• Journal of the Korean Ceramic Society
• /
• v.27 no.4
• /
• pp.529-535
• /
• 1990

This paper describes the factors which control the impedance-relative humidity characteristics of the TiO2-V2O5 humidity sensor. To obtain the quantitative relationships between impedance and many manufacturing parameters such as V2O5mol%, the sintering time and temperature, various sets of samples are preared and tested. With changing relative hymidity from 20% to 80%, it is measrued that the corresponding capacitance and impedance from the semicircles which complex impedance plots make. As a result we found that the impedance-relative humidity characteristics are mainly controlled by the doping amount of V2O5 total pore volume and bulk resistence of the elements. We can assume the equivalent circuits of each samples and finally control the sintering time to get a linear humidity impedance response curve which plays an important role in device making. 4mol% V2O5-TiO2 specimen sintered at 90$0^{\circ}C$ for 10min. show liear log(Z) vs. RH characteristics and 10mol% V2O5-TiO2 specimen sintered at the same temp. for 20min. show linear (Z) vs. RH.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.25 no.9
• /
• pp.1263-1271
• /
• 2001

An experimental study is carried out for an aluminum foam heat sink attached to an isolated heat source to evaluate high potential of aluminum foam as a heat sink with impinging jets. The effects of the pore density and the height of the aluminum foam heat sink, the jet Reynolds number, and the nozzle diameter are delineated in comparison with a conventional pin type heat sink. It is found that the aluminum foam with small pores is inefficient for the heat transfer enhancement due to the large flow friction at the given porosity. In the parameter ranges of the present study, the change in the nozzle diameter shows no significant effects on the surface temperature of the aluminum foam heat sink at a given Reynolds number. The heat transfer enhancement is strongly dependent on the jet Reynolds number and shows a maximum value at a moderate Reynolds number.

• Research in Plant Disease
• /
• v.7 no.2
• /
• pp.69-79
• /
• 2001

Meloidogyne arenaria race 2 (59%) is widely distributed, followed by M. incognita race 1 (23%), and an unknown race of M. incognita (18 ％) in greenhouses in southern Korea. The key character to distinguish between M. arenaria and M. incognita is excretory pore in female head. When oriental melon, Cucumis melo L., grafted on Shintozoa (Cucurbit maxima x Cu. moschata) is transplanted in February in a plastic tunnel inside a greenhouse infested with M. arenaria, nematodes produced egg masses on roots at 40 days after transplanting and the soil juveniles (J2) population reach maximum in July to 3,817/100 ㎤. Juveniles are distributed relatively uniform over the 180-cm-wide row horizontally and the highest density occurs at 0-25 cm soil depth. For the control of root-knot nematodes, rice rotation, solarization, and soil addition treatments are the most effective (P=0.05); treatments reduce number of J2 over 90% and increase yield two times. Corn retation, fosthiazate, and soil drying treatment are moderately effective, while sesame and green onion rotations are not effective. The relationship between M. arenaria and yield of oriental melon is adequately described by a linear regression model. In the test with wild Cucumis genetic sources introduced from U.S.Dept. of Agriculture (USDA), one of C.heptadactylus, two of C.anguria, two of C. anguria var. longaculeatus, nine of C. metuliferus are resistant to both species of root-knot nematodes.

• The Plant Pathology Journal
• /
• v.19 no.6
• /
• pp.280-283
• /
• 2003

A soybean-sprout rot epidemic occurred in a mass production soybean sprout factory in 2000 and 2001 in Korea, which caused up to 20% production loss. Among the causal pathogenic bacteria and fungi, Pythium deliense was found to be the dominant pathogen of severe root and hypocotyls rot, particularly in recirculating water system. An average of 90% of the isolated fungi from the rotted sprout on potato dextrose agar were Pythium sp. The fungal density of Pythium in the sampled water was monitored in the recycled water system for 1 year using a selective medium (com meal agar with Pimaricin, 10 mg； Rifampicin, 10 mg； and Ampicillin, 100 mg per 1 liter). The drained water from the soybean-sprout cultivation always had a certain amount of fungus in it. The removal of Pythium from the recycling water system must be thorough, safe, and environment friendly. However, the pathogen in the water was easily found even after ozone and chlorine treatments, which were devised on the recycling system for the removal of microorganisms. 5-$\mu\textrm{m}$ pore size filter was applied and was able to successfully control the disease. As the sprout industry increasingly shifts into mass production, the demand for water will increase continuously. Recycling water for sprout production is eco-friendly. However, a process must be devised to be able to first decompose organic matters before Pythium zoospores are filtered.

• Korean Journal of Soil Science and Fertilizer
• /
• v.48 no.5
• /
• pp.326-331
• /
• 2015

High salinity and sodicity of soils play a negative role in producing crops in reclaimed tidal lands. To evaluate the effects of soil ameliorants on salt removal in a highly saline and sodic soil of reclaimed tidal land, we conducted a column experiment with treating gypsum, compost, and phosphate at 0-2 cm depth and measured the salt concentration of leachate and soil. Electrical conductivity of leachate was $45-48dSm^{-1}$ at 1 pore volume (PV) of water and decreased to less than $3dSm^{-1}$ at 3 PV of water. Gypsum significantly decreased SAR (sodium adsorption ratio) of leachate below 3 at 3 PV of water and soil ESP (exchangeable sodium percentage) below 3% for the whole profile of soil column. Compost significantly decreased ESP of soil at 0-5 cm depth to 5% compared with the control (20%). However, compost affected little the composition of cations below a depth of 5 cm and in leachate compared with control treatment. It was concluded that gypsum was effective in ameliorating reclaimed tidal lands at and below a soil layer receiving gypsum while compost worked only at a soil layer where compost was treated.

