• 한국전기전자재료학회논문지
• /
• 제29권7호
• /
• pp.408-413
• /
• 2016

The dielectric thin films applied to multi-colored semitransparent thin film solar cells have been extensively studied. In this work, we prepared GeSbTe and GeTe chalcogenide thin films using magnetron sputtering, and investigated their optical and phase-change properties to replace the dielectric films. The changes of surface morphology, sheet resistance, and X-ray diffraction of the Te-based chalcogenide films support the fact that the amorphous stability of GeTe films is superior to that of GeSbTe films. While both amorphous GeSbTe and GeTe films thinner than 30 nm have optical transparency between 5% and 60%, GeTe films transmit more visible light than GeSbTe films. It is confirmed by computer simulation that the color of semitransparent silicon thin film solar cells can be adjusted with the addition of GeSbTe or GeTe films. Since it is possible to adjust the contrast of the solar cells by exploiting the phase-change property, the two kinds of chalcogenide films are anticipated to be used as an optical layer in semitransparent solar cells.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1987년도 정기총회 및 창립40주년기념 학술대회 학회본부
• /
• pp.207-209
• /
• 1987

This paper reports the effect of additive elements such as Bi, Sb on degradation and hole formation of the Te-Se thin films. Changes in light transmission were used to monitor the degradation rate of thin Te films in an accelerated temperature-humidity environment. In thin accelerated temperature-humidity environment, $(Te_{86}Se_{14})_{70}Bi_{30}$ thin film was stable and $(Te_{86}Se_{14})_{50}Sb_{50}$ thin film was unstable in comparison with the other films that used in this experiment. The hole formation was carried out in the Te-based thin films.

• 반도체디스플레이기술학회지
• /
• 제8권3호
• /
• pp.13-17
• /
• 2009

we have studied characterization of microbolometer based on the co-sputtered silicon-antimony ($Si_{1-x}Sb_x$) thin film for infrared microbolometer. We have investigated the resistivity and the temperature coefficient of resistance (TCR) with annealing. We deposited the films using co-sputtering method at $200^{\circ}C$ in the Ar environment. The Sb concentration has been adjusted by applying variable DC power from Sb targets. TCR of deposited $Si_{1-x}Sb_x$ films have been measured the range of -2.3~-2.8%/K. The resistivity of the film is low but TCR is higher than the other bolometer materials. Resistivity of the films has not been affected hugely according to the low annealing temperature however the resistivity has been dramatically decreased over $250^{\circ}C$. It is caused of a phase change due to the rearrangement of Si and Sb atoms during crystallization process of the films.

• 한국재료학회지
• /
• 제8권3호
• /
• pp.195-199
• /
• 1998

R.F. Magnetron Sputtering 법으로 Co를 base로 MnSbPt 합금박막의 최적 열처리 조건은 $300^{\circ}C$-4시간 이었으나, 종래의 MnSbPt 합금박막의 경우와 같이 수직자화막은 얻을 수 없었다. 보자력은 Co의 두께가 $250\AA$에서 최대를 나타냈으나 약 500 Oe이하로 실용적 측면에서 불충분 하였다. 진공중에서 $300^{\circ}C$ 4시간 열처리한 합금박막의 경우, 700nm의 입사파장에서 약 $0.78^{\circ}$에 이르는 Kerr 회전각을 보이므로 고보자력을 지닌 수직자화막을 제조할 수 있다면 우수한 차세대 고밀도 자기 기록매체로서 유망하다.

• 한국재료학회지
• /
• 제24권3호
• /
• pp.145-151
• /
• 2014

Solution-based Sb-doped $SnO_2$ (ATO) transparent conductive oxides using a low-temperature process were fabricated by an electrospray technique followed by spin coating. We demonstrated their structural, chemical, morphological, electrical, and optical properties by means of X-ray diffraction, X-ray photoelectron spectroscopy, field-emission scanning electron microscopy, atomic force microscopy, Hall effect measurement system, and UV-Vis spectrophotometry. In order to investigate optimum electrical and optical properties at low-temperature annealing, we systemically coated two layer, four layer, and six layers of ATO sol-solution using spin-coating on the electrosprayed ATO thin films. The resistivity and optical transmittance of the ATO thin films decreased as the thickness of ATO sol-layer increased. Then, the ATO thin films with two sol-layers exhibited superb figure of merit compared to the other samples. The performance improvement in a low temperature process ($300^{\circ}C$) can be explained by the effect of enhanced carrier concentration due to the improved densification of the ATO thin films causing the optimum sol-layer coating. Therefore, the solution-based ATO thin films prepared at $300^{\circ}C$C exhibited the superb electrical (${\sim}7.25{\times}10^{-3}{\Omega}{\cdot}cm$) and optical transmittance (~83.1 %) performances.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2007년도 추계학술대회 논문집
• /
• pp.262-263
• /
• 2007

