• 대한인간공학회지
• /
• 제5권1호
• /
• pp.19-28
• /
• 1986

To study the body trunk form which is essential to clothing constructions, necessary body sizes were measured indirect1y from 216 unmarried women from 19 to 24 years old by a photographic network method. The results are obtained as follow; 1) In this study of body type measurements, the four factors of bust, abdomen, column and hip size have been divided into four-stage intervals and given the body type codes 1, 2, 3 and 4, with 1 designating the size difference of the factor with the minimum size difference of the factor with the maximum size difference from waist size. These body type codes can be easily, linguistically interpreted. In this study, among $4^4=256$ possible body types, 54 types appeared frequently. These 54 types are integrated into 6 groups of types by clustering analysis. Representative types of each group are types 3333 and 2333 in group 1, 2233, 1233 and 1332 in group 2, 2222, 1222 and 1223 in group 3, 2223 in group 4, 2323 and 2322 in group 5, and 3323, 3223 and 3322 in group 6. In the types of groups 1, 2, and 3, the change is mainly in bust size, and in the types of group 4. is single type. In the types of group 5 the change is mainly in hip size, and in the types by groups 6 the change is mainly in abdomen size and hip size. 2) The analysis by measuring the four elements of body trunk in reference to waist size is scientific and grading of similar styles is possible in clothing construction. 3) Assuming that the human body is oval, using the calculating method, the size of girth, which cannot be measured by the indirect measuring method, is obtained approximate to actual size, with an error of ${\pm}2.8cm$.

• 대한건축학회논문집:계획계
• /
• 제35권2호
• /
• pp.43-52
• /
• 2019

The purpose of this study is to classify the building layout and plan types according to the urban location, use and function of civil and to analyze the characteristics by the type classified. After constructing a framework (Mathia type, Nagaya type, Detached House type) for analyzing Modern Private Housing Architecture in Gunsan, the research was conducted on 30 representative buildings, and a plot plan, a floor plan and elevation were created. After analyzing the relationship between the lot of land and the urban street, we classified the type of arrangement into Mathia type and Nagaya type which directly enter the building from the road, and derived the Detached House type which indirectly enters from the road. When we look at the use of the derived arrangement types, most of the Mathia type are commercial and residential buildings, and some of them are specially designed for commercial buildings. The Nagaya type appears in the form of commercial and residential house or residential private house, and the Detached House type is classified as residential style. As a relation with the urban street, the Mathia type and the Nagaya type are generally located on the main urban street, whereas the Detached House type is located on the small urban street. As a result of analyzing, the floor plan was changed according to the plot plan. The plan of the Mathia and Nagaya type are arranged to enter directly from the street, with commercial space being mainly located on the street, and the residential space being composed on the back or the second floor. the plan of the Detached House is a type that enters indirectly into the interior through a separate space (Courtyard), and forms an organic space between the residential interior and the front and rear yard. The purpose of this study is to investigate the Characteristics of a plot plan and a floor plan of Modern Private Housing Architecture in Gunsan by means of analysis considering the urban street, Uses of buildings, Construction method and the yard through actual measurement.

• 한국주거학회논문집
• /
• 제23권3호
• /
• pp.1-11
• /
• 2012

The purpose of this study was to make clear considerations in the planning of community housing and the roles of coordinators. Seongmisan village, a representative urban community village in Seoul, was selected for this study on problem solving between residents and opinion coordination between residents and coordinators. For this qualitative research, 2 residents and 2 coordinators answered 'open questionnaires' on prior basic planning, land purchase, financing, architectural planning, construction and inspection, and actual living conditions thereafter. They were each interviewed for 2 hours at a time that was 14-16 months after the residents started living in the new houses, and the records were transcribed. The following was the result. 1) The residents, who ruled the steps of prior basic planning and land purchase, did not have sufficient information or knowledge of the construction of community housing, so that they faced difficulties especially in the legal and financial aspects. 2) The coordinators participated in the project at the steps of architectural planning and construction. The residents accepted the coordinators' opinions on the choice of floor and position, and the coordinators listened to the residents' opinions on individual plans and finishing materials. In the construction step, however, there was conflict between them, and dissatisfaction occurred on the completion time and construction cost. For the successful construction of community housing, a professional coordination company needs to join the project to establish a system of opinion coordinating from the step of prior basic planning to the step of afterconstruction management.

• 한국건축시공학회지
• /
• 제13권3호
• /
• pp.218-226
• /
• 2013

건설재료 중 시멘트 및 철강은 대표적으로 탄산가스를 발생시키는 재료산업이다. 건설 산업에서의 탄소 배출량 감소를 위해서는 이러한 재료의 사용을 감소시키는 것이 가장 효과적이라고 할 수 있다. 본 연구에서는 시멘트의 사용량을 감소시킨 저발열형 혼합시멘트의 개발을 목적으로 하고 있다. 시멘트 혼합 비율을 10 %로 낮춘 저탄소 배출형 저발열 혼합시멘트의 수화 특성 및 콘크리트의 온도상승 특성을 검토하였다. 시험 결과, 혼화재의 반응 활성화를 위해서는 CaO 및 $SO_3$의 공급원 필요하며, 석고 및 생석회를 적정 배합비율 적용할 경우 초기에는 강도 발현이 다소 지연되지만 장기재령에서는 기존의 저발열 혼합시멘트와 유사한 성능을 확보 가능한 것으로 나타났다. 특히 저탄소 저발열 혼합시멘트의 경우 콘크리트의 수화열도 기존 저발열 혼합시멘트에 비해 감소시킬 수 있는 것으로 나타났다.

