• Journal of Practical Agriculture & Fisheries Research
• /
• v.8 no.1
• /
• pp.30-42
• /
• 2006

This experiment was conducted to investigate current situation and plant grouping by light and watering of mingled several cacti and succulents in a pot. The main 11 cacti are consist of Myrtillocactus geometrizans (Mart.) Cons., Gymnocalycium mihanovichii var. friedrichii Werd., Marginatocereus marginatus(DC.) Backbg., Eriocactus leninghausii (Hge. Jr.) Backbg, Notocactus scopa (Spreng.) Berg., Lobivia nealeana Backbg., Mammillaria elongata var. intertexta (DC.) SD., Pseudoespostoa (Vp1.) Backbg., Mammillaria albilanata Backbg., Mammillaria klissingiana Bod. and Espostoa lanata (HBK.) Br. & R. The main 10 succulents are Kalanchoe thyrsifolia Harv., Portulacaria afra var. foliis-variegatis Jacobs., Crassula perforata Thunbg., Echeveria pulvinata Rose, Aeonium arboreum cv. atropurpureum., Echeveria lauii Moran & J. Meyran, Pachypodium lamerei Drake, Sedum rubrotinctum cv. Aurora Boom., Aloe mitriformis Mill., and Euphorbia coerulescens Haw. The cacti were native to Mexico, Brazil, Peru, Paraguay, Ecuador, etc. The sucullents were native to Mexico, Africa, Gran Canaria, Madagascar, etc. Most of all the cacti and sucullents in the experiment are growing well under full sun or light shade, however Portulacaria afra var. foliis-variegatis Jacobs, and Sedum rubrotinctum cv. Aurora Boom. did not influenced by light. And all the plants require a little or moderate watering. Thus, planting by similar required water and light, when growing in a pot of several cacti and succulents, might be decreased the rate of death causing by their different plant physiology.

• Journal of Practical Agriculture & Fisheries Research
• /
• v.7 no.1
• /
• pp.90-96
• /
• 2005

Tubers(4-5cm diameter) of Zantedeschia 'Black Magic' were used to study the induction of flowering in GA₃ soaking times and concentration. The GA₃ soaking were 10 seconds and 30 minutes at the GA₃ concentrations of 50, 100, 250, and 500 mg·L¹. The time to emergence in GA₃ treatment were 1.1~4.0 days shorter than control Growth characteristics were good in GA₃ treatment but that was no significance in GA₃ soaking time and concentration. When GA₃ soaking time and concentration were increased, days to flowering was shorter, but flower stalk length, flower stalk width, flower length, flower width were no difference. The number of flower per tuber was most as 4.0~4.3 in 250~500 mg·L¹ GA₃ concentration and that was about 2 times compared to control. The normal flower ratio and bulb enlargement were similar compared with GA₃ soaking time and concentration. GA₃ 250~500 mg·L¹ treatment is necessary for improvement of number of flowers per bulb.

• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• 2023.05a
• /
• pp.108-109
• /
• 2023

The purpose of this study is to set a policy that can be specifically promoted according to the recently announced domestic equipment industry fostering strategy, and to suggest a plan that can be implemented. As a plan to foster the equipment industry, a new technology certification system and a new technology test and verification area operation and vitalization plan were set as alternatives. And a survey was conducted on companies conducting R&D to derive specific demand and introduction plans. As a result of the survey, it was found that there was a high demand for the use of new technology certification systems and testing and verification area. Also demonstration in connection with port equipment, testing and evaluation in connection with accredited verification agency, and preparation of dedicated agencies were derived to foster the equipment industry. Based on this, this study suggests a new technology certification system specialized for port equipment was established and a plan to institutionalize. In addition, in connection with the survey results and certification system, the basic functions and roles of the new technology testing and verification area was established. For future activation, incentives with effective certificates such as exemption of certification costs and issuance of performance confirmation certificates are needed, and efficient operation and management through dedicated organization and certification center were suggested.

