• Journal of the Korean Geotechnical Society
• /
• v.37 no.7
• /
• pp.5-12
• /
• 2021

When drilling investigations for Rock Slopes are not possible, it is often difficult to calculate the Ground Design Constants required for the Limit Equilibrium Analysis. Therefore, the outcrops or partially cutted Rock Slopes were analysed using JRC and JCS that can be easily and conveniently measured. In particular, the effect of the JRC on the Safety Factor or the Rock Slopes was analyzed intensively, and the results were presented as a relationship formula and Table. When the Rock slope was stable, the JRC increased by an average of 9.0% as the slope height increased, and increased by an average of 29.8% as the slope angle increased. JRC was more sensitive to slope angle changes. The Cohesion corresponding to JRC was calculated from JRC-Fs formula. JRC and Cohesion showed a nonlinear relationship, and the Cohesion was about 8.0% more sensitive to slope height changes than slope angle changes.

• 한국방재학회:학술대회논문집
• /
• 2008.02a
• /
• pp.561-564
• /
• 2008

Rock slope had been slope failure due to geological and physical things over time. In this paper, it discusses rock slope stability analysis which was concerned about additional slope failure located near the Andong-si. Initially, achieved basic geological investigation and field test about rock slope, examine the stability of rock slope by doing limit equilibrium method and stereographic projection about 5 slopes.

• The Journal of Engineering Geology
• /
• v.17 no.2 s.52
• /
• pp.253-261
• /
• 2007

The failure of the road cut-slope due to heavy rains brings about lots of injuries and damage on national properties. KICT has developed CSMS system by means of prevention to manage the dangerous cut slopes. In spite of the continuous management the frequency of cut-slopes failure is increasing the past due to changes of earth-environment. KICT has installed the "Real-Time Monitoring System" on dangerous slopes. The operation of Real-Time Monitoring System is used as a positive system to reduce injuries and damages. However, Although the slope manager is aware of the signs collapsed in advance, it has temporal and spatial limits until the slope manager performs the works which are preventing the accidents. When real time monitoring system finds out an indication of slope collapse, the Rock-fall Signal Lamp System makes road-users indicated the risk of cut slopes. It is a kind of prevention system that it will minimize the damages of the properties as suspension of traffic automatically or passively.

• Journal of the Korean Society of Environmental Restoration Technology
• /
• v.5 no.4
• /
• pp.61-69
• /
• 2002

This study was conducted to develop revegetation methods for the restoration of the steep slopes by seed attached ripping net revegetation methods. In general, steep slopes with decomposed granite soils and ripping rock are easy to erode by precipitation and impossible to revegetate only using hydroseeding with core net mulching because of poor soil fertility. The Seed Attached Ripping Net Revegetation Methods(SALNRM) will be the most popular and sustainable methods to restore decomposed granite soils and ripping rock exposed slopes. The main results are summarized as follows; 1. The net size with $1.5cm{\times}1.0cm$ density was more suitable for growing plants, and increasing the ratio of the slow release fertilizer was better to make early coverage and to grow germinated plants. 2. The fertilizer bag made by the ratio of Peatmose : Vermiculite : Perlite : Quick release fertilize r : Slow release fertilizer = 10 : 2 : 5 : 3 : 4 (v : v) was the best for plant's growth. 3. According to the seed mixture experiments, even though not using foreign grasses, the SALNRM using native plants can make diverse plant composition. 4. The SALNRM will make same early ground coverage by only using native plants like using foreign grasses. The SALNRM would become the popular revegetation methods to restore decomposed granite soils and ripping rock exposed slopes in Korea.

