• Nuclear Engineering and Technology
• /
• v.24 no.1
• /
• pp.98-109
• /
• 1992

In this study uniaxial cyclic loading tests were performed on Cheon-Ho Mt. Limestone specimens to investigate the fatigue failure behavior. The loading rate was kept constantly at 760kg/$\textrm{cm}^2$/sec under cyclic loading. In order to reveal the fatigue behavior for each rock type, the test results were mutually compared with previous studies carried out on Indiana Limes-tone and Seong-Ju Sandstone. Fatigue data is presented in the form of S-N curves, which illustrate the relationship of maximum applied stress(S) to the number of cycles(N) required to produce failure. For the purpose of comparing the S-N curves for each rock type, the test data were formulated up to 10$^4$cycles and the correlation coefficients(R) on Cheon-Ho Mt. Limestone and Seong-Ju Sandstone specimen are 0.886 and 0.983, respectively. All three rock specimens were found to have shorter fatigue life at higher applied stress levels. The fatigue life for each rock type was considered as no less than 81.5, 70 and 74.8%, for Cheon-Ho Mt. Limestone, Indiana Limestone and Seong-Ju Sandstone, respectively. The comparison in static strength for monotonic loaded specimens and specimens which did not fail even after 10$^4$cycles indicated that the increasing rate of strength was about 6.18 and 10.96% , for Cheon-Ho Mt. Limestone and Indiana Limestone, respectively. Poisson's ratio and volumetric strain for Cheon-Ho Mt. Limestone and Seong-ju Sandstone, tended in all the cases to rapidly increase at higher stress levels and with an increase in number of cycles. This increasing trend becomes rapid and obvious just before failure. Also Poisson's ratio and volumetric strain for each stress level were compared and analyzed at the first cycle and the cycle prior to failure.

• Polymer(Korea)
• /
• v.36 no.4
• /
• pp.427-433
• /
• 2012

A series of poly(imide-aramid-sulfone)s with alternatingly introduced imide/aramid groups were prepared by reacting divinyl sulfone (DVS) and $N^1,N^4$-bis(4-(vinylsulfonyl)phenyl)terephthalamide (2) with pyromellitic diimide. Three model compounds, N-[2-(p-aminophnenylsulfonyl)ethyl]phthalimide (3), 2,2'-(2,2'-sulfonylbis(ethane-2,1-diyl))diisoindoline-1,3-dione (4), and N,N-bis(4-(2-(1,3-dioxoisoindolin-2-yl)ethylsulfonyl)phenyl)terephthalamide (5), resembling polymers were prepared with good yields by reacting p-aminophenyl vinyl sulfone, DVS, and 2 with phthalimide. Condensation polymerization was carried out by Michael-type addition reaction of the difunctional phthalimide group with the DVS group in the presence of tetrabutylammonium hydroxide (TBAH), resulting in poly(imide-aramid-sulfone)s 6-12 with moderate molecular weights and good yields. They were highly soluble in polar solvents such as N,N-dimethylformamide, dimethylsulfoxide, N-methylpyrrolidinone and tetrahydrofuran. The ratios of DVS/2 were 1/0, 3/1, 2/1, 1/1, 1/2, 1/3, and 0/1. Molecular weight and physical properties such as solubility, viscosity, and thermal properties of the polymers were examined.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2008.11a
• /
• pp.133-134
• /
• 2008

이 논문에서는 $SiN_x$의 band gap 차이를 이용하여 MIS 구조의 메모리 소자를 제작하고 이를 분석하였다. $SiN_x$ 박막은 증착 가스비에 따라 다양한 band gap을 가지게 된다. 본 실험에서는 n-type 단결정 실리콘 기판위에 $SiH_4/NH_3$ 가스를 혼합하여 $SiN_x$ 박막을 증착하고, UV-Vis Spectrophotometer 장비를 이용하여 band gap을 구하였다. 큰 band gap을 갖는$SiN_x$ 박막을 블로킹 층에, 작은 band gap을 작는 $SiN_x$ 박막을 전하 저장 층에 사용하였다. 제작된 NNO 구조일 소자는 7.6 V의 hysteresis roof 폭과 1000초 후에 88.6 %의 retention 값을 갖는 우수한 메모리 특성을 보였다.

