• Journal of the Korean Society of Safety
• /
• v.22 no.4
• /
• pp.13-19
• /
• 2007

An numerical method to estimate thermal diffusivity has been developed for one-dimensional unsteady heat conduction problem, when the temperatures are know at two positions in a semi-infinite body. Using the closed form solution which has already derived an explicit solution for the inverse problem for one-dimensional transient heat conduction using Laplace transform technique, we first estimate the surface temperature. The thermal diffusivity can be estimated by using the estimated surface temperature and measured temperatures, which include some uncertainties. The estimated surface heat flux and thermal diffusivity are found to be in good agreement with those of the experimented conditions. This method will be extended to the simultaneous measurement of thermal diffusivity and thermal conductivity.

• Journal of the Korean Ceramic Society
• /
• v.26 no.5
• /
• pp.670-676
• /
• 1989

The PbTiO3 is well known materials having remarkable ferroelectric, piezoelectric, and pyroelectric properties. PbTiO3 thin films with a perovskite structure were successfully fabricated on titanium substrate by chemical vapor deposition. These films were characterized according to composition, crystal structure, and electrical properties. Semi-quantitative compositional analysis of the deposited films was made by Auger Electron Spectroscopy(AES). The PbTiO3 film deposited on titanium substrate at the deposition temperature 75$0^{\circ}C$, the Ti(C2H5O)4 fraction 0.15, and O2 partial pressure 0.06atm, has a columnar structure and grows with(001) preferred orientation, and has stoichiometric composition. A clear dielectric transition and offset in the dc conductivity near the transition temperature(48$0^{\circ}C$) were observed in the deposited lead titanate film.

• The Journal of the Acoustical Society of Korea
• /
• v.10 no.3
• /
• pp.19-30
• /
• 1991

The surface properties such as energy gap, exciton, shallow trap level, deep trap level, type inversion with annealing and metastable state of $EL_2$ level of SI GaAs wafers and the conductivity distribution of 2 inch Cr doped GaAs wafer were investigated using nondestructive TAV(transverse acoustoelectric voltage) technique. The TAV is generated when SAW and semiconductor interact. We also have tried newly SAW oscillator technique to investigate the surface properties of semiconductor wafers and we have shown the validity of this technique.

• Bulletin of the Korean Chemical Society
• /
• v.33 no.6
• /
• pp.1925-1928
• /
• 2012

Adsorption of alkali metals (Li, Na, and K) on the surface of magnesium oxide nanotubes (MgONTs) with different diameters was investigated using density functional theory. According to the obtained results, the most stable adsorption site was found to be atop the oxygen atom of the tube surface with adsorption energies in the range of -0.25 to -0.74 eV. HOMO-LUMO gap ($E_g$) of the tubes dramatically decreases upon the adsorption of the alkali metals, resulting in enhancement of their electrical conductivity enhancement. The order of $E_g$ decrement caused by the metal adsorption is as follows: K > Na > Li. The results suggest that the MgONTs were transformed from semi-insulator to semiconductor upon the alkali metal adsorption. Increasing the tube diameter, the HOMO/LUMO gap of the pristine tube is enhanced and adsorption energies of the alkali metals are decreased.

• Steel and Composite Structures
• /
• v.51 no.2
• /
• pp.139-151
• /
• 2024

In this research, a semi-analytical solution is presented for computing mechanical displacements and thermal stresses in rotating thick cylindrical pressure vessels made of functionally graded material (FGM). The modulus of elasticity, linear thermal expansion coefficient, and density of the cylinder are assumed to change along the axial direction as a power-law function. It is also assumed that Poisson's ratio and thermal conductivity are constant. This cylinder was subjected to non-uniform internal pressure and thermal loading. Thermal loading varies in two directions. The governing equations are derived by the first-order shear deformation theory (FSDT). Using the multilayer method, a functionally graded (FG) cylinder with variable thickness is divided into n homogenous disks, and n sets of differential equations are obtained. Applying the boundary conditions and continuity conditions between the layers, the solution of this set of equations is obtained. To the best of the researchers' knowledge, in the literature, there is no study carried out bi-directional thermoelastic analysis of clamped-clamped rotating FGM thick-walled cylindrical pressure vessels under variable pressure in the longitudinal direction.

