• Journal of the Korean Geophysical Society
• /
• v.5 no.3
• /
• pp.219-231
• /
• 2002

Single beam echo sounding was used to delineate bathymetry sea bottom in the area of hydrography and marine navigation. This research was aimed at measuring the thickness of floating silty clay sediment with dual frequencies echo sounding system. There occur discrepancies in penetrating depth through sea beds between high frequency(200 KHz) and low(33 KHz) frequency. RI density logging was employed to characterize the floating silty clay sediment of Guangyang bay, which was chosen to investigate the proposed site for reclamation field. The volume of floating silty clay sediment was used to design by estimating size of reclamation site. The estimation strategies developed in this study will be readily applicable to measure the Pattern of sedimentation via regular hydrographic survey in the future.

• Geomechanics and Engineering
• /
• v.27 no.6
• /
• pp.595-604
• /
• 2021

With the advantages of high permeability and strength, pervious concrete piles can be suitable for ground improvement with high water content and low bearing capacity. By comparing the strength and permeability of pervious concrete with different aggregate sizes (3-5 mm and 4-6 mm) and porosities (20%, 25%, 30% and 35%), the recommended aggregate size (3-5 mm) and porosity (30%) can be achieved. The model tests of the pervious concrete piles in soft soil (silt and clay) foundations were conducted to evaluate the bearing characteristics, results show that, for the higher consolidation efficiency of the silty foundation, the bearing capacity of the silty foundation is 16% higher, and the pile-soil stress ratio is smaller. But when it is the ultimate load for the piles, they will penetrate into the underlying layer, which reduces the pile-soil stress ratios. With higher skin friction of the pile in the silty foundation, the pile penetration is smaller, so the decrease of the pile axial force can be less. For the difference in consolidation efficiency, the skin friction of pile in silt is more affected by the effective stress of soil, while the skin friction of pile in clay is more affected by the lateral stress. When the load reaches 4400 N, the skin friction of the pile in the silty foundation is about 35% higher than that of the clay foundation.

• Journal of the Korean Geotechnical Society
• /
• v.27 no.5
• /
• pp.5-15
• /
• 2011

Recent increase of large scale construction near costal area has also increased the application of soft ground treatment. As a result, solidification with cement and lime which increases stability and durability of soils, is frequently used for surface layer stabilization in soft ground site. While stabilization of very soft clay with high plasticity and compressibility has widely been studied, studies on silty clay with low plasticity and compressibility are relatively rare. In this study, after stabilizing low plasticity silty clay of Songdo area with cement and lime under various water contents, mixing ratio, and curing time, uniaxial compression test and plate load test were performed. Strength properties from both tests were considerably consistent. And trackability of construction equipment on the treated surface layer of dredged land was estimated. Finally, optimum mixing condition for Songdo silty clay was proposed.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.38 no.3
• /
• pp.290-295
• /
• 1993

To evaluate rice yield and changes of soil properties, 3 tillage methods including no tillage was tested in different soil textures, such as silty clay, sandy loam and silt loam fields. Hwaseongbyeo was transplanted by machine at May 28. Water and soil temperature of no tillage were lower than other plots, but differences of temperature were not larger in different treatments. Mean water requirement in depth of sandy loam field was larger than other textures, but that of silty clay field was smaller. The water requirement in depth of no tillage was larger by 1.4～2.2mm / day than the other plots. In the silty clay field, mineral contents, except Na$_2$O content, of rice plant of no tillage plot at the harvesting stage was higher than the other treatments. The rice yields in the no tillage plot were decreased by 18% in sandy loam, by 7% in silty clay and by 1% in silt loam respectively than the power tiller plots.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2000.11a
• /
• pp.177-184
• /
• 2000

Geotube is a tube made of geotextile and hydraulically filled with dredged soil. This technological method has been widely used in the advanced countries of the world to build the shore protection embankment. The dredged contaminated sediments from the lake, river, and harbor can be pumped into the geotube by using the hydraulic pump. So, environments effects can be minimized and enhanced by using this method. This paper presents a field test result of a geotube in the land reclamation project for the Songdo New City construction site. The dredged silty clay was dredged by the dredging ship and hydraulically pumped into the geotube. The height of geotube was measured at every filling stage and also measured width and diameter of geotube with the elapsed time. The unit weight of soil and undrained shear strength of filled soil in a tube were measured at the various locations and heights of geotube with the elapsed time. Geotube technique can be effectively implemented for the silty clayey soil with using the dredging ship.

• Geomechanics and Engineering
• /
• v.12 no.4
• /
• pp.707-721
• /
• 2017

The objective of this paper is to experimentally study the consolidation of saturated silty clay subjected to repeated heating-cooling cycles using a modified temperature-controlled triaxial apparatus. Focus is placed on the influence of the water content, confining pressure, and magnitudes and number of thermal loading cycles. The experimental results show that the thermally induced pore pressure increases with increasing water content and magnitude of thermal loading in undrained conditions. After isothermal consolidation at an elevated temperature, the pore pressure continues to decrease and gradually falls below zero during undrained cooling, and the maximum negative pore pressure increases as the water content decreases or the magnitude of thermal loading increases. During isothermal consolidation at ambient temperature after one heating-cooling cycle, the pore pressure begins to rise due to water absorption and finally stabilizes at approximately zero. As the number of thermal loading cycles increases, the thermally induced pore pressure shows a degrading trend, which seems to be more apparent under a higher confining pressure. Overall, the specimens tested show an obvious volume reduction at the completion of a series of heating-cooling cycles, indicating a notable irreversible thermal consolidation deformation.

