• Proceedings of the Korean Vacuum Society Conference
• /
• 2014.02a
• /
• pp.344-344
• /
• 2014

Transparent amorphous oxide semiconductors such as a In-Ga-Zn-O (a-IGZO) have advantages for large area electronic devices; e.g., uniform deposition at a large area, optical transparency, a smooth surface, and large electron mobility >10 cm2/Vs, which is more than an order of magnitude larger than that of hydrogen amorphous silicon (a-Si;H).1) Thin film transistors (TFTs) that employ amorphous oxide semiconductors such as ZnO, In-Ga-Zn-O, or Hf-In-Zn-O (HIZO) are currently subject of intensive study owing to their high potential for application in flat panel displays. The device fabrication process involves a series of thin film deposition and photolithographic patterning steps. In order to minimize contamination, the substrates usually undergo a cleaning procedure using deionized water, before and after the growth of thin films by sputtering methods. The devices structure were fabricated top-contact gate TFTs using the a-IGZO films on the plastic substrates. The channel width and length were 80 and 20 um, respectively. The source and drain electrode regions were defined by photolithography and wet etching process. The electrodes consisting of Ti(15 nm)/Al(120 nm)/Ti(15nm) trilayers were deposited by direct current sputtering. The 30 nm thickness active IGZO layer deposited by rf magnetron sputtering at room temperature. The deposition condition is as follows: a rf power 200 W, a pressure of 5 mtorr, 10% of oxygen [O2/(O2+Ar)=0.1], and room temperature. A 9-nm-thick Al2O3 layer was formed as a first, third gate insulator by ALD deposition. A 290-nm-thick SS6908 organic dielectrics formed as second gate insulator by spin-coating. The schematic structure of the IGZO TFT is top gate contact geometry device structure for typical TFTs fabricated in this study. Drain current (IDS) versus drain-source voltage (VDS) output characteristics curve of a IGZO TFTs fabricated using the 3-layer gate insulator on a plastic substrate and log(IDS)-gate voltage (VG) characteristics for typical IGZO TFTs. The TFTs device has a channel width (W) of $80{\mu}m$ and a channel length (L) of $20{\mu}m$. The IDS-VDS curves showed well-defined transistor characteristics with saturation effects at VG>-10 V and VDS>-20 V for the inkjet printing IGZO device. The carrier charge mobility was determined to be 15.18 cm^2 V-1s-1 with FET threshold voltage of -3 V and on/off current ratio 10^9.

• Journal of Hospice and Palliative Care
• /
• v.14 no.1
• /
• pp.28-33
• /
• 2011

Purpose: Recognition of impending death is crucial not only for efficient communication with the caregiver of the patient, but also determination of the time to refer to a separate room. Current studies simply list the events 'that have already occurred' around 48 hours before the death. This study is to analyze the predictability of each event by comparing the time length from 'change' to death. Methods: Subjects included 160 patients who passed away in a palliative care unit in Incheon. The analysis was limited to 80 patients who had medical records for the last week of their lives. We determined 9 symptoms and 8 signs, and established the standard of 'significant change' of each event before death. Results: The most common symptom was increased sleeping (53.8%) and the most common sign was decreased blood pressure (BP) (87.5%). The mean time to death within 48 hours was 46.8% in the case of resting dyspnea, 13.6% in the ease of low oxygen saturation, and 36.9% in the case of decreased BP. The symptom(s) which had the highest positive predictive value (PV) for death within 48 hours was shown to be resting dyspnea (83%), whereas the combination of resting dyspnea and confusion/delirium (65%) had the highest negative PV. As for the most common signs before death within 48 hours, the positive PVs were more than 95%, and the negative PV was the highest when decreased BP and low oxygen saturation were combined. The difference in survival patterns between symptoms and signs was significant. Conclusion: The most reliable symptoms to predict the impending death are resting dyspnea and confusion/delirium, and decline of oxygen saturation and BP are the reliable signs to predict the event.

