• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.21 no.1
• /
• pp.155-162
• /
• 2020

In this paper, we present a radiation compensation method and experiment method for two-dimensional direction finding by elevation and azimuth angles of broadband GPS signal, and then produce experimental results. Previous studies have performed direction finding by only using the azimuth angle of the detected signal. So, the compensation table utilizes compensation data by azimuth angles only. However, the presented method in this study has compensation data by azimuth and elevation angles for two-dimensional direction finding. Because of direction finding systems and applications are diversified, recently. So, we present a two-dimensional radiation compensation method. For evaluation of the presented compensation method, we calculate the ideal phase differences on the antenna for two-dimensional direction finding and simulate phase differences using a FEKO EM simulator. Subsequently, we analyze experimental data by radiation compensation experiments using the presented compensation method in an anechoic chamber.

• Journal of Drive and Control
• /
• v.9 no.4
• /
• pp.32-41
• /
• 2012

Most diagnosis methods for servo valves requires installing spool displacement sensor or flow sensor as well as pressure sensor. The measurement of flow is hard to implement and many kinds of servovalves or proportional direction valves do not have a built-in spool displacement sensor. In this study, static performances of servovalve or proportional-direction-valve are studied theoretically and a diagnosis technique, which uses only load pressure and input current signal, is assessed. An experimental setup was made based upon a personal computer and the LabVIEW graphical language. A series of diagnosis tests were performed and the analysis results showed it possible to measure the pressure gain, hysteresis and null bias in a relatively simple methodology.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.9 no.1
• /
• pp.11-17
• /
• 2009

This paper deals with the estimation performance DoA (Direction of Arrival) using the 3D adaptive array antenna in W-CDMA signal. For this, we proposed the 5 types of 3D array antenna, and appied for the MUSIC in order to the estimation of DoA algorithm for that antenna, commonly, then the DoA estimation error was used for the estimation performance. In the mobile communication and radio positioning service, performing the spatial filtering after the DoA estimation in array antenna, the quality of receiving signal can improve by the nulling or minimization of interfering signal which is from the undesired direction and the forming of beam which is from the desired direction. The result of DoA estimation and the DoA estimation error by varying the signal to noise ration and the number of interfering signal and power of each type antenna was calculated by computer simulation. As a result of simulation, the other propose antenna has good performance excluding the stack 3D antenna in DoA estimation and the Curved-B type antenna has more superior performance when increasing the number of interfering signal and power in the DoA estimation error.

• Journal of Broadcast Engineering
• /
• v.20 no.2
• /
• pp.238-247
• /
• 2015

We develop the signal processing method for adaptive implementing direction of signal and the frequency sensitivity of human visual system(HVS). Existing multibnad energy scaling method makes ringing artifact because it does not consider signal direction. To solve this problem, we use block gradient for signal direction in addition to existing method. And we use the fact that frequency component of signal is more sensitive than value of signal over human eyes. we enhance the signal according to contrast sensitivity function(CSF) which is the model of frequency sensitivity of human eye. Compared that the existing analysis models only improve the efficiencies in the existing systems, the developed method can process the image signals to be more desirable and suitable to HVS.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.9 no.2
• /
• pp.395-400
• /
• 2008

This paper relates to the performance analysis of DoA estimation algorithm in 2-dimensional circular array antenna for the receiving of GPS signal which is used for the performance improvement by elimination of jammer signal. By performing the spatial filtering after the DoA estimation in array antenna, the quality of receiving signal can improve by the nulling of jammer signal from the undesired direction and the forming of beam from the desired direction. In this paper, the MUSIC and MinNorm algorithm used for DoA estimation were applied after fixing the angle and power of jammer signal in 4 element and 7 element circular array antenna. In order to performance analysis, the estimation result and estimation error were computed by computer simulation. As a result, the MUSIC and MinNorm were fairly good in azimuth and elevation angle estimation of DoA in case of good signal to noise ratio and the MUSIC has better performance compared to MinNorm in case of poor signal to noise ratio.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.32 no.4C
• /
• pp.433-439
• /
• 2007

This paper derives an approximate expression for the output SINR(Signal to Interference plus Noise Ratio) of Applebaum type adaptive array under the scenario of the interferer's proximity to the desired signal. The approximation is made in terms of array geometry, the arrival direction of desired signal and that of an interfering signal. An interferer in the close proximity of target signal is shown to drastically impair the away performance. An approximate expression for interferer arrival direction which results in a predetermined performance loss is also obtained in terms of array configurations. Proposed approximation agrees with the computer calculated performance impairment when the two signals are apart by less than eight degrees. The allowable proximity of the interfering signal increases with the number of array elements.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.27 no.9
• /
• pp.808-816
• /
• 2016

In this paper, a new technique and cost function which can be to classify jamming signal and target signal from the spectral distribution of received signal in order to minimize the main beam distortion of target signal and to form nulls in the direction of jamming signal in array antennas of single port system is proposed. The proposed cost function is applied to the adaptive algorithm which has the fast convergence and stable nulling performance through the combination of the PSO(Particle Swam Optimization) algorithm and the gradient-based perturbation algorithm, which shows stable nulling performance adaptively even under the moving jamming signal where the incident direction of the jamming signal is changing with time.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.36 no.4A
• /
• pp.399-406
• /
• 2011

Adaptive beamformers, which utilize a priori information on the arrival angle of the desired signal. suppress interferences while maximizing their gains in the desired signal direction. However, if there exist errors in the direction information, they can suffer from severe performance degradation since the desired signal is treated as an interference. A robust adaptive beamforming method is presented which exploits the signal-blocking structure of the Duvall beamformer. The proposed method finds an interference signal space directly from correlations of received signals and then obtains a weight vector such that it is orthogonal to the space. Applying the weight vector to two sub arrays which consist of one less sensors than the original uniform lineal array (ULA), the beamformer efficiently estimates the arrival angle of the desired signal. Its computational complexity is lower than existing methods, which require matrix inversion or eigendecomposition.

• Korean Journal of Optics and Photonics
• /
• v.1 no.1
• /
• pp.58-64
• /
• 1990

The flow direction in a glass tube is measured by using a forward scattering dual beam laser Doppler velo$.$ cimeter with an acousto-optic modulator. We can determine the flow direction by measuring the shifted Doppler frequency which is dependent on the order of modulation of the laser beam and the fluid flow direction. Also. an electronic amplification circuit which has a bandwidth of 0 . 300 MHz and a gain of 38 dB is designed and fabricated to amplify the high frequency signal.signal.

• Journal of the Korean earth science society
• /
• v.33 no.5
• /
• pp.395-400
• /
• 2012

One of the main problems concerning the shallow seismic survey is how to generate high frequency signals with large amplitudes using small seismic sources. If one could focus the seismic energy in the direction of the survey line, it will be much helpful in identifying the first break. In this research, we have used hammer as an impulsive source and compared the signal powers generated by different shapes of the hammer plates: circular, square, and rectangular. The experiment was conducted by calculating the power spectral density function to compare the frequency spectrum and signal power. In the direction perpendicular to the long side of the rectangular plate, the largest seismic energy with the highest frequency was achieved even with the same weights of hammer plates. Our conclusion is that it is more efficient to use a rectangular plate than a circular (or square) one when conducting a 2-D shallow seismic survey.