• Journal of Radiation Protection and Research
• /
• v.41 no.3
• /
• pp.286-290
• /
• 2016

Background: Activation of air and water in the electron linear accelerator for medical use has not been considered severely. By the new Japanese regulation for protection of radiation hazard, it became indispensable to evaluate of activation of air and water in the accelerator room. The measurement of induced activity in air and water components in the electron energy region of 10 to 20 MeV is very difficult, because this energy region is close to the threshold energy region of photonuclear reactions. Then, we measured the photonuclear reaction yields of $^{13}N$, $^{15}O$, and $^{11}C$ by using the electron linear accelerator. Obtained data were compared with the data calculated by the Monte Carlo method. Materials and Methods: An activation experiment was performed at the Research Center for Electron Photon Science, Tohoku University. Highly purified $SiO_2$, $Si_3N_4$, and carbon disks were irradiated for 10 minutes by bremsstrahlung converted by a tungsten plate. Induced activity from C, N, and O was obtained. Monte Carlo calculation was performed using MCNP5 and AERY (DCHAIN-SP) to simulate the experimental condition. Cross section data were adopted the KAERI dataset. Results and Discussion: In our experiment in hospital, calculated values were not agreed with experimental values. It might be three possible reasons as the cause of this deference, such as irradiation energy, calculation procedure and cross section data. Obtained data of this work, calculated and experimental values were good agreement with each other within one order. In this work, we used KAERI dataset of photonuclear reaction instead of JENDL. Therefore, it was found that the photonuclear cross section data of light elements are most important for yield calculation in these reactions. Conclusion: Further improvement for calculation using a new dataset JENDL/PD-2015 and considering electron energy spreading will be needed.

• Journal of Advanced Marine Engineering and Technology
• /
• v.36 no.2
• /
• pp.244-249
• /
• 2012

Recently energy crisis and environmental pollution using fossil fuel became social issue. The Fuel Cell, one of the new and renewable energy has great advantage for the former mentioned problems. The PEM Fuel Cell needs highly purified hydrogen for fuel, in many cases CH4 was reformed to H2 basically using steam reforming. The purpose of this paper is to understand the probability of ceramic honeycomb to apply the combustor of STR. We tested the heat accumulation performance of ceramic honeycomb by change of excess air ratio. The results were suitable for our purpose and also these results can be used to make high temperature air at mild combustion field.

• 한국지구물리탐사학회:학술대회논문집
• /
• 2003.11a
• /
• pp.624-628
• /
• 2003

Lanthanum oxyfluoride can be synthesized by mechanochemical (MC) reaction between lanthanum oxide ($La_2O_3$) and polytetrafluoroethylene (PTFE, ($({CF_2CF_2}_n)$) in air using a planetary mill. MC reaction between the two materials induced from intensive grinding operation. The MC reaction is almost finished by 240min, and the products ground for 240min or more are composed of LaOF, amorphous $La(CO_3)F$ and amorphous carbon (C). Heating this MC reaction products at $600^{\circ}C$ enables us to eliminate amorphous C and decompose $La(CO_3)F$ into LaOF, so that pure LaOF material can be obtained as the final product. The average particle size of the final product (purified LaOF) is around few ten nanometers.

• International Journal of Fuzzy Logic and Intelligent Systems
• /
• v.4 no.2
• /
• pp.172-175
• /
• 2004

Generally, the yield rate of semiconductors is the major factor that affects directly the price of semiconductors. For a high yield rate of semiconductors, the air inside clean room is needed to be purified and high efficient filters are used for this. The filter are made of super-fine fiber and certain pinholes can be easily produced on the filter's surface by inadvertent manufacturing. As these pinholes are not easily detected with the bare sight, these pinholes exert a negative impact to filtration performance of the filter. In this research, not only the automatic test equipment for detecting pinholes is proposed, but also inverse modeling scheme based on artificial neural network is applied for tuning of its important parameters.

• Journal of Ginseng Research
• /
• v.40 no.4
• /
• pp.309-314
• /
• 2016

Korean Red Ginseng (KRG) is a heat-processed ginseng developed by the repeated steaming and air-drying of fresh ginseng. Compared with fresh ginseng, KRG has been shown to possess greater pharmacological activities and stability because of changes that occur in its chemical constituents during the steaming process. In addition to anticancer, anti-inflammatory, and immune-modulatory activities, KRG and its purified components have also been shown to possess protective effects against microbial infections. Here, we summarize the current knowledge on the properties of KRG and its components on infections with human pathogenic viruses such as respiratory syncytial virus, rhinovirus, influenza virus, human immunodeficiency virus, human herpes virus, hepatitis virus, norovirus, rotavirus, enterovirus, and coxsackievirus. Additionally, the therapeutic potential of KRG as an antiviral and vaccine adjuvant is discussed.

