• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.12 no.6
• /
• pp.619-628
• /
• 2019

In this paper, we designed a beta ray sensor for a true random number generator. Instead of biasing the gate of the PMOS feedback transistor to a DC voltage, the current flowing through the PMOS feedback transistor is mirrored through a current bias circuit designed to be insensitive to PVT fluctuations, thereby minimizing fluctuations in the signal voltage of the CSA. In addition, by using the constant current supplied by the BGR (Bandgap Reference) circuit, the signal voltage is charged to the VCOM voltage level, thereby reducing the change in charge time to enable high-speed sensing. The beta ray sensor designed with 0.18㎛ CMOS process shows that the minimum signal voltage and maximum signal voltage of the CSA circuit which are resulted from corner simulation are 205mV and 303mV, respectively. and the minimum and maximum widths of the pulses generated by comparing the output signal through the pulse shaper with the threshold voltage (VTHR) voltage of the comparator, were 0.592㎲ and 1.247㎲, respectively. resulting in high-speed detection of 100kHz. Thus, it is designed to count up to 100 kilo pulses per second.

• Progress in Medical Physics
• /
• v.27 no.4
• /
• pp.224-231
• /
• 2016

The usefulness of Gel Bolus phantom was investigated by comparing the temperature distribution characteristic of the agar phantom produced to investigate the dose distribution characteristic of radiofrequency hyperthermia device with that of the Gel Bolus phantom under conditions similar to those of an agar phantom that can continuously carry out temperature measurement. The temperatures of the agar phantom and the Gel Bolus phantom were raised to $36.5{\pm}3^{\circ}C$ and a temperature sensing was inserted at depths of 5, 10, and 15 cm from the phantom central axis. The temperature increase rate and the coefficient of determination were analyzed while applying output powers of 100 W and 150 W, respectively, at intervals of 1 min for 60 min under conditions where the indoor temperature was in the range $24.5{\sim}27.5^{\circ}C$, humidity was 35~40%, internal cooling temperature of the electrode was $20^{\circ}C$, size of the upper electrode was 250 mm, and the size of the lower electrode was 250 mm. The coefficients of determination of 150 W output power at the depth point of 5 cm from the central axis of the phantom were analyzed to be 0.9946 and 0.9926 in the agar and Gel Bolus phantoms, respectively; moreover, the temperature change equation of the agar and Gel Bolus phantoms with time can be expressed as follows in the state the phantom temperature is raised to $36^{\circ}C:Y(G)$ is equation of Gel Bolus phantoms (in 5 cm depth) applying output power of 150 W. Y(G)=0.157X+36. It can be seen that if the temperature is measured in this case, the Gel Bolus phantom value can be converted to the measured value of the agar phantom. As a result of comparing the temperature distribution characteristics of the agar phantom of a human-body-equivalent material with those of the Gel Bolus phantom that can be continuously used, the usefulness of Gel Bolus phantom was exhibited.

• Ocean and Polar Research
• /
• v.32 no.4
• /
• pp.337-350
• /
• 2010

This study conducted sedimentological and geophysical surveys for 3 years (2006-2008) in southern Gyeonggi Bay, Korea to elucidate temporal changes in subaqueous dune morphology on a sand ridge trending northeast to southwest that has been excavated by marine sand mining. The sand ridge (~20 m in height, ~2 km in width and 3~4 km in length) has a steep slope on the NW side and a gentle slope on the SE side, creating an asymmetric profile. Large (10~100 m in length) and very large (>100 m in length) dunes occurring on the SE side of the ridge show a northeastward asymmetrical shape, whereas dunes on the NW side destroyed by marine sand mining display a southwestward asymmetry. The comparison between Flemming (1988)'s correlation and the height-length correlation of this study indicates that tidal current and availability of sand sediment are major controlling factors to the development and maintenance of dunes. Depth and sedimentary characteristics (grain size) are not likely to be major controlling factors, but indirectly influence dune growth by hydrological and sedimentary processes. The length and the height of dunes decrease toward the southeastern trough away from the crest of the ridge. These features result from the decrease of tidal current and sediment availability. The length and the height of dunes on the southeast side decrease gradually over time. This is a result of the interaction between tidal current and the decrease in sediment availability due to sediment extraction by marine sand mining. Marine sand mining has destroyed the dunes directly, causing irregular shapes of shorter length and lower height. The coarse fraction of suspended sediments is transported and deposited very close to the sand pit. By contrast, relatively fine sediments are transported by the tidal current and deposited over a wide range by the settling-lag effect, resulting in a decrease of sediment grain size in the area where suspended sediments are deposited. In addition, marine sand mining, decreases the height of dunes. Therefore, morphological and sedimentological characteristics of dunes around the sand pits will be significantly changed by future sand mining activities.

