• 한국대기환경학회지
• /
• 제12권2호
• /
• pp.121-130
• /
• 1996

The catalysts composed of Pt, Pd and W as active-components, $Al_{2}O_{3}$ and $SiO_{2}$ as supports, were perpared on the honeycomb type substrate and characterized by BET, SEM, TGA, FT-IR and XRD for diesel emission control. CO, $C_{3}H_{6}$, and $SO_{2}$ oxidation was carried out over these catalysts in a fixed bed continuous flow reactor at the temperatures between 100-500.deg.C and reactant gas was composed of 10 vol.% $O_{2}$, 1 vol.% CO, 0.8 vol.% $C_{3}H_{6}$ and 88.2 vol.% $N_{2}$. It was found that under these experimental conditions, the CO, $C_{3}H_{6}$ oxidation activity of Pt-W catalyst was higher than that of any other prepared catalyst, and this catalyst had also a good inhibition effect on $SO_{2}$ oxidation. Also it was show that the influence of $SO_{2}$ on $Al_{2}O_{3}$ was more sever than that of $SO_{2}$ on $SiO_{2}$.

• 한국대기환경학회지
• /
• 제14권5호
• /
• pp.443-454
• /
• 1998

Pt-V catalytic converter was installed on a heavy duty diesel engine and the characteristics of the emission reduction were tested using a engine dynamometer at various operating conditions. The emission reduction performance of Pt-V catalyst was also compared with that of a commercialized Pt catalyst currently being used in some of the heavy duty diesel engines in advanced countries. The effects of Pt-V and Pt catalysts on regulated and unregulated emissions were investigated using a 0.05 weight percent sulfur content fuel with an engine dynamometer Experiments for gaseous emissions (CO, HC and aldehyde) as well as particulate emissions (TPM, SOF and sulfate) have been conducted at several operating conditions such as T-7 mode, D-13 mode and S-13 mode before and after installing the Pt-V and Pt catalysts in the exhaust system. The emission reduction performance of Pt catalyst with respect to CO, HC, SOF, PAHs and aldehyde was found to be a little higher than that of Pt-V catalyst, but the Pt catalyst showed innate disadvantage of causing an increase of PM due to the sulfate formation via high SO2 conversion at high exhaust temperature, especially above 45$0^{\circ}C$.

• 한국수소및신에너지학회논문집
• /
• 제23권6호
• /
• pp.640-646
• /
• 2012

The effect of Ce promotion over 1wt% $Pt/{\gamma}-Al_2O_3$ catalysts on the CO conversion and $CO_2$ selectivity was investigated in preferential CO oxidation (PrOx) to reduce the CO concentration less than 10 ppm in excess $H_2$ stream for polymer electrolyte membrane fuel cell (PEMFC). Ce-promoted 1wt% $Pt/{\gamma}-Al_2O_3$ catalysts were prepared by incipient wetness impregnation method and the loading amount of Pt was fixed at 1wt%. The content of Ce promoter which has excellent oxygen storage and transfer capability due to the redox property was adjusted from 0 to 1.5wt%. Ce-promoted 1wt% $Pt/{\gamma}-Al_2O_3$ catalysts exhibit high CO conversion and $CO_2$ selectivity at low temperatures below $150^{\circ}C$ due to the improvement of reducibility of surface PtOx species compared with the 1wt% $Pt/{\gamma}-Al_2O_3$ catalyst without Ce addition. When Ce content was more than 1wt%, the catalytic activity was decreased at over $160^{\circ}C$ in PrOx because of competitive $H_2$ oxidation. As a result, 0.5wt% Ce is optimal content not only to achieve high catalytic activity and good stability at low temperatures below $150^{\circ}C$ in the presence of $CO_2$ and $H_2O$ but also to minimize the $H_2$ oxidation at high temperatures.