• Journal of the Korean Chemical Society
• /
• v.10 no.1
• /
• pp.1-3
• /
• 1966

The organic yields (i.e. fraction of nuclear events resulting in organic compound formation) of the radioative neutron capture reactions of halogens in purified bromobenzene have been determined varying extraction time, at $100^{\circ}C$ for thermal effect, varying irradiation time, varying neutron flux and with additional U. V. irradiation. Among the important results are; (1) The organic yields show no remarkable fluctuations with time following neutron irradiation; (2) The organic yields show no change with thermal energy; (3) The organic yields of degassed samples are same in different length of irradiation time whereas the yields of the samples in open air appear to increase with increasing time of irradiation (4) The organic yields increase remarkably with increased neutron flux; (5) The organic yields show a sharp increase by additional U. V. irradiation after neutron irradiation.

• Archives of Pharmacal Research
• /
• v.19 no.3
• /
• pp.223-227
• /
• 1996

The antioxidant activity of Ecklonia stolonifera was determined by measuring lipid peroxide produced when a mouse liver homogenate was exposed to the air at $37^{\circ}C$ using 2-thiobarbituric acid (TBA) and the radical scavenging effect on 1,1-diphenyl-2-picrylhydrazyl (DPPH) radical. The methanol extract of Ecklonia stolonifera showed strong antioxidant activity. And the methanol extract was fractionated with several solvents. With regard their fractions, the antioxidative activity were in the order of ethyl acetate>dichloromethane insoluble intermediated phase>dichloromethane>n-butanol>water fraction. The ethyl acetate soluble fraction exhibiting the strongest antioxidant activity was further purified by repeated silica gel and Sephadex LH-20 column chromatography. Antioxidant phloroglucinol was isolated and identified by$ ^1H-NMR\; and\; ^{13}C-NMR$. Its antioxidant activity was simlilar to that of L-ascorbic acid.

• Journal of the Korean Wood Science and Technology
• /
• v.36 no.6
• /
• pp.130-137
• /
• 2008

In this study cadalene, which is classified into sesquiterpenes constructed with 15 carbons of naphthalene skeleton, was isolated from ethanol extracts of Zelkova wood (Zelkova serrata) using successive silica gel column chromatography. The purified cadalene compound was subjected to structural analysis using HPLC, EI-MS and $^1H$, $^{13}C-NMR$. Its molecular weight was measured to 244 (m/z) and methyl and isopropyl group were attached at C1 and C4 position, as well as hydroxyl group at C7 and methoxyl group at C3 in the naphthalene skeleton, respectively. Yield of 7-hydroxy-3-methoxycadalene amounts to 0.03% based on air dried Zelkova wood powder. It was distributed only in xylem tissues(only in heartwood) of Zelkova wood, not in leaves and bark.

• Proceedings of the IEEK Conference
• /
• 2001.10a
• /
• pp.357-361
• /
• 2001

The possibility of producing Cr$_2$O$_3$powder from waste magnesia-chromium refractory was investigated by sulfuric acid reaction, alkali fusion, water leaching & purification and heat treatment. The effects of temperature, the amount of NaOH added and the flow rate of air on chromium extraction efficiency in an alkali fusion step were investigated. The fusion product was leached with methanol to solve free-NaOH, and then leached with water to produce a Na$_2$CrO$_4$solution. The purity of chrome(Ⅵ) oxides, prepared both from monochromate with an impurity content and monochromate purified with $CO_2$were also examined. The purified monochromate solution was reduced from Cr(Ⅵ) to Cr(III) with NaHSO$_3$solution. The reduced solution was neutralized with NaOH to produce Cr(OH)$_3$. Water washing was treated to eliminate Na$_2$SO$_4$from neutralized Cr(OH)$_3$slurry. The washed Cr(OH)$_3$was dried and thermally treated to produce Cr$_2$O$_3$powder. The properties like lightness and hue of Cr$_2$O$_3$fabricated in this study were L=47.47, a=-14.40 and b=17.21.

• Journal of the Korean Ceramic Society
• /
• v.13 no.1
• /
• pp.25-29
• /
• 1976

The properties vary with quality of ferric-oxide that is major material of ferrites. In this point of view, a manufacturing method of pure and homogeneous fine ferric oxide is very important. The characters of this study are as follows: 1) Ferric oxide was made from waste pickling liquor of steel. 2) The crude ferric-oxide that is made by roasting the pickling liquor was dissolved in 20% HCI solution and then produced ferric chloride is purified by ethyl ether extraction. 3) The methanol solution of purified ferric chloride was sprayed into the refractory tube with compressed air and propane gas and then ignited leading to the ferric-oxide powder. 4) The produced oxide powder was introduced to the scrubber type vessel throught cooling system in order to collect the powder. 5) Crystalline phase of the powder was identified by X-ray diffraction and particle size, crystalline shape of the powder were investigated by settling method and electron microscope and the effects of concentration of ferric chloride in methanol on grain size were discussed. Results were obtained as fellows: 1) Total impurity in the ferric oxide produced from waste pickling liquor was 3.7%. 2) The solubilityof crude ferric oxide that was made from waste pickling liquor in HCI solution increased with the HCI concentration and reached to saturation range at 15% HCI concentration. 3) Extraction of FeCl3 increased with HCI concentration which is solvent. 4) Alpha ferric oxide obtained was very fine crystalline particles, the mean crystalline grain increased with the concentration of ferric chloride, and mean grain size distributed from 3.5$\mu$(at 0.5mole/l) to 0.5$\mu$(at 0.05mole/l).