• Journal of Korea Spatial Information System Society
• /
• v.8 no.1 s.16
• /
• pp.1-16
• /
• 2006

Recently, human based computing environment for supporting users to concentrate only user task without sensing other changes from users is being progressively researched and developed. But middleware deletes steream data processed for reducing process load of massive information from RFID sensor in this computing. So, this kind of middleware have problems when user demands probability or statistics needed for data warehousing or data mining and when user demands very important stream data repeatedly but already discarded in the middleware every former time. In this paper, we designs Sensor Middleware Architecture on Multi Level Spatial DBMS with Snapshot and manage repeatedly required stream datas to solve reusing problems of historical stream data in current middleware. This system uses disk databse that manages historical stream datas filtered in middleware for requiring services using historical stream information as data mining or data warehousing from user, and uses memory database that mamages highly reuseable data as a snapshot when stream data storaged in disk database has high reuse frequency from user. For the more, this system processes memory database management policy in a cycle to maintain high reusement and rapid service for users. Our paper system solves problems of repeated requirement of stream datas, or a policy decision service using historical stream data of current middleware. Also offers variant and rapid data services maintaining high data reusement of main memory snapshot datas.

• Economic and Environmental Geology
• /
• v.42 no.4
• /
• pp.343-356
• /
• 2009

SCS method was applied to make the assessments of direct runoff according to land use changes in Jeju island. Land uses were obtained from 5 year-period remote sensing time series data from 1975 to 2000 which are provided by Water Management Information System (WAMIS). Hydrologic soil groups were categorized based on soil series of National Academy of Agricultural Sciences (NAAS), and permeable geologic structures such as Sumgol, Gotzawal and so on. The land uses of Jeju island are obviously characterized by urban-agricultural areas increases, and forest areas decrease. According to land use changes, curve number (CN) for Jeju island was consistently increased from 65.3 in 1975 to 69.6 in 2000. From 1975 to 2000, the amount of direct runoff and ratios increased due to CN changes. When the rainfall data in 1995 was applied to each year, the direct runoff amounts were $299.0{\sim}351.6\;mm$, and runoff ratios were $15.1{\sim}17.7%$. In the case of the application of the rainfall data in 2000, the direct runoff amounts were $136.9{\sim}161.5\;mm$, and runoff ratios were $9.7{\sim}11.5%$. Since direct runoff can be closely related to groundwater recharge and sustainable groundwater yield, the groundwater influence caused by land use changes or district exploitations should be considered for the reasonable water management and development in Jeju island.

• Journal of Sensor Science and Technology
• /
• v.10 no.2
• /
• pp.101-107
• /
• 2001

A highly selective, sensitive and reliable ozone sensing $In_2O_3$ thin film was fabricated by a sol-gel method. The fabricated film is operated at a relatively lower temperature than ever developed thin films and saved operating power. $In_2O_3$ films deposited by sol-gel technique has been recently attracted because it is an economical and energy saving method and precisely controlled microstructure. Indium alkoxide precursor was synthesized from the reaction between indium hydroxide and butanol. PVA binder was used to improve adhesion of the films. The $In_2O_3$ thin films were obtained by spin coating from 1 to 5 times followed by drying at $100^{\circ}C$ and calcining at $600^{\circ}C$ for 1h. The film thickness was controlled by the number of coating time. The morphology and the thickness of the $In_2O_3$ films were examined by a SEM and XRD. The $In_2O_3$ thin films show a high sensitive to ozone gas at operating temperature of $250^{\circ}C$. The $In_2O_3$ sensor has very good selectivity to $CH_4$, CO, $C_4H_{10}$ and ethanol.

