• Journal of Adhesion and Interface
• /
• v.7 no.4
• /
• pp.18-23
• /
• 2006

The influence of the notch length on the stress distribution of mid-bondline and adherend was investigated using elasto-plastic finite element method. The results from the simulation showed that peak stress of mid-bondline decreased markedly as adherend with notch in the middle of lap zone, and the stress in the middle of joint with low stress originally increased evidently. All the peak stresses decreased firstly and increased again as the length of notch increased. The relative higher peak stress appeared at the point near the notch of adherend where might be failed previously during the loading procedure.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.12 no.1
• /
• pp.41-45
• /
• 2012

We observed that in chemical vapor deposition (CVD) tungsten silicide (WSix) poly gate scheme, the gate oxide thickness decreases as gate length is reduced, and it intensifies the roll-off properties of transistor. This is because the fluorine diffuses laterally from WSix to the gate sidewall oxide in addition to its vertical diffusion to the gate oxide during gate re-oxidation process. When the channel length is very small, the gate oxide thickness is further reduced due to a relative increase of the lateral diffusion than the vertical diffusion. In DRAM cells where the channel length is extremely small, we found the thinned gate oxide is a main cause of poor retention time.

• Journal of Ginseng Research
• /
• v.5 no.2
• /
• pp.163-169
• /
• 1981

In order to clarify the biological effects of chemical mutagen, ethyl methane sulphonate (EMS), in M, seedling(Ponax ginseng C. A. Meyer) . the dehiscent seeds of ginseng were treated with EMS for 12 hours at 20t and Post-washed for 24 to 72 hours. The differences of biological injuries in M, generation due to the concentration of EMS were quite obvious in rate and date of germination, stem length, stem diameter, leaf length, leaf width, root length, root diameter, and root weight . Especially, the seeds treated with the high concentration of EMS , above 0.8%, were not germinated The growth injury was directly proportional to the concentration of EMS but not relative to the post-washing time of afire 25 hours. The useful range of EMS concentration and post-washing time in ginseng seeds were 0.4 % - 0.6% and above 24 hours, respectively.

• Korean Journal Plant Pathology
• /
• v.14 no.3
• /
• pp.247-252
• /
• 1998

A series of greenhouse test was conducted to evaluate infection of Calonectria ilicicola on soybean plants of different ages at time of inoculation. Lesion length and number of perithecia were determined on cultivars Braxton, Deltapine 726, and Riverside 699 that were 10∼40 days old and 4-10 days old at time of inoculation. Quadratic and linear relationships were described between plant age at inoculation and lesion length or perithecia production in greenhouse studies. Soybean seedlings exhibited low susceptibility to C. ilicicola regardless of cultivar susceptibility. On 8- or 1-0-days-old Braxton, lesion lenght and perithecia numbers were reduced. Lesion lengths were longest on plants 30 days old whereas perithecia production was greatest on plants 20∼30 days old at time of inoculation. Differences in lesion length and perithecia production that were observed on young plants (4∼10 days old) were similar to relative levels of susceptibility in soybean cultivars in greenhouse and field tests, suggesting that reaction to C. ilicicola in soybean cultivars may be determined early in plant development.

• The Korean Journal of Ecology
• /
• v.1 no.2
• /
• pp.49-56
• /
• 1977

For the culture the population growth, shell length and spawning seasons of Gomphina veneriformis, and its environmental factors, were investigated at the Jeju coastal regions. from Feburuary, 1975 to March, 1976. The soil movements of the tidal flats where the clams inhabited were relatively rapid during the strong tidal actions. The rate of population growth were rapid from April to September, then became obsure. The relative growth equations of the shell height (SH) and the shell breadth (SB) against the shell length (SL) of the clams were as follows: Changhung : SH=0.751 SL + 0.685, SB=0.448 SL-0.630 Pyoson : SH-0.775 SL - 0.115, SB=0.464 SL-1.008 Hwhason : SH=0.794 SL - 0.923, SB=0.485 SL-1.155 Kwhagzee : SH=0.771 SL - 0.644, SB=0.455 SL-1.049 The meat weight increases of the clams were continued from March to late June, then it decreased sharply up to late August. The spawning of the clams seems to be late from June to Spetember in the regions studied.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.20 no.2
• /
• pp.689-696
• /
• 1996

A comparison is made of the heat loss from a hollow cylinder, computed using an one-dimensional analytic method and a two-dimensional separation of variables scheme. For a two-dimensional analysis, the temperature of the inner surface as a boundary condition can be varied along the length of the cylinder by varing the temperature variation factor, b. Comparisons of the heat loss from the hollow cylinder using these two methods are given as a function of non-dimensional cylinder length, the ratio of the outer radius to the inner radius, temperature variation factor and Biot number. The result shows that the value of the heat loss from the hollow cylinder obtained using the one-dimensional analytic method becomes close to the value given by the two-dimensional separation of variables scheme as the value of Biot number and the non-dimensional hollow cylinder length increase and as the ratio of the outer radius to the inner radius decreases.

• Proceedings of the Korean Institute of Communication Sciences Conference
• /
• 1991.10a
• /
• pp.205-209
• /
• 1991

The conventional modeling equations for planar MOSFET can not be directly used for zero or minus junction depth concave MOSFET. In this paper, we suggest a new model which can simulate the electrical characteristics of concave MOSFET. The threshold voltage modeling was achieved using the charge sharing method considering the relative difference of source and drain depletion widths. To analyze the ID-VDS characteristics, the conventional expressions for planar MOSFET were employed with the electrical channel length as an effective channel length and the channel length modulation factor as ${\alpha}$ΔL. By comparing the proposed model with experimental results, we could get reasonably similar curves and we proposed a concave MOSFET conditiion which shows no short channel effect of threshold voltage(V${\gamma}$).

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.30 no.5
• /
• pp.903-905
• /
• 1997

Morphological differences were studied using the analysis of covariance between various partial length and mantle length of the common Todarodes pacificus by cohorts in the Korean waters. Analysis of seven morphological characters proved that each cohort has no sexual differences, except significant sexual differences only in the Summer cohort in term of relative growth between mantle length and body weight. The three cohorts represent significant differences in morphological characters.

• International Journal of Aeronautical and Space Sciences
• /
• v.9 no.1
• /
• pp.1-30
• /
• 2008

When the stagnation temperature of a perfect gas increases, the specific heats and their ratio do not remain constant any more and start to vary with this temperature. The gas remains perfect; its state equation remains always valid, except, it is named in more by calorically imperfect gas. The aim of this work is to trace the profiles of the supersonic axisymmetric Minimum Length Nozzle to have a uniform and parallel flow at the exit section, when the stagnation temperature is taken into account, lower than the dissociation threshold of the molecules, and to have for each exit Mach number and stagnation temperature shape of nozzle. The method of characteristics is used with the algorithm of the second order finite differences method. The form of the nozzle has a point of deflection and an initial angle of expansion. The comparison is made with the calorically perfect gas. The application is for air.

• Proceedings of the Korean Society of Agricultural Engineers Conference
• /
• 1999.10c
• /
• pp.499-505
• /
• 1999

The time paramters most frequently used in hydrology are the tuime of concentration, lag time , time base, time to equilibrium , time to peak, time of travel, and residence time. Especially the time of concentraion constitute an important part of operating rainfall-runoff modeling and determining critical rainfall intensity. In the result of simulation , we discoved that SCS foumula has the highest value with length, Kerby with height and SCS with slop respectively, while only Kraven formula has the lowest value in them. With concerning to relative sensitivty, the time of concentraion was marked the constant effect according to increase of length and slope level, and the length has much more effect than the slope relatively in parameters.