• Journal of the Korean Geosynthetics Society
• /
• v.22 no.1
• /
• pp.87-96
• /
• 2023

There are a lot of difference between the surface settlement and the differential settlement measured at the Busan New Port, where the dredged and reclaimed clay layer exists and below the clay is originally thickly distributed. To find the cause and solution of this, the actual conditions of each differential settlement used for the soft ground improvement, characteristics, installation method, measurement frequency, measurement data management, and data analysis of each type were considered. In the deep soft ground improvement work where large deformation occurs, the bending deformation of the screw-type differential settlement gauge is less than that of other types of measuring instruments, so there is less risk of loss, and the reliability of data is relatively high as the instruments are installed by drilling for each stratum. Since the greater the amount of high-precision settlement measurement data, the higher the settlement analysis precision. It is necessary to manage with higher criteria than the measurement frequency suggested in the standard specification. For the data management of the differential settlement gauge, it is desirable to create graphs of the settlement and embankment height of the relevant section over time, such as surface, differential, and settlement of pore water pressure gauge for each point. In the case of multi-layered ground with different compression characteristics, it is more appropriate to perform settlement analysis by calculating the consolidation characteristics of each stratum using a differential settlement data.

• Journal of Environmental Impact Assessment
• /
• v.17 no.2
• /
• pp.97-103
• /
• 2008

This study presented politic proposals and diverse utilization-type in coastal areas by analyzing results of reviewed related-statements of marine environment during the one year period of 2007 by Marine Environmental Impact Assessment Center. Total of 358 cases were reviewed, which was a significant increase from 270 in 2006. Consultation on the utilization of sea areas (CUSA) accounted for the largest number of 165 (46.1%) and it was followed by 104 cases of environmental impact assessment (EIA) (29.0%) and 89 cases of prior environmental review (PER) (24.9%). As such, evaluation statements (EIA+PER) related to consultations of the Ministry of Environment accounted for approximately 54% of the entire cases reviewed. To analyze the overall results of reviewing marine-related evaluation statements, utilization and planning were conducted by 47.9%, 38.4% and 13.7% in the South Sea, West Sea and East Sea of Korea, respectively. In evaluation statements (EIA+PER), port construction, industrial complex construction, urban management plan and road construction took up most of the part by 40.9%, 20.2%, 10.4% and 7.3%, respectively. In terms of CUSA-statement, it was evaluated that consultations were mostly carried out on use and reclamation of public water surface in coastal areas and on sea aggregate extraction process in EEZ. The largest number of plans for coastal use were established for Jeollanam-do, followed by Gyeongsangnam-do, Chungcheongnam-do, Gyeongsangbuk-do and Gyeonggi-do. In particular, development plans were concentrated on Jeollanam-do and Gyeongsangnam-do with stable marine environment and outstanding view of the nature. In most cases, these regions are adjacent to the areas designated as a sea area for environmental management and fisheries resources protection zone. Therefore, conflicts exist between development and preservation. Also, rather than random development, more detailed marine environmental impact assessment, gathering of public opinions and politic harmony are essentially required. For efficient coastal management and environmentally sound and sustainable development, fulfilling consistent and transparent coastal policies as well as active and reliable decision making to center on coastal environment by management bodies will be important.

• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• 2015.10a
• /
• pp.279-282
• /
• 2015

Fisheries development of the basic law pursuant to article 15 (marine safety management, etc.) one of maritime safety and maritime traffic facilities nationwide network of DGPS in accordance with the building maximize infrastructure utilization and country. Source technology has been improving steadily raised for the benefit daegukmin. In particular, look at the type of product for the marine supply medium-wave receiver Performance products that satisfy most of the IMO Advisory. The antenna and receiver are separate structural supply for some integrated model with a very high Rather it is used as a portable receivers for marine positioning cheap integrated model development is needed. Correction of satellite navigation receivers for the current Marine GPS module, medium-wave modules can be developed one low cost Integrated in independent operating environments do not support the model development done look at what the problem is 285kHz ~ 315kHz in DGPS Beacon receiver structure using a medium wave or Beacon The medium-wave antenna and a GPS receiver signal to noise ratio was studied GPS signal attenuation on the DGPS performance looked at each GPS manufacturer medium-wave signal-to-noise ratio and normalized impact by GPS manufacturers noise power ratio per bandwidth for medium-wave GPS signals affect it was implemented to improve performance.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.27 no.7
• /
• pp.905-917
• /
• 2021

