• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2007.06a
• /
• pp.371-372
• /
• 2007

• Journal of Korea Society of Industrial Information Systems
• /
• v.6 no.2
• /
• pp.31-37
• /
• 2001

In this paper, We designed and implemented an RF module for WLL multi-channel personal stations. Then, we experimentally evaluated in receiving sensitivity, adjacent channel interference selectivity and spurious response limit. From the measurement results on the RF module for WLL multi-channel personal stations, we observed and confirmed as follows: First, the variation in output power level was kept to be less than 30 dBm in the range of the input power level from -90 dBm to -30dBm. This measurement result confirmed the dynamic range of 60 dB. Secondly, at the output stage of the RF module, the gain flatness in the pass band was measured to be less than 2dB, which confirmed a precise control of the bandspread signals. Thirdly, at the RF module, the bandwidth and power level in transmission were measured to be 10 MHz, respectively we note that these features satisfy the design specifications.

• Proceedings of the Korea Electromagnetic Engineering Society Conference
• /
• 2005.11a
• /
• pp.169-174
• /
• 2005

In this paper, we proposed a new algorithm of the inverse scattering for the reconstruction of unknown dielectric scatterers using the finite-difference time-domain method and the design sensitivity analysis. We introduced the design sensitivity analysis based on the gradient for the fast convergence of the reconstruction. By introducing the adjoint variable method for the efficient calculation, we derived the adjoint variable equation. As an optimal algorithm we used the steepest descent method and reconstructed the dielectric targets using the iterative estimation. To verify our algorithm we will show the numerical examples for the two-dimensional $TM^2$ cases.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.20 no.11
• /
• pp.1130-1137
• /
• 2009

This paper proposes a new clock routing design for suppressing clock harmonic effects in a Printed Circuit Board (PCB) for a terrestrial Digital Multimedia Broadcasting(DMB) system. Typical crystal reference frequencies that are widely used in DMB tuners are 16.384 MHz, 19.2 MHz, 24.576 MHz. When the high-order harmonic components of these reference frequencies fall near the RF channel frequencies, receiver sensitivity of the tuners is seriously degraded. In this work, we propose a new clock routing design in order to address the clock harmonic coupling issue. The proposed design incorporates two inductors for isolating the clock ground from the main ground, and adopts a new strip line-style routing instead of the conventional microstrip line style routing to minimize the overlap area with the main ground. As a result, the RF sensitivity of the T-DMB tuner is improved by 2 dB.

• Korean Journal of Clinical Laboratory Science
• /
• v.39 no.1
• /
• pp.42-48
• /
• 2007

This study was carried out to review and evaluate anti-CCP ELISA assay for diagnostic in RA patients from an early arthritis clinic (EAC). The subjects were obtained from patients visiting the outpatient clinic of the Dept. of Rhumatology med.of P hospital in Daegu, during 6 months from July 1, 2006 to December 31, 2006. The subjects were 140 cases : 80 cases from RA patients (60 women and 20 men; mean age 58 years; range, 32-68 years) confirmed by clinical diagnostic. 39 cases of these RA patients were classified as having early RA (EAC). 50 cases (non-RA) did not fulfill the criteria for RA, and 10 cases were from healthy individuals. We performed the analysis with solid phase-ELISA method (ETI-max3000, Diasorin; Italy) for anti-CCP and Nephelometry assay (Roche/Hitachi 902 analyzer; USA) for RF. The results obtained were summarized as follows ; anti-CCP ELISA is more specific than RF Nephelometry assay (specificity 94% vs 90%) to diagnose RA patients with suspected EAC (early arthritis clinic). The combination test "anti-CCP and RF" had a very high specificity (specificity 98.3%, PPV; RA group 96%, EAC 95%), the difference was statistically significant (p<0.05). Anti-CCP ELISA had more sensitivity in EAC (Early arthritis clinic) patients than chronic RA patients (sensitivity 64% vs 24%, respectively), anti-CCP of RA group and EAC group was more specific than RF (anti-CCP PPV; 92%, 89% vs 89%, 81% respectively), the difference was statistically significant (p<0.05). The difference of antibody concetration between anti-CCP and RF for RA and the control group is statistically significant (p<0.05). In conclusion, anti-CCP ELISA testing may be useful if performed concomitantly with RF Nephelometry assay to diagnose RA patients with suspected EAC (early arthritis clinic).

