• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1995년도 하계학술대회 논문집 C
• /
• pp.1133-1136
• /
• 1995

RF-magnetron sputtering 방법으로 형성한 $BaTa_2O_6$의 공정변수에 따른 전기, 광학적 특성변화를 관찰하여 $BaTa_2O_6$ 박막의 TFELD(thin film electroluminescent display) 절연막으로서 응용 가능성을 연구하였다. $BaTa_2O_6$ 박막의 유전특성은 증착시의 $O_2$ 함량과 sputtering 압력의 변화에는 큰 영향을 받지 않으나 기판온도에는 영향을 받는 것으로 확인되었다. 이들 공정변수를 가변하여 실험한 결과, $BaTa_2O_6$ 박막 형성의 최적조건으로 플라즈마 압력을 6 mtorr, sputtering gas 내의 $O_2$ 혼합비율은 40%, 기판온도는 $100^{\circ}C$로 결정하였다. 이상의 조건에서 제조된 $BaTa_2O_6$ 박막은 10.2 ${\mu}C/cm^2$의 매우 우수한 성능지수를 보였다. 이상의 $BaTa_2O_6$ 박막을 하부절연층으로, 절연파괴강도가 높은 $SiO_xN_y$를 상부 절연층으로 사용하여 제조된 EL 소자는 1 kHz, 삼각파 구동시 발광 임계전압은 약 32 volts, 최대휘도는 54 $cd/m^2$으로 측정되었다.

• 대한전기학회논문지:전기물성ㆍ응용부문C
• /
• 제48권12호
• /
• pp.755-760
• /
• 1999

Various fluoride films were investigated for a gate insulator of thin film transistor application. Conventional oxide containing materials like $SiO_2\;Ta_2O_5\; and \; Al_2O_3$ exhibited high interface states which lead to an increased threshold voltage and poor stability of TFT. In this paper, we investigated gate insulators using a binary matrix system of fluoride such as $CaF_2,\; SrF_2\; MgF_2,\; and\; BaF_2$. These materials exhibited an improvement in lattice mismatch, interface state and electrical stability. MIM and MIS devices were employed for an electrical characterization and structural property examination. Among the various fluoride materials, $CaF_2$ film showed an excellent lattice mismatch of 5%, breakdown electric field higher than 1.2MV/cm and leakage current density of $10^{-7}A/cm^2$. MIS diode having $Ca_2$ film as an insulation layer exhibited the interface states as low as $1.58\times10^{11}cm^{-2}eV^{-1}$. This paper probes a possibility of new gate insulator materials for TFT applications.

• 한국전기전자재료학회논문지
• /
• 제20권10호
• /
• pp.883-888
• /
• 2007

Investigation of improving the properties of UV detector which uses the wide bandgap of ZnO are under active progress. The present study focused on the design and fabrication of i-ZnO/p-inversion $layer/n^--Si$ Epi. which is characterized with very thin p-type inversion layer for UV detectors. The i-ZnO thin film for achieving p-inversion layer which was grown by RF sputtering at $450^{\circ}C$ and then annealed at $400^{\circ}C$ in $O_2$ gas for 20 min shows good intrinsic properties. High (0002) peak intensity of the i-ZnO film is shown on XRD spectrum and it is confirmed by XPS analysis that the ratio of Zn : O of the i-ZnO film is nearly 1 : 1. Measurement shows high transmission of 79.5 % in UV range (< 400 nm) for the i-ZnO film. Measurement of $V_r-I_{ph}$ shows high UV photo-current of 1.2 mA under the reverse bias of 30 V.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2003년도 하계학술대회 논문집 Vol.4 No.1
• /
• pp.452-455
• /
• 2003

[ $ZrO_2$ ] dielectric layers were grown on the p-type Si (100) substrate by metalorganic molecular beam epitaxy(MOMBE). Zrconium t-butoxide, $Zr(O{\cdot}t-C_4H_9)_4$ was used as a Zr precursor and Argon gas was used as a carrier gas. The thickness of the layers was measured by scanning electron microscopy (SEM) and the properties of the $ZrO_2$ layers were evaluated by X-ray diffraction, high frequency capacitance-voltage measurement. and HF C-V measurements have shown that $ZrO_2$ layer grown by MOMBE has a high dielectric constant (k=18-19). The growth rate is affected by various process variables such as substrate temperature, bubbler temperature, Ar, and $O_2$ gas flows.

• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2011년도 제41회 하계 정기 학술대회 초록집
• /
• pp.188-188
• /
• 2011

MgO는 암염구조의 이온결합성 화합물로 7.8 eV의 높은 띠 틈과 약 95%의 탁월한 투과도를 갖는다. 또한, ${\gamma}$ process에 의한 이차 전자 방출이 높고 이온 스퍼터링에 의한 표면 손상이 적어 면 방전 AC-PDP의 보호막으로 이용된다. 따라서 MgO 보호막에 관한 연구는 이차 전자 방출 계수를 높여 방전 전압을 감소시키고 높은 유전율과 투과도를 유지시키기 위한 목적으로 전개되어지고 있다. 본 연구는 이온 스퍼터링에 의한 MgO 보호막의 표면 특성의 변화를 알아보기 위해 이루어졌다. MgO 박막은 electron beam evaporation의 방법을 통해 챔버 내에 O 기체를 주입하고 P type Si 기판을 300$^{\circ}C$ 가열하여 40 nm 두께로 제작되었다. 박막 시료는 표면분석 전 초고진공챔버 내에서 표면에 산화된 불순물 제거를 위해 550$^{\circ}C$의 열처리가 되어졌다. 그리고 250 eV의 He 이온으로 박막 표면을 스퍼터링 하여 XPS, REELS, UPS를 이용하여 전자 및 광학적 특성을 연구하였다. XPS 분석을 통해 MgO 박막은 He 이온 스퍼터링에 의해 표면의 화학적 조성이 변하지 않는다는 것을 확인했다. MgO 박막에 이온 스퍼터링을 하면 표준 시료와 비교하여 Ep=1,500 eV일 때 7.54 eV에서 7.63 eV로 높아지는 경향이 있다. 일함수는 He 이온 스퍼터링 한 결과 3.85 eV로부터 4.09 eV로 약간 높아졌다. 또한, QUEELS simulation으로 얻은 가시광 투과도는 91~92%로 분석되었다.

