• Journal of Environmental Science International
• /
• v.24 no.8
• /
• pp.981-992
• /
• 2015

This study is mainly focused on micellar effect of tetradecyltrimethyl ammonium bromide(TTABr) solution including alkylbenzimidazole(R-BI) on dephosphorylation of diphenyl-4-nitrophenylphosphinate(DPNPIN) in carbonate buffer(pH 10.7). Dephosphorylation of DPNPIN is accelerated by $BI^{\Theta}$ ion in $10^2$ M Carbonate buffer(pH 10.7) of $4{\times}10^{-4}$ M TTABr solution up to 80 times as compared with the reaction in Carbonate buffer by no benzimidazole(BI) solution of TTABr. The value of pseudo first order rate constant($k_{\psi}$) of the reaction in TTABr solution reached a maximum rate constant increasing micelle concentration. The reaction mediated by $R-BI^{\Theta}$ in micellar solutions are obviously slower than those by $BI^{\Theta}$, and the reaction rate were decreased with increase of lengths of alkyl groups. It seems due to steric effect of alkyl groups of $R-BI^{\Theta}$ in Stern layer of micellar solution. The surfactant reagent, TTABr, strongly catalyzes the reaction of DPNPIN with R-BI and its anion($R-BI^{\Theta}$) in Carbonate buffer(pH 10.7). For example, $4{\times}10^{-4}$ M TTABr in $1{\times}10^{-4}$ M BI solution increase the rate constant($k_{\psi}=99.7{\times}10^{-4}1/sec$) of the dephosphorylation by a factor ca. 28, when compared with reaction($k_{\psi}=3.5{\times}10^{-4}1/sec$) in BI solution(without TTABr). And no TTABr solution, in BI solution increase the rate constant($k_{\psi}=3.5{\times}10^{-4}1/sec$) of the dephosphorylation by a factor ca. 39, when compared with reaction ($k_{\psi}=1.0{\times}10^{-5}1/sec$) in water solution(without BI).

• Korean Journal of Animal Reproduction
• /
• v.15 no.3
• /
• pp.195-199
• /
• 1991

This study was carried out ot investigate effect of pH stimulation on acrosome reaction of bovine spermatozoa. The results obtained were as follows : 1. When sperm was sequentially washed with SHP solution of pH 7.4, 7.7 and 7.4 and incubated in mTALP solution of pH 7.4 for 120min, 15, 30, 60 and 120min incubations showed significantly(p<0.05) higher sperm acrosome reaction rate than 0 min. 2. When sperm was sequentially washed with SHP solution of pH 7.4, 8.0 and 7.4 and incubated in mTALP solution of pH 7.4 for 15 minutes, sperm acrosome reaction rate was significantly(p<0.01) increased until 9 min. Incubation, but not increased thereafter. 3. When sperm were separately washed with SHP solutions of pH 7.0, 7.4 and 8.0 and incubated in mTALP solution of pH 7.4 for 9min, sperm acrosome reaction rate was 74.8, 71.8 and 93.4%. pH 8.0 showed signifciantly(p<0.01) higher sperm acrosome reaction rate than pH 7.0 and 7.4. The results suggest that stimulation of sperm with high pH induces sperm crosome reaction.

• Korean Journal of Crystallography
• /
• v.11 no.4
• /
• pp.224-230
• /
• 2000

We have been investigated the flaking mechanism of the soda-line glass. The pH of aqueous solution approached to 10 and increased with reaction time by ion exchange reaction between Na/sup +/ ion of glass and H/sup +/ ion of aqueous solution under the conditions of below pH 9 of start solution. The relationship between the pH of solution and reaction time shows logarithm. Total dissolution reaction of glass components by OH/sup -/ ion in aqueous seems to be dominant after the pH solution reached to 10 and the dissolution rate linearly increased with reaction time. The above tow reactions are simultaneously occurred. The dissolved Ca/sup 2+/ ions are reprecipitated on the glass surface to Ca-compound. The flakes are formed by the separation of leached layer of glass due to the different thermal expansion coefficient.

• Journal of Hydrogen and New Energy
• /
• v.21 no.6
• /
• pp.479-486
• /
• 2010

In order to confirm the effect of $HI_x$ solution on Bunsen reaction in Sulfur-Iodine thermochemical hydrogen production process, the reaction was investigated using $HI_x$ solution as a reactant. The phase separation characteristics of reaction with $HI_x$ solution were compared with the reaction using $I_2$ and $H_2O$ as reactants. Firstly, saturation points of $I_2$ in $HI_x$ solution at various temperatures were investigated to determine reaction conditions. With increasing temperature, the amounts of unreacted $I_2$ and $H_2O$ in $HI_x$ solution were increased, while impurities (HI in $H_2SO_4$ phase and $H_2SO_4$ in $HI_x$ phase) in each phase were decreased. The volumes of $H_2SO_4$ phase obtained from Bunsen reaction with $HI_x$ solution was relatively less than those obtained from the reaction with $I_2$ and $H_2O$. The difficulty of phase separation in Bunsen reaction using $HI_x$ solution may be due to the insufficient amount of $H_2O$ existed in $HI_x$ phase after reaction. Therefore, we concluded that the supplement amount of $H_2O$ should be calculated on the basis of the moles of HI and $H_2SO_4$ and added to the reaction system for good phase separation.

