• Korean Journal of Computational Design and Engineering
• /
• v.20 no.1
• /
• pp.11-21
• /
• 2015

Currently, the United States, the United Kingdom, Australia etc. are actively utilizing energy simulation for efficiency evaluation of building energy. However, domestic energy efficiency assessment system doesn't use energy simulation system properly at present: parameters based architecture plans and Ashrae Standard are inputted for the evaluation, because the input parameters for the simulation haven't been established yet. This fact causes poor reliability during energy simulation, as the values of the two standards are different from each other. Therefore, the aim of the study is to set domestic standard parameter for BIM-based energy performance evaluation, focusing on possession area per person of occupants at government office in Korea. We found that the difference among the result values occurred approximately 3% in the energy simulation. As a result of the analysis, possession area per person of occupants in Government office is $31.87m^2$. Other input parameters may be set based on this. This will increase the reliability of energy simulation through a domestic standard parameter.

• Journal of Science Education
• /
• v.47 no.1
• /
• pp.75-87
• /
• 2023

This study analyzed correlation among peer evaluation, self-evaluation, and instructor evaluation of argumentation writing conducted in the 'Biology logic and essay' class. To this end, 14 pre-service biology teachers wrote argumentation four times, and peer evaluation, self-evaluation, and instructor evaluation were conducted on these results. The peer evaluation for argumentation writing averaged 2.70 points, the self-evaluation average was 2.68 points, and the instructor evaluation average was 2.71. Looking at the average of each sub-evaluation area, scientific knowledge was the highest in peer evaluation, and the composition area was the highest in self-evaluation. In addition, the area of scientific knowledge was the highest in the instructor evaluation. As a result of examining the standard deviation, the standard deviation of self-evaluation was the largest. As a result of analyzing the correlation between evaluation types, there was a high correlation between peer evaluation and instructor evaluation, and there was a moderate correlation between self-evaluation and instructor evaluation. On the other hand, there was no significant correlation between peer evaluation and self-evaluation. As a result of analyzing the correlation by evaluation area, there was no significant correlation between peer evaluation and self-evaluation in all four areas of scientific knowledge, scientific argumentation, composition, and expression. On the other hand, in the analysis between peer evaluation and instructor evaluation, there was a significant correlation in the areas of scientific knowledge, scientific argumentation, and composition. In addition, there was a significant correlation between self-evaluation and instructor evaluation only in the area of expression. The results of this study show that peer evaluation is highly likely to be applied in the 'Subject logic and essay' class. It also suggests that it is necessary to subdivide evaluation criteria according to the type of evaluation in order to use peer evaluation and self-evaluation.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.25 no.5
• /
• pp.127-134
• /
• 2021

When constructing a tunnel on a stable ground, stress is changed in the ground during excavation stage and installation of ground support materials. In the standards for safety evaluation of structures in use, it is suggested to perform numerical analysis reflecting the excavation stage. But method of seismic performance evaluation was not presented. Therefore, in this study, numerical analysis was performed with different analysis methods, and the results were compared and analyzed. As a result of the numerical analysis, seismic wave applied in the horizontal direction were no difference depending on the analysis methods. However, there was a big difference in the result according to the evaluation methods of tunnel member forces. When reviewing with the strength design method, the structure performance could be not satisfied depending on the existence or nonexistence of reinforcing bars. Based on these research results, it is suggested that the interpretation method should be clearly presented and reflected in the relevant standards.

• Archives of design research
• /
• v.14 no.2
• /
• pp.137-146
• /
• 2001

In this paper it is investigated that the visual elements of preference which influence the visual preference for bench. "What color of bench is preferred when the location is the same\ulcorner" Started from those questions, the elements of preference which influence the visual preference for bench is investigated. In this research, a equal standard mark system is applied for the evaluation of visual elements of preference and then the relationship between the visual preference and the elements of preference are examined by the method of multiple regression analysis. The result of primary factor analysis from the visual evaluation in this paper will affect visual preference of the bench in urban park. Thus, the result of this study will contribute to development of urban parks for the maximum satisfaction of park visitors supplying necessary information for a resting place planning and design. It will provide a useful management guide of urban park facilities to prepare a strategic management plan of the benches from the users point of view. Especially, to know the correct preference of people, which will be provided by the evaluation of visual preference to bench will be the key to rest place planning.

• Explosives and Blasting
• /
• v.35 no.4
• /
• pp.1-9
• /
• 2017

This study undertakes an evaluation of blast effect through the analysis of the contribution rate and effect that different artificial joint number, artificial joint spacing and artificial joint angle have on blast velocity. Blast velocity according to the different state of the artificial joint was obtained using AUTODYN, a dynamic analysis program. The result of the numerical analysis was subjected to further normalization analysis. For the contribution rate of design factors was analyzed using the robust design method. The orthogonal array used in the analysis was $L_9(3^4)$ and each parameters were having 3 levels. The result of normalization analysis regarding the artificial joint angle was indicated a tendency in which blast velocity decreased. The result of analyzing blast velocity regarding artificial joint spacing and artificial joint angle was indicated a tendency in which blast velocity decreased as artificial joint spacing increased when the angle was perpendicular. In the case of blast velocity contribution rates they were ranked in the descending order of artificial joint angle, artificial joint number, artificial joint spacing.

