• Proceedings of the Materials Research Society of Korea Conference
• /
• 2006.05a
• /
• pp.23.1-23.1
• /
• 2006

• Korean Journal of Materials Research
• /
• v.9 no.10
• /
• pp.1006-1011
• /
• 1999

B-doped hydrogenated amorphous silicon carbide (a-SiC:H) thin films were prepared by plasma-enhanced chemical-vapor deposition in a gas mixture of $SiH_4$, $CH_4$ and $B_2H_6$. Microstructures and chemical properties of a-SiC:H films grown with varing the volume ratio of $CH_4$ to $SiH_4$ were characterized with various analysis methods including scanning electron microscopy(SEM), X-ray diffractometry(XRD), Raman spectroscopy, Fourier-transform infrared (FTIR) spectroscopy. X-ray photoelectron spectroscopy(XPS), UV absorption spectroscopy and photoconductivity measurements. While Si:H films grown without $CH_4$ showed amorphous state, the addition of $CH_4$ during deposition enhanced the development of a microcrystalline phase. By introducing C atoms into the film, Si-Si and Si--$\textrm{H}_{n}$ bonds of a -Si:H films were gradually replaced by Si-C, C-C, and Si--$\textrm{C}_{n}\textrm{H}_{m}$ bonds. Consequently, the electrical resistivity and optical bandgap of a-SiC:H films were increased with the C concentration in the film.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.8 no.5
• /
• pp.1013-1019
• /
• 2007

Amorphous silicon and silicon-nitride films were deposited using plasma-enhanced chemical vapor deposition (PECVD) method at $150^{\circ}C$. As fraction of $H_2$ in source gas was increased, characteristics of low-temperature silicon-nitride films approached those of conventional high-temperature films; the refractive index approached 1.9 and the ratio of nitrogen-hydrogen bonds to silicon-hydrogen bonds increased. And also, as fraction of $H_2$ in source gas was increased, characteristics of low-temperature silicon films approached those of conventional high-temperature films; refractive index and optical band gap approached 4.2 and 1.8 eV, and $[Si-H]/([Si-H]+[Si-H_2])$ increased. Lower RF power and process-pressure made the amorphous silicon films to be better properties. Increase of $H_2$ ratio seemed as the common factor to get reliable amorphous silicon and silicon-nitride films for thin-film-transistors (TFTs) at low temperature.

• Proceedings of the Korean Society Of Semiconductor Equipment Technology
• /
• 2002.11a
• /
• pp.34-46
• /
• 2002

Si-O-C-H films with a low dielectric constant were deposited on a p-type Si(100) substrate using a mixture gases of the bis-trimethylsilyl-methane (BTMSM) and oxygen by an inductively coupled plasma chemical vapor deposition (ICPCYD). High density plasma of about $~10^{12}\textrm{cm}^{-3}$ is obtained at low pressure (<400 mTorr) with rf power of about 300W in ICPCVD where the BTMSM and $O_2$ gases are fully dissociated. Fourier transform infrared (FTIR) spectra and X-ray photoelectron spectroscopy (XPS) spectra show that the film has $Si-CH_3$ and OH-related bonds. The void within films is formed due to $Si-CH_3$ and OH-related bonds after annealing at $500^{\circ}C$ for the as-deposition samples. The lowest relative dielectric constant of annealed film at $500^{\circ}C$ is about 2.1.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.18 no.11
• /
• pp.996-1000
• /
• 2005

Experimental results are presented for the degradation of 3 nm-thick gate oxide $(SiO_2)$ under both Negative-bias Temperature Instability (NBTI) and Hot-carrier-induced (HCI) stresses using P and NMOSFETS, The devices are annealed with hydrogen or deuterium gas at high-pressure $(1\~5\;atm.)$ to introduce higher concentration in the gate oxide. Both interface trap and oxide bulk trap are found to dominate the reliability of gate oxide during electrical stress. The degradation mechanism depends on the condition of electrical stress that could change the location of damage area in the gate oxide. It was found the trap generation in the gate oxide film is mainly related to the breakage of Si-H bonds in the interface or the bulk area. We suggest that deuterium bonds in $SiO_2$ film are effective in suppressing the generation of traps related to the energetic hot carriers.