• Journal of Korean Society for Geospatial Information Science
• /
• v.22 no.3
• /
• pp.129-136
• /
• 2014

This study deals with red tide detection by using the remote sensing imagery from the Geostationary Ocean Color Imager (GOCI), the world's first geostationary orbit satellite, around the southern coast of Korea where the most severe red tide occurred recently. The red tide zone was determined by the available data selection from the GOCI imagery during the period of red tide occurrence and also the severe red tide zone was detected through the spatial analysis by temporal change out of the red tide zone. This study results showed that the coast in the vicinity of the Hansan and Yokji in Tongyeong-si was classified into the severe red tide zone, and that the red tide was likely to spread from the coast of Hansan and Yokji to the one of Sanyang-eub. In addition, the comparative analysis between the area of red tide occurrence, the prevention activities of Gyeongsangnam-do provincial government and the amount of the damage cost over time showed close correlation among them. It is still early to conclude that the study is showing the severe red tide zone and the spread path exactly due to various factors for red tide occurrence and activities. In order to improve the reliability of the results, the more data analysis is required.

• Journal of Biosystems Engineering
• /
• v.39 no.1
• /
• pp.47-56
• /
• 2014

Purpose: In protected crop production facilities such as greenhouse and plant factory, farmers should be present and/or visit frequently to the production site for maintaining optimum environmental conditions and better production, which is time and labor consuming. Monitoring of environmental condition is highly important for optimum control of the conditions, and the condition is not uniform within the facility. Objectives of the paper were to investigate spatial and vertical variability in ambient environmental variables and to provide useful information for sensing and control of the environments. Methods: Experiments were conducted in a strawberry-growing greenhouse (greenhouse 1) and a cherry tomato-growing greenhouse (greenhouse 2). Selected ambient environmental variables for experiment in greenhouse 1 were air temperature and humidity, and in greenhouse 2, they were air temperature, humidity, PPFD (Photosynthetic Photon Flux Density), and $CO_2$ concentration. Results: Considerable spatial, vertical, and temporal variability of the ambient environments were observed. In greenhouse 1, overall temperature increased from 12:00 to 14:00 and increased after that, while RH increased continuously during the experiments. Differences between the maximum and minimum temperature and RH values were greater when one of the side windows were open than those when both of the windows were closed. The location and height of the maximum and minimum measurements were also different. In greenhouse 2, differences between the maximum and minimum air temperatures at noon and sunset were greater when both windows were open. The maximum PPFD were observed at a 3-m height, close to the lighting source, and $CO_2$ concentration in the crop growing regions. Conclusions: In this study, spatial, vertical, and temporal variability of ambient crop growing conditions in greenhouses was evaluated. And also the variability was affected by operation conditions such as window opening and heating. Results of the study would provide information for optimum monitoring and control of ambient greenhouse environments.

• Science of Emotion and Sensibility
• /
• v.14 no.1
• /
• pp.157-164
• /
• 2011

Emotion science is one of the rapidly expanding engineering/scientific disciplines which has a major impact on human society. Such growing interests in emotion science and engineering owe the recent trend that various academic fields are being merged. In this paper we propose the potential importance of the biochip technology in which the human emotion can be precisely measured in real time using body fluids such as blood, saliva and sweat. We firstly and newly name such a biochip an Emotion-On-a-Chip (EOC). EOC consists of biological markers to measure the emotion, electrode to acquire the signal, transducer to transfer the signal and display to show the result. In particular, microfabrication techniques made it possible to construct nano/micron scale sensing parts/chips to accommodate the biological molecules to capture the emotional bio-markers and gave us a new opportunities to investigate the emotion precisely. Future developments in the EOC techniques will be able to help combine the social sciences and natural sciences, and consequently expand the scope of studies.

• Journal of rehabilitation welfare engineering & assistive technology
• /
• v.11 no.3
• /
• pp.119-126
• /
• 2017

In the clinical setting, the pressure bio-feedback device is used for the spinal rehabilitation of patients with back pain, but it has several disadvantages. The purpose of this study was to develop a digitalized pressure biofeedback system that provides precise exercise method and posture in real time during the spinal rehabilitation exercise by sensing and monitoring body movements and balance of users and providing biofeedback to users. After that, the usability testing for a digitalized pressure biofeedback system will be conducted to identify problems such as safety, performance, operability, and satisfaction, and suggest improvement directions. A total of 33 subjects were participated in the usability testing. The experts group and the users group evaluated the developed digitalized pressure biofeedback system on a scale of 5 points after using the equipment. In the user group, safety was 3.59, operability was 4.38, satisfaction was 4.49. In the expert group, safety was 2.86, operability was 3.91, and performance was 4.28. Based on the usability evaluation, if the problems of stability of the cradle for tablet PC, air injection, screen display, etc. are solved, it becomes a exercise device capable of accurately exercising and evaluating the function of the spine by checking its own motion state while the spinal stabilization exercise.