• Architectural research
• /
• v.10 no.2
• /
• pp.37-42
• /
• 2008

This study is to get the proper evaluation of the residual property of reinforced concrete beam exposed to fire. This study focused on the strength resistance and analytical evaluation of RC members exposed high temperature. And this study is the basis analytical research to conduct the other studies. To analysis by the finite element method, the Total-RC program was used to analysis it and the Total-Temp program was also used to analysis the temperature distributions at the section. All of results were compared with the pre-existing experimental data of simple supported beam. Using it, the parameters influencing the structural capacity of the high temperature-damaged RC members and residual strength estimation are investigated. The temperature distribution and the structural capacity at the section are calculated in this step. An application of this method is compared with the heating test result and residual property test for simple supported beam which is subjected to ISO 834 test fire. The results of this study are as follows; 1) The loads-displacement relationship of RC beam, considering initial thermal stress of cross section and heat transfer analysis are estimated comparing analytical value with pre-existing experimental results. 2) by the heating time (0, 1, 2 hours), the results of analysis with parameters show that the load capacity exposing at fire is affected.

• Journal of the Korean GEO-environmental Society
• /
• v.11 no.11
• /
• pp.19-26
• /
• 2010

An influence factors for soundness evaluation of river levee include consisting embankment in case piping, permeability coefficient of ground, height of embankment, the width of crest, material characteristics of embankment and foundation ground, shape of embankment slope, an influence for penetration of rainfall or river water in case slope stability. In this study, it was operated a feasibility investigation of existing design result, stability evaluation for permeability coefficient use and permeability coefficient change of foundation ground to investigate an influence in line with permeability coefficient change for result of river levee penetration analysis. The evaluation results of influence factors, the permeability coefficient was used in design and it was evaluated influence in safety factor of piping. After the evaluation of influence factors, the permeability coefficient used in the design appears with the fact that differs in a design report about same soil.

• Journal of Applied Biological Chemistry
• /
• v.57 no.3
• /
• pp.235-242
• /
• 2014

The purpose of this study is the establishment of scientific processes for making food safety policies. Thus, we investigated pesticide residue level of the agricultural commodities from market, and performed risk assessment. Fifteen agricultural items are chosen based on the frequency of Korean consumption. The samples were collected from 9 cities where populations are more than one million. Total 283 active ingredients were monitoring ( total sample number =232). Single-analysis of target pesticides was for three kinds of possible growth regulators and the multicomponent analysis was for 280 kinds of pesticides, a total of 283 species were selected to perform the pesticide residues. Before monitoring the analytes, the improvements of the analytical methods were done by method validations under the CODEX analytical method development guidelines and can produce metrics that represent the international standards applied in accordance with the guidelines. In addition to residual pesticides detected during monitoring we compare the ADI to EDI values using detected result and dietary consumption data which is extracted from annual market basket survey. The 163 samples were non-detected in the total 232 samples so it means that every agricultural commodity will residual pesticides-free in 70.3%. The detected residual pesticides showed for a total of 69 cases (29.7%). Two of samples violate Korean MRL (0.9%). The ratio of EDI compared to ADI resulted in only from 0.00087 to 0.902%. In result, we can assume that all detected residual pesticides are very safe level and current policies of Korean pesticides control may be working.

• Journal of the Korean housing association
• /
• v.16 no.4
• /
• pp.57-64
• /
• 2005

The purpose of this paper is to find out and to show that the probability of the adaption of YURAGI theory of wall covering in interior design. By using personal computer, visible image of wall covering is inputted to a computer program as 'bmp' file, Windows bitmap file format, for Fourier transform. The evaluation indexes such as 'Map', 'YURAGI coefficient', 'Rest error', and 'Linearity' are defined to display the analytical result. The result of this study is shown by visual image and numerical value. As a result of this paper, we can understand that the psychological evaluations about wall coverings are different according to the YURAGI coefficient which came out by fluctuation analysis method as YURAGI theory. So, now we are able to know that the adaptation of YURAGI theory is very useful at psychological evaluation about wall covering.

• Journal of the Architectural Institute of Korea Structure & Construction
• /
• v.36 no.3
• /
• pp.129-134
• /
• 2020

The current evaluation time period for the construction management service is the project completion or after project completion. Therefore, the construction manager has the following problems. First, it is difficult to prepare the evaluation due to the new field movement of the existing participating engineer. Next, the CM work is complex as well as extensive. Therefore, the critical success factors of the construction technology services evaluation are required as a systematic performance standard of CM work. In this study, we extracted the critical success factors that can systematically prepare the evaluation from the early stage of the project through in - depth interviews with experts. And, this study was analyze the priority of each factor by using AHP technique. As a result, the most important factors were related to the systemization of the preparation process, the construction manager work capabilities and practical construction management. And the priorities of all factors were analyzed high in the factors suggested by the owner groups. The results of this analysis are expected to provide the standards that construction management service performer carry out structured management of construction management throughout the project.