• International Journal of Control, Automation, and Systems
• /
• v.5 no.5
• /
• pp.601-605
• /
• 2007

In this paper, we propose a simple and relative electrode contact monitoring method. By exploiting the power line interference, which is regarded as one of the worst noise sources for bio-potential measurement, the relative difference in electrode impedance can be measured without a current or voltage source. Substantial benefits, including no extra circuit components, no degradation of the body potential driving circuit, and no electrical safety problem, can be achieved using this method. Furthermore, this method can be applied to multi-channel isolated bio-potential measurement systems and home health care devices under a steady measuring environment.

• Journal of Institute of Control, Robotics and Systems
• /
• v.9 no.1
• /
• pp.10-21
• /
• 2003

During seek operation in disk drives, the recording head is moved toward desired track by seek servo controller and then is settled onto the center of the desired track by settling servo controller. If the head speed at the start of settling servo control is not slow, it may produce overshoot relative to the center of track and thus extend the settling time. The degradation in settling performance will be more severe as the track width becomes smaller for higher density of data storage. We design a new settling servo controller for minimizing settling time based on the pole-zero cancellation. In order to cancel slow poles in settling response, we apply discrete pulse signals to the system in addition to the state feedback control. For exact pole-zero cancellation, we consider the dynamics of power amplifier used for actuator current regulation and the effects of delay in control action. In addition, we present system parameter identification algerian for the robustness of our controller to system parameter variation. In order to demonstrate the practical use of our controller, we present experimental results obtained by using a commercially available disk drive.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.22 no.12
• /
• pp.1684-1690
• /
• 2018

A new digital pre-distortion (DPD) technique for closely spaced dual-band signals is proposed. In the system under consideration, dual-band signals are amplified by a single broadband power amplifier (PA) at a transmitter. The PA output is distorted by cross-modulation between the two bands as well as their own inter-modulation distortion. Especially, if the two bands are placed in close proximity to each other, their spectral regrowths due to in-band intermodulation overlap with each other, which degrades DPD performance. To solve this problem, we propose a new DPD technique where the dual-band PA characteristics are estimated first, and then the DPD parameters are obtained from the estimated PA characteristics. By finding the DPD parameters through two steps, pre-distortion can perform well for the closely-spaced dual band signals. The proposed technique is verified through computer simulation. Simulation result shows that the proposed method performs better than the conventional method for closely-spaced dual band signals.

• Proceedings of the KIPE Conference
• /
• 2020.08a
• /
• pp.172-174
• /
• 2020

기존의 절대위치 감지 방식은 초기위치를 알기 위하여 이동자의 위치를 초기화해야 하고 생산 단가가 높다는 단점을 보완하기 위해 MR 센서를 이용하여 비접촉 방식으로 선형모터 이동자 절대위치를 판별하는 시스템을 제안하였다. 센서값을 이용하여 절대위치를 판별해야 하기 때문에 ADC 기능과 실시간 연산 기능이 필요하다. 때문에 8bit MCU(Atmega324PA)를 이용했다. 본 논문에서 이용한 MR 센서의 출력 변동폭이 작기 때문에 Instrumentation Amplifier를 이용하여 증폭된 출력을 MCU로 읽어 사용했다. 제안 시스템의 회로 및 알고리즘을 구현하였고 이를 이론적, 실험적 분석을 통해 동작 및 타당성을 검증하였다.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.66 no.4
• /
• pp.629-635
• /
• 2017

Free-Flooded Ring (FFR) transducer array for use in Sonar system can be driven with large amplitude in a wide frequency band due to its structural characteristics, in which two resonances of a ring mode (1st radial mode) and an inner cavity vibration mode occur in a low frequency band. Since its sound wave generation characteristics are not influenced by the water pressure, the FFR transducer array is widely used in the deep sea. So FFR has been recognized as a low-frequency active sound source and has received much attention ever since. In order to utilize the FFR transducer array for SONAR systems in military and industrial applications, its equivalent electric circuit model is necessary especially to design the matching circuit between the driving power amplifier and the FFR transducer array. Thus this paper proposes the equivalent electric circuit model of FFR transducer array by using measured values of parameter, and suggest the improved method of parameter identification. Finally it verifies the effectiveness of the proposed circuit model of FFR transducer array by experimental measurements.