• Journal of IKEEE
• /
• v.13 no.1
• /
• pp.57-64
• /
• 2009

The optoelectrical characteristics of the ZnO nanoparticles (NPs) annealed in vacuum or oxygen condition from $200^{\circ}C$ to $600^{\circ}C$ were examined. Increased on-off ratio (or, the ratio of photocurrent to dark current) was observed when they were annealed at $300^{\circ}C$, $400^{\circ}C$ and $500^{\circ}C$ with the values enhanced about 4 orders compared to the as-prepared ZnO NPs in both annealing conditions, while the maximum efficiency was shown at the annealing temperature of $600^{\circ}C$ for the ZnO NPs annealed in vacuum with the value of 29.8 mA/W and at the temperature of $500^{\circ}C$ for those annealed in oxygen condition with the value of 40.3 mA/W. Photoresponse behavior of the ZnO NPs annealed in oxygen showed the sharp increase right after the ir exposure to the light followed by the slow decay and saturation during steady illumination, differing from the ZnO NPs annealed in vacuum which only exhibited the gradual increase. This difference occurred due to the curing effect of the oxygen vacancies. SEM images indicated no change in their morphologies with annealing, indicating the change in their internal structures by annealing, and most remarkably at $600^{\circ}C$. As for their photoluminescence(PL) spectra, the decrease of the deep-level(DL) emission was observed when they were annealed in oxygen at $400^{\circ}C$, and not at $200^{\circ}C$ and $600^{\circ}C$.

• Asian Pacific Journal of Cancer Prevention
• /
• v.15 no.9
• /
• pp.3965-3971
• /
• 2014

Background: In Iran, there are high rates of breast cancer. It is among the five most common cancers, the first among cancers diagnosed, and is the leading cause of cancer deaths among Iranian women. Objectives: The purpose of this qualitative study was to explore perception of breast cancer screening among Iranian women who have never had a mammograph. Materials and Methods: The current study was part of a qualitative research conducted by means of content analysis method and purposive sampling of 16 women over the age of 30 years who had not undergone mammography using individual semi-structured interviews. Interviews were recorded and transcribed verbatim. The data were under continuous consideration and comparative analysis in order to achieve data saturation. Results: After codification of data, three concept categories were achieved including: i) low awareness, ii) worries, and iii) lack of motivation. Conclusions: Although there is a tendency among Iranian women to participate in breast cancer screening, there is a powerful cultural belief that breasts are sexual organs that should not be discussed publicly. Due to the incidence of breast cancer in Iranian women, it is critical that breast awareness education be performed by health care experts to explore the concepts of breast cancer and breast cancer screening.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.48 no.2
• /
• pp.95-104
• /
• 2011

In this paper, the metamaterial transmission line (TL) based on the complementary spiral resonators (CSRs) and interdigital structure is presented for reducing the phase noise of the voltage-controlled oscillator (VCO). The metamaterial TL is realized by adopting the array of the CSRs etched on the ground plane and the interdigital transmission line on the signal plane. The interdigital TL on the signal plane has been used to obtain higher Q value than the conventional TL without the interdigital structure. The resonance properties and inherent saturation of Q value of the proposed metamaterial TL have been analyzed by varying the width of the TL on the signal plane, dimensions of the CSRs, current directions between the CSRs, number of the unit cell-pair of the CSRs, and whether or not there is the interdigital structure in this paper. The phase noise and tuning range of the proposed VCO are -127.50~-125.33 dBc/Hz at 100 kHz and 5.744~5.852 GHz.

• Journal of IKEEE
• /
• v.22 no.1
• /
• pp.1-5
• /
• 2018

In this research, sol-gel processed CuO p-type thin film transistors were fabricated with copper (II) acetate monohydrate precursors. After $500^{\circ}C$ annealing process, the deposited thin films were fully converted into CuO. We investigated $UV/O_3$ process time effect on electrical characteristics of sol-gel processed CuO thin film transistors. After 600 sec $UV/O_3$ process, the fabricated CuO thin film transistor delivered field effect mobility in saturation regime of $5{\times}10^{-3}\;cm^2/V{\cdot}s$ and on/off current ratio of ${\sim}10^2$.

