• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.23 no.12
• /
• pp.1327-1336
• /
• 2012

In this paper, the dual-faced monopole antenna, which is arranged by numerous rectangular ring patches in sequence for the multi-bands is proposed. The ring type structure of the patch can be increased the bandwidth. Therefore the bandwidth and beam width are improved by using multiple arrayed patches. When the ring type patches are inserted serially, the resonance frequencies are occurred by the current flow from the first ring patch. It is possible because the gap between the patches is very narrow. In addition, if the patches are composed on the same plane as the feed-line, fabrication could be very difficult because the gap between the patches is extremely narrow. The thickness and permittivity of the antenna, moreover, are very important parameters because both sides of the substrate are used. We finally found the optimal thickness and permittivity to generate the coupling effect by simulation. All patches are consisted of 4-steps which the patch size was decreased 85 % by each step. In conclusion, the resonant frequency bands are 1.75~2.6 GHz(850 MHz), 3.24~3.46 GHz(220 MHz), 3.8~4.0 GHz(200 MHz), and 4.4~4.9 GHz(500 MHz).

• Journal of Chest Surgery
• /
• v.16 no.3
• /
• pp.337-341
• /
• 1983

The experience with operative treatment for total correction of Tetralogy of Fallot at the department of Thoracic and Cardiovascular Surgery, Korea University Hospital from January, 1977, through April, 1983 was reviewed. Of the 29 patients reviewed, male to female occurrence ratio was 22:7 Type of V.S.D. was type II in 26 cases[90%] and total conus defect in 3 cases[10%]. Average size of V.S.D. was 19 mm. Type of Right ventricular outflow tract stenosis was highest frequency with pulmonary valvular and infundibular stenosis combined type in 21 cases[72%], and there were 8 deaths In this group. Type of R.V.O.T. reconstruction contains 2 cases of infundibulectomy only, 1 case of infundibulectomy with valvular commissurotomy, 2 cases of pericardial patch, 23 Cases of pericardial patch with Teflon or Dacron felt reinforced and 1 case of pulmonary valved conduit reconstruction. Operative mortality was higher in outflow patch through pulmonary valve ring. Overall mortality was 31%. Major causes of death and postoperative complications were low output syndrome, complete A-V block acute renal failure, ventricular fibrillation, bleeding brain abscess, and sudden cardiac arrest.

• Journal of Advanced Navigation Technology
• /
• v.20 no.1
• /
• pp.93-98
• /
• 2016

The purpose of this study is to design for MOB antenna attached on safety helmet using microstrip patch antenna. The patch antenna is fabricated in 0.2 mm FR-4 substrate with $64{\times}64mm$ size. The proposed antenna is based on a slot-ring design which cover Inmarsat (1.52 ~ 1.65 GHz) and GPS (1.575 GHz) frequency band. To obtain the optimized parameters, HFSS simulator is used, and antenna is designed by optimized parameters. After antenna was etched, SMA connector was attached to the microstrip feeding line and the result between antenna simulation and measurement was analyzed. Proposed antenna is satisfied the -10 dB bandwidth requirement while simultaneously covering the 1.53 ~ 1.65 GHz.

• Journal of the Society of Cosmetic Scientists of Korea
• /
• v.22 no.2
• /
• pp.174-181
• /
• 1996

The novel synthesis of 3-aminopropyl dihydrogen phosphate(3-APPA; 3-Aminopropane phosphoric acid), and its applicability to the skin as a cosmetic raw material in terms of its efficacy and toxicology were presented. The phosphorylation of 3-amino-1-propanol was carried out via cyclization into 6-membered 2, 6-oxaza-phosphoryl ring in the presence of phosphorous oxychloried and an organic base. The subsequent ring-opening hydrolysis and crystallization afforded the highly purified product in 90% isoloated yield. The method is much superior to the previous literature phosphorylation methodsm, as the procedure is simple and high-yielding. To confirm the efficacy of 3-APPA, several activities related to anti-aging capacity were measured. In-vitro human fibroblast, linear and 3-dimensional collagen matrix culture revealed that 3-APPA stimulated the proliferation of fibroblasts, and enhanced the synthesis of collagen, which showed 3-APPA's potency for skin wrinkle reduction. The toxicolgical aspect of 3-APPA was also extensively examined. In vivo toxicity tests such as acute oral toxicity, eye irritation, human patch, and the repeat insult human patch test proved 3-APPA to be a safe material. Thus 3-APPA can be used as an effective anti-aging agent for various cosmetic formulations.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.18 no.3 s.118
• /
• pp.323-333
• /
• 2007

In this paper, a new MDAS-DR antenna structure designed to efficiently shape a flat-topped radiation pattern is proposed. The antenna structure is composed of a stacked micro-strip patch exciter and a multi-layered disk array structure(MDAS) surrounded by a dielectric ring. The MDAS, which was supplied by a stacked microstrip patch exciter with radiating power, can form a flat-topped radiation pattern in a far field by a mutual interaction with the surrounding dielectric ring. Therefore, the design parameters of the dielectric ring and the MDAS structure are important design parameters for shaping a flat-topped radiation pattern. The proposed antenna used twelve multi-layered disk array elements and a Teflon material with a dielectric constant of 2.05. An antenna operated at 10 GHz$(9.6\sim10.4\;GHz)$ was designed in order to verify the effectiveness of the proposed antenna structure. The commercial simulator of CST Microwave $Studio^{TM}$, which was adapted to a 3-D antenna structure analysis, was used for the simulation. The antenna breadboard was also fabricated and its electrical performance was measured in an anechoic antenna chamber. The measured results of the antenna breadboard with a flat-topped radiation pattern were found to be in good agreement with the simulated one. The MDAS-DR antenna gain measured at 10 GHz was 11.18 dBi, and the MDAS-DR antenna was capable of shaping a good flat-topped radiation pattern with a beam-width of about $40^{\circ}$, at least within a fractional bandwidth of 8.0 %.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.14 no.2
• /
• pp.192-201
• /
• 2003