• Geomechanics and Engineering
• /
• v.11 no.4
• /
• pp.457-469
• /
• 2016

Steep rock slope with water-filled tension crack will happen to overturn around the toe of the slope under seismic loading. This failure type is completely different from the common toppling failure occurring in anti-dipping layered rock mass slopes with steeply dipping discontinuities. This paper presents an analytical approach to determine the seismic factor of safety against overturning for an intact rock mass slope with water-filled tension crack considering horizontal and vertical seismic coefficients. This solution is a generalized explicit expression and is derived using the moment equilibrium approach. A numerical program based on discontinuous deformation analysis (DDA) is adopted to validate the analytical results. The parametric study is carried out to adequately investigate the effect of horizontal and vertical seismic coefficients on the overall stability against overturning for a saturated rock slope under two water pressure modes. The analytical results show that vertically upward seismic inertia force or/and second water pressure distribution mode will remarkably decrease the slope stability against overturning. Finally, several representative design charts of slopes also are presented for the practical application.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2005.10a
• /
• pp.210-220
• /
• 2005

We have analyzed the stability for cut-slopes at main street 3-2 line section in Pa-ju local industrial complex. After studying an additional boring test, laboratory test and face mapping etc., we have determined the extent of reinforcement, slope inclinations and soil strength parameter from the analysis of test results. After changing the inclination of slopes for ground limit and carrying out the analysis of slope stability, we applied the Mass Nailing Method to the site because of need for reinforcement to soil and weathered rock slopes. In slope for soft and hard rock sections, we also reinforced the sections that are difficult to obtain the safety without reinforcement in alteration zone.

• Journal of the Korean Society of Environmental Restoration Technology
• /
• v.10 no.4
• /
• pp.95-108
• /
• 2007

Test application of revegetation measure was made on the roadside slope damaged by Nongseo-Eomo national road improvement project in a bid to prevent the soil from being washed out as well as to restore the ecological environment, and the survey for assessment of the effect of slope revegetation measures was conducted, beginning May 11 through Nov 7, 2006. In the wake of comprehensive reviewing and evaluating the surrounding topographic environment, physical and chemical characteristics of soil, germination of revegetation plants, analysis of bio mass, covering ratio and the plants appeared, measure b was found to have been most appropriate to cut blasting rock slope, and alternatively measure c. For cut ripping rock slope, measure c-1 appeared to be effective in revegetation effect, and alternatively, b-1.When it comes to cut soil slope, measure c-2 was found to be effective, and b-2 to be a good alternative. And for embankment soil slope, measure b-3 appeared to be most efficient in revegetation effect and measure f as alternative.

• The Journal of the Korea Contents Association
• /
• v.10 no.6
• /
• pp.471-479
• /
• 2010

The main contribution of this paper is to propose the integrated database schema from several research projects included in "The Next Generation New Technology for Rock-falling and Landsliding Project". Furthermore this paper describes the development of integrated standard database system for the slopes databases. We also develop and implement the global real time web service system in order to provide one-stop data service for the slopes. In this paper, the new integrated database paradigm for rock-fall and landsliding data is designed and proposed and also data management system is developed based on the global web service system.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2000.09a
• /
• pp.81-92
• /
• 2000

Green Slope(F.F.R : Fabric Form Reinforcement Method) is one of an environmental slope protection method at steep cutting sites. This method is that soil and rock at the steep slope is fixed using the environmental Fabric Form, Nail, Rock Bolt and Rock Anchor, And then, the surfaces covered with grasses or weeds. This method will be satisfied both safe slope protection and natural environment appearance. Green Slope is a useful method of the construction sites of steep cutting slopes.

• Tunnel and Underground Space
• /
• v.9 no.2
• /
• pp.158-167
• /
• 1999

There are substantial difficulties in assessing the volume of soill/rock to be excavated and the cost thereof, which is attributable to the subjective and qualitative methods of rock mass classification prevailing at the moment. This paper intends to introduce more objective and quantitative rock mass classification method easily applicable to the excavation of granites in Muakjae, Seoul. As a result of such study it is proven that Schmidt hammer and point load strength tests are fairly reliable and easily applicable to estimate and quantify uniaxial compressive strength of granitic material in Seoul. In an efforts to confirm the granitic rock mass conditions in 12 meters underground, seismic refraction surveys were made on the top of vertical exposures from where underlying rock mass conditions could be directly inspected. Rock mass boundaries determined by seismic refraction methods were found to agree within a 1m variance with visible differences in rock mass conditions in the vertical exposure beneath the test site. Thus it can be concluded that detailed geotechnical mapping on cutting slopes is a most efficient, dependable and cost-effective technique in assessing likely excavation conditions of shallow granitic mass in Seoul.