• Journal of Sensor Science and Technology
• /
• v.12 no.5
• /
• pp.218-224
• /
• 2003

The devices of n-channel poly silicon thin film transistors(TFTs) hydrogenated by plasma, $H_2$ and $H_2$/plasma processes are fabricated. The carriers sensitivity characteristics are analyzed with voltage bias stress at the gate oxide. The parametric sensitivity characteristics caused by electrical stress conditions in hydrogenated devices are investigated by measuring the drain current, threshold voltage($V_{th}$), subthreshold slope(S) and maximum transconductance($G_m$) values. As a analyzed results, the degradation characteristics in hydrogenated n-channel polysilicon thin film transistors are mainly caused by the enhancement of dangling bonds at the poly-Si/$SiO_2$ interface and the poly-Si grain boundary due to dissolution of Si-H bonds. The generation of traps in gate oxide are mainly dued to hot electrons injection into the gate oxide from the channel region.

• Proceedings of the IEEK Conference
• /
• 2008.06a
• /
• pp.487-488
• /
• 2008

SiOC films containing alkyl groups have a low dielectric constant because of the interaction between the C-H hydrogen bonds and the oxygen of high electro-negative atom. The Si-$CH_3$ in a void is broken by the $O_2$, therefore the strength of CH bond in Si-O-O-$CH_3$ bond increases. The Si-O-O-$CH_3$ bond is broken by nucleophilic attack due to Si atom, again. The elongation of C-H bond causes the red shift, and the compression of C-H bond causes the blue shift. Among these chemical shifts, the blue shift from $1000\;cm^{-1}$ to $1250\;cm^{-1}$ was related with the formation of pores. If the oxygen is deficient condition, the methylradicals of the electron-rich substitution group terminate easily the Si-O-Si cross-link, and the pore is originated from the cross-link breakdown due to much methyl radicals of Si-$CH_3$. The dielectric constant of the films decreases due to pore generation.

• Journal of the Korean institute of surface engineering
• /
• v.29 no.6
• /
• pp.797-802
• /
• 1996

Hydrogenated amorphous silicon carbide (a-SiC:H) films have been deposited on unheated substrates by low frequency (50Hz) plasma using $SiH_4+CH_4+H_2$ gas mixtures. Deposition rate, refractive index, optical band gap, Vickers hardness and IR spectrum of the deposited a -SiC:H films have been measured for various rations of gas flow rates k(=$CH_4/SiH_4$, 0.5k4) with a constant $H_2$ flow rate (100sccm). As k increases, the deposition rate of the a-SiC:H films increases up to the maximum value of about 220nm/h at k=2.5, and then it decreases. The refractive index of the films was 2.6 for k=2.5, while the optical band gap of the films was 3.3eV for k=2.2. The maximum value of Vickers hardness of the films was 1500Hv at k=1. The infrared transmission measurement shows that the films contain both Si-C and Si-$CH_3$ bonds.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2005.07a
• /
• pp.272-275
• /
• 2005

The high stability of a-Si:H TFTs device is studied with different deposited conditions of $SiN_x$ films by PECVD. The process parameters of $N_2$, $NH_3$ gas flow rate, RF power, and pressure s of hydrogenated amorphous silicon nitride are taken into account and analyzed by Taguchi experimental design method. The $NH_3$ gas flow rate and RF power are two major factors on the average threshold voltage and the a-SiNx:H film's structure. The hydrogen contents in $SiN_x$ films were measured by FTIR using the related Si-H/N-H bonds ratio in $a-SiN_x:H$ films. After the 330,000 sec gate bias stress is applied, the threshold voltages ($V_th$) shift less than 10%. This result indicates that the highly stable a-Si:H TFTs device can be fabricated with optimum gate $SiN_x$ insulator.

• Korean Journal of Materials Research
• /
• v.3 no.5
• /
• pp.459-465
• /
• 1993

By making the inter-metal PECVD $SiO_2$ as a Si rich oxide under the SOG, the hydrogen and water related diffusants could be captured a t SI dangling bonds. This gettering process was known to prevent the device characteristics degradations related to the H, $H_20$. The basic characteristics of Si rich oxide have been studied according to changing high/low frequency power and $SiH_4/N_2O$ gas flow ratio in PECVD. As increase in low frequency power, deposition rate decreased but K.I. and compressive stress increased. Decrease of the water peaks of FTIR spectra at the wave number range of 3300~3800$\textrm{cm}^{-1}$' also indicated that intensty the films were densified. As increase in SiH, gas flow rate, deposition rate, R.I. and etch rate increased while compressive stress decreased. F'TIK spectra showed that peak intensity corresponding to Si-0-Si stretching vibration decreased and shifted to the lower wave numbers. But AES showed that Si dangl~ng bonds were increased as a result of lower Si:O(l: 1.23) ratlo inthe Si rich oxide as compared to Si : O(1 : 1.98) ratio of usual oxide.