• Journal of the Microelectronics and Packaging Society
• /
• v.7 no.3
• /
• pp.19-25
• /
• 2000

In this paper, we describe RF receiver module for IMT-2000 handset with 5 MHz channel bandwidth. The fabricated RF receiver module consists of Low Noise Amplifier, RF SAW filter, Down-converter, If SAW filter, AGC and PLL Synthesizer. The NF and IIP3 of LNA is 0.8 dB, 3 dBm at 2.14 GHz, conversion gain of down-converter is 10 dB, dynamic range of AGC is 80 dB, and phase noise of PLL is -100 dBc at 100 kHz. The receiver sensitivity is -110 dBm, adjacent channel selectivity is 48 dBm.

• Journal of Advanced Navigation Technology
• /
• v.23 no.5
• /
• pp.415-423
• /
• 2019

In this paper, a design method for a high-sensitivity microstrip patch sensor antenna (MPSA) loaded with a bent-slot was studied for the permittivity measurement. The bent-slot similar to a single-ring complementary split ring resonator was added along a radiating edge of the patch in order to enhance the sensitivity to the permittivity. The sensitivity of the proposed MPSA was compared with that of a conventional rectangular MPSA and a thin rectangular-slotted MPSA. Three MPSAs were designed and fabricated on a 0.76-mm-thick RF-35 substrate so that the input reflection coefficient would resonate at 2.5 GHz in the absence of the superstrate under test. When five different Taconic substrates with a relative permittivity ranging from 2.17 to 10.2 were used as the superstrate under test, experiment results show that the sensitivity of the proposed MPSA, which is measured by the shift in the resonant frequency of the input reflection coefficient, is 4.1 to 6.1 times higher than that of the conventional MPSA.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.29 no.8
• /
• pp.632-639
• /
• 2018

This paper presents a single antenna radar sensor with a Ku-band radar transceiver IC realized by 130 nm CMOS processes. In this radar receiver, sensitivity time control using a DC offset cancellation feedback loop is employed to achieve a constant SNR, irrespective of distance. In addition, the receiver RF block has gain control to adjust high dynamic range. The RF output power is 9 dBm and the full chain gain of the Rx is 82 dB. To reduce the direct-coupled Tx signal to the Rx in a single antenna radar, a stub-tuned hybrid coupler is adopted instead of a bulky circulator. The maximum measured distance between the horn antenna and a metal plate target is 6 m.

• Journal of Biomedical Engineering Research
• /
• v.33 no.3
• /
• pp.148-154
• /
• 2012

Hemorrhagic shock is a primary cause of deaths resulting from injury in the world. Although many studies have tried to diagnose accurately hemorrhagic shock in the early stage, such attempts were not successful due to compensatory mechanisms of humans. The objective of this study was to construct a survival prediction model of rats in acute hemorrhagic shock using a random forest (RF) model. Heart rate (HR), mean arterial pressure (MAP), respiration rate (RR), lactate concentration (LC), and peripheral perfusion (PP) measured in rats were used as input variables for the RF model and its performance was compared with that of a logistic regression (LR) model. Before constructing the models, we performed 5-fold cross validation for RF variable selection, and forward stepwise variable selection for the LR model to examine which variables were important for the models. For the LR model, sensitivity, specificity, accuracy, and area under the receiver operating characteristic curve (ROC-AUC) were 0.83, 0.95, 0.88, and 0.96, respectively. For the RF models, sensitivity, specificity, accuracy, and AUC were 0.97, 0.95, 0.96, and 0.99, respectively. In conclusion, the RF model was superior to the LR model for survival prediction in the rat model.

• ETRI Journal
• /
• v.40 no.2
• /
• pp.167-179
• /
• 2018

This paper proposes an IEEE 802.15.4m compliant TV white-space orthogonal frequency-division multiplexing (TVWS)-(OFDM) radio frequency (RF) transceiver that can be adopted in advanced metering infrastructures, universal remote controllers, smart factories, consumer electronics, and other areas. The proposed TVWS-OFDM RF transceiver consists of a receiver, a transmitter, a 25% duty-cycle local oscillator generator, and a delta-sigma fractional-N phase-locked loop. In the TV band from 470 MHz to 698 MHz, the highly linear RF transmitter protects the occupied TV signals, and the high-Q filtering RF receiver is tolerable to in-band interferers as strong as -20 dBm at a 3-MHz offset. The proposed TVWS-OFDM RF transceiver is fabricated using a $0.13-{\mu}m$ CMOS process, and consumes 47 mA in the Tx mode and 35 mA in the Rx mode. The fabricated chip shows a Tx average power of 0 dBm with an error-vector-magnitude of < 3%, and a sensitivity level of -103 dBm with a packet-error-rate of < 3%. Using the implemented TVWS-OFDM modules, a public demonstration of electricity metering was successfully carried out.