• Journal of the Chungcheong Mathematical Society
• /
• v.23 no.3
• /
• pp.425-434
• /
• 2010

Here we see that the $p-Ces{\grave{a}}ro$ operators, the generalized $Ces{\grave{a}}ro$ operators of order one, the discrete generalized $Ces{\grave{a}}ro$ operators, and their adjoints are all posinormal operators on ${\ell}^2$, but many of these operators are not dominant, not normaloid, and not spectraloid. The question of dominance for $C_k$, the generalized $Ces{\grave{a}}ro$ operators of order one, remains unsettled when ${\frac{1}{2}}{\leq}k<1$, and that points to some general questions regarding terraced matrices. Sufficient conditions are given for a terraced matrix to be normaloid. Necessary conditions are given for terraced matrices to be dominant, spectraloid, and normaloid. A very brief new proof is given of the well-known result that $C_k$ is hyponormal when $k{\geq}1$.

• Annual Conference on Human and Language Technology
• /
• 2021.10a
• /
• pp.602-604
• /
• 2021

최근 자연어 처리 분야에서 사전 학습된 언어 모델은 다양한 응용 태스크에 적용되어 성능을 향상시켰다. 하지만 일반적인 말뭉치로 사전 학습된 언어 모델의 경우 중공업 분야처럼 전문적인 분야의 응용 태스크에서 좋은 성능을 나타내지 못한다. 때문에 본 논문에서는 이러한 문제점을 해결하기 위해 중공업 말뭉치를 이용한 RoBERTa 기반의 중공업 분야에 특화된 언어 모델 HeavyRoBERTa를 제안하고 이를 통해 중공업 말뭉치 상에서 Perplexity와 zero-shot 유의어 추출 태스크에서 성능을 개선시켰다.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.16 no.4
• /
• pp.821-828
• /
• 2012

In this paper, we report that the differences between RF power levels can be improved in wavelength division multiplexing - radio over fiber (WDM-RoF) system by using a photonic crystal fiber. In a WDM-RoF system, each WDM channel experiences different received RF power level fluctuation in remote node (RN) because of wavelength-dependent dispersion. Since each WDM channel experiences different power fluctuation, the RF power fluctuation acts as a design constraint in viewpoint of network design. We designed a photonic crystal fiber to improve the effect of wavelength- dependent dispersion on RF power fluctuation. Also, we analyzed the wavelength-dependent difference of inter-channel RF power fluctuations.

• Journal of the Society of Naval Architects of Korea
• /
• v.43 no.4 s.148
• /
• pp.451-459
• /
• 2006

When a ship is damaged and flooded, the motion of the damaged ship is significantly influenced by the flooding water dynamics. The flooding water in the damaged ship has been treated as a lumped mass under the quasi-static assumption in most of previous researches. To calculate the motion of damaged ship rigorously, it is necessary to analyze the coupled dynamics of flooding water. In this study, a series of numerical and experimental studies is conducted for the damaged part of ITTC RORO passenger. FLOW3D is used for investigating the feasibility of the state of the art CFD technique. An applicability of the coupled motion analysis of damaged ships can be confirmed by agreement between the numerical results and the model experiments. A CFD technique is considered for the numerical modeling of the dynamics of flooding water.

• Special Issue of the Society of Naval Architects of Korea
• /
• 2013.12a
• /
• pp.13-20
• /
• 2013

In this paper, a collision accident of a container/Ro-Ro ship was numerically analyzed. A container trailer collided with a longitudinal bulkhead of the ship in the accident, which constituted a longitudinal wall of a heavy fuel oil tank. Due to the accident, the bulkhead plate was ruptured and the heavy fuel oil spilled out of the tank. The detailed information regarding the collision velocity and the mass of the trailer was not provided. Therefore, several collision accident scenarios were constructed based upon the arrangement of the ramp way. Each collision accident scenario was analyzed to predict the extents of damage using a commercial numerical package, ABAQUS. Based on the analysis results it is proposed how to minimize the extents of damage. Through the investigations performed in this study it was found that the understandings of various damages due to collision accidents and the developments of structural design guidance against collision are necessary for the betterment of Container/RO-RO ships' performance.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.27 no.7
• /
• pp.948-955
• /
• 2003