• 한국응용과학기술학회지
• /
• 제34권4호
• /
• pp.883-891
• /
• 2017

고분자 전해질 연료전지의 연료에 포함된 일산화탄소의 선택적 산화를 위하여, 귀금속 촉매를 대체하기 위한 CuO-$CeO_2$ 복합 산화물 촉매를 졸-겔법과 공침법으로 제조하였다. 졸-겔법으로 촉매 제조 시 Cu/Ce의 비와 가수분해 비를 변화시켰다. 제조한 촉매의 활성은 귀금속 촉매($Pt/{\gamma}-Al_2O_3$)와 비교하였다. Cu/Ce의 비를 변화시키면서 제조한 촉매 중 Cu/Ce의 비가 4:16인 촉매가 가장 높은 CO 전환율(90%)과 선택도(60%)를 나타내었다. 촉매의 제조에서 가수분해 비가 증가할수록 촉매 표면적이 증가하였고, 아울러 촉매 활성 또한 증가하였다. 공침법으로 제조한 촉매와 1wt% $Pt/{\gamma}-Al_2O_3$ 촉매의 가장 높은 CO 전환율은 각각 82% 및 81%인 반면, 졸-겔법으로 제조한 촉매의 경우는 90%가 얻어졌다. 이는 졸-겔법으로 제조한 촉매가 공침법으로 제조한 촉매나 귀금속 촉매보다 더 높은 촉매활성을 보임을 의미한다. CO-TPD 실험을 통하여, 낮은 온도($140^{\circ}C$)에서 CO를 탈착하는 촉매가 본 반응에서 더 높은 촉매활성을 보임을 알 수 있었다.

• 한국재료학회지
• /
• 제19권12호
• /
• pp.667-673
• /
• 2009

The electrocatalytic characteristics of oxygen reduction reaction of the $PtxM_{(1-x)}$ (M = Co, Cu, Ni) supported on multi-walled carbon nanotubes (MWNTs) have been evaluated in a Polymer Electrolyte Membrane Fuel Cell (PEMFC). The $Pt_xM_{(1-x)}$/MWNTs catalysts with a Pt : M atomic ratio of about 3 : 1 were synthesized and applied to the cathode of PEMFC. The crystalline structure and morphology images of the $Pt_xM_{(1-x)}$ particles were characterized by X-ray diffraction and transmission electron microscopy, respectively. The results showed that the crystalline structure of the Pt alloy particles in Pt/MWNTs and $Pt_xM_{(1-x)}$/MWNTs catalysts are seen as FCC, and synthesized $Pt_xM_{(1-x)}$ crystals have lattice parameters smaller than the pure Pt crystal. According to the electrochemical surface area (ESA) calculated with cyclic voltammetry analysis, $Pt_{0.77}Co_{0.23}$/MWNTs catalyst has higher ESA than the other catalysts. The evaluation of a unit cell test using Pt/MWNTs or $Pt_xM_{(1-x)}$/MWNTs as the cathode catalysts demonstrated higher cell performance than did a commercial Pt/C catalyst. Among the MWNTs-supported Pt and $Pt_xM_{(1-x)}$ (M = Co, Cu, Ni) catalysts, the $Pt_{0.77}Co_{0.23}$/MWNTs shows the highest performance with the cathode catalyst of PEMFC because they had the largest ESA.

• 청정기술
• /
• 제18권4호
• /
• pp.432-439
• /
• 2012

백금(Pt)과 루테늄(Ru)의 조성비가 일산화탄소(CO) 산화반응에 미치는 영향을 조사하고자 탄소를 지지체(support)로 사용한 20 wt% 백금과 백금-루테늄 시리즈 촉매(Pt : Ru = 7 : 3, 5 : 5, 3 : 7)를 콜로이드 방법(colloidal method)으로 합성하였다. 다양한 물리 화학적 분석장비인 투과전자현미경(transmission electron microscopy, TEM)과 X-선 회절(X-ray diffraction, XRD), 에너지 분산형 X-선 분석기(energy dispersive X-ray spectroscopy, EDS)를 이용하여 구조 화학적 특성을 분석하고, X-선 광전자 분광법(X-ray photoelectron spectroscopy, XPS)을 통해 전자적 특성 변화를 확인하였다. 더불어 일산화탄소 벗김 전압전류실험(CO stripping voltammetry)을 이용하여 전기화학적 거동을 분석하였다. 합성된 촉매들 중 $Pt_5Ru_5/C$가 가장 낮은 개시 전위(vs. Ag/AgCl)와 가장 큰 일산화탄소의 전기화학적 활성화 표면적(CO EAS) 값을 나타냈으며 이를 통해 $Pt_5Ru_5/C$이 일산화탄소의 전기화학적 산화반응에 있어 가장 효과적인 촉매임을 확인하였다. $Pt_5Ru_5/C$의 격자상수 변화를 통한 구조적 특성변화 및 백금 d-밴드의 페르미 레벨 변화를 통한 전자적 특성변화 그리고 이작용기(bifunctional)의 효과가 일산화탄소의 전기화학적 산화반응에 대한 활성을 증진시켰다고 사료된다.