• Proceedings of the Korean Institute of Surface Engineering Conference
• /
• 2000.11a
• /
• pp.27-27
• /
• 2000

TDEAT precursor를 이용하여 DC-Pulse Plasma MOCVD 방법과 Thermal MOCVD 방법으로 각각 TiN 박막을 증착하였다. 본 논문에서는 DC-Pulse Plasma MOCVD 방 법으로 증착된 TiN 박막과 Therrnal MOCVD 방법으로 증착된 TiN 박막의 전기적 특성에 관하여 비교 분석하였다. 동일한 조건 하에서 각각의 방법으로 증착된 박막은 4-point probe를 이용하여 면저항을 측정하였고, XRD를 이용하여 박막의 성장방향을 관찰하였으며, FE-SEM을 이용하여 박막의 두께와 단면 사진, 표면형상을 관찰하였으며, AES depth profile을 통해 두께에 따른 Ti, N, 잔류 C와 0의 함량을 분석하였으며, XPS를 통해 C의 결합형태를 파악하고자 하였다. 분석결과 DC-Pulse Plasma MOCVD 방법으로 증착된 TiN 박막이 Thermal MOCVD 방법으로 증착된 TiN 박막에 비해 전기적 특성은 매우 우수하였으며, 치밀한 구조의 박막을 가지는 것으로 나타났다. 또한, 잔류 C, O의 함량이 낮은 것으로 나타났다.

• Journal of Korean Society of Forest Science
• /
• v.111 no.2
• /
• pp.234-241
• /
• 2022

We performed this study to determine the foliar nutrient concentration and the nutrient stocks of restoration areas and adjacent Pinus densiflora S. et. Z. (red pine) stands in opencast kaolinite mines in Sancheong-gun, Gyeongsangnam-do, southern Korea. We chose six sites to determine foliage nutrient concentrations and the nutrient stocks of soils (0-10 cm depth). The dominant vegetation planted in restoration areas comprised Quercus acutissima Carruth., P. koraiensis S. et. Z., Festuca arundinacea Schreb., and Lespedeza cuneata G. Don. Invading vegetation in the restoration areas comprised Alnus incana (L.) Medik., Robinia pseudoacacia L., and Lespedeza spp., among others. The carbon and nitrogen stocks at 10 cm soil depth were significantly higher in the red pine stands than those in the restoration areas, whereas those of phosphorus, potassium, and magnesium were not significantly different between the two areas. However, calcium stocks were significantly higher in the restoration areas than in the red pine stands. Nitrogen concentration in foliage was higher in L. cuneata (20.28 mg N g^-1) than that in F. arundinacea (5.67 mg N g^-1), whereas potassium concentration was twice as high in F. arundinacea (18.8 mg K g^-1) as that in L. cuneata (9.07 mg K g^-1). Foliar nitrogen concentrations in invasive vegetation such as A. incana, R. pseudoacacia, and Lespedeza spp. were twice or four times higher than those of Q. acutissima and P. koraiensis. Our results indicate the development of suitable vegetation and soil amendment treatments to improve poor soil environmental conditions in restoration areas are necessary following opencast kaolinite mining.

• Korean Journal of Materials Research
• /
• v.9 no.10
• /
• pp.1012-1017
• /
• 1999

Low resistance ohmic contacts to the Si-doped $\textrm{In}_{0.17}\textrm{Ga}_{0.83}\textrm{N}$(~$\times10^{19}\textrm{cm}^{-3}$) were obtained using the W metallization schemes. Specific contact resistance decreased with increasing annealing temperature. The lowest resistance is obtained after a nitrogen ambient annealing at $950^{\circ}C$ for 90 s, which results in a specific contact resistance of $2.75\times10^{-8}\Omega\textrm{cm}^{-3}$. Interfacial reactions and surface are analyzed using x-ray diffraction and scanning electron microscopy (SEM). The X-ray diffraction results show that the reactions between the W film and the $\textrm{In}_{0.17}\textrm{Ga}_{0.83}\textrm{N}$ produce a $\beta$-$W_2N$ phase at the interface. The SEM result shows that the morphology of the contacts is stable up to a temperature as high as $850^{\circ}C$. Possible mechanisms are proposed to describe the annealing temperature dependence of the specific contact resistance.

