• Applied Biological Chemistry
• /
• v.23 no.4
• /
• pp.206-210
• /
• 1980

The minor components of $saponin-ginsenoside-Rf,\;-Rg_2\;and\;-Rh_1$ were isolated from Panax ginseng C.A. Meyer by preparative, semi-preparative and analtical high performance liquid chromatography. The rapid method developed in this work was proved to be very effective in separation and isolation of these minor ginsenosides. A further isolation was achieved by using the recycling technique.

• Korean Journal of Materials Research
• /
• v.7 no.6
• /
• pp.522-528
• /
• 1997

RF-magnetron Sputtering Process를 이용하여 Pt/Ti/Si(100)기판위에 lanthanum-modified lead titanate 박막을 제작하였다. 기판온도와 증착시간이 증가함에 따라 증착율은 감소하였다. 기판온도가 증가함에 따라 fine grain들은 large grain으로 변화하였다. Perovskite구조는 기판온도 54$0^{\circ}C$, gas pressure 30mtorr에서 나타나기 시작하였다. 본 실험에서 perovskite 박막제작에 대한 조건은 기판온도 58$0^{\circ}C$, gas pressure 30mtorr였다. Pt/Ti/Si(100) 우선 배향된 박막을 얻었다. La양이 증가함에 따라 유전율, 항전계, 잔류분극량은 증가하였다. 중심주파수가 44.7MHz, 전파속도는 2680m/sec를 가지는 SAW filter 특성을 얻었다.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2008.10a
• /
• pp.895-897
• /
• 2008

ZnO films were fabricated using rf-magnetron sputter deposition process with different $N_2$ ambient. N-content in N-doped ZnO films was less than 1%. The wavelength of the highest intensity PL peak of N-doped ZnO was shifted to higher wavelength with increasing $N_2$ flow rate in the deposition ambient. These results indicated that the optical property of ZnO was significantly affected by the defect level created by doping with a very small amount of N.

• Journal of Ginseng Research
• /
• v.20 no.1
• /
• pp.106-110
• /
• 1996

The present study was undertaken to elucidate the effects of ginseng components on rat lens aldose reductase activity. Ginseng total saponin (GTS) exhibited inhibitory activities on rat lens aldose reductase in a dose-dependent manner. Among ginsenosides, Rf and Rgl showed potent inhibitory activities on rat lens aldose reductase. Lipid soluble fraction also inhibited rat lens aldose reductase activities. These data suggest that ginseng components inhibit rat lens aldose reductase activity in vitro.

• YAKHAK HOEJI
• /
• v.13 no.2_3
• /
• pp.71-75
• /
• 1969

Chemical changes in components of ginseng roots by heat treatment were observed. We have let the roots of fresh ginseng, of steamed ginseng and the water soluble parts obtained from preparing steamed one be subject to our research. Acids, bases, neutral substances and genins from each one of the above came up to 12 fractions. Having the fractions through column chromatography and TLC test thereafter, we determined the Rf values of each spots presented. Among so many similar values of them, 15 spots of heterogenous component in the fresh ginseng and 6 spots in the steamed one, and 10 spots in that of water soluble parts wre detected. Considering this data obtained, we can assume that partialor all of some components of fresh ginseng might be passed into water parts while preparing steamed ginseng from fresh ones and also some components of the later (fresh ginseng) might have been converted into other substances while being heated.

• Journal of the Microelectronics and Packaging Society
• /
• v.7 no.1
• /
• pp.13-18
• /
• 2000

Low temperature co-fired ceramics on metal (LTCC-M) is efficient for embedding passive components with good tolerance in a module due to the dimensional stability in x and y directions by the constraint of metal core during the firing. In addition, the radiation noise can be reduced by metal core. In this paper, embedded passive components were introduced and a power amplifier module (PAM) fabricated by using the passive components was explained. The embedded passive components in test patters showed the tolerance of 10~20% and the good repeatability in tolerance of embedded passives was maintained in module fabrication. The shortened traces in multi chip modules (MCMs) make the signal delay time decreased and the embedded passives simplify the packaging processes owing to the less solder points, which enhance the electrical performance and increase the reliability of the modules. The LTCC-M technology is one of the promising candidates for RF application and is expected to expand its applications to power and high performance devices.