• 한국건설순환자원학회논문집
• /
• 제5권1호
• /
• pp.37-44
• /
• 2017

레드머드는 보오크사이트 원광석에서 생산되는 알루미나의 선광과정에서 발생되는 무기질 부산물이다. 레드머드를 활용하고자하는 연구가 국내에서 이루어지고 있다. 강알칼리성의 레드머드를 건설산업용 촉진제로서 활용하고자 하는 연구로서 알칼리활성화 슬래그-레드머드 시멘트가 국내외적으로 발표되고 있다. 본 논문은 레드머드 대체율에 따른 알칼리활성화 슬래그-레드머드 건식 흙포장재의 최적함수율, 압축강도, 흡수율, 백화발생 특성에 대하여 비교 검토하였다. 그 결과 레드머드 대체율이 증가할수록 알칼리활성화 슬래그-레드머드 흙포장재의 최적 함수비, 흡수율, 백화면적은 증가하고 압축강도는 감소하였다.

• Environmental Engineering Research
• /
• 제21권4호
• /
• pp.427-435
• /
• 2016

In this study, change in water-dissolved oxygen (DO) was analyzed under various synthetic water qualities and nanobubbles (NBs) application conditions, such as gas type, initial DO as well as water dissolved, suspended and organic matters contents. When oxygen, rather than air, was introduced into nitrogen-desorbed ultra-pure water, the stagnation time was significantly increased. It took ten days for DO concentration to drop back to saturation. The higher the initial DO concentration, the longer particles were observed above saturation due to particle stability improvement. The oxygen mass transfer rate of 0.0482 mg/L/min was found to reach a maximum at an electrolytic concentration of 0.75 g/L, beyond which the transfer rate decreased due to adsorption of negative ions of the electrolyte at the interface. High levels of turbidity caused by suspended solids have become a barrier to dissolution of NBs oxygen into the water solution, and thus affected the transfer performance. On the other hand, by applying NBs for just an hour, up to 7.2% degradation of glucose as representative organic matter was achieved. Thus, NBs technology would maintain a high DO extent for an extended duration, and thus can improve water quality provided that water chemistry is closely monitored during its application.

• Wind and Structures
• /
• 제36권4호
• /
• pp.263-275
• /
• 2023

As a new kind of construction facility for high rise buildings, the integral steel platform scaffold system (ISPS) consisting of the steel skeleton and suspended scaffold faces high wind during the construction procedure. The lattice structure type and existence of core tubes both make it difficult to estimate the wind load and calculate the wind-induced responses. In this study, an aeroelastic model with a geometry scale ratio of 1:25 based on the ISPS for Shanghai Tower, with the representative square profile, is manufactured and then tested in a wind tunnel. The first mode of the prototype ISPS is a torsional one with a frequency of only 0.68 Hz, and the model survives under extreme wind speed up to 50 m/s. The static wind load and wind vibration factors are derived based on the test result and supplementary finite element analysis, offering a reference for the following ISPS design. The spacer at the bottom of the suspended scaffold is suggested to be long enough to touch the core tube in the initial status to prevent the collision. Besides, aerodynamic wind loads and cross-wind loads are suggested to be included in the structural design of the ISPS.

• 산업경영시스템학회지
• /
• 제23권55호
• /
• pp.107-116
• /
• 2000

Electronic Commerce is purchasing or sales a products and services to customers using computer network. It is different to traditional commerce. Also, It divide into business to business commerce and business to customer commerce. Cyber Shopping Mall is a representative type of business to customer commerce. The interest and demand of national business to customer commerce is explosively increasing with industry. It expect to reach 61 billion won in the 2000. Thus Structure of Cyber Shopping Mall is the more complex and the more vary types. It is the problem that change of established Cyber Shopping Mall structure is very difficult. The purpose of this study Is designed to Cyber Shopping Mall Purchase Process that deal with quickly changable internet environment and meet the needs of customers immediately using UML(Unified Modeling Language) in design phase determinant of Cyber Shopping Mal1 structure. Cyber Shopping Mall Purchase Process is designed to have objective-oriented development methodology's advantage. It has a flexibility in case of shopping mall structure change and acts as useful guideline in design phase of construction of Cyber Shopping Mall.

• 대한건축학회논문집:구조계
• /
• 제35권3호
• /
• pp.35-41
• /
• 2019

In this study, the fire resistance performance of polymer cement mortars which are used as a representative repair material for section restoration, is evaluated and residual bond strength is measured by considering unity with concrete. According to the evaluation of fire resistance performance of re-emulsification type polymer cement mortars, residual compressive strength was drastically decreased according to heating temperatures with an increase of polymer addition rate, and this seems to be attributable to the application of polymer film. In addition, an explosion phenomenon occurred frequently with an increase of addition rate, so this should be considered when selecting repair materials and processing.

• Earthquakes and Structures
• /
• 제3권2호
• /
• pp.117-140
• /
• 2012

The proposed research includes a comprehensive study on the seismic vulnerability assessment of typical building types, representative of the structural materials, the seismic codes and the construction techniques of Southern Europe. A damage database is created after the elaboration of the results of the observational data obtained from post-earthquake surveys carried out in the area struck by the September 7, 1999 Athens earthquake, a near field seismic event in an extended urban region. The observational database comprises 180.945 buildings which developed damage of varying degree, type and extent. The dataset is elaborated in order to gather useful information about the structural parameters influence on the seismic vulnerability and their correlation to the type and degree of building damages in near field earthquakes. The damage calibration of the observational data was based on label - damage provided by Earthquake Planning and Protection Organization (EPPO) in Greece and referred to the qualitative characterization for the recording of damage in post-earthquake surveys. Important conclusions are drawn on the parameters that influence the seismic response based on the wide homogeneous database which adds to the reliability of the collected information and reduces the scatter on the produced results.