated sludge, the effect of sodium ions on the toxicity of high concentrations(80 to 100mg/L) of DNP was investigated over a sodium ion concentration range of 9.3$\times$10-5 to 94mM. The concentration of sodium ions in the activated sludge mixed liquor seemed to have little effect on the DNP toxicity. However, a lack of sodium in the grwoth media resulted in a reduction of the DNP degradation rate by a bacterial isolate from the activated sludge culture identified as Nocardia asteroides.

• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2012.05a
• /
• pp.85-86
• /
• 2012

This application plan is hasty prepared with the actual condition in which the majority is reclaimed by the waste with the marine and the polysilicon sludge, that is the main raw material of the solar pannel support, does. In this research, by using OPC and Fly ash, the applicability as the blending material of the polysilicon sludge was analyze and it tried to contribute to the waste reduction afterward. The replacement ratio of the sludge was set to 5. 10, 15, 20(%) with the experiment based on the based test result and the air flow rate, liquidity, flexural strength, and compressive strength was measured. The liquidity was reduced in spite of as the replacement ratio of the sludge increased and the air flow rate increased.

• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2018.05a
• /
• pp.265-266
• /
• 2018

In recent years, active loess cement has been used instead of cement in order to reduce the amount of cement and industrial byproducts that are the main cause of environmental pollution. We also used polysilicon sludge as a by-product to reduce the amount of cement used and to improve the environmental pollution due to the reduction of carbon dioxide. Polysilicon is a raw material used in the production of panels for solar power generation. When producing 1 ton of polysilicon, 2 tons of sludge is generated. It is an experiment to reduce sludge treatment and cement usage. This study analyzed basic characteristics of polysilicon sludge and active loess cement according to replacment ratio.