• Journal of the Korean Ceramic Society
• /
• v.28 no.11
• /
• pp.885-891
• /
• 1991

Calcium hydroxyapatite have been synthesized by a direct precipitation reaction between 0.05 M calcium hydroxide suspension and 0.3 M orthophosphoric acid solution. 0.01 M calcium hydroxide solution was added during the reaction in order to increase the total Ca/P mol ration and reaction pH of the solution. The stoichiometric hydroxyapatite was synthesized over 1.75 as total Ca/P mol ratio, but the calcium-deficient hydroxyapatite was prepared under 1.725 as total Ca/P mol ratio. The nonstoichiometry of the precipitates were interpreted in terms of the pH change during the reaction.

• Journal of the Korean Ceramic Society
• /
• v.37 no.7
• /
• pp.681-685
• /
• 2000

The influence of ZnCl2 in portland cement hydration was studied. The hydration reaction was progressed with ZnCl2 solution to observe the adiabatic hydration exothermic and hydration products. To compare with cement hydration, Ca(OH)2 solution reacted with ZnCl2 was carried out. The addition of ZnCl2 solution to the portland cement was retarded hydration quantitatively. Because ZnO which was produced in certain pH adsorbed with unhydrated cement made retarded the hydration reaction.

• YAKHAK HOEJI
• /
• v.7 no.2_3
• /
• pp.51-54
• /
• 1963

In this experiment, it is found that the decomposition reaction of hexamine aqueous solution by heat is the pseudo first order reaction and the calculated decomposition velocity constants of Hexamine aqueous solution are 1.17 * $10^{-5}min.^{-1}(60{\deg}$ C), 1.99 * $10^{-5}min.^{-1}(70{\deg}$ C), 2.35 * $10^{-5}min.^{-1}(80{\deg}$ C), 6.63 * $10^{-5}min.^{-1}(100{\deg}$ C). In the result, the activation energy of decomposition reaction of hexamine aqueous solution is 12 $Cal.mole^{-1}$.

• East Asian mathematical journal
• /
• v.35 no.5
• /
• pp.535-545
• /
• 2019

This paper is concerned with the optimal control problem associated to strong solution of Belousov-Zhabotinskii reaction model in 2D domain. That is, we otain the global existence of strong solution and show the existence of optimal control.

• Korean Journal of Materials Research
• /
• v.12 no.1
• /
• pp.58-67
• /
• 2002

In this study copper chloride(CuCl$_2$) solution was used as raw material to produce the fine copper oxide powder which has less than 1 $\mu\textrm{m}$ average particle size and has uniform particle size distribution by spray pyrolysis process. In the present study, the effects of reaction temperature, the injection speed of solution and air, the nozzle tip size and the concentration of raw material solution on the properties of produced powder were studied. The structure of the powder became much more compact with increasing the reaction temperature regardless of copper concentration of the raw material solution. The particle size of the powder increased accordingly with increasing the reaction temperature in case of 30 g/$\ell$ copper concentration of the solution. The particle size of the powder increased accordingly, and the surface structure of the powder became more porous with increasing the copper concentration of the raw material solution. When copper concentration in raw material solution was more than 100 g/$\ell$, all produced powder was CuCl regardless of reaction temperatures. When copper concentration in solution was below 30 g/$\ell$ and reaction temperature was higher than 90$0^{\circ}C$, CuO was the main phase. The surface of the powder tended to become porous with increasing the injection speed of solution. Particle size was increased and the surface of the powder showed severely disrupted state with increasing the nozzle tip size. The particle size was decreased and the particle size distribution was more uniform with increasing the air pressure through the nozzle.

• Nuclear Engineering and Technology
• /
• v.32 no.6
• /
• pp.531-536
• /
• 2000

The extraction of precious metals from aqueous solutions is performed by using a photoredox reaction with a Q-switched Nd:YAG laser. The metallic silver was efficiently precipitated and extracted from the silver nitrate solution by laser photolysis. An optimum reaction condition for silver extraction was determined by adjusting various experimental factors such as type of reducing agent, type of acids and reaction time. The composition of the reaction product was analyzed and it was identified as metallic silver, not other molecular types. The photoreaction of chromium(III) chloride in an acidic aqueous solution was also investigated. The 355 nm laser light was better suited for the reaction of silver nitrate as well as chromium(III) chloride in an acidic solution compared to the 532 nm light.