In this paper, to reduce the size of patch, three types of 3-dimensional patch antennas which are one-directionally-corrugaged type, rectangular ring-likely corrugated type, and lattice-likely corrugated type rectangular microstrip patch antennas(MPA) are designed and fabricated at the 1.575 GHz. As the result, one-directionally corrugated rectangular MPA is reduced in the resonant length of patch by 21.4% than that of general plane MPA. -10 dB bandwidth(B.W) is 62 MHz(3.9 %) and this is broader than that(39 MHz, 2.5 %) of plane MPA by 23 MHz(1.5 %). The gain is 5.8 dBd and this is reduced by 0.9 dB than that(6.7 dBd) of plane MPA. Half power beamwidth(HPBW) is broadened by 18$^{\circ}$ than that of plane MPA in the E-plane and this is due to the reduced length of patch. For rectangular ring-likely corrugated retangular MPA, the patch size is miniaturized by 21.6 % than that of plane MPA. For lattice-likely corrugated rectangular MPA, in the linear polarization, the size of patch is miniaturized by 43.3 % than that of plane MPA. -10 dB B.W is 70 MHz(4.4 %) and this is broadened than that of plane MPA by 31 MHz(2 %). Gain is 2.2 dBd and this is smaller than that of plane MPA by 4.5 dB. HPBW is increased in both E-plane and H-plane by 22$^{\circ}$ and 13$^{\circ}$, respectively. For circular polarization, the size of patch is reduced by 41 % than that by 41 %. The axial ratio(AR) is 0.8 dB at the 1.575 GHz and the axial ratio bandwidth(ARBW) within 2 dB is 20 MHz(1.27 %) and this is increased by 10 MHz(0.63 %) than that 10 MHz(0.63 %) of plane MPA. From all the results above, it is conformed that the proposed antenna has merit in size reduction of patch and in the input impedance B.W, and is more profitable in many application than the general plane type MPA.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.17 no.7 s.110
• /
• pp.665-672
• /
• 2006

In this paper, we propose and fabricate the dual-band microstrip patch antenna with parasitic patch for S-DMB(Satellite-Digital Multimedia Broadcasting) and ITS (Intelligent Transport System) services. The measured - 10 dB bandwidth and the minimum return loss is 300 MHz and - 27 dB for S-DMB, 600 MHz and -17 dB for ITS, respectively. It is noticed that the measured and simulated results are agreed well. The S-DMB antenna has conical beam pattern in the vertical plane and has omni-directional beam pattern in the horizontal plane. The conical beam pattern has the maximum gain about 4.2 dBi when ${\theta}$ is $45^{\circ}$ at the center frequency of 2.6 GHz. The ITS antenna has directional beam pattern in the vertical plane that has maximum gain about 6.4 dBi when ${\theta}$ is $0^{\circ}$ at the center frequency of 5.8 GHz.

• Journal of Electrical Engineering and Technology
• /
• v.10 no.1
• /
• pp.331-337
• /
• 2015

A novel fully-printed microstrip antenna with negative first resonance and dual polarization is proposed. The radiator is printed on the 1-layer substrate instead of multilayers. The -1st resonance results from a composite right- and left-handed(CRLH) structure that has a circumferentially interlocked gap capacitively coupling a patch with a shorted-ring. This compact antenna is provided with a dual-polarization capability by creating two orthogonal linear polarizations in one body with coaxial feeds. The design is carried out by doing full-wave EM field simulation which is compared with the measurement of the fabricated antenna prototype. The measured results give the gain of 5 dBi and the efficiency of 78% at the -1st resonance mode as the center frequency of a downlink channel of the bandwidth over 20 MHz with 29 dB polarization isolation for mobile communication.

• Journal of Chest Surgery
• /
• v.20 no.4
• /
• pp.710-714
• /
• 1987

Over the past 6 years, from July, 1981. through June, 1987., 14 consecutive patient with congenital aortic stenosis underwent corrective surgery in our department of Thoracic and Cardiovascular Surgery. The patient ranged in age from 1 to 20 years. There were 8 male and 6 female patients. According to the operative findings, stenotic site was valvular stenosis [5 cases], subvalvular stenosis [5 cases], supravalvular stenosis [2 cases], valvular and supra valvular stenosis [1 case]. We have performed valvotomy and commissurotomy [5 cases]. Resection of subvalvular membrane [3 cases], patch enlargement of Ascending aorta [2 cases], LV myotomy [2 cases], valvotomy and excision of membrane [1 case], patch enlargement of ascending aorta and valve ring [1 case]. There was one hospital mortality [7.1%]. He died of C-I bleeding and sepsis on the 25th postoperative day. All survivors showed improvement in NYHA functional class in the 160 patient/month follow up period.

• Proceedings of the Korean Magnestics Society Conference
• /
• 2009.05a
• /
• pp.37-39
• /
• 2009