• The Journal of Korean Obstetrics and Gynecology
• /
• v.36 no.4
• /
• pp.96-120
• /
• 2023

Objectives: This study reports the findings that support the efficacy of herbal medicine (HM) for premenstrual syndrome (PMS). Methods: We conducted meta-analysis of findings from randomized controlled trials (RCTs) for PMS treated with HM. The articles were published before July 2022, located using 9 databases (Pubmed, EMBASE, Cochrane Library, CINAHL, CNKI, CiNii, SCIENCE ON, KoreaMed, OASIS). Results: We observed 2,034 studies, of which 23 RCTs met our inclusion criteria. The risk of bias in the included studies was relatively unclear or high. Meta-analysis of 3 RCTs showed that HM group had a significantly higher total effective rate than the western medicine group (RR 1.20 [95% CI 1.06, 1.36, p=0.004]). Meta-analysis of 1 RCT showed that HM group had a significantly lower symptom score (MD -3.04 [95% CI -5.36, -0.72, p=0.01]), while there was no significant difference in daily record of severity of problems scale (MD -20.52 [95% CI -49.33, 8.29, p=0.16]). Conclusions: HM significantly improved PMS symptoms than general treatment and no serious adverse events were reported. However, the evidence on the effectiveness and safety of HM for PMS was not enough to provide reliable results due to the small number and low quality of included studies. We believe that rigorous RCTs will lead to more reliable evidence of the intervention.

• Applied Chemistry for Engineering
• /
• v.34 no.6
• /
• pp.590-595
• /
• 2023

Novel aromatic imine derivatives with yellow were designed and synthesized for their potential application in color filters for image sensors. The synthesized compounds possessed chemical structures using aromatic imine groups. This innovative material was evaluated thoroughly, considering its optical and thermal properties under conditions similar to commercial device manufacturing processes. Following a rigorous performance evaluation, it was found that (E)-3-methyl-4-((3-methyl-5-oxo-1-phenyl-1H-pyrazol-4(5H)-ylidene)methyl)-1-phenyl-1H-pyrazol-5(4H)-one, abbreviated as MOPMPO, exhibited an impressive solubility of 0.5 wt% in propylene glycol monomethyl ether acetate, predominantly utilized as the solvent in the industry. Furthermore, MOPMPO showed exceptional performance as a color filter material for image sensors, having a high decomposition temperature of 290 ℃. These data unequivocally establish MOPMPO as a viable yellow dye additive for coloring materials in image sensor applications.

• Journal of the Society of Naval Architects of Korea
• /
• v.60 no.5
• /
• pp.375-387
• /
• 2023

The subsea power cables are increasingly important for harvesting renewable energies as we develop offshore wind farms located at a long distance from shore. Particularly, the continuous flexural motion of inter-array dynamic power cable of floating offshore wind turbine causes tremendous fatigue damages on the cable. As the subsea power cable consists of the helical structures with various components unlike a mooring line and a steel pipe riser, the fatigue analysis of the cables should be performed using special procedures that consider stick/slip phenomenon. This phenomenon occurs between inner helically wound components when they are tensioned or compressed by environmental loads and the floater motions. In particular, Vortex-induced vibration (VIV) can be generated by currents and have significant impacts on the fatigue life of the cable. In this study, the procedure for VIV fatigue analysis of the dynamic power cable has been established. Additionally, the respective roles of programs employed and required inputs and outputs are explained in detail. Demonstrations of case studies are provided under severely sheared currents to investigate the influences on amplitude variations of dynamic power cables caused by the excitation of high mode numbers. Finally, sensitivity studies have been performed to compare dynamic cable design parameters, specifically, structural damping ratio, higher order harmonics, and lift coefficients tables. In the future, one of the fundamental assumptions to assess the VIV response will be examined in detail, namely a narrow-banded Gaussian process derived from the VIV amplitudes. Although this approach is consistent with current industry standards, the level of consistency and the potential errors between the Gaussian process and the fatigue damage generated from deterministic time-domain results are to be confirmed to verify VIV fatigue analysis procedure for slender marine structures.

• Journal of the Korea Society for Simulation
• /
• v.32 no.4
• /
• pp.41-58
• /
• 2023

As naval warfare changes to composite warfare that includes simultaneous engagements against surface, underwater, and air enemies, performance and tactical analysis are required to respond to naval warfare. In particular, for practical analysis of composite warfare, it is necessary to study engagement simulations that can appropriately utilize the limited performance resources of the detection system. This paper proposes a DEVS (Discrete Event Systems Specifications)-based simulation model for composite warfare analysis. The proposed model contains generalized models of combat platforms and armed objects to simulate various complex warfare situations. In addition, we propose a detection performance allocation algorithm that can be applied to a detection system model, considering the characteristics of composite warfare in which missions must be performed using limited detection resources. We experimented with the effectiveness of composite warfare according to the strength of the detection system's resource allocation, the enemy force's size, and the friendly force's departure location. The simulation results showed the effect of the resource allocation function on engagement time and success. Our model will be used as an engineering basis for analyzing the tactics of warships in various complex warfare situations in the future.