• Korean Journal of Soil Science and Fertilizer
• /
• v.30 no.1
• /
• pp.51-55
• /
• 1997

Three soils, sandy loam, loam and silty clay loam, were selected and three inches soil cores with 4 bulk density(BD) levels were made by compressing the soils wetted with 3 levels water. Mechanical and water characteristics were measured and analyzed the mechanical resistance limiting water, available water and least-limiting water range. Mechanical resistance limiting water(MRLW) were appeared at higher bulk density than $1.6Mg/m^3$ in sandy loam, and $1.4Mg/m^3$ in loam and silty clay loam. The least-limiting water ranges were sharply decreased at the bulk density $1.6Mg/m^3$ in sandy loam and loam, $1.4Mg/m^3$ in silty clay loam. There were big deferences between available water contents and least limiting water ranges in finer texture and higher bulk density soils.

• Korean Journal of Soil Science and Fertilizer
• /
• v.44 no.1
• /
• pp.22-28
• /
• 2011

With the increasing cultivation of acid-loving plants such as blueberries, the artificial acidification of soils is frequently required. This research was conducted to determine the application rates of elemental sulfur (S) required in the soil acidification for blueberry cultivation. Laboratory incubation experiment was conducted to acidify three arable soils (pH 6-7) of different texture to pH 4.5-5.0 by the addition of varying amounts of elemental S. All rates of elemental S addition reduced soil pH, although the efficacy of acidification was related to the application rate and soil characteristics. pH reduction was slow in sandy loam soil, and the final equilibrium pH was obtained after 60, 43, and 30 days of incubation in sandy loam, loam, and silty clay, respectively. Although the final pHs obtained after 93 days of incubation were not significantly different among the three soils, the equilibrium pH was relatively higher in soil of higher clay content in the application rates of 1.5-2.0 g S $kg^{-1}$ soil. The estimated amounts of elemental S required in lowering pH to 4.5-5.0 were 0.59-1.01, 0.67-1.03, and 0.53-0.88 g S $kg^{-1}$ for sandy loam, loam, and silty clay, respectively. The lowest estimated amount of elemental S in the acidification of silty clay soil was attributable to the low organic matter content. For clay soils containing optimum level of organic matter, the application rates of elemental S should be much higher than those values estimated in this research. Soil acidification did not significantly increase the available concentrations of Ca, Mg and K. Extractable Cu and Zn was not greatly affected by the acidification, but extractable Fe, Mn, and Al in the acidified soils were higher than those found in non-acidified soils. Such increases in solubility are attributable to the dissolution of oxides and hydroxides of the elements.

• Korean Journal of Soil Science and Fertilizer
• /
• v.4 no.2
• /
• pp.187-192
• /
• 1971

This paper deals mainly with the genesis and classification of the Jeonnam series. These soils have brown to dark brown silt loam and silty clay loam A horizon(strong brown or reddish brown where eroded). Argillic B horizons are dominantly red or yellowish red silty clay loam to silty clay with moderately developed subangular blocky structure and with thin clay cutans on the ped faces. The C horizons are strongly and very deeply weathered strong brown, yellowish brown, pale brown and reddish yellow silty clay loam and sandy loam granitic saprolite. Content of clay increases with depth to a maximum between 100cm. Percolating water seems to be responsible for transportation and oriented deposition of clay. Chemically, soil reaction is strongly acid to medium acid throughout the profile. The content of organic matter is 1 to 2 percent, and decreases regularly with depth. Base saturation is low, based on amount of extractable cations. Characterisltically the Jeonnam series are similar to Red-Yellow Podzolic soils of the United States and are similar to Red-Yellow soils of the Japan. In the writer's opinion the Jeonnam soils are classified as Red Yellow soils. According to USDA 7th approximation, this soil can be classified as Typic Hapludults and in the FAO/UNESCO World Soil Map as Helvic Acrisols.

• Geotechnical Engineering
• /
• v.10 no.4
• /
• pp.153-166
• /
• 1994

In this paper, the experimental study on the behavior of the dredged clay was performed by introducing the consolidation teat method using continuous loading. Also a new testing method was examined and the strength of the dredged clay using thin plate was evaluated. The rheological characteristics of the dredged clay are described by the gingham model. The static and rheologic thin plate penetration test is proposed for the shear strength testing method. It is found that both of testing methods are reasonable and have a practicability. Especially, the strength increases for a water content which is less than two times of liquid limit in case of silty soil and clayey soil. About plasticity index, the strength increases rapidly for a value less than 10 for silt, 5 for clay which a water content is normalized by plasticity index of silty soil rather than clayey soil.