• ETRI Journal
• /
• v.26 no.4
• /
• pp.307-314
• /
• 2004

The application of a discrete pseudomorphic high electron mobility transistor (p-HEMT) as a grounded switch allows for the development of low cost phase shifters and phase modulators operating in a Ku band. This fills the gap in the development of phase control devices comprising p-i-n diodes and microwave monolithic integrated circuits (MMICs). This paper describes a discrete p-HEMT characterization and modeling in switching mode as well as the development of a low-cost four-bit phase shifter and direct quadrature phase shift keying (QPSK) modulator. The developed devices operate in a Ku band with parameters comparable to commercially available MMIC counterparts. Both of them are CMOS compatible and have no power consumption. The parameters of the QPSK modulator are very close to the requirements of available standards for satellite earth stations.

• Proceedings of the IEEK Conference
• /
• 2004.06b
• /
• pp.411-414
• /
• 2004

This paper introduces a modulation method for digital wireless communication based on general DS-QPSK. The design and fabrication is for home networking application to a typical RF transmitter with DS-QPSK modulator. This modulator implemented using VHDL hardware programming language, the fabrication of IC chip $5{\times}5 mm^2$ was carried by 27th IDEC MPW(Multi Project Wafer) process in 0.35${\mu}m$ rule at Samsung Inc. This paper presented the important of this technology for the future application in wireless sensor. This module can be efficient usage for home network to transmit the RF wireless sensor system.

• Proceedings of the IEEK Conference
• /
• 2000.07b
• /
• pp.914-918
• /
• 2000

In this paper, a next generation high speed QPSK transmitter is designed based on 1.8${\mu}$m design rule. The designed transmitter supports the MPEG2-TS coded packed data for the DAVIC standard. Transmitter is composed of the convolutional coder, the shortened Reed-Solomon coder, and QPSK modulator. The coded packets are modulated in APSK with an RC filter. Especially, Galois Field multiplier with a standard basis is designed with the pipelined parallel architecture. Also, in the QPSK modulator, the RC filter and mixer are simplified into the ROM table, which can improve the performance of the transmitter. The total number of gates for the implemented baseband transmitter is 26,875.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.53 no.7
• /
• pp.144-149
• /
• 2016

In this paper, we analyze a QPSK MODEM over underwater acoustic channel model. Ambient noises and parameters of underwater environments debase the BER performance of an underwater modem. In the paper, the BER performance of uncoded QPSK and rate-2/3 convolutional coded QPSK is analyzed. And To improve BER Performance, we apply a channel equalization technique to the underwater modem.

• Current Optics and Photonics
• /
• v.2 no.2
• /
• pp.134-139
• /
• 2018

A novel approach for frequency-tripling vector signal generation via balanced detection without precoding and optical filter is proposed. The scheme is mainly utilizing an integrated dual-polarization quadrature phase shift keying (DPQPSK) modulator. In the DPQPSK modulator, one QPSK modulator is driven by an RF signal to generate high-order optical sidebands, while the other QPSK modulator is modulated by I/Q data streams to produce baseband vector signal as an optical carrier. After that, a frequency-tripling 16-quadrature-amplitude-modulation (16QAM) vector millimeter-wave (mm-wave) signal can be obtained by balanced detection. The proposed scheme can reduce the complexity of transmitter digital signal processing. The results show that, a 4 Gbaud baseband 16QAM vector signal can be generated at 30 GHz by frequency-tripling. After 10 km single-mode fiber (SMF) transmission, the constellation and eye diagrams of the generated vector signal perform well and a bit-error-rate (BER) below than 1e-3 can be achieved.

• Proceedings of the Korean Institute of Communication Sciences Conference
• /
• 1986.10a
• /
• pp.16-19
• /
• 1986

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.45 no.3
• /
• pp.1-6
• /
• 2008

A dual band I/Q modulator which converts baseband input signals to 2.4GHz or 5GHz RF output has been proposed. The dual band I/Q modulator for 2.4GHz and 5GHz wireless LAN applications consists of $90^{\circ}$ phase shifter and wideband mixer. The I/Q modulator showed 15dB conversion loss at 2.4GHz and 16dB conversion loss at 5GHz. The sideband suppression is about 15dBc at 2.4GHz and 16dBc at 5GHz. Measured data shows 8.5% EVM at 2.4GHz, and 10% EVM at 5GHz for QPSK with symbol rate of 11Mbps. A carrier rejection is about 40dBc at 2.4GHz/5GHz band, and the I/Q modulator satisfied the output wireless LAN spectrum mask with baseband input signal.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.37 no.4
• /
• pp.413-418
• /
• 2009

The S-band Transponder for telemetry and command of small satellite is designed and fabricated as prototype model using COTS(Commercial Off-The-Shelf) components. QPSK modulator and demodulator of transponder is implemented by using FPGA for system extension. The transponder consists of RF Front End, RF Modulator, RF Demodulator, and MODEM. The measured results of fabricated transponder show BER of less than $1.1{\times}10^{-6}$ at -105 dBm input power.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.35 no.11
• /
• pp.1052-1057
• /
• 2007

A highly reliable Video Transmission System (VTS) was developed in order to obtain both video and digital data simultaneously in the real time flight test situation of a flying vehicle. The VTS integrates GPS data, digital telemetry data and video signals into a compact digital data package which is compressed and processed by an MPEG-2 Encoder and a DVB-S modulator respectively. The DVB-S modulator is composed of a specially devised Forward Error Correction processor and base band QPSK modulator. The designed VTS was verified and proved for its required functioning and performance through separate flight tests using an airplane and missiles.

• Journal of the Korean Institute of Telematics and Electronics C
• /
• v.34C no.2
• /
• pp.1-11
• /
• 1997

We developed a base station modulator ASIC for CDMA digital cellular system. In CDMA digital cellular system, the modulation is performed by convolutional encoding and QPSK with spread spectrum. The function blocks of base station modulator are CRC, convolutional encoder, interleaver pseudo-moise scrambler, power control bit puncturing, walsh cover, QPSK, gain controller, combiner and multiplexer. Each function block was designed by the logic synthesis of VHDL codes. The VHDL code was described at register transfer level and the size of code is about 8,000 lines. The circuit simulation and logic simulation were performed by COMPASS tools. The chip (ES-C2212B CMB) contains 25,205 gates and 3 Kbit SRAM, and its chip size is 5.25 mm * 5,45 mm in 0.8 mm CMOS cell-based design technology. It is packaged in 68 pin PLCC and the power dissipation at 10MHz is 300 mW at 5V. The ASIC has been fully tested and successfully working on the CDMA base station system.