Atmospheric pollutant emissions, mainly exhaust gas emissions from vessels, and the resultant social costs of pollution in the Korean harbor cities of Incheon, Mokpo, Gwangyang, Busan and Ulsan, are examined in this study, and the need for an emissions reduction plan is highlighted. Busan had several vessels entering its port, while Mokpo had few vessels, yet the vessels emission contribution was high in both the cities. Ulsan had world-class heavy-chemical industries, Gwangyang had steel mills and Incheon had a manufacturing industry and more vessels entering its port than Mokpo, yet the emission contribution was low in these cities. By calculating exhaust gas emissions from the vessels, it was found that CO₂ was the highest, followed by NOx and SOx. By vessel type, Busan, Ulsan, and Incheon had more oil tank vessels, Gwangyang had more cargo vessels, and Mokpo had more ferries. As a result of social cost, Busan paid the highest, while the highest emission was PM. The use of low-sulfur oil can directly reduce PM and, SOx emissions and indirectly reduce NOx emissions. However, in order to reduce high CO₂ emissions, only low-sulfur oil will not help. Therefore, the study suggested the need for reduction plan that use of fossil fuels, by using alternative maritime power (AMP).

• The Journal of Korean Association of Computer Education
• /
• v.13 no.5
• /
• pp.103-110
• /
• 2010

If an exterior computer wants to join the Grid/cloud computing platform for a while, all of the related firewalls' filtering rule should be immediately updated. As the platform of Internet application is gradually evolving into the Grid/Cloud environment, the R&D requirement for the dynamic traversing of the multiple firewalls by a single try is also increasing. In this paper, we introduce the new mechanism for the dynamic traversing of the multiple firewalls using the concept of the one-time master key that can dynamically unlock the tiers of firewalls simultaneously instead of the existed filtering rule based method like a lock management at each firewall. The proposed master keys are like one-time password, consisted of IP addresses, port numbers, and TCP's initial sequence numbers, and generated by end users not administrators. They're exchanged mutually in advance and used to make a hole at local-side firewalls for the other's packet incoming. Therefore, the proposed mechanism can function regardless of the number or type of firewalls.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.24 no.6
• /
• pp.654-661
• /
• 2018

This paper analyzes the type of facilities and equipment of the marina port and analyzes its lift facilities (lift pier) and equipment (marine mobile lift). It set up the lift facilities and equipment standards. Depending on the gross tonnage of vessels in operation in Korea, the required inner width of lift piers is 5.50 m for 35-ton vessels, and 6.20 m for 50-ton vessels. The inside width of the marine mobile lift is 6.10 m for 35-ton vessels, and 6.80 m for 50-ton vessels. There are two places where the target ship can be lifted from the lift pier installed on the domestic marina, and other marinas' lift piers inner widths are insufficient by about 0.35 ~ 0.50 m. Among the marine mobile lifts in operation, there were two apparatuses that secured the inside width necessary to lift the target vessel. Other marine mobile lifts' inner widths are insufficient by about 0.3 ~ 0.6 m.

• Journal of Digital Convergence
• /
• v.10 no.11
• /
• pp.197-202
• /
• 2012

Block Train Services(BTS) are actively studied in many countries for higher productivity and eco-friendly systems of inland freight distribution. However it is difficult for an ordinary student or researcher to approach for understanding and studying BTS because rail transport is operated monopolistically by Korea government and most freight information in each company belongs to its business secret due to the industrial characteristics. For such reasons, the study aimed to develop a BTS simulation model that it supports understanding and strategic decision required for BT operation. To build the result, expert depth-interviews were conducted with analysis of relative references through the domestic representative BT operating company K. The simulator refers to the Busan NewPort-Uiwang section and functionally, it supports scenario generation and analysis on BT operation. It makes a contribution to study a new type's technological application for learning and strategic analysis of BTS.

