• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2002년도 하계종합학술대회 논문집(1)
• /
• pp.171-174
• /
• 2002

In this study, we proposed a specification which is able to estimate tile uncertainty more easily and quickly and also able to maintain a confidence level when measuring tile magnitude and phase of 1-port and 2-port transmission.reflection coefficient using a VNA and attached coaxial cable probes. This proposed specification is available when it needs extra special condition of uncertainty estimation and when there is no additional standard equipment like as beadless airline or mismatch standard at the measurement institute. We compared and examined this proposed uncertainty estimation method with recommended EA specification and Agilent specification. As a result, we think that this proposed specification can be used as a reference for uncertainty estimation and calculation of VNA system, that is, a reference based on the IS0/1EC 17025 requirements.

• Bulletin of the Korean Chemical Society
• /
• 제25권9호
• /
• pp.1403-1407
• /
• 2004

Dielectric relaxation measurements on 3-nitrotoluene (3-NT) mixture of dimethylacetamide (DMA), dimethylformamide (DMF) and dimethysulphoxide (DMSO) have been carried out across the entire concentration range using Time domain reflectometry technique at 15, 25, 35 and $45^{\circ}C$ over the frequency range from 10 MHz to 20 GHz. For all the mixtures, only one dielectric loss peak was observed in this frequency range and the relaxation in these mixtures can be well described by a single relaxation time using Debye model. Bilinear calibration method is used to obtain complex permittivity ${\varepsilon}^{*}({\omega})$ from complex reflection coefficient ${\rho}^{*}({\omega})$ over frequency range 10 MHz to 20 GHz. The excess permittivity, excess inverse relaxation time, Kirkwood correlation factor, molar energy of activation are also calculated for these mixtures to study the solute-solvent interaction.

• Journal of electromagnetic engineering and science
• /
• 제6권1호
• /
• pp.53-61
• /
• 2006

In this paper, we present parametric studies for the optimum design of a hexagonal plate monopole antenna. The dependence of the antenna performance on various geometric parameters is investigated using a commercial electromagnetic software, from which an optimum design of a hexagonal plate monopole antenna is derived. Guidelines for determining initial parameter values are given. The diameter of the circular ground plane is minimized tlo 1/5 wavelength at the lowest operating frequency. The antenna impedance matching is controlled by adjusting the gap between the plate and the ground plane, the plate base width, and the base bevel angle. The antenna proposed in. this paper shows a reflection coefficient less than -10 dB and a $2.0{\sim}6.2$ dBi gain over $3{\sim}20$ GHz frequencies.

• 한국정밀공학회지
• /
• 제11권4호
• /
• pp.165-173
• /
• 1994

Retroreflector is different from other reflecting surfaces as it mades reflection in which radiation is returned in directions close to its incoming direction. Because of this characteristics, retroreflectors find many applications in traffic safety related areas. Retroreflectors are usually made using comer cubes, or partially coated glass beads. These glass beads can be made very small, so that they can be coated on sheets or mixed with paints. The design of glass type retroreflector depends on glass bead's shape and material, and its optical characteristics are related to the refractive index of glass. In this paper, a method of anlyzing glass bead type retroreflector's sptical characteristics with respect to shape and optica property of the glass, is presented. First, the coefficient of retroreflection, which is a measure of retroreflector's optical characteristics, is derived analytically using geometrical optics method. And the result is plotted using numerical methods. The results show good match with those obtained experimentally, which were supplied from a commercial retroreflector manufacturer.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2004년도 하계학술대회 논문집 Vol.5 No.2
• /
• pp.1042-1045
• /
• 2004

ITO thin films ($\sim150nm$) are deposited on glass substrates by different deposition condition. The sheet resistance of ITO thin films measured by using a four probe station. The microstructure of these films is determined using a X-ray diffractometer (XRD) and a scanning electron microscope (SEM) and a atomic force microscope (AEM). The sheet resistance of ITO thin films compared $s_11$ values by using a near field scanning microwave microscope.

• International Journal of Ocean System Engineering
• /
• 제3권3호
• /
• pp.158-163
• /
• 2013

The acoustic target strength (TS) is one of the most important parameters for a submarine's stealth design. Because modem submarines are larger than their predecessors, TS must be managed at each design stage in order to reduce it. To predict the TS of a submarine, TASTRAN R1 was developed based on a Kirchhoff approximation in a high-frequency range. This program can present TS values that include multi-bounce effect in the exterior and interior of the structure by combining geometric optics (GO) and physical optics (PO) methods, anechoic coating effect by using the reflection coefficient, and response time pattern for a detected target. In this paper, TS calculations for a submarine model with the above effects are simulated by using this developed program, and the TS results are discussed.