• Geomechanics and Engineering
• /
• v.14 no.6
• /
• pp.581-588
• /
• 2018

In order to explore the comprehensive evaluation means of the extent of hydraulic fracturing region in coal seams, we analyzed the feasibility of detecting the response of coal rock direct current (DC) apparent resistivity to hydraulic-fracturing using Archie's theory, and conducted experimental researches on the response of DC resistivity in the hydraulic fracturing process using small-scale coal rock samples. The results show that porosity and water saturation are the two factors affecting the apparent resistivity of coal rock while hydraulic fracturing. Water has a dominant effect on the apparent resistivity of coal rock samples. The apparent resistivity in the area where water flows through is reduced more than 50%, which can be considered as a core affect region of hydraulic fracturing. Stress indirectly impacts the apparent resistivity by changing porosity. Before hydraulic fracturing, the greater axial load applied, the more serious the rupture in the samples, resulting in the greater apparent resistivity. Apparent resistivity testing is a potential regional method to evaluate the influence range of hydraulic fracturing in coal seams.

• Journal of the Institute of Electronics Engineers of Korea SP
• /
• v.44 no.2 s.314
• /
• pp.126-136
• /
• 2007

This paper presents an enhanced algorithm for compensating the visual quality in back-light image. Current cameras do not represent all details of scene into human's eye. Saturation and underexposure are common problems in back-light image. Retinex algorithm, derived from Land's theory on human visual perception is known to be effective in enhancing the contrast. However, its weaknesses are long processing time and low contrast of bright area in back-light scene because of compensating the details of dark area. In this paper, K-Retinex algorithm is proposed to reduce the processing time and enhance the contrast in both dark and bright area. To show the superiority of proposed algorithm, we compare the processing time, local standard deviation and contrast per pixel of each area above.

• Journal of the Korean Association of Geographic Information Studies
• /
• v.18 no.2
• /
• pp.105-119
• /
• 2015

The overseas expansion is essential to expand domestic geospatial industries in a state of saturation. But current overseas expansion method has be limited to expand global market. Inter-industry convergence strategies may be the most resonable alternative to expand global market through raising the expansion possibility to developing countries with ODA funds and to developed countries with converging global competitive industries. This research investigates various foreign developed and developing countries to draw each demand. As a result, easiness of convergence, confidentiality of information, complementarity of poor infrastructure, responsiveness of various demands and sustainability of system are needed to successful convergence on multiple industries. This research seeks convergence framework to meet this demands, and suggests each component. This convergence framework is consisted of geospatial convergence common framework, inter-industry convergence model and institutional supporting system for overseas expansion.

• Publications of The Korean Astronomical Society
• /
• v.32 no.1
• /
• pp.73-75
• /
• 2017

Debris disks are important observational clues to understanding on-going planetary system formation. They are usually identified by significant mid-infrared excess on top of the photospheric emission of a central star on the basis of prediction from J-, H-, and Ks-band fluxes and the stellar model spectra. For bright stars, 2MASS near-infrared fluxes suffer large uncertainties due to the near-infrared camera saturation. Therefore we have performed follow-up observations with the IRSF 1.4 m near-infrared telescope located in South Africa to obtain accurate J-, H-, and Ks-band fluxes of the central stars. Among 754 main-sequence stars which are detected in the AKARI $18{\mu}m$ band, we have performed photometry for 325 stars with IRSF. As a result, we have successfully improved the flux accuracy of the central stars from 9.2 % to 0.5 % on average. Using this dataset, we have detected $18{\mu}m$ excess emission from 57 stars in our samples with a $3{\sigma}$ level. We find that some of them have high ratios of the excess to the photospheric emission even around very old stars, which cannot be explained by the current planet-formation theories.