• JSTS:Journal of Semiconductor Technology and Science
• /
• 제14권1호
• /
• pp.70-82
• /
• 2014

A nano-power CMOS voltage reference is proposed in this paper. Through a combination of switched-capacitor technology with the body effect in MOSFETs, the output voltage is defined as the difference between two gate-source voltages using only a single PMOS transistor operated in the subthreshold region, which has low sensitivity to the temperature and supply voltage. A low output, which breaks the threshold restriction, is produced without any subdivision of the components, and flexible trimming capability can be achieved with a composite transistor, such that the chip area is saved. The chip is implemented in $0.18{\mu}m$ standard CMOS technology. Measurements show that the output voltage is approximately 123.3 mV, the temperature coefficient is $17.6ppm/^{\circ}C$, and the line sensitivity is 0.15 %/V. When the supply voltage is 1 V, the supply current is less than 90 nA at room temperature. The area occupation is approximately $0.03mm^2$.

• 전기학회논문지P
• /
• 제61권4호
• /
• pp.186-191
• /
• 2012

DC Bus Electrolytic capacitors have been widely used in power conversion system because they can achieve high capacitance and voltage ratings with volumetric efficiency and low cost. This type of capacitors have been traditionally used for filtering, voltage smoothing, by-pass and other many applications in power conversion circuits requiring a cost effective and volumetric efficiency components. Unfortunately, electrolytic capacitors are some of the weakest components in power electronic converter. Many papers have proposed different methods or algorithms to determinate the ESR and/or capacitance C for fault diagnosis of the electrolytic capacitor. However, both ESR and C vary with frequency and temperature. Accurate knowledge of both values at the capacitors operating conditions is essential to achieve the best reference data of fault judgement. According to parameter analysis, the capacitance increases with temperature and the ESR decreases. Higher frequencies make the ESR and C to decrease. Analysis results show that the proposed electrolytic capacitor parameter estimation technique can be applied to reference signal of capacitor diagnosis systems successfully.

• 한국환경농학회지
• /
• 제35권3호
• /
• pp.223-233
• /
• 2016

BACKGROUND: This study was to develop a analytical reference material including twenty pesticides in tomato. To use it for proficiency test, the suitability of homogeneity, storage stability, assigned values and uncertainty for analytical reference material were important.METHODS AND RESULTS: In order to develop a analytical reference material of tomato for multi-residue analysis of pesticides, twenty-pesticides were treated in tomato and the samples were frozen and homogenized. The homogeneity, stability, assigned value and uncertainty were calculated according to the requirements of the KS A ISO Guide 35, KS Q ISO 13528 and EURL-PT protocol. The values of the within-bottle standard variation(s_wb) and the between-bottle standard variation(s_bb) were 0.9~6.5% of assigned value and the uncertainty(u*_bb) due to inhomogeneity was also calculated as 0.6~1.9% for all pesticides. This indicated that it was satisfactory to be used as a analytical reference material. The storage stabilities of twenty-pesticides at room temperature and freezing conditions were assessed according to the requirement of the KS Q ISO Guide 35. All pesticides were stable at room temperature (20~30℃) for 8 days and freezing (-20℃) for 23 days.CONCLUSION: The feasibility of analytical reference material for pesticide multi-residue analysis in a tomato matrix was investigated. Homogeneity of within/between-bottle, uncertainty and stabilities at room temperature and freezing condition were satisfactory for a use of proficiency test and quality control. From these results, a analytical reference material would be applicable to monitor the proficiency test of pesticide analysis organizations to improve the reliability and consistency.

• 동아시아식생활학회지
• /
• 제16권5호
• /
• pp.573-577
• /
• 2006

The rutin content of Fagopyrum tataricum is 100-fold higher than that of Fagopyrum esculentum. For the development of a rutin-containing beverage, a suitable method to extract rutin from buckwheat (Fagopyrum tataricum) with high rutin yield was investigated. A roasting temperature range of $310/240^{\circ}C$ (Ed-confirm that this is indeed a range; otherwise perhaps, 'Roasting temperatures ranging from 310 to $240^{\circ}C$ were considered$\ldots$') was considered to be the best as the basic color reference. Rutin content varied according to the roasting time and heating temperature; i.e., it decreased with increasing roasting time and temperature. (Ed- this sentence is unnecessarily complicated and should be simplified to 'Rutin content decreased with increasing roasting time and heating temperature.') The optimal extraction temperature and processing time were obtained as $80^{\circ}C$ and 10 minutes to maximize the rutin concentration in the extract.

• 한국농공학회지
• /
• 제43권4호
• /
• pp.50-56
• /
• 2001

In order to provide basic information for the estimation of reference crop evapotranspiration in the greenhouse on experiment was performed. Daily evapotranspiration of the reference crop wear measured using lysimeters. kentucky Blue Grass was used as a reference crop. Climatic elements I the greenhouse such as air temperature relative humidity and radiation were measured. The influence of each climatic element on the evapotranspiration were analyzed. A multi-regression model for the estimation of reference crop evapotranspiration in the greenhouse was developed and tested simulated evapotranspiration by the model were in good agreement with measured evapotransiration.

