• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.29 no.4B
• /
• pp.377-384
• /
• 2009

In order to reduce computing time significantly for a large matrix in EFEM of linear waves propagation over ripple beds, each of which is approximated to a multi-step topography, a partition method is presented to calculate reflection coefficients. By use of 10 evanescent modes in the model, the most accurate numerical solutions have been obtained up to date, which show different behaviors of computed reflection coefficient in some cases against the existing results. Both computing time and memory of the present partition model for solving a large matrix are still so much demanding that it is needed to develop an efficient method.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.18 no.4
• /
• pp.321-328
• /
• 2006

In the present study extensisve numerical experiments are conducted using the CFD code, FLUENT, to investigate the energy dissipation due to perforated walls for various wall-thickness and flow conditions. A new empirical formula for energy loss coefficient considering the effect of the thickness of perforated wall is obtained based on the results of computational experiments. It is found that the energy loss coefficient decreases as the wall-thickness increases and the maximum coefficient reduction reaches upto 40% of the value calculated using the conventional formulas for the sharp-crested orifice. To check the validity of the new formula the reflection coefficient of waves due to perforated wall is evaluated and compared with the results of existing theories and hydraulic experiments. The result shows that the new formula is superior to the conventional ones.

• The Journal of the Acoustical Society of Korea
• /
• v.16 no.4
• /
• pp.85-89
• /
• 1997

In this paper, the imdedance for each layer using triple cepstrum signal processing for reflected ultrasonic signal from the multilayer structure has been analyzed. The reflection coefficient can be obtained from the amplitude and the polarity of the peaks in the triple cepstrum, and then the impedance of each layer has been reconstructed by the reflection coefficient. In this experiment, four types of multilayers consisting of different metal layers were manufactured. The reflected signals from the multilayer structure have been detected by pulse-echo method. The impedances have been reconstructed by triple cepstrum technique. The experimental results have been in good agreement with the theoretical results.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2002.11b
• /
• pp.492-497
• /
• 2002

In this paper, Power Flow Analysis(PFA) method has been applied to the prediction of vibration energy density and intensity of coupled shell structures in the medium-to-high frequency ranges. To consider the wave transformation at joint between shell elements, power transmission and reflection coefficients are investigated for various joint angles, and here Donnell-Mushtari thin shell theory has been used. For validations computations are performed to analyze the response of coupled shells by changing the excitation frequency and damping loss factor.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.39A no.9
• /
• pp.560-562
• /
• 2014

Broadband power divider operating over the frequency band assigned for all domestic mobile communications is designed and implemented. The implemented power divider with 20Watts power rating has the maximum insertion loss of 3.49dB, input reflection coefficient of below -18.48dB and output reflection coefficient of below -20.2dB, above 24.7dB isolation and -141.2dBc of 3rd PIMD over the operating frequency of 810 ~ 2620MHz.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.28 no.4A
• /
• pp.232-237
• /
• 2003

We present the derivation of the loci of the reflection coefficient of a loaded transmission line on the Smith chart as the length of the transmission line is varied. The results show that the loci constitute a circle when the characteristic impedance of the transmission line differs from the normalizing one, whose center and radius are determined by the impedances of the load and the transmission line. The results can be used in the matching circuit design using microstriplines when line width and length should be compromised.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2003.07b
• /
• pp.673-676
• /
• 2003

This paper describes the modeling and experimental results for Bulk Acoustic Wave(BAW) Resonator using PolyVinyliDene Fluoride(PVDF). We measured the input reflection coefficient ($S_{11}$) of resonators using vector network analyzer and experimental results were measured fundamental resonance at 2.3 GHz with a return loss of -29 dB. Because of fabricated resonator without etching process, we can confirm a possibility of resonator application as using a PVDF.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2004.05a
• /
• pp.132-136
• /
• 2004

열 증착 방법을 이용하여 copper(II)-phthalocyanine(CuPc) 박막을 glass 기판 위에 제작하였다. 열처리 조건은 $150^{\circ}C$에서 후열(annealing) 처리 하는 방식과 예열하는 두 가지 방식으로 달리하였다. 제작된 박막의 전기전도도를 평가하기 위해 마이크로웨이브 근접장 효과를 이용한 근접장 현미경(near-field scanning microwave microscope)을 이용하여 비파괴적인 방식으로 CuPc 박막의 반사계수(reflection coefficient)를 측정하였다. CuPc 박막의 전기전도도 특성을 UV 흡수도를 통한 에너지 밴드갭의 shift 현상과 관련지어 설명하고 또한 x-ray diffraction(XRD) data를 통해 박막의 결정 특성과 비교하였다. 박막 표면 특성은 SEM(scanning microscope microscopy)을 통해 관측하였다. 열처리 조건에 따른 CuPc 박막의 전기전도도 특성은 후열 처리한 박막의 경우 예열 처리한 박막보다 전기 전도 특성이 향상되었음을 관측할 수 있었다.

• Journal of the Korea Society for Simulation
• /
• v.14 no.4
• /
• pp.69-76
• /
• 2005

To investigate the characteristics of the sound-pipe on the top of King Song-Dok bell, using computer simulation, the throat impedance was evaluated for the straight pipe and conical pipes with varying taper angles. When sound propagates in a rigid walled, unflanged circular pipe with wavelength larger than radius, the acoustic motion is planar, much as in a bar. The incident sound waves are reflected at the end of pipe and some of them are transmitted. The reflection coefficient and radiation impedance of the sound-pipe of King Song-Dok bell were calculated, and the results demonstrated that the high frequency sound is radiated through the sound-pipe. It behaves like a frequency filter.

• Journal of the Optical Society of Korea
• /
• v.11 no.1
• /
• pp.1-5
• /
• 2007

We investigate the efficiency of an optical intensity modulator based on an electrically tunable $LiNbO_3$ reflection grating. Assuming a grating coupling coefficient and the waveguide propagation loss, waveguide length is varied to find its effect on the modulator slope efficiency and the device capacitance. With the low propagation loss of the $LiNbO_3$ waveguide, a very efficient optical intensity modulator can be achieved for a low frequency (${\sim}1GHz$) as long as the requirement for the grating coupling coefficient is satisfied.