• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2004년도 추계학술대회
• /
• pp.974-979
• /
• 2004

The fluidic muscle cylinder consist of an air bellows tube, flanges and lock nuts. It's features are softness of material and motion, simplicity of structure, low production cost and high power efficiency. In this study, we carried out the finite element modelling and analysis about the main design variables such as contraction ration and force, diameter increment of fluidic muscle cylinder. On the basis of finite element analysis, the prototype of fluidic muscle cylinder was manufactured and tested. Finally, we compared the results between the test and the finite element analysis.

• 한국유체기계학회 논문집
• /
• 제3권1호
• /
• pp.10-18
• /
• 2000

This paper reports the impeller performance of centrifugal pump, modified HES65-250. Developed CFD code uses SIMPLE algorithm, power-law scheme, standard $k-{\espilon}$ turbulence model in curvilinear coordinate system. The calculations are conducted for 5 cases, from 0.6 to 1.4 of flow rate ratio with 0.2 increment. The flow characteristics inside of impeller are analysed. The results show that reversal flows exist at the inlet of impeller which have small rotary stagnation pressure. The obtained results are compared with the experimental data at impeller exit and shows good qualitative agreement.

• 산업기술연구
• /
• 제29권B호
• /
• pp.187-191
• /
• 2009

Recently, we have used LEDs to illumination because it has a high luminous efficiency and prolong lifespan. However the light power and lifetime is reduced by junction temperature increment of LED. So it is important to measure the junction temperature accurately. In case of using a electrical method measuring junction temperature of LED. Temperature measurement errors are spontaneously generated because of a parasitic capacitances in LED. In this paper, we proposed a method that reducing LED's parasitic capacitance effects for electrical measurement. It was demonstrated by the experimental result that is more correct than established method.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2001년도 하계종합학술대회 논문집(2)
• /
• pp.137-140
• /
• 2001

This paper shows an asynchronous comparator circuit for 1.2Gbps signal receiver that converts 1.2Gbps data rate input signals with less than 100㎷ swing to on-chip CMOS compatible voltage levels in a 0.35${\mu}{\textrm}{m}$ CMOS process. Folded-cascode nMOS input stage with source-coupled pMOS input stage cover rail-to-rail input common-mode range. Drastic gain-bandwidth increment due to gain-boosting stage with positive-feedback latch as well as wide input common-mode range make designed circuit be suitable for a fully differential signal receiver. HSPICE simulation results show that worst-case sensitivity is less than 20㎷ and maximum propagation delay is 640-psec. And also we verified 3.97㎽ power consumption with 150㎷ differential swing amplitude at 1.2Gbps.

• 한국축산식품학회:학술대회논문집
• /
• 한국축산식품학회 2004년도 제34차 추계 국제 학술대회
• /
• pp.407-411
• /
• 2004

Ohmic heating occurs when an electric current is passes through food, resulting in a temperature rise in the product due to the conversion of the electric energy into heat. The time spent in the thawing is critical for product sterility and quality. The objective of this study is to conduct numerical modelling between the effect of ohmic thawing intensity on PTT(phase transition time) at constant concentration and the effect of matrix concentrations on PTT at constant voltage condition. the stronger ohmic thawing intensity resulted in decreasing the PTT. High ohmic intensity causes short PTT. And the higher gelatin concentration, the faster increment of PTT. A numerical modeling was executed to predict the PTT influenced by the power intensity using exponential regression and the PTT influenced by gelatin concentration using logarithmic regression. Therefore, from this numerical model of gelatin matrix, it is possible to estimate exact values extensively.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1996년도 하계학술대회 논문집 C
• /
• pp.1854-1856
• /
• 1996

This study describes the minimum ignition limit for LPG-Ai-r mixtures by switching sparks in radio-frequency limits using RF power supply and IEC type ignition spark apparatus. As a result, the minimum ignition limit voltage is increased in proportional to the rate of increasing of frequency in LPG-Air mixed gas. Especially, increment between 10[kHz] and 30[kHz] is typical. It is considered that ignition is caused by one discharge until 10 [kHz] and, beyond 10[kHz] ignition is caused by more than two discharges. The reason is analysed that energy loss is caused by existing pause interval between discharges.

• 한국안전학회지
• /
• 제12권4호
• /
• pp.86-92
• /
• 1997

Demand of LPG and LNG will increase continuously due to high calories, clearness, and convenience for usage. These gases are used widely for power plants, industrial plants, and domestic fuel. But accidents related with gas are increasing in proportion to increment of gas usage. Especially LPG has high ignitability due to weak dispersion to air and accumulation at low place because LPG is heavier than air. There are many hazards during transportation as well as production, storage, and usage of LPG. Commonly, tank lorry is used for inland transportation of LPG. If tank lorry were to raise leakage incidents and then LPG released during transporting, the accidents cause serious effects on the environment as well as human damage of surrounding area. In this study, therefore, hazards which cause LPG of tank lorry to leak during transportation were identified and risk of LPG transportation was assessed quantitatively. Also, the result of this study might be a useful measure for predicting damage and preparing safe transportation strategies of LPG tank lorry.

• 한국정보통신설비학회:학술대회논문집
• /
• 한국정보통신설비학회 2006년도 하계학술대회
• /
• pp.259-264
• /
• 2006

Using M-ary QAM and PSK, various modulation methods are researched so far. In this paper, a new constellation method of $4L^2$-PSK that normalized circular multi-layer method is proposed with the advantage of those modulation methods. These replacements of signal points complement weak points of an nonlinear radius increment as a layer increases in M-ary QAM and a low efficiency in PSK compared with QAM. But, $4L^2$-PSK have some problems that in the power efficiency and difference of BER in each layer, So in this paper suggest that advanced $4L^2$-PSK also.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2002년도 전력전자학술대회 논문집
• /
• pp.459-461
• /
• 2002

Various device or devices is automated by developments of various control appliance. however, the control method is not escaping local area System. In these meaning, this research uses PLC and HMI software for the Growth Chamber's remote monitor and control.

• Preventive Nutrition and Food Science
• /
• 제2권1호
• /
• pp.23-28
• /
• 1997

Physicohemical properties of corn starches isolated from non-glutinous and corn grains fol-lowing γ-irradiation up to 10kGy were investigated. Blue value, water binding capacity and swelling power decreased, while alkali number ad solubility increased by γ-irradiation , which was more pronounced in glu-tinous corn starch than in non-glutinous corn starch. The optical transmittance increased with an increment of heating temperature and applied irradiation doses. No significant difference was observed in Hunter's color value between both starches isolated from non- irradiated and irradiated and irradiated corn grains. Amylograph viscosities decreased remarkably as dose levels increased. The overall effects of γ-irradiation was more distinguished in glutinous starch than in non-glutinous starch.