• 한국수자원학회논문집
• /
• 제46권9호
• /
• pp.933-946
• /
• 2013

유역의 수문기상학적 특성을 분석하거나 수자원계획을 수립하는 과정에서 필수적인 사항은 증발산에 대한 정량적인 특성을 파악하는 것이다. 일반적으로 증발산량에 대한 정량적인 분석은 기온, 풍속 등 기상학적 인자를 바탕으로 잠재증발산량 또는 기준증발산량을 추정하는 방법을 이용하고 있으며, Hargreaves 공식은 기온자료를 이용하여 기준증발산량을 산정할 수 있는 간단한 경험식이라 할 수 있다. 본 연구에서는 Hargreaves 공식을 우리나라에 적용함에 있어 보다 정확한 기준증발산량 추정이 가능하도록 공식의 매개변수를 지역화하기 위한 연구를 수행하였다. 먼저 일사량 관측자료와 기온과의 관계를 검토하여 수정 관계식을 도출하였으며, 수정 관계식과 Penman-Monteith 방법에 의한 기준증발산량 산정결과를 이용하여 Hargreaves 공식의매개변수지역화를 수행하였다. 또한 매개변수와 기온과의 관계분석을 통해 기온자료로부터 Hargreaves 공식의 매개변수를 추정할 수 있는 관계식을 제안하였으며, 이에 대한 검증을 수행하였다. 연구결과, 우리나라에서 기존 Hargreaves 공식을 그대로 이용할 경우 Penman-Monteith 방법에 비해 과대 또는 과소 산정될 수 있음을 확인하였으며, 지역화된 매개변수를 이용할 경우 정확도가 크게 개선되고 있음을 확인하였다. 또한 기온자료로부터 Hargreaves 공식의 매개변수를 추정할 수 있는 관계식에 대한 검증을 통해 본 연구에서 제안한 관계식의 적용 가능성을 확인할 수 있었다.

• 전산구조공학
• /
• 제11권1호
• /
• pp.153-160
• /
• 1998

본 연구에서는 가압열충격 사고로 소형 냉각재 상실사고를 가정하여 냉각재의 온도와 압력의 이력으로 부터 용기 벽의 온도분포를 구하고, 이로 부터 열응력과 압응력을 해석적으로 구하였다. 또 균열 선단에서의 응력강도계수와 파괴인성치를 ASME코드의 방법을 이용하여 구하였고, 이들을 시간에 따라 비교하여 균열의 진전여부를 평가하였다. 원자로 용기 벽에 존재하는 여러 형태의 균열이 견딜 수 있는 최대 기준무연성천이온도를 결정하였으며 평가 결과에 대하여 고찰하였다.

• Bulletin of the Korean Chemical Society
• /
• 제31권10호
• /
• pp.2939-2942
• /
• 2010

A new high-temperature pH sensor has been successfully developed by reforming the internal reference systems of the pH sensors based on oxygen-ion conducting ceramic membrane. The conventional internal reference system, a mixture of Ni and NiO, has been replaced with partially oxidized Ni powders, where Ni and NiO coexist on the surface of particles, in order to avoid the cumbersome mixing step of Ni and NiO particles. The partially oxidized Ni particles were made by oxidizing Ni under air atmosphere at $600^{\circ}C$ and characterized by X-ray diffraction (XRD) and FTIR spectroscopy. The viability of the pH sensor developed was assessed in boric acid (1000 ppm-B)/ lithium hydroxide (1 to 3 ppm-Li) buffer solutions at $280^{\circ}C$. The pH sensor showed excellent accuracy with a small error less than ${\pm}0.2$ pH units.

• 제어로봇시스템학회:학술대회논문집
• /
• 제어로봇시스템학회 2004년도 ICCAS
• /
• pp.1006-1011
• /
• 2004

Recently, technical trend in machine tools is focused on enhancing of speed, accuracy and reliability. Such high speed usually results in thermal displacement and structural deformation. To minimize such thermal effect, most precision machine tools adopt high precision cooling system. This study proposes a temperature control for an oil cooler system using PI control with fuzzy logic. In a cooler system, the refrigerant flow rate is controlled by rotational speed of the compressor, where the outlet oil temperature is selected as the control variable. The fuzzy control rules iteratively correct PID parameters to minimize the error, difference between the outlet temperature and the reference one. Here, the ambient temperature is used as the reference one. To show the effectiveness of the proposed method, a series of experiments are conducted for an oil cooler system of machine tools, and the results are compared with the ones of a conventional PID control. The experimental results show that the proposed method has advantages of smaller overshoot and smaller steady state error.

• 한국전산구조공학회논문집
• /
• 제16권2호
• /
• pp.153-163
• /
• 2003

원자로 용기의 온도-압력 한계곡선을 위하여 국내공동비교연구를 수행하였다. 국내 원전의 데이터를 이용하여 국내 각 기관에서 온도-압력 한계곡선 작성에 사용하고 있는 방법 및 기법을 비교하기 위하여 round robin 해석을 제안하였고 주어진 문제에 대하여 각 기관이 문제를 해석한 후 결과를 제출하여 이들을 분석함으로써 온도-압력 한계곡선 작성에 대한 표준 해석 자료를 만들어 추후 평가에 이용할 수 있도록 하였다.