• 한국표면공학회:학술대회논문집
• /
• 한국표면공학회 2018년도 춘계학술대회 논문집
• /
• pp.32.1-32.1
• /
• 2018

Novel soft magnetic materials can be achieved by altering material properties such as morphology, composition, crystallinity, and grain size of soft magnetic alloys. Especially, magnetic properties (i.e., saturation magnetization, coarcivity) of soft magnetics are significantly affected by grain boundaries which act as a control of magnetic domain wall movement. Thus, we herein develop a two-step electroless plating method to control morphology and grain size of FeCo films for excellent magnetic properties. Accordingly, the chemical composition to control the degree of polarization of FeCo alloys was altered by electroless deposition parameters; for example, electrolyte concentration and temperature. The grain size and crystallinity of FeCo alloys was dramatically affected by the reaction temperature because the grain growth mechanism dominantly occurs at $90^{\circ}C$ where as the neucleation only happens at $50^{\circ}C$. By simply controlling the temperature, the micron-sized FeCo grains embedded FeCo film was synthesized where the large grains allow high magnetization originated from larger magnetic domain with low corecivity and the nano-sized grains allow excellent soft magnetic properties due to the magnetic correlation length.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2002년도 추계학술대회 논문집 Vol.15
• /
• pp.47-50
• /
• 2002

ZnO nanowires were coated conformally with aluminum oxide ($Al_{2}O_{3}$) material by atomic layer deposition (ALD). The ZnO nanowires were first synthesized on a Si (100) substrate at $1380^{\circ}C$ from ball-milled ZnO powders by a thermal evaporation procedure with an argon carrier gas without any catalysts; the length and diameter of these ZnO nanowires are $20\sim30{\mu}m$ and $50{\sim}200$ nm, respectively. $Al_{2}O_{3}$ films were then deposited on these ZnO nanowires by ALD at a substrate temperature of $300^{\circ}C$ using trimethylaluminum (TMA) and distilled water ($H_{2}O$). Transmission electron microscopy (TEM) images of the deposited ZnO nanowires revealed that 40nm-thick $Al_{2}O_{3}$ cylindrical shells surround the ZnO nanowires.

• 대한전기학회논문지:전기물성ㆍ응용부문C
• /
• 제52권7호
• /
• pp.288-292
• /
• 2003

AlM thin film has been deposited on A1$_2$O$_3$ substrate by reactive radio frequency(RF) magnetron sputtering method under various operating conditions such as working pressure, fraction of nitrogen partial pressure, and substrate temperature. Scanning Electron Microscope(SEM), X-ray Diffraction(XRD), and Atomic Force Microscope(AFM) have been measured to find out structural properties and preferred orientation of AlN thin films. SAW velocity of IDTs/AlN/Si structure was about 5038［㎧］ at the center frequency of 251.9［MHz］ and insertion loss was measured to be relatively low value of 35.6［dB］. SAW velocity of IDTs/AlN/A1$_2$O$_3$ structure was improved to be about 5960［㎧］ at the center frequency of 296.7［MHz］.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2002년도 추계학술대회 논문집 전기물성,응용부문
• /
• pp.79-81
• /
• 2002

ZnO 나노와이어는 ZnO 파우더를 볼밀 처리하여 열증착 방법으로 $1380^{\circ}C$에서 촉매없이 Si 기판위에서 합성되었다. 합성된 ZnO 나노와이어의 길이와 직경은 $20{\sim}30{\mu}m$와 $50{\sim}200$ nm 였다. ZnO 나노와이어 표면을 atomic layer deposition(ALD) 방법으로 $Al_2O_3$ 박막을 얇게 코팅하였다. 성장온도는 $300^{\circ}C$였고, 사용한 전구체는 Trimethlaluminum(TMA)와 distilled water($H_2O$) 이다. Transmission electron microscopy(TEM) 으로 측정한 $Al_2O_3$ 박막의 두께는 40 nm 로서 매우 균일하게 ZnO 나노와이어에 증착되었음을 알 수 있었다.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2003년도 추계학술대회 논문집 Vol.16
• /
• pp.11-14
• /
• 2003

[ $HfO_2$ ] thin films were deposited at $300^{\circ}C$ on p-type Si (100) substrates using $HfO_2(HfO_xN_y)$ as the precursor by plasma-enhanced chemical vapor deposition and were annealed at $300^{\circ}C$ in nitrogen plasma ambient. Compared with $HfO_2$, nitrogen plasma annealed $HfO_2$ show good chemical stability, higher crystallization temperature, lower leakage current and thermal stability. Leakage current density of nitrogen plasma annealed $HfO_2$ is approximately one order of magnitude lower than that of $HfO_2$ for the same EOT. The improvement in electrical characteristics of nitrogen plasma annealed $HfO_2$ can be explained by the better thermal stability due to nitrogen incorporation.