Effect of co-doping on optical and electrical properties of $SnO_2$ based thin films were studied. $SnO_2$ ceramic targets with up to 50mol% $CuSb_2O_6$ were prepared by sintering mixed-oxide compact in the temperature range of $1100^{\circ}C{\sim}1300^{\circ}C$ in air. Thin films were then deposited onto glass substrates by pulsed laser deposition where substrate temperature was maintained in the range of $500{\sim}650^{\circ}C$ with oxygen pressure of 3m~7.5mTorr and energy density of $1Jcm^{-2}$. It was found that with the increase amount of dopant, the electrical properties of thin films tended to improve with the smallest resistivity value obtained at about 8mol% doping, further increase, however, usually impaired the optical transmission in the visible range.

• 한국재료학회:학술대회논문집
• /
• 한국재료학회 1997년도 한국재료학회 추계학술발표회
• /
• pp.60-60
• /
• 1997

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2006년도 제37회 하계학술대회 논문집 C
• /
• pp.1438-1439
• /
• 2006

$Ge_{2}Sb_{2}Te_5$(GST) thin film at present is a promising candidate for a phase change random access memory (PCRAM) based on the difference in resistivity between the crystalline and amorphous phase. PCRAM is an easy to manufacture, low cost storage technology with a high storage density. Therefore today several major chip in manufacturers are investigating this data storage technique. Recently, A. Pirovano et al. showed that PCRAM can be safely scaled down to the 65 nm technology node. G. T Jeonget al. suggested that physical limit of PRAM scaling will be around 10 nm node. Etching process of GST thin ra films below 100 nm range becomes more challenging. However, not much information is available in this area. In this work, we report on a parametric study of ICP etching of GST thin films in $Cl_2$/Ar chemistry. The etching characteristics of $Ge_{2}Sb_{2}Te_5$ thin films were investigated using an inductively coupled plasma (ICP) of $Cl_2$/Ar gas mixture. The etch rate of the GST films increased with increasing $Cl_2$ flow rate, source and bias powers, and pressure. The selectivity of GST over the $SiO_2$ films was higher than 10:1. X-ray photoelectron spectroscopy(XPS) was performed to examine the chemical species present in the etched surface of GST thin films. XPS results showed that the etch rate-determining element among the Ge, Sb, and Te was Te in the $Cl_2$/Ar plasma.

• 한국광학회지
• /
• 제12권5호
• /
• pp.394-400
• /
• 2001

다층 박막에서의 빛의 반사와 흡수 및 열전달 방정식을 수치해석적으로 풀어 광기록매체용 다층 박막의 광학적 특성과 열전달 특성을 알아보고 이 두 특성들을 모두 고려하여 광기록에 적합한 레이저의 출력 및 지속시간, 다층 박막 구조 상수를 제시하였다. 그 결과 레이저는 650 nm 파장을 기준으로 출력 18mW, 지속 시간 60 nm가 적당하였으며 박막 구조 상수는 ZnS-SiO$_2$140nm, Ge-Sb-Te 20 nm, ZnS-SiO$_2$20~30nm, Al-alloy 100~150 nm가 적당하였다.

• 한국진공학회지
• /
• 제6권1호
• /
• pp.69-76
• /
• 1997

순간 증착법으로 $Bi_{0.5}Sb_{1.5}Te_3$(p형)와 $Bi_2Te_{2.4} Se_{0.6}$(n형) 박막을 제조하여 두께와 어닐 링 조건에 따른 Seebeck 계수, 전기전도도, carrier 농도 및 이동도, 열전도도, 성능지수의 변화 등 열-전기적 특성을 조사하였다. 473K에서, 1시간 진공 열처리한 결과 p형과 n형의 성능지구는 각각 $1.3{\times}10^{-3}K^{-1}$ 및 $0.3{\times}10^{-3}K^{-1}$으로 향상되었으며 두께에 크게 의존하지 않았 다. 이런 성질을 갖는 열전 박막을 소자화한 박막 온도 센서를 유리와 Teflon기판 위에 제 조하였으며, 이들의 온도 변화에 대한 열기전력, 민감도 및 시간 상수 등 센서 특성을 측정 하였다. p 및 n형의 leg 폭 1mm$\times$길이 16mm인 박막 온도 센서의 경우, Teflon 기판일 때 좋은 성능을 나타내었으며, 민감도는 2.91V/W, 시간 상수는 28.2초이었다.