• 한국대기환경학회지
• /
• 제11권2호
• /
• pp.171-178
• /
• 1995

The hydrodesulfurization (HDS) of dibenzothiophene (DBT) were performed simultaneously over CoPtMo/LaY catalyst under high H$_{2}$ pressure. The structure and physical properties of this catalyst were characterized using XRD, IR and surface area analyzer. The origin of acid site was mainly Bronsted. The structures of impregnated molybdenum and platinum were deactivated by DBT to MoS$_{2}$ and PtS, respectively. The activities of the HDS and the hydrocracking increased with increasing temperature and pressure. They decreased with increasing the DBT mole ratio(DBT/n-heptane). They remained constant with increasing the H$_{2}$/H.C. mole ratio. With increasing pressure and DBT mole ratio, the products of secondary cracking increased. To perform simultaneous HDS and hydrocracking effectively, the optimum condition were 500.deg.C, 4MPa.

• 융복합기술연구소 논문집
• /
• 제10권1호
• /
• pp.19-24
• /
• 2020

The purpose of the study is to investigate the thermal durability characteristics of the Pt catalyst and additives used in a catalytic combustor. The catalyst used in the experiment was based on Pt (3 wt%), and a total of 12 types were prepared using a combination of additives (Ni, La, Ce, Fe, and Co). From the results, In the fresh state, the two types of combination catalysts with the highest C₃H₈ conversion were Pt_Ce (79.9%) at 500℃, and in the three types of combination catalysts, Pt_La_Ni (93.4%) at 500℃ had the best performance. Among aged catalysts at 850℃ and 8 hours, Pt-La-Ni and Pt-Ni-Ce catalysts showed the highest C₃H₈ conversion of about 71% at 500℃.

• 한국환경과학회지
• /
• 제17권12호
• /
• pp.1307-1314
• /
• 2008

Hydrogen gas is used as a fuel for the proton exchange membrane fuel cell (PEMFC). Trace amount of carbon monoxide present in the reformate $H_2$ gas can poison the anode of the PEMFC. Therefore, preferential oxidation (PROX) of CO is essential for reducing the concentration of CO from a hydrogen-rich reformate gas. In this study, conventional Pt/$Al_2O_3$ catalyst was prepared for the preferential oxidation of CO. The effects of catalyst preparation method, additive, and hydrogen on the performances of PROX reaction of CO were investigated. Water treatment and addition of Ce enhanced catalytic activity of the Pt/$Al_2O_3$ catalyst at low temperature below $100^{\circ}C$.

• 공업화학
• /
• 제23권6호
• /
• pp.572-576
• /
• 2012

온실가스인 $CO_2$를 저감하기 위해 Pt계 촉매상 $CO_2$ methanation 반응에 관한 연구를 수행하였다. $Al_2O_3$의 전구체인 AlO(OH)를 열처리하여 지지체로 사용하였으며, 활성금속으로서 Pt를 사용하였다. XRD 분석결과, 활성금속인 Pt가 고르게 잘 분산되었음이 관찰되었으며, 지지체는 gamma phase의 $Al_2O_3$로 존재함을 확인할 수 있었다. 활성실험을 통해 $600^{\circ}C$로 열처리된 $Pt/Al_2O_3$ 촉매가 가장 우수한 전환율 및 선택도를 나타냄을 확인하였다.