• Journal of Korea Port Economic Association
• /
• v.34 no.4
• /
• pp.141-160
• /
• 2018

In this paper, to analyze the perception and response strategy of Korean ship owners on Global Sulphur Cap 2020, examined the IMO environmental regulation status focusing on MARPOL Annex VI regulation about air pollution prevention, technological measures to reduce SOx emission, shipping industry and management status of Korean ship owners. First of all, the questionnaire was conducted for Korean ship owners after selecting the evaluation factors. The purpose of this study was to investigate the difference of the perception and response strategy of Korean ship owners by corporation size and main vessel type using frequency and cross analysis. It is confirmed that various researches on SOx emission reduction have been carried out from various points of view at home and abroad. In this study, existing studies related to technical factors for regulatory response and economics analysis were examined and evaluation factors were selected. As a result of analysis, it is found that large-sized shipping companies are more prepared for regulatory response than small and medium-sized bulk carrier owners. There were similar perception and the direction of response strategy about the impacts by corporation size and main vessel type. In about two years to be implemented in 2020, It is necessary to find an appropriate response strategy based on the support policy of the government and related organizations and the systematic analysis of the ship owners. Through this study, although the difference between the perception and response strategy of the ship owners by corporation size and main vessel type was understood, it was found that there were limitations on specific response strategy and corporate data collection. In future research, we should overcome the limitations of this study and conduct an in-depth study.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.19 no.11
• /
• pp.506-512
• /
• 2018

The fine dust generated in the home and restaurant business occupies a low ratio of about 4% of the total fine dust emissions. However, at the foodservice business, the rate of change of the pollutant concentration is very high, so that the temporary fine dust concentration can be measured up to 60 times. The pollutants generated from non-industrial combustion plants consist of particulate fine dust and gaseous organic compounds. To remove these pollutants, cleaning dust collection system, which is an effective system for simultaneous removal of gaseous and particulate matter, is applied. This is a method of increasing the probability of diffusion capture of the Brownian motion by pressurized liquid injection method using the atomizing nozzle. The dust removal efficiency of the fine dust collecting system was analyzed by nozzle spraying air pressure condition and angle using the manufactured fine dust removing system. As a result, it was confirmed that the efficiency of removal of fine dust and gaseous organic compounds was more than 90%. The developed system is expected to be highly usable in the future because it can remove particulate dust from the existing plant hood system without any installation cost.

• Clean Technology
• /
• v.23 no.1
• /
• pp.54-63
• /
• 2017

Volatile organic compounds (VOCs) are widely used in both industrial and domestic activities. VOCs are one of the most unpleasant, frequently complaint-rousing factors of pollution around the world. It is now necessary to research and develop an alternative technology that could overcome the problems of the existing odor-control and VOC-eliminating techniques. In this study, essential oil and photocatalytic process was applied in the removal of benzene and toluene, typical VOCs in petrochemistry plant. therefore, this study conducted experiments on the selection of appropriate essential oil, photodegradation, hydroxyl radical generation capacity. The removal efficiency and reaction rate were performed to selecte the type and concentration of essential oil. As a result, removal efficiency of Hinoki Cypress oil was approximately 70% and reaction rate of Hinoki Cypress was high. The results of photolysis experiment, photocatalytic oxidation process showed that the decomposition efficiency of VOCs increased considerably with increasing UV lamp power. In addition, the conversion of VOCs was increased up to $0.1gL^{-1}$ photocatalysts. The hydroxyl radicals measure was performed to determine the ability to generate hydroxyl radicals. The analytical result showed that high $TiO_2$ concentration and lamp power was produced many hydroxyl radical. Experiments of the removal efficiency and reaction rate were performed using essential oil and photooxidation. As a result, the removal efficiency showed that the removal efficiency was increased high temperature and reaction time. The activation energy was calculated from the reaction rate equation at various temperature condition. Activation energy was approximately $18kJmol^{-1}$.