• 전자공학회논문지 IE
• /
• v.44 no.2
• /
• pp.1-7
• /
• 2007

The increasing high frequency capabilities of CMOS have resulted in increased RF and analog design in CMOS. Design of RF and analog circuits depends critically on device S-parameter characteristics, magnitude of real and imaginary components and their behavior as a function of frequency. Utilization of scaled high performance CMOS technologies poses challenges as concerns for reliability degradation mechanisms increase. It is important to understand and quantify the effects of the reliability degradation mechanisms on the S-parameters and in turn on small signal model parameters. Various physical effects influencing small-signal parameters, especially the transconductance and capacitances and their degradation dependence, are discussed in detail. The measured S-parameters of H-gate and T-gate devices in a frequency range from 0.5GHz to 40GHz. All intrinsic and extrinsic parameters are extracted from S-parameters measurements at a single bias point in saturation. In this paper we discuss the analysis of the small signal equivalent circuits of RF SOI MOSFET's verificated for the purpose of exacting the change of parameter of small signal equivalent model followed by device flame.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.20 no.11
• /
• pp.1130-1137
• /
• 2009

This paper proposes a new clock routing design for suppressing clock harmonic effects in a Printed Circuit Board (PCB) for a terrestrial Digital Multimedia Broadcasting(DMB) system. Typical crystal reference frequencies that are widely used in DMB tuners are 16.384 MHz, 19.2 MHz, 24.576 MHz. When the high-order harmonic components of these reference frequencies fall near the RF channel frequencies, receiver sensitivity of the tuners is seriously degraded. In this work, we propose a new clock routing design in order to address the clock harmonic coupling issue. The proposed design incorporates two inductors for isolating the clock ground from the main ground, and adopts a new strip line-style routing instead of the conventional microstrip line style routing to minimize the overlap area with the main ground. As a result, the RF sensitivity of the T-DMB tuner is improved by 2 dB.

• Journal of Advanced Marine Engineering and Technology
• /
• v.38 no.3
• /
• pp.302-311
• /
• 2014

In this work, a FTTL (fishbone-type transmission line) structure was fabricated on PES (polyether sulfone) for a realization of transparent flexible wireless communication device, and its RF characteristics were investigated. According to the results, the FTTL on PES showed a short wavelength characteristic compared with conventional coplanar waveguide. Concretely, the wavelength of the FTTL was 2.23 mm at 50 GHz, which was 56.6 % of the conventional coplanar waveguide. According to the bandwidth extraction result, the passband of the FTTL on PES was 608 GHz. Unlike conventional periodic structures, the characteristic impedance of the FTTL on PES showed a very low frequency dependency, which means that the FTTL on PES can be used for application to transmission line and distributed passive components with a broadband operation frequency.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.51 no.4
• /
• pp.282-286
• /
• 2006

The effect of biofertilizer (compound of microbial inoculants or groups of micro-organisms) on growth and yield of rice was investigated. The experiment was carried out in a randomized complete block design with 3 replications and 7 treatments namely: $RF=N-P_2O_{5-}K_2O$ (11-5.5-4.8 kg $10a^{-1}$); half of the recommended fertilizer rate, $HRF=N-P_2O_5-K_2O$ (5.5-2.75-2.4 kg $10a^{-1}$); HRF+Bio 250=HRF combined with 250 kg biofertilizer $10a^{-1}$; HRF+Bio 500=HRF combined with 500 kg biofertilizer $10a^{-1}$; Bio 250=250 kg biofertilizer $10a^{-1}$; Bio 500=500 kg biofertilizer $10a^{-1}$; and NF = No Fertilizer. Results showed that the recorded values of plant height, tiller number and chlorophyll content at 40 to 60 days after transplanting (DAT) in HRF+Bio 500 were significantly higher than those recorded in the RF treatment. Similar observations between these two treatments were only recorded from 60 DAT onwards. Yield components were also superior in HRF+Bio 500 treatment and comparable to that of RF. The highest grain yield obtained in HRF+Bio 500 treatment (785.8 kg $10a^{-1}$) was statistically similar to that of RF (739.8 kg $10a^{-1}$) but significantly higher than that of NF (506.7 kg $10a^{-1}$). Finally, head grain recovery (90.9) was low while chalkiness (0.03) was high at HRF+Bio 500 treatment as compared with RF, which were (96.1) and (0.3), respectively. Results showed that combined treatment of HRF and 500 kg biofertilizer $10a^{-1}$ has similar effects on the growth and yield of rice with that of RF.