• Transactions of the Korean hydrogen and new energy society
• /
• v.32 no.1
• /
• pp.41-52
• /
• 2021

NiO and Co3O4-doped porous La(CoNi)O3 perovskite oxides were prepared from excess Ni addition by a hydrothermal method using porous silica template, and characterized as bifunctional catalysts for oxygen reduction reaction (ORR) and oxygen evolution reaction (OER) for Zn-air rechargeable batteries in alkaline solution. Excess Ni induced to form NiO and Co3O4 in La(CoNi)O3 particles. The NiO and Co3O4-doped porous La(CoNi)O3 showed high specific surface area, up to nine times of conventionally synthesized perovskite oxide, and abundant pore volume with similar structure. Extra added Ni was partially substituted for Co as B site of ABO3 perovskite structure and formed to NiO and Co3O4 which was highly dispersed in particles. Excess Ni in La(CoNi)O3 catalysts increased OER performance (259 mA/㎠ at 2.4 V) in alkaline solution, although the activities (211 mA/㎠ at 0.5 V) for ORR were not changed with the content of excess Ni. La(CoNi)O3 with excess Ni showed very stable cyclability and low capacity fading rate (0.38 & 0.07 ㎶/hour for ORR & OER) until 300 hours (~70 cycles) but more excess content of Ni in La(CoNi)O3 gave negative effect to cyclability.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.4 no.2
• /
• pp.178-189
• /
• 1994

Fine $BaTiO_3$ powder was synthesized from the various starting solution with 0.05 M by ultrasonic spray pyrolysis method. The conditions of synthesis were fixed on flow rate was 0.5 cm/sec, low temperature furnace was $300^{\circ}C$, and high temperatures furnace was $700^{\circ}C$. The formation procedure was investigated directly by SEM with the collected particle from the each reaction step. Also, the trace of particle in reaction tube was researched theoretically. Fine $BaTiO_3$ was synthesized only in the case of nitrate aqueous solution. The synthesized $BaTiO_3$ powder was porous and spherical which was consist of primary particle at the size of 19.1 nm. The formation procedure was as follows : the particle size decreased in drying step and then increased in initial thermal decomposition step. Finally, particle size was decreased to $0.42 {mu}m$. The trace of particle in reaction tube was also theoretically simulated and discussed.

• Journal of the Korean Ceramic Society
• /
• v.25 no.5
• /
• pp.509-517
• /
• 1988

The controlled Ti(CO2H5)4 hydrolysis reactions for the synthesis of Spherical Monodispersed Titania powders are described. Increasing the concentration of TEOT and the molar ratio of water to TEOT in alcohol solution decrease the reaction time and the particle size. The reaction time is delalyed by increasing the chain length and the number of carbon branches of alcohol as a solvent. The prepared powders with an average diameter of 0.8$\mu$ and the spherical monodispersed transfer to Rutile phase at 55$0^{\circ}C$.

• Journal of the Korean institute of surface engineering
• /
• v.15 no.3
• /
• pp.146-151
• /
• 1982

The electrochemical reaction behavior of nickel electrode of the nickel-cadium battery system in potassium hydroxide solution has been studied by cyclic voltammetry, controlled potential electrolysis and X-ray diffraction method. It has been found that the reaction mechanism of positive nickel electrode for charging was assumed to be proten transfer step with a rate controlling diffusion process and char-ging state of positive electrode was amorphous $\beta$-NiOOH.

• Journal of the Korean Ceramic Society
• /
• v.19 no.2
• /
• pp.109-114
• /
• 1982

Fluoro-phlogopite crystals (Mica) were synthesized by two different methods; firstly the crystal was crystallized from the melts, and secondly mica crystalline was obtained from the direct solid state reaction. Addition of $CaF_2$ in the mica batch revealed the lowering the solid state reaction temperature. SEM and XRD were employed to observe mica crystalline flakes and solid solution forms. As a starting raw material Pyrophyllite was used resulting in the formation of mica crystals.

• Journal of the Korean Ceramic Society
• /
• v.16 no.4
• /
• pp.201-205
• /
• 1979

Domestic Yungil bentonite (montmorillonite) was treated with 1N sodium hydroxide solution in an autoclave at several temperatures, between 100 to 200℃, for 1 to 24 hrs. The products were examined by X-ray diffraction analysis. The following concecutive reaction was valid. montmorillonite→amorphous aluminosilicate→analcime The reaction rate constants k and k' at 200℃ were 0.35hr-1 and 0.22hr-1, respectively. The activation energies for the conversion from montmorillonite to amorphous aluminosilicate and from amorphous aluminosilicate to analcime were 10 kcal/mol and 12kcal/mol, respectively.

• Journal of the Korean Society of Safety
• /
• v.13 no.2
• /
• pp.76-87
• /
• 1998

This study was carried out to investigate the effect of on temperature control from actuating method, recycling ratio and the position (top, middle and bottom) of set and controlled temperature within the reactor in adiabatic ebullated recycling condition, when the disturbance was occurred. Estimation of the solution were performed numerically using the finite difference method. It was assumed that the reaction is in constant with heat of reaction and the physical properties(density, heat capacity and viscosity, etc) of the reactants are same condition within the reactor.

• YAKHAK HOEJI
• /
• v.22 no.1
• /
• pp.15-21
• /
• 1978

Gentamicin sulfate reacted with pyridoxal and zinc (II) ion in pyridine-methanol solution to yield highly fluorescent zinc(II) chelates of N-pyridoxylidene derivatives. This fluorescence reaction was sensitive and showed excitation maximum at 398nm, and emission maximum at 482nm. The effects of reagent concentration, reaction time and temperature, standing time and temperature were studied. And a new fluorophotometric method for the determination of gentamicin sulfate was developed. A good result was obtained and this method was applied to various preparations.

• Journal of the Korean Ceramic Society
• /
• v.26 no.1
• /
• pp.81-90
• /
• 1989

High purity alumina and amorphous silica were prepared from Ha-dong kaolin by means of appliance of sulfuric acid. The effect of sulfuric acid concentration, reaction temperature and reaction time on the formation of aluminum sulfate was investigated. The precipitation conditions ofaluminum sulfate from the sulfuric acid solution with ethanol and ammonium hydroxide were deteremined. In the optimum condition, the conversion of aluminum oxide in kaolin to aluminum oxide powder was 85.0 percent. Alumina powder was prepared by calcination of the precipitates, and its purity was 99.0 percent.

• Journal of the Korean Ceramic Society
• /
• v.14 no.1
• /
• pp.7-11
• /
• 1977

Domestic Anyang feldspar was treated in autoclave with 1N sodium hydroxide solution for 1-6 hrs at 100-20$0^{\circ}C$ By X-ray diffraction patterns and cation exchange capacity, the products were examined. The following concecutive reaction was valid. AlbitelongrightarrowAmorphous aluminosilicatelongrightarrowAnalcime The reaction rate constants, k1 and k2, were 0.20 and 0.15(1/hr) at 20$0^{\circ}C$ respectively. The activiation energy from albite to amorphous aluminosilicate was 10 kcal/mol, and from amorphous aluminosilicate to analcine 13 kcal/mol. The analcime obtained was excellent in cation exchange capacity, amounting to 210meq./100g.