• Applied Chemistry for Engineering
• /
• v.24 no.6
• /
• pp.616-620
• /
• 2013

In this work, the combustive properties of the swine manure, poultry manure, and mixtures based on the resource recycling-energy were investigated. After the specimens were dried to a constant weight by dry oven, combustive properties were tested by the cone calorimeter (ISO 5660-1). It was found that the peak effective heat of combustion (PEHC) in the swine manure (78.72 MJ/kg) has risen due to more amount of the hydrocabon compared with poultry manure (69.41 MJ/kg), also the swine manure increased both of the higher $CO_2$ production rate (0.1959 g/s) and total smoke release rate (THRR) ($419m^2/m^2$) than those of the poultry manure. However, both of the CO production release (0.0996 kg/kg) and CO production rate (0034 g/s) in the poultry manure increased due to more amount of the inorganic contents compared with swine manure. Thus, the high combustion energy is expected to generate depend on the hydrocarbon content.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.22 no.2
• /
• pp.90-97
• /
• 2018

The quantities of electronic waste have been increased rapidly, and was caused variety problems such as environmental pollution or dissipation of resource. So, it needed to development of recycling technology about heavy metal in the electronic waste. Meanwhile, filler material (concrete or mortar) was used for shielding radioactive waste, however, it did not used materials that it is proved radiation shielding performance. So, there is a lack of confidence in the shielding performance. Therefore, in this paper, mechanical properties of concrete was evaluated for the applicability using electronic waste as fine aggregate of filler material. From the test results, compressive and flexural strength and elasticity modulus and the micro pore in the $1{\mu}m$ range was significantly affected by substitution of electronic waste, however, it could be improved the performance by using mineral admixture as binder. So, it is shown that the electronic waste could be applicable as fine aggregate of filler material.

• Korean Journal of Construction Engineering and Management
• /
• v.11 no.5
• /
• pp.53-64
• /
• 2010

Remodeling becomes the significant issue in the aspect of the resource recycling, because it does not demolishes the whole buildings, but a part of main structure. However, compared with new construction, remodeling has several problems of adding the repair and rehabilitation works, using the partial demolition method, and having difficulties of making decision due to disagreement between several owner organizations. BIM, which is the total solution for managing and producing information during whole life cycle of the buildings, seems to be the right solution for the way to address these issues. has a possibility for solving the problems. Therefore this paper provided the framework and database for applying the BIM in the remodeling, and proved the applicability of the BIM database in the remodeling project through the case studies.

• Applied Chemistry for Engineering
• /
• v.31 no.4
• /
• pp.438-442
• /
• 2020

Studies on the recovery conditions and optimization process for valuable metal recovery through chemical treatment from detoxified asbestos-containing waste composed of calcium silicate, larnite, merwinite, and akermanite were conducted. The main components, Si, Ca, and Mg, of detoxified asbestos-containing waste (DACW) were separated and recovered in the form of SiO₂, CaSO₄, and Mg(OH)₂ compounds, respectively. Each separated component was confirmed through X-ray diffraction (XRD) and inductively coupled plasma spectrometer (ICP) analysis. The recovery conditions for each component were first treating them with an acid to separate SiO₂ and subsequently with H₂SO₄ to recover Ca in the form of sulfate, CaSO₄. The remaining Mg was recovered by precipitation with Mg(OH)₂ under strong basic conditions. This study suggested that it is possible to convert existing treatment process of asbestos waste by landfill through recovering the components into a resource-recycling green technology.

• Journal of the Korean Applied Science and Technology
• /
• v.31 no.2
• /
• pp.296-304
• /
• 2014

For this research, prepared polyurethane dispersion of hard segment type and polyethylene emulsion wax. Use these resin, this article has been analyzed about mechanical properties variation by increasing amount of polyethylene emulsion wax on Lam skin leather and dried film. According to measure data for solvent resistance, PUD had good property. As known in the results, increase of polyethylene wax constant did not influence to big variation of hybrid resin properties. As test of tensile strength, PUD had good tensile characteristic($1.235kg_f/mm^2$) and PUD-EW4 had lowest tensile characteristic($1.022kg_f/mm^2$). As same as tensile characteristic, abrasion test determined PUD(52.225 mg.loss) had highest properties. In elongation case, PUD showed 698 % modulus which was best properties in this experiment.