Pressure coefficient in rotating discharge hole was measured to gain insight into the influence of rotation to the discharge characteristics of rotating discharge hole. Pressure measurements were done by the telemetry system that had been developed by the authors. The telemetry system measures static pressure using piezoresistive pressure sensors. Pressure coefficients in rotating discharge hole were measured in longitudinal direction and circumferential direction with various rotating speed and 3 pressure ratios. From the results, the pressure coefficient, and therefore the discharge coefficient, is known to decrease with the increase of Ro number owing to the increase of flow approaching angle to the discharge hole inlet. However, there exists critical Ro number where the decrease rate of discharge coefficient with the increase of Ro number changes abruptly; flow separation occurs from the discharge hole exit at this critical Ro number. Critical Ro number increases with the increase of length-to-diameter ratio, but the increase is small where the length-to-diameter ratio is higher than 3. The decrease rate of discharge coefficient with the increase of Ro number depends on the pressure recovery at the discharge hole, and the rate is different from each length-to-diameter ratio; it has tendency that the short discharge hole shows higher decrease rate of discharge coefficient.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.35 no.4B
• /
• pp.559-565
• /
• 2010

In Mobile IPv6 handover should be followed by RO(Route Optimization) to support direct communication between a MN(Mobile Node) and CN(Correspondent Node). For this RR MIPv6 must perform RR(Return Routability) procedure before BU(Binding Update) to CN. The Fast Handover for MIPv6(FMIPv6) also performs the RR test for MN to communicate with CN directly. However, Return Routability test has long latency resulting in handover delay in MIPv6. This paper proposes the method to reduce the handover deay by reducing RO latency in FastMobile IPv6.

• Proceedings of the KSRS Conference
• /
• 2007.10a
• /
• pp.65-68
• /
• 2007

FORMOSAT-3 was launched in April of 2006. It consists of six low earth orbit (LEO) satellites that will be eventually deployed to an orbit at 800 km height. Its scientific goal is to utilize the radio occultation (RO) signals to measure the bending angles when the GPS signals transect the atmosphere. The bending angle is then used to infer atmospheric parameters, including refractivity, temperature, pressure, and relative humidity fields of global distributions through inversion schemes and auxiliary information. The expected number of RO events is around 2500 per day, of which 200 events or so fall into the polar region. Consequently, the FORMOSAT-3 observations are expected to play a key role to improve our knowledge in the weather forecasting and space physics research in the polar region. In this paper, we use temperature profiles retrieved from FORMOSAT-3 RO observations to study the climatology of gravity wave activity in the polar region. FORMOSAT-3 can provide about 200 RO observations a day in the polar region, much more than previous GPS RO missions, and, hence, more detailed climatology of gravity wave activity can be obtained.

• Journal of Korean Society on Water Environment
• /
• v.22 no.5
• /
• pp.926-932
• /
• 2006

A series of bench-scale membrane filtration experiments were performed to systematically investigate the removal mechanisms of reverse osmosis (RO) and nanofiltration (NF) membranes for BTEX (benzene, toluene, ethylene, xylene), trichloroethylene (TCE) and tetrachloroethylene (PCE). The molecular weight of these organic compounds ranged from 78 to 166 dalton. The rejection of organic compounds by RO/NF membranes varied significantly from 59.6 to 99.2% depending on solute and membrane types. Specifically, experimental results demonstrated that the removal efficiency of RO/NF membranes increased as solute molecular characteristics such as W/L (molecular width/length) ${\times}$ $M_W$ (molecular weight) and octanol-water partition coefficient increased. This observation suggested that the rejection of small organic compounds by RO/NF membranes was determined by the combined effect of physical (molecular size and shape) and chemical (hydrophobicity) properties.

• Molecules and Cells
• /
• v.19 no.3
• /
• pp.350-355
• /
• 2005

Selectins are carbohydrate-binding cell adhesion molecules that play a major role in the initiation of inflammatory responses. Heparin can bind to P-selectin, and its anti-inflammatory property is mainly due to inhibition of P-selectin. However, the strong anticoagulant activity of heparin limits its clinical use. We prepared periodate-oxidized, borohydride-reduced heparin (RO-heparin) by chemical modification and tested its anticoagulant and anti-inflammatory activities. Activated partial thromboplastin time (aPTT) assays showed that, compared with heparin, RO-heparin had greatly reduced anticoagulant activity. Intravenous administration of this compound led to reduction in the peritoneal infiltration of neutrophils in a mouse acute inflammation model. In vitro cell adhesion experiments demonstrated that the effect of RO-heparin on inflammatory responses was mainly due to inhibiting the interaction of P-selectin with its ligands. These results indicate that RO-heparin may be a safer treatment for inflammation than heparin, especially when selectin is targeted.