• Asia-Pacific Journal of Business Venturing and Entrepreneurship
• /
• v.18 no.2
• /
• pp.95-111
• /
• 2023

Korea has achieved a high startup rate by promoting government-led startup policies for national economic and industrial development. However, as high as the startup rate is, the closure rate of startup companies can be judged to be insufficient for the qualitative growth of the domestic startup ecosystem. This study aims to investigate how to improve the survival rate of startups by overcoming the valley of death from a location environment perspective. It analyzes the effects of technology orientation and market orientation of start-ups on management performance and the moderating effects of economic, accessibility, and network factors that constitute the location environment. To achieve the research objectives, the empirical analysis was conducted on start-up companies that received corporate support projects from innovation intermediary organizations. The results show that R&D capability of technology orientation has a significant effect on management performance, and market information generation and market information response of market orientation have a significant effect on management performance. As for the moderating effect, accessibility, a sub-factor of the location environment, has a positive moderating effect on the relationship between technological innovation and managerial performance, and the location environment (economy, accessibility, and network) has a positive moderating effect on the relationship between market information generation and managerial performance. This study compared and analyzed previous studies on the success and failure of start-ups and identified common factors. In addition, this study provides policy implications for the sustainable growth of startups through empirical analysis and interview with stakeholders. For future research, it is necessary to compare and analyze start-ups in metropolitan areas and non-metropolitan areas. In addition, it is necessary to study startups that have moved out of the region and into the metropolitan area to find ways to develop the regional startup ecosystem.

• Journal of Practical Agriculture & Fisheries Research
• /
• v.26 no.1
• /
• pp.22-29
• /
• 2024

In this study, we summarized the definition of smart vegetable seedling production technology, analysis of smart seedling production system, a hardware and software configuration model for smart seedling production system, research and development trends in smart seedling production system, and proposed future research and development plans for smart seedling production technology. Smart vegetable seedling production is a data-based seedling production, management, and distribution system that utilizes 4th Industrial Revolution technology to improve seedling productivity and quality. The production of vegetable seedlings using smart seedling production technology can be efficiently managed by collecting, analyzing, and managing information on seedlings, environment, and tasks at each stage of production by linking with the smart seedling integrated management system. However, there is still a lack of standardization of seedling standards and quality for each vegetable crop to establish smart seeding production technology, as well as development of smart seedling production element technology, which requires national wide R&D support.

• Management & Information Systems Review
• /
• v.31 no.3
• /
• pp.223-248
• /
• 2012

This study analyses support policy and structural change of textile industry in Daegu Kyungbuk region, and suggests major issues for textile industry's innovation. In Daegu Kyungbuk, it was 1999 that a policy, so called Milano Project, in order to promote a textile industry was devised. In 2004, the Regional Industrial Promotion Plan was devised. The plan was born from a view point of establishing a regional innovation system and of promoting the innovative clusters under a knowledge based economy. After then, the Regional Industry Promotion Project or Regional Strategic Industry Promotion Project became a core of regional textile industrial policy. Research results indicated that the first stage Milano project (1999-2003) showed both positive and negative effects. There were no long-term development plan, clear vision and strategy. But, core industrial infrastructure for differentiated product development, such as New product Development Support Center and Dyeing Design Practical Application Center, was constructed. The second stage Daegu Textile Industry Promotion Plan (2004-2008) displayed a significant technological performance and new product sales with the assistance of Kyungbuk province. Also, textile industry revealed positive fruits such as financial structure, productivity, and profitability as a result of strong restructuring. In industrial structure, there was a important change from clothe textile material to industry textile material. Most of textile companies did not showed high capability in CEO's technology innovation intention, entrepreneurship, R&D and human resource competency in compare with other industry. We suggested that Daegu Kyungbuk has to select and concentrate on the high-tech textile material and living textile for sustainable development and competitiveness. We also proposed a confidence and cooperation based innovation network and company oriented innovation cluster.