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.3 no.2
• /
• pp.146-151
• /
• 2015

Recycled aggregate by the recycling construction waste has a lot of advantage such as the developing the alternative resource and protecting of environment. However, recycled aggregate is used as the low quality grade, because it is difficult to remove old mortar from aggregate. To use the recycled aggregate as high quality grade, it is important to develop the technology to produce the high quality recycled aggregate. To manufacture the high quality recycled aggregate, old mortar attached on the aggregates should be removed efficiently. Therefore, in this study, we suggested the optimum condition to remove old mortar effectively using sulfuric acid and low speed wet rotary mill for high quality recycled fine aggregate. The results shows that the recycled aggregate satisfy on the standards of KS F 2573 in density, absorption and solid volume, when adequate condition of sulfuric mole ratio and aggregate ratio are make.

• Journal of Energy Engineering
• /
• v.21 no.3
• /
• pp.315-324
• /
• 2012

Waste reduce, recycle, energy recovery technology is one of 27 key green technology by 2012, the government should increase R&D investment, despite the period 2008 to 2010 average annual growth rate was decreased. Accordingly, this area of government investment in R&D status analyzed in detail and as a result, total government investment in R&D decreased, but in these fields to define strategic product services investment in technology is increasing centralization trend that appears to be investment in the quality of determined that the good is. In particular, in 2010, strategic product service of the technologies 3 technology groups ((1) waste energy equipment (2) waste resource recycling facilities (3) waste based materials production facilities) the proportion of 24-28% relatively evenly invested, government R&D is judged that adequate investment in quality.

• Journal of Energy Engineering
• /
• v.25 no.4
• /
• pp.214-225
• /
• 2016

Gasification is one of the important contribution to resource recycling by conversion of biomass to a variety of energy sources such as alcohol, SNG etc., and to global warming prevention by reduction of green house gases such as $CO_2$. The aim of this study is to draw the optimal operation condition of dual fluidized-bed gasifier with biomass fuel, to verify SNG production efficiency and to establish the basis for the domestic commercialization of dual fluidized bed gasification. As a result, dual fluidized-bed gasifier has the optimal conditions at $826^{\circ}C$ with steam input 1,334 g/hr, air input 5.56 L/min. The carbon conversion is 81% and SNG production efficiency was $CH_4$ 92%.

• Journal of the Korean BIBLIA Society for library and Information Science
• /
• v.24 no.1
• /
• pp.189-205
• /
• 2013

The purpose of this study is to describe the trends and contents of literature in green library and to suggest the research direction on green library. Earlier studies focus on the green library architecture and necessity, after then green library management studies have proliferated. Green library architecture studies have emphasized on 'energy and atmosphere' and 'indoor environmental quality' based upon 5 categories of LEED evaluation system. Green library management studies have focused on library resources recycling and utilizing energy through effective management of library collection. Based on the analysis of literature, five research directions are suggested, such as the number of libraries in an area, library shelf position and space, library space program, collection ratio for library storage, and user studies.

• Mineral and Industry
• /
• v.28
• /
• pp.1-13
• /
• 2015

In this study, it was carried out separation process research and development to be able to produce high-grade tungsten concentrate form tungsten taken form Mongolia. In order to reduce treatment cost and increase separation efficiency the jig separation at first was applied for recovering the concentrate. Which reground would make the degree of liberation increase. Which was treated by shaking table to reject the gangue minerals from the first concentrate. Because the heavier product contains not only ferberite but also cassiterite, the product was treated by further dry magnetic separation to obtain the ferberite concentrate. Finally, the high-grade ferberite concentrate of 67.63% $WO_3$ could be obtained with recovery of 86.07% through the separation process developed in this study.