• The Journal of Korean Medicine
• /
• v.44 no.2
• /
• pp.34-44
• /
• 2023

Objectives: The purpose of this research was to find out the efficacy of Castanea crenata Inner Shell (CCIS) distilled herbal medicine on the skin by comparing the difference effect between only simple distilled water and the CCIS distilled herbal medicine application after MTS (microneedle therapy system) treatment. Methods: The present author performed once a week and total 4 times of MTS treatment. The treatment time took about 5~10 minutes and the depth of the needle was adjusted according to the participant's skin condition. In the control group, simple distilled water was applied after MTS and in the experimental group, CCIS distilled herbal medicine was applied. One week after each treatment, the change of skin condition was measured. Two weeks after the end of the clinical trial, the skin condition was checked again. Results: In the case of the test group, there was a significant decrease in pore size and there was a significant increase in U-zone oil, skin tone and elasticity. The test group using distilled herbal medicine showed a significant effect on facial skin compared to the control group using only simple distilled water. Conclusion: Distilled herbal medicine showed an effective action on facial skin. In the case of CCIS distilled herbal medicine, it was found to have a significant effect on U-zone oil content, skin tone, pores, and skin elasticity.

• Journal of Korean Society of Water and Wastewater
• /
• v.37 no.6
• /
• pp.325-334
• /
• 2023

Membrane bioreactor (MBR) provides the benefits on high effluent quality and construction cost without the secondary clarification. Despite of these advantages, fouling, which clogs the pore in membrane modules, affects the membrane life span and effluent quality. Studies on the laboratory scale MBR were focused on the control of particulate fouling, organic fouling and inorganic fouling. However, less studies were focused on the control of biofouling and microbial aspect of membrane. In the full scale operation, most MBR produces high effluent quality to meet the national permit of discharge regulation. In this study, the performance and microbial community analysis were investigated in two MBRs. As the results, the performance of organic removal, nitrogen removal, and phosphorus removal was similar both MBRs. Microbial community analysis, however, showed that Azonexus sp. and Propionivibrio sp. contributed to indirect fouling to cause the chemical cleaning in the DX MBR.

• Journal of Electrical Engineering and Technology
• /
• v.1 no.2
• /
• pp.246-250
• /
• 2006

Highly ordered gold nanodot arrays have been successfully obtained by vacuum evaporation using an anodic aluminum oxide (AAO) as a shadow mask. An AAO mask with the thickness of 300 um was prepared through an anodization process. The structure of the nanodot arrays was studied by a field- emission scanning electron microscope (FE-SEM) equipped with an energy dispersive spectrometer (EDS). A tapping mode atomic force microscope (AFM) was employed for studies of height and phase feature. The nanodot arrays were precisely reproduced corresponding to the hexagonal structure of the AAO mask in a large area. In the gold nanodot arrays, the average diameter of dots is approximately the same as the AAO pore size in the range from 70 um to 80 nm and 100 nm center-to-center spacing. EDS analysis indicated that the gold dots were almost entirely consisted of gold, a highly demanded material.

• Journal of the Korean Society of Clothing and Textiles
• /
• v.24 no.4
• /
• pp.560-570
• /
• 2000

The purposes of this study were to segment the cosmeceuticals market based on consumer usage behavior and to develop a profile of each segment using appearance-related variables, purchase attributes, purchase behavior and demographics. A total of 518 responses collected from a questionnaire survey to female consumers was analyzed. Cluster analysis on usage behavior of cosmeceutical products identified three groups including: Anti-aging/Whitening/Slimming product users (22% ); Pore-control product users(20%); and Minimum users(57%). MANOVA, ANOVA and Chi-square analysis revealed significant differences among the three groups on 2 appearance-related variables, 3 purchase attribute factors, 4 purchase behaviors, and 2 demographic characteristics. Based on the results, the study developed a profile of each segment and provided marketing implications.

• Journal of Korean Society for Atmospheric Environment
• /
• v.17 no.1
• /
• pp.75-84
• /
• 2001

Hot gas filtration method via using ceramic filters is an evolving technology applicable to numerous industrial and air pollution control processes. Alumino silicate, organic and inorganic binders were the major raw materials in manufacturing ceramic filters. In this work, disc type ceramic filters(50$\phi$$\times$10t) were manufactured by vacuum forming processes using ceramic raw materials. The porosity and bulk density of disc type ceramic filers ranged from 86 to 89% and from 0.27 to 0.36 g/㎤, respectively. In this work disc type ceramic medium were tested utilizing coupon experimental apparatus. Disc type filters showed high collection efficiencies over 99.96% with Darchs law coefficients of 4.1$\times$10(sup)10~9.63$\times$10(sup)10/$m^2$ depending on mean pore sizes. In addition, filtration and detachment of ceramic filters turned out to be performed effectively using 10 cm/sec face velocity, 5 minutes filtration cycle, 100msec pulse jet valve opening time and 3 bar pulsing pressure.