• Fisheries and Aquatic Sciences
• /
• v.20 no.11
• /
• pp.30.1-30.10
• /
• 2017

Small-scale fish farmers in developing countries are faced with challenges owing to their limited information on aquaculture management. Nile tilapia farmers in Teso North Sub-County recorded lower yields than expected in 2009 despite having been provided with required inputs. Water quality was suspected to be the key factor responsible for the low yields. This study sought to assess the effects of earthen pond water physico-chemical parameters on the growth of Nile tilapia in six earthen fish ponds under semi-intensive culture system in Teso North Sub-County. The study was longitudinal in nature with pond water and fish being the units of analysis. Systematic sampling was used to select five ponds while a control pond was purposively selected based on its previously high harvest. Four ponds were fed by surface flow and two by underground water. Each pond was fertilized and stocked with 900 fry of averagely 1.4 g and 4.4 cm. Physico-chemical parameters were measured in-situ using a multi-parameter probe. Sixty fish samples were randomly obtained from each pond fortnightly for four months using a 10 mm mesh size and measured, weighed and returned into the pond. Mean range of physico-chemical parameters were: dissolved oxygen (DO) 4.86-10.53 mg/l, temperature $24-26^{\circ}C$, pH 6.1-8.3, conductivity $35-87{\mu}S/cm$ and ammonia 0.01-0.3 mg/l. Temperature (p = 0.012) and conductivity (p = 0.0001) levels varied significantly between ponds. Overall Specific Growth Rate ranged between 1.8% (0.1692 g/day) and 3.8% (1.9 g/day). Ammonia, DO and pH in the ponds were within the optimal levels for growth of tilapia, while temperature and conductivity were below optimal levels. As temperature and DO increased, growth rate of tilapia increased. However, increase in conductivity, pH and ammonia decreased fish growth rate. Temperature and DO ranging between 27 and $30^{\circ}C$ and 5-23 mg/l, respectively, and SGR of 3.8%/day and above are recommended for higher productivity.

• Korean Journal of Environmental Agriculture
• /
• v.31 no.2
• /
• pp.170-174
• /
• 2012

BACKGROUND: Inappropriate discharge of wastewaters and industrial effluents are becoming detrimental to the aquatic environment. The presence of toxic substances on wastewaters can be detected by physicochemical and biological methods. However, physicochemical methods do not give any information about biological toxicity. Therefore, in this study we tried to detect the presence of toxic substance on waters using sulfur-oxidizing bacteria (SOB) as a bioassay. MATERIALS AND RESULTS: The SOB biosensor was first stabilized using synthetic stream water and operated in both continuous and semi-continuous mode. When the SOB biosensor was operated in continuous mode, the effluent electrical conductivity (EC) stabilized at~1.72 dS/m. While in the case of semi-continuous, the EC stabilized at~0.6 dS/m. The SOB system was also operated at different reaction times to ascertain the shortest reaction time for monitoring the toxicity. Finally, the SOB biosensor was fed with nitrite as toxic substance. When 5 mg/L of nitrite was added to the SOB system, the EC decreased immediately. However, the EC recovered after few cycle. CONCLUSION: This study shows that the SOB biosensor can be used as warning system to protect aquatic environment from hazardous materials. Although SOB biosensor can not give specific information about the toxic substances, it can assess whether the water is toxic or not.