• Bulletin of the Korean Chemical Society
• /
• 제19권7호
• /
• pp.738-742
• /
• 1998

A new polyamide was prepared from 4,4'-(hexafluoroisopropylidene)di-aniline and 4-[NN-bis(2-carboxyethyl)] amino-4'-nitrostilbene. This polymer was cast into thin films by spin coating cyclohexanone solution. After being poled, the electro-optic coefficients of electrode poled polymer films were measured by the reflection measurement technique using an incident laser beam of 1.3 Jim. The film poled at the field strength of 1.2 V/μm exhibited the electro-optic coefficient (r33) of 5.9 pm/V. The relaxation behavior of the poled polymer film was compared with other reported polymers bearing the same NLO chromophores. Due to stiff and highly polar nature of the backbone and also due to formation of interchain hydrogen bonds, this polymer reveals a slower relaxation characteristics. The polymer is amorphous and soluble in various organic solvents.

• 한국수자원학회:학술대회논문집
• /
• 한국수자원학회 2019년도 학술발표회
• /
• pp.280-280
• /
• 2019

복잡한 구조의 인공어초는 그 형상에 따라 다양한 유동의 특성을 나타낸다. 이러한 유동장 분석은 여러 방면에서 다양한 실험적 연구가 수행되었으나, 현실적으로 좁은 측정영역 내에서 접촉식 계측장비의 설치가 불가하고 갇혀진 수로 내에서 발생하는 반사파랑의 영향으로 인하여 사실상 정량적인 결과도출이 어려운게 현실이다. 본 연구에서는 2차원 단면실험수로 내에 별도의 소파장치를 고안하여 단위 시간당 발생하는 반사율을 측정하고 그에 따른 인공어초 인근의 유동장의 양상을 검토하였다. 수리모형실험은 1/50의 실험축척을 적용하였으며, 서해의 조석 1주기를 재현함과 동시에 반사파랑을 최소화하기 위하여 동일한 스펙트럼(브렛슈나이더-Mytuyatu spectrum) 조건에서의 입사파랑을 15번 반복적으로 조파하였다. 실험 시 측정된 반사율은 0.05에 해당하며, PIV(Particle Image Velocimerty)시스템을 활용하여 인공어초 내부의 미세유동장을 측정하였다.

• Journal of information and communication convergence engineering
• /
• 제16권4호
• /
• pp.203-212
• /
• 2018

In this article, a novel design of patch antenna with wide band characteristics is presented. The proposed antenna is having electrical dimensions of $0.14{\lambda}{\times}0.11{\lambda}$ (at lower initial frequency) and footprints of $150mm^2$. Structural parameters optimization shows 3.1-23.5 GHz frequency range for a (reflection coefficient) $S_{11}{\leq}-10dB$ and simulated gain 6.8 dB is obtained. An equivalent circuit model is proposed to get an insight view of antenna. Advanced Systems Design (ADS) simulation results are obtain which confirm the validity of proposed model. Degenerated foster canonical form has been used to explain the reactance and capacitive behavior idea of simulated proposed antenna's input impedance later on an equivalent circuit model and smith chart is also suggested. HFSS and CST have been used to analyze antenna behavior. The proposed antenna can be further used for microwave image detection applications.

• International Journal of Naval Architecture and Ocean Engineering
• /
• 제12권1호
• /
• pp.468-478
• /
• 2020

The wave interaction problem with a vertical slotted breakwater, consisting of impermeable upper, lower parts and a permeable middle part, has been studied theoretically. An analytical model was presented for the estimation of reflection and transmission of monochromatic waves by a slotted breakwater. The far-field solution of the wave scattering involving nonlinear porous boundary condition was obtained using eigenfunction expansion method. The empirical formula for drag coefficient in the near-field, representing energy dissipation across the slotted barrier, was determined by curve fitting of the numerical solutions of 2-D channel flow using CFD code StarCCM+. The theoretical model was validated with laboratory experiments for various configurations of a slotted barrier. It showed that the developed analytical model can correctly predict the energy dissipation caused by turbulent eddies due to sudden contraction and expansion of a slotted barrier. The present paper provides a synergetic approach of the analytical and numerical modelling with minimum CPU time, for better estimation of the hydrodynamic performance of slotted breakwater.