• Applied Chemistry for Engineering
• /
• v.16 no.6
• /
• pp.778-784
• /
• 2005

It has been found that the addition of cosurfactant is necessary in order to expand three phase region containing middle phase microemulsion in ternary systems containing alkyl ethoxylate (AEO) nonionic surfactant, commercial lubricant and water. Phase behavior in the surfactant systems with addition of cosurfactant over a temperature range of 30 to $60^{\circ}C$ showed different trends depending on surfactant, temperature and chain length of alcohol added. For the $C_{12}E_4$ system, addition of n-pentanol and n-hexanol both produced a three phase region over a wide range of temperatures but the middle-phase formed was found to be a $L_3$ or D' phase which would not facilitate solubilization of high molecular weight lubricants. On the other hand, for the $C_{12}E_5$ system, the middle-phase microemulsion was found to be formed with addition of a rather long-chain alcohol such as n-hexanol, n-heptanol, n-octanol, or n-nonanol. The results shown with the addition of cosurfactant was understood in connection with interfacial tension measurements and composition analysis. The inability of the hydrocarbon region of the surfactant films to incorporate the large lubricant molecules and high solubility of a hydrophobic surfactant are thought to be the chief reasons for poor solubilization with D' phase.

• Radiation Oncology Journal
• /
• v.9 no.1
• /
• pp.65-72
• /
• 1991

One hundred and thirty five patients with carcinoma of the nasopharyx were treated by radiation therapy in the Department of Radiation Oncology, Yonsei Cancer Center, Yonsei University between August 1977 and July 1987. Of the 30 patients omitted: 8 had distant metastases at initial diagnosis or during radiotherapy; 18 Patients refused or did not receive a full course of radiation therapy, and four had not been confirmed histologically. The remaining 105 patients were analysed to determine the incidence and pattern of distant metastases. Diagnosis of distant metastases was made based on clinical signs and radiography, even though histologic confirmation was not made. Twenty-six patients developed distant metastases after definite irradiation of nasopharyx and neck, an incidence rate of $24.8\%$ . The common sites of distant metastases were, in descending order, bone, lung, liver, and brain. There was a strong correlation between Ho's N stage and distant metastases rate. But sex, age, histologic subtype (squamous cell and undifferentiated cell), AJC T and N stage, treatment modalities (radiotherapy alone and radiotherapy combined with chemotherapy) were not significant. Of those patients who developed distant metastases, $80.8\%$ were discovered within 2 years of their radical radiotherapy. The prognosis for nasopharyngeal carcinoma patients developing distant metastases was poor: median survival was nine months and $80\%$ of those patients died within two years of the initial diagnosis of distant metastasis.

• Proceedings of the KIEE Conference
• /
• 1999.11d
• /
• pp.1148-1150
• /
• 1999

Fresnel lens는 zone plate에 비해 공정은 쉬우나 회절 효율이 높은 것으로 알려져 있다. 본 논문에서는 micro fresnel lens를 설계하고 각각의 회절 효율 및 focal size를 계산하였으며. 비교적 공정이 용이한 계단 모양의 fresnel lens를 설계하여 회절 효율과 focal size를 계산하였다. 그리고, 광원의 파장과 초점거리에 따른 lens의 회절 효율을 비교하였으며, 계단의 수에 따른 회절 효율도 비교하였다.

• Journal of the Korean Chemical Society
• /
• v.50 no.5
• /
• pp.355-361
• /
• 2006

The critical micelle concentration (CMC) and the counterion binding constant (B) in a mixed micellar state of the sodium dodecylbenzenesulfonate (DBS) with the polyoxyethylene(23) lauryl ether (Brij 35) at 25oC in water and aqueous solutions of n-butanol (0.1M, 0.2M, and 0.3M) were determined as a function of a1 (the overall mole fraction of DBS) by the use of electric conductivity method and surface tensiometer method. Various thermodynamic parameters (Xi, i, Ci, aiM, , and Hmix) were calculated by means of the equations derived from the nonideal mixed micellar model. The effect of n-butanol on the micellization of the DBS/Brij 35 mixtures has been also studied by analyzing the measured and calculated thermodynamic parameters.