• Animal Bioscience
• /
• v.37 no.6
• /
• pp.1110-1120
• /
• 2024

Objective: This study was conducted to evaluate the effect of offering (OSF) or not (NSF) supplemental feed at milking on temperament (TS), udder hygiene (UHS) and body condition (BCS) scores, and milk yield per milking (MYM), milk quality traits, and profitability of primiparous Anatolian buffalo cows at 90 days of lactation confined in closed-tied (CB) or semi-open free-stall (OB) barns. Methods: In Experiment I, 108 cows were selected to encompass four treatments (OBOSF, OB-NSF, CB-OSF, and CB-NSF) of 27 cows, considering barn type (OB and CB) and supplementary feed (OSF and NSF) at milking. In Experiment II, 60 OB cows were selected to encompass one of five groups of 12 cows each: i) no supplemental feed (CON), ii) commercial concentrate (CC), iii) CC + corn silage (CCS), iv) CCS + alfalfa hay (CSA), or v) CC + ryegrass silage (CRS) at milking. Results: The TS and UHS of the OB and OSF cows were lower (better) than those of the CB and NSF cows, respectively. The OSF increased milk protein, lactose, and solids-not-fat but decreased milk freezing point and electrical conductivity compared with the NSF. The MYM and milk fat of the OB-OSF cows were higher than those of the OB-NSF and CBNSF cows. The TS and UHS of the cows negatively correlated with MYM and some milk chemicals (fat, protein, and solids-not-fat), but BCS correlated positively. The TS and milk electrical conductivity of the CCS, CSA, and CRS cows were lower than those of the CON and CC cows, but BCS, MYM, and milk fat were higher. Partial budget analysis identified a higher net profit for supplemental feed-offered groups (OB-OSF, CCS, CSA, and CRS). Conclusion: Offering roughage with concentrates at milking for indoor primiparous buffalo cows is more conducive to well-being, milk yield, milk quality, and economy.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.21 no.5
• /
• pp.205-209
• /
• 2011

Zinc oxide has semi-conductivity and super conductivity characteristics. It can be used optically and is applied on many areas such as gas sensor, solar cell and optical waveguide. In this paper, to improve optical characteristics of ZnO, aluminum was added on zinc oxide. Zinc oxide and aluminum zinc oxide was fabricated as nano fiber form. ZnO solution was created by mixing poly vinyl pyrrolidone, ethyl alcohol, and zinc acetate. An Al doped ZnO was created by adding aluminum solution to ZnO sol. By applying these sols on electro spinning method, nano fibers were fabricated. These fibers are heat treated at 300, 500, and $700^{\circ}C$ degrees and were analyzed with X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS) and scanning electron microscopy (SEM) to examine the nano structures. TGA and DSC measurement was also used to measure the change of mass and calorie upon temperature change. The absorbance of ZnO and Al-doped ZnO was carried out by UV-vis measurement.

• Korean Journal of Environmental Agriculture
• /
• v.33 no.4
• /
• pp.314-320
• /
• 2014

BACKGROUND: Run off from agricultural sites contaminates water bodies with nitrogen which is toxic and causes eutrophication when excessively accumulated. Hence, the interest in monitoring nitrogen toxicity in aquatic environment has been continuously increasing. METHODS AND RESULTS: To detect a real time toxicity of various nitrogen compounds, we applied biomonitoring method (biosensor) based on sulfur-oxidizing bacteria (SOB). The toxicity biomonitoring test was conducted in semi-continuous mode in a reactor filled with sulfur particles (2~4 mm diameter) under aerobic condition. Relative toxicity was simply determined by measuring the change in electrical conductivity (EC). Various nitrogenous compounds at different concentrations were evaluated as a potential toxic substance. Nitrite was found to be very toxic to SOB with a 90% inhibition even when the concentration as low as 3 mg/L. However, nitrate and ammonia have any inhibitory effect on SOB's activity. CONCLUSION: The biosensor based on SOB responded sensitively to nitrite even at substantially low concentrations. Therefore, it can be used as a reliable biological alarm system for rapid detection of contaminants due to its simplicity and sensitive nature.